Buick - Skylark :: When Slow Down The Engine Idle Seems To Start Looping And Almost Stall
Apr 13, 2011
I have a 96 buick skylark. I just recently had the parking pawl fixed because it was broken. Now when I slow down the engine idle seems to start looping and almost stall, it in fact has once. As I slow down, and I can feel the car somewhat trying to pull forward as if its not down shifting correctly. when I finally get stopped the idle will come back up and idle normally. the car upshifts great. I know that one of my rear wheel speed sensors has a broken wire.
View 3 Replies
Advertisement
'91 buick, 3 spd. 0 acceleration in 3rd, trouble code says TCC curcuit. Lopes @ idle when warm, runs rough @ times. many new sensors, timing chain & sprockets, still, the loping.
View 1 Replies
I just had my 72 Skylark tuned up, when I start it and put it in gear it makes popping noise and stalls, I restart and let it run a for a few minutes and it will finally go. Once it is warmed up in runs great. What causes this stalling problem,? I guess I'm too old to remember.
View 4 Replies
This 97 Buick will turn over and the engine will catch but then dies. It doesn't do this all the time. Also, the anti theft light comes on during this starting problem.
View 3 Replies
I've had a 1991 buick skylark for 3 years, just hit 100,000 miles, and for the past few months i've been having problems with it stalling out/misfiring when I press the gas, almost like a lawnmower running out of gas, and then catch and go fine. it was only happening at the 3rd gear change,(randomly but only at that change), and then it started happening only at the 2nd gear change. it first happened at the end of a long road trip, and the speedometer and odometer stopped working at the same as well, but have since returned. but now it's been happening on cross town trips.
Every time it has happened has been random, and it always corrected itself and was fine. but this last time, it was doing it consistently, at random gear changes and from idle. it finally gave out at a stop sign and it barely stuttered across the intersection, but with the check engine light on and never "catching on" or actually dying/cutting off. I took it to my local shop, and they ran all the computer test and road tested it and told me they couldn't find anything wrong. they tested the fuel pump, which had good pressure. They mentioned it might be the module, but were honest and didn't want to charge me for something they couldn't tell was actually wrong. any clue?
View 2 Replies
I have a 95 skylark 4 cylinder, i have what appears to be a coolant leak from the thermostat housing and i also have coolant mixing with my oil. Can the leak from the housing cause the coolant to mix with the oil? If not what else could be the issue?
View 3 Replies
I have a 1991 Buick LeSabre, sometime last year the check engine light came on, and I took it into a mechanic who told me that a magnetic sensor on the timing gear broke off and that it is the problem with the car, but it would cost me 500 dollars to replace the part, because it is located in the engine. I noticed that the engine felt like it lost power, and the car started vibrating when I was idle. The beginning this year, I replaced the spark plug wires, and replaced the spark plugs, when I replaced the spark plug wires, I realized that two of the wires were broken, as soon as I was done.
I tested the car, and the power is back, but I still have the stalling problem. I will try to describe how the car stalls, I come to a stop, and when I push on the gas to accelerate, the car just conks out, so I have to restart the car, and rev it a little to keep it from conking out again, and it starts running normally. I have been told by another mechanic that I need to replace a Electronic Ignition Control module, which I can not find, and that it is possible the fuel is not getting into the chambers. I just want some answers to my problem, so the car will last me till I can get a new vehicle or something better.
View 1 Replies
We just replaced instrument cluster and turned the key to on position for 10 minutes. We waited for the anti-theft light to quit flashing and the car runs great but the anti-theft light will not go off. How can I fix this problem?
View 4 Replies
1991 Buick Regal, 3800 V6
As the title says, when I start the engine cold I get a slight puttering and drop in RPMs followed by the engine revving itself to about 1100 for a few seconds and then normalizing at 600. It has only actually stalled out a few times. This does not happen once the engine is near operating temperature.
Now, I did not notice this issue prior to doing some maintenance on the vehicle (radiator replacement and transmission service) and I've read that this can be caused by a faulty coolant sensor. Possible?
Battery is new.
Also, when I say cold start I mean summer temps here in Michigan. So it's happening anywhere from 50 to 90 degrees F.
View 5 Replies
My Mazda MPV will stall at slow speeds, such as if I am turning a corner or slowing down at a stoplight. Sometimes it starts back up once I put it into park, but other times it takes a few minutes of trying/resting before it will start up. One day, I am afraid it won't start up at all again. I just got new spark plugs and recently got a new mass airflow thingy put in. Check engine light does not come on for this.
View 2 Replies
I bought a well-used 1991 Buick Century for my son in December '12. At that point I put in a battery that was bought brand new just the month before. The car ran fine until a couple weeks ago. He tried to start it but only got a slow crank, like a low battery. I tried to jump start it, with no difference. Since the car was at his school, I asked his auto shop teacher to take a look at it. The teacher tested the battery on two different machines and determined the battery was bad. I returned it to the store I bought it at, where it was tested as working fine. I then swapped the battery from my car for his, and his battery (the one that was tested bad) started my car with no problems while my battery would not start his car. It produced the same slow crank. I talked to the shop teacher again, who pulled the starter and took both the starter and the battery to various auto parts stores. The starter tested good, but the battery was tested bad at 3 shops, and weak at a fourth. So the car is still sitting at the school, and we're at a loss. What might be causing this problem and how can we get his car running again, short of just buying another car?
