Chevrolet - Blazer :: Coolant In Oil - Leak In Head Gasket?
Jan 12, 2014
I found during an oil change that there is coolant in my oil, I had suspicions of this because of having to add coolant more than I should of had to. There is probably either a crack in my block, head gasket or intake manifold, my question is how can I tell which. I figure that if I preform a compression check it will tell me that I have a cracked block and or a cracked head gasket, what will tell me if I breeched my intake manifold.
View 19 Replies
Advertisement
I have 2012 R with 33,000.00 miles on it. During regular service they detected that I have a coolant leak. They replaced a flange and determined that there was actually a head gasket leak. This is very unusual for such a low mileage. The car is still under extended warranty and they are in the process of replacing the head gasket. They told me today that they have to machine the head since there was some residue due to the coolant leak. This is all done at a VW dealer service.
View 1 Replies
Quick question, my 2007 Santa Fe with 3.3 has developed a small coolant leak. Every so often, I see a few drops on the garage floor and every 6 months or so I need to fill the reservoir with new coolant. So I took it in last Friday at a Hyundai dealership and he said that I need a new head gasket.
So my question is, is that correct? I did a search and most say that if you need a new head gasket, coolant would have leaked into the engine and oil.
When I changed the oil back in June, I don't recall seeing any foam or-or any indication that something is wrong with the oil. Even yesterday, I open up the oil cap and pull the dipstick, every looks normal. I assumed that not all head gasket problems lead to coolant in the oil?
View 22 Replies
2007 Pilot leaks coolant but, mechanic can not find the leak anywhere including the head gasket. He was a certified Honda mechanic.
View 16 Replies
I just bought my 2006 Toyota Prius about a year ago in 2009. It has been treating me LIKE GOLD !!! up to this point. About a month or two ago, the check engine light came on and stayed on along with a big red triangular warning light. I let it go for about a week hoping that it would just go away.
I brought the vehicle into my local Toyota dealership so they can diagnose it.They told me that they had 3 or 4 different "codes" coming from the machine when getting the signals from the check engine light. All the codes were related to the cooling system. They said that they felt that there was "debris" clogging the pathway for the coolant flow throughout the engine. They had recommended a "coolant flush" for the hybrid side as well as the mechanical side. So I took their advice and I had them perform the coolant flushes.
After leaving the dealership that 1st time, the check engine light came back on the next day. I called the same dealership and explained it to them. They asked me to bring it in again. SO I brought it to them a 2nd time. They diagnosed it again. They told me they came up with 2 of the SAME "codes" and 1 that was different, but ALL the codes were STILL related to the cooling system. They explained to me that something was preventing the clear flow of coolant throughout the engine. And since the thermostat was the only major obstacle, they recommended that I replace it. Well, I did. And after I left the dealership that 2nd time, I was praying that this was the last of my Prius issues! The check engine light came back on the next day.
View 1 Replies
I have the 2.4l engine and the car has 177K on it. Bought it from a friend at 60K and never had a problem with it. I started getting the coolant puddle from the rear of the engine. We took the intake manifold off and saw that the head was leaking in the rear. Real small drop forming and then falling. No codes at the time either. Seems this car has problems with the Engine bolts and was wondering how many people out there had a blown head gasket and there was no bolt issue?
Also I know this is not the right thing to do but use Engine Block Sealant? This is the kind that you drain your antifreeze,flush twice and then run this stuff in it for little while and then replace with antifreeze.
I am upside down on the car because I put 50K a year on so don't think I will get anything for trade. I am hoping my brother in law and I can fix it but am wondering what the odds are there is a problem with the bolts.
View 8 Replies
My mothers 95 blazer LS coolant is disappearing. A friend said if it's not on the ground than it's in the engine somewhere. oil pan search looked coffee looking?
View 6 Replies
New truck to me. Truck was advertised with a slow coolant leak. Figured I would trace the leak down and get it repaired no issues. Anyway, working on it this evening I take a close look around the oil filler area and notice the dreaded milkshake color.
I drained the oil out of the truck and the oil actually came out nice and black. Is the headgasket the only area that would cause the oil/coolant mixture? Supposedly the truck has never been overheated.
At any rate, on to find articles on how to pull apart a 4.6L Triton head. I'll see if I'm up to this challenge.
View 3 Replies
Is this normal or do I have a leak? Noticed this white stuff just like what you would find on the coolant cap, as well as this red stuff too.
View 7 Replies
My Subaru dealer just told me that my 2004 outback with 88k miles has developed a head gasket leak. I haven't noticed any symptoms, and the leak started sometime between now and my last major service 10k miles ago. How serious is this? They want to charge me for it? If so, when? Is disaster imminent?
