Chevrolet - Blazer :: Repair Engine Soon Light Came On - Error Code 1870
Dec 13, 2011
My engine repair soon light came on. Went to repair shop and was told i had error code number 1870. I was told i had a problem in my transmission with my transmission going into overdrive. I had not seen any problems in that area.the car seems to run fine.repair was made replacing the tcc regulator valve assembly at a cost of 424 dollars.three days later the light came back on with the same code.went back and he checked the fluid level and reset the light. It came back on before the day was over. He told me he would call me back with further action.have not heard from him yet.your thoughts on this.i feel like i have been taken for a ride.i have a 1996 chevrolet s10 blazer with 217,000 miles on it. The transmission was rebuilt at 170,000 miles.the car has been well maintained and runs and looks great.
View 4 Replies
Advertisement
My Check engine Light comes on with a P0410 Code. It used to come on every 6 months and I would get it cleared. Now it is coming on about every month. I can't find much about it. Is this something I should get fixed right away. where is it located?
View 4 Replies
I can drive below 40 mph and nothing, once I hit the freeway engine light turns on and gears start slipping. I erase the code and it runs fine at first this would happen once in a while but lately its every time I get on the freeway. I cant keep driving and erasing the code, Every shop says I need to replace the transmission?
View 4 Replies
I've been having my 'service engine soon' light turn on in my 1999 Chevy Blazer. It has an automatic transmission and 60,000 miles. I first disconnected the battery to turn off the light and to see if it would turn on again. It turned on again so I took it to AutoZone for an obd2 scan and got codes P0300 and P0442. I replaced the spark plugs and spark plug cables and the light turned off, but then turned back on after a week. I'm starting to think the problem is something simple like the gas cap.
The rubber film around the cap has a few tears, but are the tears significant enough to cause the light to turn on?
View 10 Replies
What would cause a trouble code PO 300 on a 1998 Chevy Blazer. The truck will run good sometimes. When it runs bad it will stumble at low speed acceleration. It will run fine wide open. Dealer looked at it and thought it was egr vale. I replaced it and it runs a little better but still stumbles.
View 5 Replies
So I changed my spark plugs, due to an error code saying p0301 which means cylinder one misfiring. I reset the engine light disconnecting the negative battery terminal. Once it reset it ran rough for a few miles. I put about 50 miles on it and it seems better.
View 2 Replies
I was cruising down the highway and my check engine light came on. I was a few minutes from a auto store and they said my code was p1296. I found out it is either the thermostat or the coolant temperature sensor. I wanna know where it is located in the engine bay. I have a 02 VW Jetta 1.8T.
View 1 Replies
2003 1.8t passat wagon. 50k miles... The check engine light came on today. Oil and engine temp are fine. Can most shops plug in and diagnose? Can I get one of those code readers at Advanced Auto parts to read the error code?
View 5 Replies
What is the meaning or the fault concerning 4608. The above error code was reported on the computer diagnose machine and it referred me to look into the vehicle ownership manual book BUT its rather unfortunate that i could not find that book. So, what to tackle or replace on the engine to enable the check engine lite go off.
View 17 Replies
Engine light come on and everything is running great, this morning got this error code U0d00. Went to advanced auto and had them run a scan.
View 5 Replies
I got a P0118 error code on my car. Looked up some things and most people were saying change coolant temperature sensor. I changed it 2 days ago and have not had a chance to clear the CEL. Its still on now, guy at Autozone would not clear it, said it was against company policy.
Will this turn off automatically once problem corrects itself? I went to Autozone and had them rescan the error, this time another code poped up P0444, EVAP(Evaporative Emission System)Evaporative Emission Control System Purge Control Valve Circuit Open. What this can be?
View 3 Replies
My service engine light is on and the tech at Quick Lube said this is the error code that is reporting. "P0446 EVAP Control System Vent Control Circuit Malfunction". Is the car safe to drive?
View 10 Replies
I have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 Replies
I got a 2012 Hyundai Accent SE manual 112000 mostly highway miles. For a month now I am getting the MIL on and P2191 code (System too lean at higher load bank1) after erasing the code it appeared again in 3-4 days. I replaced air filter check all valves and vacuum in air flow, changed to premium gas. Pipe that connected to the valve from EVAP system looks not damaged and valve works as intended. While changing spark plugs I noticed that all of them were quite charred. I am thinking to replace both O2 up/down stream sensors. Which not OEM sensors would be the best match for my Accent?
View 11 Replies
I recently bought a 2007 Hyundai Sonata Limited from a private seller. This car has been perfect for the few weeks I've had it. Now, my check engine light came up and the error code "P0660 Intake Manifold Tuning Valve Control Circuit / Open Bank 1" popped up. I'm not really sure what piece to look for, or which connectors to check.
View 3 Replies
I have a 86 K5 Blazer. Six years ago put a new gm 350 a rebuilt trans. and had all the work performed for inspection. Truck was run once or twice over the years. This winter I got it on the road to push snow. I ran the blazer once for about 12 hours pushing snow, on the way home I thought I had a problem with the trans. Took the k5 out today 2/20 to pick up my kid at a neighbors house. Started out fine but at the large steep hill my k5 lost power. I pulled over to check the blazer over. It was idling fine but when I would rev the engine it was muffled. I drove up the rest of the hill (barely)and picked up my kid. On the way back I was quickly throttling the gas pedal which seemed to give little bursts of power. I am thinking that I have an airflow problem.
View 11 Replies
I have a Toyota Prius (2010), and the car has run for about 2800000 kilometers. One day when a was driving my Prius the engine light suddenly get on. So I went to a car car mechanic, he checked the car and told me there was an error code (error code: P0401, exhaust problem (exhaust recirculation flow).
So I bought a liquid that I put in the gas tank, the liquid would clean the exhaust pipe, but the engine light was still on. The engine light is usually on at least 2 weeks, then disappear for about 2 days and come back in two weeks…The car is driving normally without any problems.
View 2 Replies
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
View 3 Replies
From time to time, the engine lights comes on with error code P0365, it usually disappears within two days (it disappears by itself), but it appears once per month and stays for two days.
The code scanner says :P0365 Camshaft Position Sensor B Circuit Malfunction (Bank 1)
Do I need to change the sensor? and where is it located?
my Sonata is 2009, 2.0L (Korean imported) 4 cylinder ...
View 8 Replies
I was driving along today and my Check Engine light came on. I stopped at the nearest Advance Auto to have them pull the code and it came up with the P0420, Catalyst Efficiency Below Threshold (Bank 1). I asked what could cause this and they mentioned that the fuel that was put in could be causing it. They didn't mention any other possible causes. Any others? I'm thinking it could be the fuel because the last gas station that I stopped at and filled up at is one that I never go to, and maybe just got a bad batch of fuel.
View 14 Replies
I have a 1998 chevy blazer and I cant get it to start. I removed the starter and turned the key and can see the starter popping out and spinning, but when I put it back into the flywheel all I get is clicking noise(like if the battery is dead) I had it on jumper cables so I don't think its the battery?
View 12 Replies
