Chevrolet - 1500 :: 1990 - Running Rough / Hesitating / Lurching And Not Accelerating Smoothly
Oct 8, 2012
My 1990 Chevy Silverado with 5.0 liter, 45k miles has started a problem that the guys in my diesel repair shop don't know what to do. Last week it started to run rough, hesitating and lurching and not accelerating smoothly. It idles fine, or pretty well, but just doesn't run smoothly with any kind of acceleration. I drive it back and forth to work just 1.5 miles during the week. I took it on vacation a week before, so it's not from lack of long trips, it ran fine.
A guy at my diesel repair shop put it on his Genesis scope and all it would code is the O2 sensor showed lean, but we could see it switching from rich to lean and so on. I thought vacuum leak, but couldn't find one. PCV valve is good. EGR valve is ok. I changed the fuel filter yesterday and thought it ran a little better, but now has gone back to the rough running. What I can do myself to diagnose this? I do have all the tools and shop.
View 2 Replies
Advertisement
My 2000 Chevy Astro van started having problems whenever I accelerate, hesitating losing speed, and all I can possible tie it to is a new gas station where I filled up which said "May contain ethanol". I think the "service engine light" flashed on for a second but does not stay on.
Could bad gas or the ethanol be the problem? Would getting the problem codes read at a parts place work?
View 10 Replies
I have a 1998 Chevy K1500 4x4 which is experiencing issues on two fronts: brakes and general operation.
For the brakes, over the last couple years, we have replaced just about every part of the system, including - master cylinder - calipers - brake lines. In addition, in the last week, I worked with a local mechanic to bleed the lines and he turned the rotors as well. The result is that while the truck does stop, the pedal height is still really high and feels like there's no pressure until the pedal's nearly to the floor. I get the feeling that if I needed to stop abruptly or at a higher speed than 35mph, I wouldn't be able to. I'm not sure what needs to happen next.
As to the general operation: the first time I start the truck on any given day, it fires up and runs smoothly. If I take it across town, however, and put it in the park, it gasps, sputters, and dies. It is then very difficult to get the vehicle to start again--usually, I have to push the gas pedal all the way to the floor and grind the starter until the engine turns over. After that, I have to keep my foot on the accelerator for 15-30 seconds at around 3000 RPM as the truck shudders and lurches, until it smooths out. Once I put it into drive or reverse, however, it dies, unless I am quick to push the accelerator again. Until recently, the truck had only been driven four times in the last two years or so. So far, I have: - replaced the air filter - added fresh gas (to the old) - added an engine treatment (Sea-Foam) Everything I have done is stuff that needs to be taken care of anyway, and I want to take care of all the little things before I take it to a dealership to have a full diagnostic run on it. I also plan to have an oil change done on it this week.
View 5 Replies
Just got a 1990 k1500 with the 4.3 v6 and 5 speed and it backfires. A buddy told me it was shooting flames out of my exhaust. What does that mean?
View 7 Replies
1990 chevy silverado 4x4... My truck stumbles when you start it and within 5 seconds or so clears up and runs smooth.. I changed the fuel filter , still the same result.
View 1 Replies
Does a 1990 chevy truck have a fuel regulator, 5.7 efi? if so where is it located?
View 1 Replies
1992 WT pick up 263,000 miles had new head gasket installed valves lapped and tune up it was doing it before and does get better when truck warms up, but still can hesitate at times. When cold you have to feather gas pedal to truck accelerating, you can hear truck motor pop through throttle body but will continue to speed up.
View 2 Replies
My 02 silverado has started making a bubbling sound when I accelerate. The sound is coming from under the passenger side dash.
View 2 Replies
So I used my 2000 silverado 1500 to remove a willow trunk from my yard. 4 Lo, took a bit of work but I tried not to overdo it. Now, truck sputters when accelerating. Once it gets going it's good but the startup is sputtery and bucks a little. What did I do?
View 1 Replies
2001 F150 4.6. Just replaced all 4 oxygen sensors and spark plugs. Replaced rubber grommet on brake booster as it was leaking vacuum.
