Chevrolet - 1500 :: Truck Vibrating Like It Is Going On Rumble Strips Only Over 40MPH
Apr 8, 2011
My truck just recently started to vibrate like it is going over rumble strips. It only happens over 40MPH and sporadically. It seems to happen when I'm just giving enough gas to maintain speed. Once it starts if I let off the gas or give it more gas it goes away. It reoccurs anywhere from 20 seconds up to a few minutes. I'm afraid my tire is going to fly off or my drive shaft is going to drop. There is no unusual noises or thuds if I go on and off the gas and the universal joints seem tight, and there is no vibrations from on steering wheel.
View 10 Replies
Advertisement
Very weird thing happened on the way home from work. When I left work (not to full temp) at about 1500 rpm and 30 mph (had to be at 30mph--seemed to be the key) the whole truck felt like it was rolling across rumple strips (the ones one the shoulder of the road) all vitals were normal and it was gone once on the interstate and up to temp (I did gon on it to blow out anything that may have needed to be) it felt more like drive line but honestly can't say. 2006 F350 4X4 ....
View 7 Replies
I have a 02 durango. Yesterday once i was accelerating over 30 it started feeling like i was driving over rumble strips a little. It felt like it was towards the back. I drove 15 miles to the store and back. On the way home it died down and went away. Today I started driving to town and it is doing it at all speeds. The vibration doesn't seem to change with speed but is much more intense. Only happens when I give it gas. I have searched many forums and not sure where to start? I've read everything from torque converter to solonoids to u-joints, axle bearings, engine problems, or a bad differential.
View 5 Replies
Problem: Vibration together with a noise that sounds abrasive and destructive. Mechanics have failed me.
It feels like driving over the intense short rumble strips that are meant to tell you when a wheel is outside the traffic lane. I feel and hear it in any gear, whether I am moving or not, but hardly at all in Park or Neutral, and hardly at all when cruising at high speeds. It is worst on the first drive of the day - much less on subsequent drives, even if the engine has been allowed to cool fully.
History: When this began, less than 600 miles ago, I had the transmission checked, where I had warranty coverage.
Found: No transmission trouble but a broken engine mount.
I had the engine mount replaced (and two gaskets replaced because they had started to leak), together with Virginia's mandated annual inspection - passed.
Vibration lessened but continued and started to worsen. Within 3 days the engine stalled in traffic and THE NEXT DAY the "check engine" light came on. I went back to the same place. The ignition coil and spark plugs were replaced. Power returned, and no stalling or warning light, but the vibration persisted.
One mechanic baffled: "What do you expect with 101K mileage and 16 valves?" - But this came up too fast to be ordinary wear and tear. What should I do?
2.0L Zetec E engine.
View 9 Replies
I have a '98 Ranger 4.0L SuperCab 4x4 Automatic
The other day i was driving, around 40 MPH and suddenly the truck felt like I hit rumble strips on the highway, I hit the brakes and when the truck got down to about 10-15 MPH, it went away. It didn't feel like an out of balance tire or anything like that. It felt exactly like I hit rumble strips. It was a strong, high frequency vibration. I then continued on my way, and it was fine for a little while, still doing 40 mph, then suddenly out of nowhere the same vibration came back. Once again, I slowed back down, it went away and stayed gone even when I sped back up.
Both front hub bearings are less than a year old, and a quick check of the driveshaft seemed to indicate the u-joints are still tight. Front diff/driveshaft turns freely and smoothly and the front hubs are not locked.
'm going to try and jack the truck up and check everything thoroughly, but I'm really at a loss here, as I've never experienced anything like this before in any vehicle. Some reading suggests that it might be transmission related to the 5R55, but I'm really unsure.
View 11 Replies
I have a 09 Subaru Forester with 66k miles that vibrates like it is going over rumble strips when it up shifts from 3rd to 4th gear. It occurs under normal (not brisk) acceleration. I had the trans fluid changed at both the 30k and 60k services. I have owned this since new. It began before the 60k service. Also, sometimes the tach will increase revs during this as well. I don't know if this next thing is related but when I once need to merge quickly into interstate traffic I gave it a good amount of throttle and the tach revs increased but the trans did not follow with an immediate down shift.
View 4 Replies
My 2010 F150 randomly feels like I'm driving over the rumble strips as well as a small jerk like there is a cylinder misfire. If keep it at constant speed it still happens, but under cruise control it stops. Even when load increases like going up a hill.
View 14 Replies
I hooked up the boat and went out for a tow. I ended up getting a pretty good vibration and thought maybe it was time for balancing the trailer tires. As it turns out I needed two new tires as they were at the wear bars (cheap crappy bias ply tires) so I ended up buying 4 trailer tire radials and had them balanced.
As it turns out I have what I guess is a shudder at slow speeds and also can feel it at other speeds as well. A way to explain it is that it sort of feels like you are driving over the rumble strips on the side of the road but really small ones.
View 14 Replies
Had the torque converter replaced twice on my 2007 Explorer Limited last December. Ford dealer did it once and then there were still issues so they had to replace it again. All seemed fishy to me.
