Buick - Parkavenue :: 1997 - Cruise Control Not Working
Jun 30, 2013
I recently bought a 1997 Park Avenue and have a couple of repair questions.1) The car is in need of struts/shocks. The rear has air shocks. Before I purchase new air shocks, how do I test the compressor to make sure there is no problem? If the compressor is bad, is it possible to install conversion shocks and do away with the compressor/ air shocks?2) The previous owner says the cruise control does not work. On rare occasions it will work for a brief time during the winter. What things can I check out? Someone suggested checking the brake light switch.
View 5 Replies
Advertisement
The cruise control stopped working. The "Cruise" light comes on, but the speed does not hold.Where should I start looking? Where is the control module?
View 4 Replies
So my brake lights aren't working on my 1997 Buick Park Avenue, not even my middle one. All my bulbs, fuses, relays are good. My tail lights and hazards work fine. The circuit has continuity when the pedal is pressed and power going into the brake switch when the pedal is not pressed, but when pressed it has no power going in or out it just cuts off. I figured it was probably a ground then but I checked and all of the grounds are good.
View 5 Replies
When I turn on the car the internal temp number flashes for about a minute. The AC blows cold and I haven't noticed any issues with the HVAC system. Why is it flashing?
View 9 Replies
Car drives excellent in dry weather, smooth, no hesitation. or misses. While driving in the rain, the car will start running "REAL" ruff and then will stall. I try to start it and the motor just turns over, sounds like no gas or not firing. I will keep trying and after about 6 times it will fire, start and quits, if lucky with a few more tries I can get it started and needs to rev up to 4,000, sometimes it will stay there with a miss or RPM works down and quits. When lucky I can nurse it home and then won't start for 3 days.
I have replaced Crankcase position sensor, (made shield for side at wheel well and shield on bottom), camshaft sensor, spark plugs and wires, had coil packs checked, checked plate that coil packs set on, cleaned battery posts, checked and pulled on wires to coil pack plate, none lose and had continuity, put silicone sealant at end of wires to protect from moisture and hold them in replace. Sprayed top of engine with silicone spray and flex seal. Even had intake manifold gasket replaced in case it was sucking in water. Replacing crankshaft position sensor did some good, it makes for faster starts.
View 10 Replies
I have a 1997 Buick Park Avenue with a 3800 series II motor that runs perfectly in dry weather. However, in wet conditions, rain melting snow, etc. it will begin to miss and throw out a P0300 OBDII engine code. This is the code for multiple random misfire. If I leave it to idle on its own it will get worse and die out right. Sometimes restarting it is an option though it still runs rough, but I can limp it to somewhere I can work on it. I think its electrical, since it doesn't seem to get the spark it should though fuel doesn't seem to be a problem as you can smell it after a bit of cranking.
I've been battling with this thing for over a year so far and have replaced the following, ECU, all 3 coil packs, spark plugs/wires(newest parts), mass airflow sensor, cam position sensor, ERG?(emissions deal I believe, mechanic friend put it on) valve. I had the battery trickle charged and tested at an Autozone, I haven't had the alternator tested yet.
Its a very frustrating problem, as far as I can tell I've replaced everything on the ignition system with the hopes that it did the job only to get stranded during the next long rain. It does take quite a while in wet weather for it to start acting up, but once it starts missing a little bit, it doesn't stop until the entire engine compartment has had a few days to dry. Engine temp doesn't seem tosolve the problem dry out. I'd also like to note that I've noticed on this latest trouble that the interior lights have been flickering and headlights too. It may have been doing this earlier, but I hadn't noticed if it was. I'm going to check what kind of voltages the alternator is throwing out next time I have it running.
View 6 Replies
The power steering is not working in our 2001 Buick Park Avenue. It worked yesterday but today, nothing, at all. We did not hear any noises. The fluid level is good and I don't believe that there is a fuse, as this runs off of the drive belt. The fluid did smell a bit "burnt".
View 8 Replies
My 1997 Aerostar's cruise control is not working. Horn is functional however. I've checked fuses and they seem to be ok. What could my problem be?
View 10 Replies
About 2 weeks ago my 1997 Buick Park Ave (115,000 miles) began running bad during a heavy rain storm. It was running fine. Then all of a sudden at a stop light the motor hesitated and wanted to stall. I nursed the gas peddle and limped home and turned the car off. The car hesitated and sputtered all the way home as if I was running out of gas.The next day the car would not start. It turned over but would not start. I tried starting the car for three days. My mechanic friend later diagnosed the car and stated the computer was not functioning correctly. He replaced the computer. The new computer seemed to correct the problem.
The car ran great for the next 2 weeks. Yesterday, it was raining hard while I drove the car about 150 miles without any problem. Then suddenly again the motor started running badly. Again, the motor wanted to stall and hesitate as if I was running out of gas. I limped home again. This morning I tried to start the car without any luck. In addition to installing a new computer, In the last 2 months I have changed all the fuel injectors and installed new spark plugs.I have also changed the fuel pump and repaired the fuel tank. My mechanic say the cam sensor and crank sensor are operating correctly. There is spark coming from the coil packs and to the spark plugs. I do not want to randomly change parts.