Truck is still running rough hesitating.
Pulled codes came up as PO141 oxygen sensor heater circuit. PO171 passenger side cylinders running lean. Fuel trim outside limits.
View 9 Replies
Since our weather has returned to the cold side......my truck has started bucking and hesitating at 45 mph with EOT @ 130 and ECT @ 140. I can gas on it and it will clear up/let off and it would start up again once it gets below 50 mph. Once the deltas reach 150+ it clears up completely. Its never done this until this week. FICM volts are steady @ 48V. What is causing this or what to look for?
View 2 Replies
1990 Mazda Protege with a 1.8L DOHC, manual 5-spd transmission, ~173K miles on it. On my way home the other day, the car ABRUPTLY started to run very rough - with what I would call repetitive and incessant stuttering when accelerating (though I am by no means technical with respect to cars). I shut the car down, hoped the problem would go away, but when I started it up later that day, the problem was still there - the car BOTH idles rough and doesn't accelerate very smoothy. When I come to a stop, the car feels as if it's going to stall but stays running. This afternoon, I took it out on the road for ~3 mile drive (up to ~ 50 mph) and the problem is the same - but I did also notice, when driving, that the car gave off a smell reminiscent of firecrackers - perhaps a sulfur-ish smell. I googled the issues I was having and I got a whole array of problems - ranging from simply bad spark plug wires (which have been replaced in the past 1.5 years) to a stuck EGR valve .
Here's some additional info on my car: -Was just in the shop 2wks ago for overheating - found the thermostat to be bad - they replaced it and I no longer have the overheating issue. While there, they also replaced the belts for the alternator and water pump (Which had been squealing for quite some time) -Spark plug wires and distributor cap were both replaced in the last 1.5 years -Last oil change was > 6 months (but less than 3000 miles) ago - all the fluid levels seem to be fine -Though I think it is unrelated, the car is also making a high pitched squeaking noise emanating from the R front of the car while driving - I suspect this is the suspension-related as the shop informed me that I have one front stablizer link broken while the other is loose (and when I push down on the R-front side of car while it is not running it yields a similar squeaking noise.
View 1 Replies
I just installed a new Sachs flywheel and clutch on my 1995 Chevy 1500 4x4. Got everything back together, filled up tranny fluid and gear oil, bled the clutch till no air came out and it still won't shift while the engine is running. I can get it into reverse with a little grinding when in 4H, but that's it. The stick moves freely when the engine is not running. Checked the master cylinder and it is moving just fine. I have checked and did not install the clutch plate facing the wrong way. Any other guesses on what I can do before I have to drop the transmission again and redo the whole install?
View 19 Replies
Six months ago we purchased a '91 Chevy Pickup and 3 months ago the truck started to "sneeze". Sometimes while accelerating the truck makes a "toot" noise from in front of the driver under the hood, and with the noise I have a momentary loss of RPMs. This can happen a number of times in a row, making pulling out on to busy streets difficult and dangerous. Most of the time, I take my foot completely off the gas and then re-apply it, and the issue goes away. It happens both with a cold engine and a warm/hot engine. This problem started when it was cold out (around 10 degrees Fahrenheit) and the mechanic I talked to about it thought it was the E10 87 gas I was putting in.
I switched to a 97 octane/no-ethenol fuel and the problem went away, until about a week ago when our temperatures finally broke 50 consistently. The problem is back and with it is a minor fluctuation of RPM when idling in neutral. The truck also created a new symptom, I was driving at about 50mph and the truck acted like it slipped on ice... I had evened out my speed and the truck seemed to start coasting then got back to driving at speed, it jerked the whole truck, like driving over a patch of ice. I don't know if it has anything to do with the original problem but all symptoms may be the same thing....
The truck is a 91 Chevy 1500K, 5.7L V8 and has 74,000 miles (mostly highway towing). It had been sitting 2 years, not really being used, before we bought it. We had the fuel injection system cleaned when they did the oil change, right after we purchased the vehicle.