Now a new issue that sounds like driving over rumble strips. Torque converter?
View 1 Replies
My 2005 Infiniti G35 has 144,000 miles, two new rear tires and two good front tires. Sometimes, and I cannot nail down or reproduce-on-demand this situation, my car will suddenly begin to vibrate as if I'm driving over a smaller version of those rumble strips on the side of the road. The vibration continues when I take my foot off the accelerator, and will continue at a slower rate as I decelerate until I stop. Often it seems that when I come to a dead stop and accelerate again, the vibration stops, but other times it will continue as I accelerate.
But what's really odd is other times I'll just be cruising along and the vibration will begin, keep vibrating for a few miles, then peter out and disappear. I haven't totally nailed down whether or not braking affects it, but if pressed I would say that I would use the brakes at least once before it disappears. Also, it only seems to begin once I hit 50-60 mph, but again, it doesn't happen every time I go this speed. Other times this car drives incredible and makes the road feel as smooth as glass.
I haven't taken it to the shop because I'm sure they won't be able to reproduce it.
View 11 Replies
I have a 2000 f150 lariat. Mo problem started about 2 weeks ago. Around town its fine but when I go over 50 mph it feels like I'm driving down the rumble strips on the highway and after a couple miles it just smooths out and its fine! Yesterday I went on the interstate and it did the same but this time I ran up to 85 and the vibration stopped.
I had another motor put in about 2 months ago, #4, and he changed my rear u joint as well. I replaced the rear passenger side wheel bearing a couple months ago but there seemed like a little play in the axle still but not bad. I've been to the dealer and a few other mechanics but it doesn't do it all the time and they couldn't find what is wrong.
View 6 Replies
I've looked at all the shudder issues thru the forums and mine seems a little different. Mine feels like I'm riding over tiny rumble strips or like pebbles and at all speeds. I just got new tires and a front end alignment. mine seems to do a little bit of that shudder thing but all the time. I bought it used from a honda dealer with 48k on it. I have to take it to them for the warranty they gave me. Curious how that's going to work out. 2009 5.4 3.55 rear and 157" wb. 4x4.
View 3 Replies
1992 WT pick up 263,000 miles had new head gasket installed valves lapped and tune up it was doing it before and does get better when truck warms up, but still can hesitate at times. When cold you have to feather gas pedal to truck accelerating, you can hear truck motor pop through throttle body but will continue to speed up.
View 2 Replies
Just got a 1990 k1500 with the 4.3 v6 and 5 speed and it backfires. A buddy told me it was shooting flames out of my exhaust. What does that mean?
View 7 Replies
I have a '96 Chevy Silverado that twice (in about as many months) has had some trouble starting. When I turn the key the engine starts to crank, then there is a loud pop and the engine stops. When I crank it again the engine will start, although more slowly than usual. What could be wrong?
View 19 Replies
My 1995 chevy c1500 cuts out at idle or the moment the brakes are applied to shift into drive. I replaced the passenger wheel cylinder and bled the brakes and it ran fine for a few hours, then the idle problem stated again. I have check the map senor and a few other electronic component as my mechanic said the problem " might be electrical."
View 6 Replies
1990 chevy silverado 4x4... My truck stumbles when you start it and within 5 seconds or so clears up and runs smooth.. I changed the fuel filter , still the same result.
View 1 Replies
i have a 1982 chevy 1500 4x4 with a 700R4 and it has never give me any problems at all has always shifted firm and smooth goes instantly in to drive and reverse. One day last week i got in and the truck will not shift in to second actually wont come out of first the reverse still works fine and the first is still fine it does not slip or hesitate at all. I pulled the gear cover off and can spin it!
View 8 Replies
So I used my 2000 silverado 1500 to remove a willow trunk from my yard. 4 Lo, took a bit of work but I tried not to overdo it. Now, truck sputters when accelerating. Once it gets going it's good but the startup is sputtery and bucks a little. What did I do?
View 1 Replies
My truck hasn't run for over a year and no one seems to be able to tell me why. The fuel pump supposedly has 10 lbs of pressure, it has new fuel pump relay, new throttle body, and probably more new things (can't remember exactly). It will start up normally and then it will act like it's not getting fuel and within seconds die. If I keep my foot on the gas and kind of pump it (I know it's EFI) it will try to keep running, but will die, and it really gets rough toward the end like the whole engine's going to fall out. The truck has 300K+ on it but the engine was replaced about 10,000 miles ago. It still has a lot of original equipment.
View 14 Replies
1991 chevy silverado 1500 4.3 ... Cruising at 55 down highway truck died for 2-3 seconds only to refire itself. After doing so for a few days it wouldn't start at all. Changed fuel pump,fuel filter and all spark plugs. Now runs fine until I shut it off briefly. Then it stalls on me on 3rd,4th and 5th gears. Bucks badly. Is it a fuel issue or something to do with starting it while it's warm. Also it runs good with the check light ON. Soon as it goes off it starts shutting off and refiring itself when I give it gas.
View 1 Replies