View 3 Replies
A few years ago I had the clutch changed on my 1997 F150. Afterwards the cruise control wasn't working. When I brought the truck back to the repair shop I heard the manager tell the mechanic to "attach the clip by the pedal" and that fixed it.
I just had some work done, had to replace the oil pan, and the mechanic had to remove the transmission. Now the cruise control doesn't work. I changed the Pressure switch but it didn't fix the cruise control. What that clip might be that fixed the cruise control last time?
View 3 Replies
I have an '02 F150 Lariat CC 5.4L. The truck is new to me and neither the cruise control nor the horn works. i have checked all (known) fuses and relays. I have tried the cc diagnostic, and the dash light DOES NOT illuminate. Should I assume that the dash light is not burned out? Is there a way to test the clock spring connections for continuity? and how do I access the connection
i checked the cc brake pressure switch and have continuity there.
View 2 Replies
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
View 8 Replies
While driving on the highway, the cruise control shuts off and the speedometer stops working. Check engine light comes on. Car continues to run fine.
Five days later, I start the car and the following do not work: clock, intermittent wipers, neutral safety switch, tachometer, temperature gauge, gear indicator lights, rear defrost, windows, and I believe that is all. Car runs and drives fine. Other electrical items working. I check all fuses and only find one burned out - (#1, inside, labeled 'back up lights' meter lights) I replace the fuse and it blows when I start the car again. Take the car to AutoZone and they put it on their computer and it shows one code - P0501 - CVT speed sensor.
Two days later, the car will not start. Turns over strong, but will not start. I have checked the grounds on the transmission and body and they appear to be fine. Battery cables, also.
View 4 Replies
I am having trouble with all sorts of functions on my 2002 F150 4x4, 4wd not working, cluster module illumination not working, horn not working, reving up and down at idle and sometimes dyin, cruise control quit working. I have been reading it is the GEM module that causes these issues. My question is I ordered a new one from Ford, when it arrives I was told I can just install it and It should be pre programmed. but one ford house tells me that they have to install it and program it. Which it right? I have seen several sites on u tube where people replace the module and then start their truck right up without any issue.
View 2 Replies
Added the cruise control brain, the actuator, and the column switch, all parts from the salvage yard, but I haven't been able to get it to work, so far.
Cruise indicator light does not illuminate on the dash when following the GM shop manual "Additional System Check" on page 8A-34-3. Everything meters out, following the troubleshooting guide, so it seems to be hooked up OK. Had a local shop check it - they said the voltage is present at the cruise control module, but they couldn't go any further.
Am I missing a part? A fuse? Do I need to somehow tell the PCM there is now cruise on this vehicle?
View 8 Replies
My college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 Replies
I have an 02 f150 5.4 and since I got it it hasn't had cruse control. I went to a local ford dealership and they ran the vin and didn't find any recall on it. Under the hood on the master cylinder there is brake fluid coming out of the brake control switch. Would I have to do something with the harness too?
View 9 Replies
I have recently been having some movement in the rear of my car...I can mainly feel it when I am going under 20 mph. I have had replaced the two rear tires with other used tires cuz my original tires were going bald. Can this be the problem? Can Broken belts on the tires or "BAD TIRES" can cause this or is it another problem I should be worried about i.e sway bar links/ sway bar, etc.? 2000 buick PA 3.8
View 5 Replies
My Buick Park Ave 2000 is having an acceleration problem. It seems to be skipping at different times. It happens more often at lower speeds than higher speeds. It still happens at higher speeds though. I was on a long trip of about 180 miles and on the highway it seemed fine. What do you think is causing this? I did take it to a garage and they couldn't find anything wrong with it and of course true to form nothing happened when they took it for a spin. They did computer checks and everything was fine.
View 2 Replies
I own a 1999 Buick Park Avenue - that stalls. There is no pattern to the stalling.It stalls when I start driving, after I have been driving for a long period or when I just begin driving. It stalls when I turn a corner or on the highway, when I am at a stop sign or a red light. It is baffling. My mechanic has tried a number of solutions, including replacing the crankshaft sensor, however, it still stalls.
View 2 Replies
Get in my car, try to start it and BAM it hits me. As I turn the key, the engine cranks up quick, kinda too quick, if you ask me. As I go to adjust my radio, I feel my car start to jump around and shake pretty rough. As I look at my gauges, I see my check engine light start to flash. So instead of trying to drive away, I turn it off and try to start it again. Same thing happens!! So I try it again and finally a normal start. Whew, I thought that was close. But oddly enough my check engine light comes on and stays on this time, no more flashing and the engine feels fine. What the problem could be? Is it safe to drive my car?
2000 Buick Park Avenue 3.8 auto....
View 13 Replies