View 7 Replies
I have a 06' JGC with the 5.7L Hemi w/80k and about a month ago I noticed a little smoke under the hood after driving, I found an oil leak and it's running down the passenger side of the rear main seal but the leak is above the seal. I had the shop put die in it and they dont know for sure but they belive it is the head gasket. There is no water in the oil but they said that doesnt matter. Apparently the heads cant be resurfaced on hemi's but they have to be checked to make sure they are in spec.
View 2 Replies
Have a 2000 Alero. Mechanic says oil on ground is from leaking head gasket. $3000 to repair, or buy rebuilt engine for about the same. I thought head gasket leaks were into the coolant, not outside. Is this legit, including the cost? Valve cover gaskets were replaced earlier this year. Should I get another opinion? Other possible sources of leak?
View 2 Replies
I've been told that the 2002 Santa Fe that I drive has a small leak in the head gasket and that this will be a major problem for the A/C compressor in the not-too-distant future. Supposedly the compressor is located below where the leak is and that over time (5-6 months) this can/will cause the compressor to need to be replaced. Does this seem like a credible scenario?
View 2 Replies
I recently had an issue with my head gasket. It was repaired but then learned the real issue was that I had diesel gas in my engine. (Long story, fuel hauler put wrong gas in tank and service station sold the gas to us unsuspecting drivers.) After head gasket was fixed, tried to leave service shop but car still had issues - turned around and went back. O2 sensor and other fuel trim numbers were off. But couldn't diagnose problem completely so told me to drive home (30 miles) and come back next day.
That's when I found out about the diesel gas issue. My car got drained of bad gas and cleaned. Got car back but now is leaking oil. My husband thinks it is either from the valve covers or from head gasket. Can diesel gas in your engine damage the head gasket? Could I have done more damage by driving the 30 miles home with the bad gas? Or did the shop just do a bad head gasket repair? I only bought this car 6 months ago - used. It now has 88K miles.
View 6 Replies
I just finished replacing the head gaskets and all gaskets above it on my Chevy Venture. When I went to start the vehicle the first time nothing happens. The dashlights come on, but when I turn the key to start nothing happens. No clicking, no nothing. I have tested the battery...OK. I have tested the starter...OK. I have traced the wiring harness to ensure all wires are plugged in. I have checked all the fuses. I thought maybe its the gear switch so I changed down to 1st and then back up to Park...Nothing. I jiggled while in park..Nothing. Could it be the actual ignition switch? It was fine before this escapade.
View 8 Replies
I have a 2011 RX 350, leaking coolant from head gasket. It has 113000km, engine warranty is 110000km ...
View 5 Replies
Our 05 Elantra (170k miles) is leaking coolant externally from the head gasket. At first I thought it was coming from the freeze plugs, but it's actually leaking from above. I'm mechanically inclined but have no experience with head gaskets. I have access to Alldata but no service manual. Will it tell me everything I need to know? The farthest I've gone inside an engine is removing valve covers car runs great and we like it enough to want to keep it for a while ... I'll also mention I will be replacing the timing belt as well.
View 7 Replies
A local mechanic tells me I have a blown head gasket on my 2003 Saab 9-5. He also said there's coolant standing in one cylinder. If this is due to stretched head bolts, might I remedy the problem by replacing the head bolts and torqueing to specifications?
View 4 Replies
I have a 03 5.4 F150 SCrew... The intake was leaking on the passenger side (water outlet tube meets plastic).
Putting in the Dorman replacement and noticed that the front cylinder drivers side (#5) had a decent amount of coolant in it.. None of the others did. I've drained the coolant already and was wondering should I just put this back together and see?
The water outlet crossing has a hole right next to this cylinder and I can't see any cracks and not sure if the gaskets were leaking under it.
Seems like if the head gasket was blown I would see it in more cylinders? It never smoked or run bad before I got this leak... Drove it maybe 10 miles with it leaking out onto Cyl#1. Ran fine, never missed.
I just don't want to put this back together if the head gasket is blown but I don't know what to do.
View 3 Replies
I have a 91 Ranger V6 4WD with 150K that has been sitting for 7 years. The last time I drove it (7 years ago) to a mechanic, who diagnosed it with a bad head gasket - leaking coolant and coolant in the oil.
What am I looking at as far as a project: besides redoing the head gasket, what else will I most likely need to do given that its been sitting 7 years?
View 6 Replies
I have a oil leak that I can't seem to find the source of. The head gasket corner (driver side firewall corner) has oil on it. (3.8 SC). Or maybe the intake valley gaskets are leaking but it doesn't appear so (and the intake was done within the last 20k miles). The back side of the oil pan (toward rear of car) is wet and the oil seems to be dripping off the transmission pan somehow.
Another thing is the knock sensor between the block and transmission seems wet, not sure if the oil is coming from above that or not, would the knock sensor leak oil or coolant? (or nothing)...
View 6 Replies
