Chevrolet - 1500 :: 1997 Chevy Truck V8 Fuel Pump Failure
Aug 15, 2016
Several years ago I had to replace the fuel pump - truck had about 100,000 miles. Within the last 4 - 5 months I have replaced the fuel pump twice and just today (about two months since the last replacement), the fuel pump has failed again. That has been the pattern now for the last several months. I have had the work done by one of the reputable car repair shops in town - they have also done work on my 2004 Impala with no issues with the repair. There must be something else going on besides just the fuel pump going bad. What would cause so many fuel pump failures.
View 16 Replies
Advertisement
I got this truck from my step father, drove it from mississippi to washington (state) with minor problems. It's been sitting in my driveway for the last 6 months and I probably drive it once a week. I loaned it to my sister-in-law and she drove it for a couple of days with no problems. She went out one morning to take it and it wouldn't start, just cranked it for a few minutes and gave up. To make a long story even longer, I though it was fuel so I checked the pump, changed the filter, drained some fuel thinking water might have gotten in, ... to no success. I then started looking at electrical. Spark was getting to at least one plug. Pulled the distributor cap and cleaned it all up, replaced all the plug wires, and then tried starting it with the same results. (Oh, by the way, no check engine light so I assume no codes).
This goes on for a couple of weeks as it's in the driveway and I only pop the hood when it's not raining (we live just outside of Seattle). The other day I have the hood open, my wife decides to check on me since she thinks I'm talking to God and is wondering why I would use that kind of language when address a diety. I ask her to jump in and crank it while I pull a plug wire to see if I'm getting spark....again. Low and behold, the truck starts right up. I jump in to see if it's throwing a code and nothing. The thing is running great. I did notice that there is a ticking coming from the engine compartment and I realize the plug wire is still disconnected so I turn it off (with much hesitation) connect the wire, go back inside to start it and the thing won't start. I'm a private pilot and they say, if you're flying along and you do something and the engine stops, undo what you just did. So, I go back out, unplug the spark plug wire, and the thing starts right up. So, I start thinking, try another plug wire. I reconnect it, try another, and it won't start. So, what I figure is that it will only run when the second to the front cylinder plug wire on the drivers side on the engine is disconnected.
View 7 Replies
My plan to clean the fuel injectors on my 2008 Silverado LS 4.8L V8 came to an abrupt halt when I was unable to disable the fuel pump relay because it is missing from the spot where it should be located according to the schematic in the owner's manual. Would removing the "fuel system control module" (fuse #21) instead of the fuel pump relay work?
View 7 Replies
My 95 chevy 1500 pickup is having fuel pump issues. Somewhere between the relay and the sending unit. Pulled the tank, and put power directly to both the pump and the sending unit. They both run. Put in new relay, still not turning on the pump. Do not know if this is related, but the switch to turn on the interior light when you open the door does not work on the drivers side door. If I pull on the switch the light will come on.
View 3 Replies
Last week my truck started to stall a little bit. As I drove it a little longer, it stalled all the way out. It started back up fine but when I gave it some gas, it cut off. This happened several times. I popped the hood and noticed the throttle body was a little loose. Thinking air may have gotten into the system,I tightened it back up. I started it up,put it in gear and it seemed to drive fine and it started stalling again.
While I was on the interstate, it would cut off, cut back on,cut off and then cut back on. Finally it completely stalled out. I had to have it towed to my house. I hooked my code scanner up to it and it through code 44 (O2 sensor) and code 54 (Fuel pump relay or something like that). What could be causing my truck to run this way.
View 14 Replies
I own a 95 chevy 1500 with a 5.7 engine. The other day I'm driving home and my truck completely stalls out and has no power what so ever. To be more specific I didn't have lights, radio, key buzz nothing. Well by the time I got the under the hood I had power again and it cranked right up. I put it in drive and 5 minutes down the road and it stalls again with no power what so ever. I've been having problems recently with it stalling at stop signs/red lights but never with a loss of electrical systems. What this could be?
View 3 Replies
I have a 1996 Chevy Cheyenne pickup with a fuel injected small block that has 50k miles. Earlier this summer the truck developed a problem where it is very hard to start when cold (after sitting overnight or after sitting for many hours on my flat driveway). When the engine is cold (say the first start of the day) I can only get it to start by giving small bursts of cranking power to the starter. That is, it won’t start if I hold the key in the cranking position but is more likely to start if I give it a short burst of cranking power (when I hold the key in “start” position) for a second or two.After the first start of the day, the engine runs fine and subsequent starts are quick and normal. The “Check Engine” light is not on and there are no trouble codes…. Other than hard starting there are no issues with engine performance.