View 6 Replies
1981 Datsun 280ZX 5spd manual L28 IL6 SOC. maintenance history unknown. Today after a short drive and a bath the engine started looping after 2000 rpm. The car idles fine while sitting but as soon as you push the gas the engine revs to 2k and then decelerates then back up to 2k then back down.The car does this with no hesitation until you take you foot off the gas then idles normal again. Could this be a sensor issue? If so which one? The car didn't start the problem until i bathed the engine area.
View 1 Replies
When I start my S60, it runs extremely rough and will eventually stall. I do this over and over . . try and put it in gear and it will go a bit, run very rough, and will stall out. After a few minutes, something kicks in and it runs perfectly. If I don't try to drive, and sit with it idling, it runs very rough and I have a difficult time getting the rpms up. Then, the engine will suddenly race for a bit and everything is fine. It is very periodic in nature, doesn't matter if the engine is cold or not. It can sit over night and be fine, or do it, I can run around all day without problems and then suddenly it decides not to start up and run. The temperature outside doesn't seem to be a factor.
View 2 Replies
I have an 87 ranger, 2.3 4cyl. 2wd 5 speed. When I start up the truck after it sits for a few hours it will idle fine but then it starts to bog down and wants to stall but after about 5 mins its fine and runs like a champ. I don't know if its a sensor or what.
View 2 Replies
I have a 2003 silverado with a 4.8 engine. i bought the truck in the summer of 2010. no problems in the winter of 2010. ran great all year in 2011, then my block heater shorted out in the winter of 2011, so i wasn't able to plug the truck in.
We get some cold nights up her in alberta, but anything below -10c the truck would idle surge and stall, would do this about 4 times in a row then it would just surge a few times but stay running.
I had a buddy that's a gm drive ability tech take the truck and do a tone of updates for the throttle body and to correct idle surge and some other drive ability related stuff. i cleaned the maf, map and tps as well as the throttle plates. replaced plugs, wires, air filter and fuel filter. all this and it was still doing it, but it had to be really cold to stall.
wasn't able to replace the block heater till this summer. but now that its getting colder and dropping below -10c at night the truck is starting to idle surge when i start it up in the morning.
View 3 Replies
I have a '95 Ford F150 with a manual transmission and when I come to a stop light, the engine will either idle down more then it should then go back to normal or it will idle down and then stall out. And when I accelerate, I have to gun the engine for it to go forward or it will stall out again. I replaced the fuel filter and cleaned the air intake area and it still happens.
View 2 Replies
I have a 2001 Ford F150 Lariat. It has the 5.4L Triton motor. I was having starting problems as such the truck would crank and not start or crank, start and barely idle and stall within 5 seconds. It was NOT tripping any lights. I was told it was a possible fuel issue. I have since changed the fuel pump, fuel filter, as well as the hoses in the rear connected to the tank. Truck started, ran great, even seemed to have more power. Ran great for about a week. I was on my way out yesterday about 2 miles from home when the truck just stalled out on me. It is now having the same issues it was having before I changed the pump, filter, etc. What the issue may be? Clogged line? Fuel injector? If it is an injector how can I tell which one?
View 8 Replies
I have a 1990 Alfa spider. It has a blip at idle. Originally it was much worse. Idle would drop to 500 then pop up to 1200 the back down, back up etc. Engine would sometimes stall while driving. This happened as I would take my foot off the gas coming to a stop. I replaced the first large air duct between the mass air flow gauge and the air intake chamber(cracked on underside). Worked but still had blip which was then unpredictable. I cleaned the air flow gauge and the constant idle actuator with air flow cleaner. This worked more but I still have the blip during engine warmup. Idles fine at start up, blips for a while, then stops bliping as engine nears running temperature. What should I do next?
View 1 Replies
This morning when I started my car the RPMs were all over the place. The engine would rev to just below 2k and then drop, as it it were gonna die and right before it did, it would rev back up. Then, when I tried to move it, it would not accelerate and would hardly move and while coasting it dies if the clutch is depressed. The car does not die when idling (albeit a very rough idle) but it does when it is moving.
It flashed a check engine for a few seconds at one point but went away and has not come back on. I am running APR Stg 1 and a Carbonio intake. I switched from 93 octane mode to stock and nothing changed.
View 3 Replies
I have a 2001 santafe with a 4 cyl The code 102 was up so I replaced the mass air flow censer . I go on a test drive and the light stays off , but when I go to re start it again the light come on and stays on, with the same code. The only strange thing is the idle will raise for a min then drop down to almost a stall.
View 2 Replies
I have a 2013 Golf TDI with 2070 miles on it. For around 2-3 weeks, I've noticed that it intermittently will idle rough, shakes, etc, as if it is about to stall out, but stays running and drives normal. I figured it was a typical Diesel thing and wasn't too worried about it. However, today, this happened, and I got an engine light. Yikes! I made an appointment for it but need to wait till after the 4th for it to be looked at. What's up here? Is it a regen cycle? Timing issues? Am I doomed with my Golf TDI?
View 8 Replies