View 4 Replies
I have a 97 Chevy K1500 truck that i have been having problem with starting. Sometimes it will start. When it does the idle is rough. When i put in in gear it almost acts like it will shut off. Then it comes back and it drives fine. If it shut it off it may or may not start. I had the distributor cap a rotor replaced. Then I replaced the spark plugs and wires. Still does not start. It seems like it is getting too much fuel. I pulled the fuel pump relay and the truck would start then die out. When i put the relay back in truck does not start. I am not sure what might be the next piece to look at. I was thinking the MAP sensor or the throttle position sensor. So far i have not had any codes come up.
View 4 Replies
I have a 1990 3.1L, multiport fuel injection (NOT sequential FI), which runs very well most of the time. However, when I cold start it runs rough (misfire) for about 1 minute (no throttle) or until acclerated. The is no misfire when running normal, but it might be running a little rough when stopped at a traffic light (in Drive, foot on brake).
I put new plugs and wires on, but it did not affect this problem.
I am not using coolant, or oil, the plugs that were removed were somewhat worn, enough that I expected to notice a difference after they were changed.
I have not yet (1) cleaned the MAF, (2) checked carefully for vacuum leaks, (3) checked for leaking injectors.
Since this is a 1990, OBDI, I can't say which cylinder is misfiring or how the fuel trims look etc.
View 10 Replies
I have a 1992 Chevy 1500 5.7L V8 with 167,000 miles that is running hot. When I drive the vehicle the temperature quickly rises to just about 250 degrees and hovers just under the "red" zone. It never fully overheats, even on longer drives (50+ miles). It seem to run just fine otherwise. It is not leaking coolant and I have not had to fill the radiator. My first thought was that the thermostat was bad, but wouldn't that be an "all or nothing" issue? Where should I start looking for the problem? It has been going on for about 3 weeks, and I want to get it resolved quickly.
View 10 Replies
My fathers 1990 GMC Sierra 1500 Pickup Truck 4.3L runs fine when it is cold but as soon as it warms up it starts running rough then stalls and won't start. There is no spark when it dies. As soon as it cools off it starts back up and runs fine till it warms back up.
View 2 Replies
]I recently bought a 1990 ford ranger with a 2.9 @187,000 miles. That being said I went through and changed a few vacuum lines, the oil, air filter, pcv/grommet, and fuel filter.
The problem is it hates to start. I could crank on it for 10 seconds and not a single thing. Sometimes if i turn the key to the off position, wait a second, and try again, Ill get the truck to fire. When it does fire up it just reeks of the lean exhaust. It also gives me some hesitation when I rev it. I did a fuel pressure test (KOEO) last night and it gave me 32 psi and within a minute the needle fell to about 25 psi. I hear the fuel pump run for only 2-3 seconds too.
I've already pulled the MAF off and cleaned it, replaced the TPS, and did a fuel pressure test. The fuel filter is brand new
View 14 Replies
I have a 2001 Chevy Silverado with the 4.8L V-8 engine. It acts like it is running out of gas ( the gas tank is over half full). The truck has sat for about 6 months in this condition without being started here in Sacramento, CA. I then replaced the fuel filter and for a few minutes it started and the engine ran fine (without actually driving it). A few days later I started it again and it now again acts like it has fuel starvation, it will rev up briefly then act like it is running out of fuel. I know the fuel pumps are the Achilles Heel of these trucks, but before I try changing it I was wondering if there might perhaps be another problem such as the new fuel filter plugging up quickly or possibly an electrical problem. I've always heard these fuel pumps either work or they don't work, nothing in between. This problem is intermittent but big enough the truck is not driveable. Is there any way to get a good take on the problem before diving into the fuel pump replacement and hoping that solves the problem ?
View 5 Replies
1990 Ford Aerostar. When I start runs really rough and has excessive fuel consumption and the exhaust smells like gas and has a misfire my friend says its the coil pack going bad im not sure. I love my ford aerostar dont wanna get rid of it.
View 5 Replies