View 2 Replies
can i adjust idle on car, seems to be running faster without using gas pedal.
View 2 Replies
I am looking for the location of the fuel pump relay on a 1997 Chevy S10. There is a bank of relays on the firewall on the passenger side, but I do not have any info on which relay is for the fuel pump.
I briefly looked at this vehicle where they had it towed to after it had stalled on the road and they couldn't get it to start.I had no tools at the time, but not hearing the hum of the pump, and no fuel at the test port on the rail, all pointed to a fuel problem. The owners boyfriend took over from there and replaced the pump this past Saturday and still no pump.
I suggested that he find the right relay and test it, but he skipped that part. Which of those realy are for the pump??????
View 2 Replies
How do you test the fuel pump regulator, the truck wont start. I tested the schrader valve and it does have pressure but didn't seem like much. (need a gauge) I replaced fuel pump a few years ago so was wondering about the regulator. Is there a test procedure?
View 7 Replies
I have installed my 6th resistor and they continue to burn up, leaving #5 only.
View 4 Replies
I have a 1998 Ford F150 with 4.2.. Started off a intermittent problem of not starting acct no fuel. Now will not start at all. Checked all fuses and relays.. Am not getting voltage at fuel pump. Changed ECM thinking that was the problem.. Have checked all multi wire connectors for corrosion and tightness. Am at a lost what to try next.
Also, not sure if its related or not. The turn signals and hazard flashers do not work. When I turn on the hazard flashers, nothing happens. If I leave the flashers switch on, the turn signal work. Checked all fuses and relays and they appear good.
View 2 Replies
When pumping fuel in 07 silverado classic 1500 4.8L the gas pump at the station continues to cut off. Took me 20 minutes to pump. I now have a check engine light on and the code says it code be the EVAP vent solenoid or the purge solenoid. Truck seems to be running fine other than stronger fuel odor at the exhaust. which solenoid need replaced....
View 6 Replies
Can't fill the tank in my 1981 Chevy 1500 Truck; pump cuts off after 7 gallons. I took the vent tube and the fill hose off and there are no blockages.
View 8 Replies
1992 WT pick up 263,000 miles had new head gasket installed valves lapped and tune up it was doing it before and does get better when truck warms up, but still can hesitate at times. When cold you have to feather gas pedal to truck accelerating, you can hear truck motor pop through throttle body but will continue to speed up.
View 2 Replies
Just got a 1990 k1500 with the 4.3 v6 and 5 speed and it backfires. A buddy told me it was shooting flames out of my exhaust. What does that mean?
View 7 Replies
Got done with replacing head gaskets and intake gaskets, Van started fine and I backed it out of the garage. Left it running and put down ramps and drove up on them so I could get under and connect the exhaust. Got that done and then got back in it and all it will do is crank and it will not start now. It also has a new cam shaft sensor( wire broke on old one). I can hear the fuel pump when I turn the key. It is like now there is no fire to start it. What could be wrong? What do I check? What causes it to fire? If something was connected wrong, would it have still started and then wont do anything but crank? Got dark on me and started raining so I say tomorrow is another day. I feel it is something simple.
View 4 Replies
I have a '96 Chevy Silverado that twice (in about as many months) has had some trouble starting. When I turn the key the engine starts to crank, then there is a loud pop and the engine stops. When I crank it again the engine will start, although more slowly than usual. What could be wrong?
View 19 Replies
My 1995 chevy c1500 cuts out at idle or the moment the brakes are applied to shift into drive. I replaced the passenger wheel cylinder and bled the brakes and it ran fine for a few hours, then the idle problem stated again. I have check the map senor and a few other electronic component as my mechanic said the problem " might be electrical."
View 6 Replies
1990 chevy silverado 4x4... My truck stumbles when you start it and within 5 seconds or so clears up and runs smooth.. I changed the fuel filter , still the same result.
View 1 Replies
i have a 1982 chevy 1500 4x4 with a 700R4 and it has never give me any problems at all has always shifted firm and smooth goes instantly in to drive and reverse. One day last week i got in and the truck will not shift in to second actually wont come out of first the reverse still works fine and the first is still fine it does not slip or hesitate at all. I pulled the gear cover off and can spin it!
View 8 Replies
