I bought a one-owner, 50,000 mile Buick Lucerne in February. Yesterday I heard a squeaking noise from the steering wheel/column and it is there today. Does this mean I need to lubricate or replace the lower seal on the steering shaft?
View 2 RepliesI've seen posts about this problem online, but no one has listed a good fix. There seem to be LOTS of '06 Lucernes with back doors that won't open. It is not a child door lock issue as the customer has no kids needing such protection, and the door should open from the outside anyway.
I need to remove the inner door panel, but can't figure out how to do that with the door closed. Once the door panel is off, I can probably see what's going on inside, and maybe fix it.
I have a 2006 Buick Lucerne. The wheels were losing chrome and were oxidizing. I just bought some new "Koenig Unknown" wheels for it. I took it to the local shop to have the new wheels put on And one of the tires had some bad scuffing on the sidewall. The mechanic said it was too much damage on the tire and that he could not mount it on the new rim. So, I took it home and did it myself.
The duct tape that I used under on the flat bar was not sufficient and I ended up putting some rather deep nicks on the edge of the new rim. Though you cannot see it them unless you look very close, I know that these digs can be sources of corrosion. The lip of the rims are a polished mirror-like aluminum finish. I am sure they have some clearcoat on them and that is what I have damaged. How I can fix them to prevent any corrosion from happening.
2006 Buick Lucerne... I have been experiencing this for about 12 months… But now I have new tires that have been balanced twice by two separate shops. I'm still getting a wobble from the right front at about 65 miles an hour. The original tire on the right front has outside wear about half way around the tire. It seems very strange… Half of the outside of the tire is down to the cord the other half has some tread remaining… It's like something is shaking it up and down…
View 11 RepliesI have a 2007 Lexus ES 350 ultra that I quite enjoy, it has 182,000 miles on it and as time has gone on it has developed this noise in the steering wheel and steering column that I cannot diagnose, it's a noise that I have posted in a video : [URL] .....
I'm fairly mechanically adept and inclined but I truly don't know what this noise is caused by, it sounds like it is in the steering column itself. Normally I would say it has something to do with suspension but since this happens whether I'm moving or stopped, I think it is just a worn or loose piece but I don't know where or what.
1992 buick riviera 3.8L
So working on the steering column I had to remove the lock plate. Everything went well with my repair, I have the turn signal switch installed but I can not for the life of me get the lock plate spring pushed down far enough to slip in that little ring. I believe the part I am having trouble with is the top bearing inner race. Here is a link to how this looks exactly on my car.
[URL] ......
AS soon as i took off the spring that pushes the lock plate I noticed this race was just loosely sitting and the steering column just wobbles around. What am I doing wrong?
I did this in this order. I just moved the top bearing inner race as far back as it will go (it still just wobbles around with the steering column). then I put the spring in so that it touches the race. finally I place in the lock plate and compress it with the lock plate tool. However it simply will not compress enough for me to slip in the ring and lock it in place. Am i doing something wrong ? Is there some part of the bearing that should go in before this race?
The picture with the red background is how I am inserting these parts. The spring sits on this race but I cant compress it enough. Like i cant get it aligned properly or something.
I ask this because when on the hwy (60-70mph) you can feel some vibration in your hands. I can let the steering wheel go and it won't move a bit but when hands placed on it you can definitely feel the road, including bumps, and regardless of road conditions. Tires where balanced at 7500mi but it still happens. Regardless of temperature or PSI in the tire.
I thought we had electric/electronic steering and no hydraulics? Maybe unrelated but, when turning in my driveway, very slow, I can hear a slight clicking (maybe rubbing) noise coming from the steering wheel column. Everything else has to be silent to be able to hear it.
I just got a 2013 Corolla Saturday (manual transmission). So far, I love the car, but I think I'm having a problem with the steering column. When I turn the steering wheel in a parked position, I can hear an audible "rubbing" noise coming from the column. I called the dealership, and spoke not only to the service department, but also to my salesman, who has one too. He says he's never heard that, and the service department assures me it's normal and is because it's an electric motor now instead of a fluid power steering system.
So, do I have reason to be concerned? Experienced this after only 300 or so miles on a new car? We traded a Scion IQ for this Corolla (didn't like the CVT whine in the IQ), and never heard anything like this.
My steering column is squeaking when it extends at start up. This seems to worsen in warm weather. Looking at lubing the telescopic mechanism?
View 12 RepliesI have a 2006 RAV4 with a clicking noise in the steering column. The dealership says the intermediate steering shaft, which will cost over $500, but that it can wait - I can drive it safely for awhile. First, what the heck is "awhile"? And is he correct - can it be driven safely? How will I know when it is no longer safe?
View 2 RepliesI own a 2009 Scion tC, has about 70k miles on the car. I am experiencing a squeaky noise when turning the steering wheel left or right, as well as accelerate and braking. A friend and I jacked up the car, listen to the noise while the engine was running. We were able to duplicate the noise and it seems like its coming from the tie rod area, inner tie rod that is connected to the rack and pinion. Do it needs to be greased? keep in mind that for my car, i will have to replace the whole tie rod, can't grease it because it doesn't have a Zerk fitting. Also, when i push down on the passenger side fender, the squeaky noise reappear. noise is coming from passenger side. This has been going on for about 2 months now.
View 2 RepliesTurning my steering wheel left or right, especially when parked, there's a very noticeable creaking. This happens as well when I am going over bumps in a parking lot or somewhere at a low speed. The car itself turns fine, not sticking or power steering loss. So I am not quite sure whats going on here.. At 71k miles 2010.
View 3 RepliesI did a search on all three of these and did not find anything.
1) Odd noise coming from steering column while turning.
2) Vanity mirror on driver's side, the lid/flap thingy does not stay open.
3) Trunk only opens when using key. Using FOB of door button does not work. You can hear movement but it does not open.
I recently bought a 2014 Santa Fe Sport 2.0T about a 3 months ago, and have since noticed a couple issues that have come up with it. First was with a squeaking front suspension, but that was fixed by simply lubricating the sway bar bushings.
The second is that the steering wheel seems louder than normal when turning left/right at low speeds, mainly when parking, it sounds like two pieces of paper rubbing against each other right behind the steering wheel like a dry noise.
I test drove another Santa Fe before getting mine for about a week and didn't notice this issue. Is this a normal sound that eventually develops after having the Santa Fe for a while? I'm like at 3,600 miles.
We have a 2008 Buick Lucerne. Now that the weather has become humid, we have been using the air conditioner more. We noticed that the carpet was wet on the rear passenger floor. Shortly after that, we noticed it on the driver rear floor. The dealer repair guys are puzzled and say it can't be the air conditioner as it would get the front passenger floor wet and not the back. They blamed on a luggage rack or sun roof (which we do not have!) or on the rain or car wash. We haven't been through the car wash and it hasn't rained here in over 3 weeks. What would cause this to occur and how do we fix it?
View 4 RepliesI just recently had a new pressure hose (had a leak) replaced on the power steering pump but there is a slight squeaking noise when I turn the wheel. the mechanic says it'll go away after a week or so because of the new fluid that was put in? Is this correct?
View 4 RepliesWhere is the horn relay for a 2007 Buick Lucerne?
View 3 RepliesInstalled new compressor, condenser, drier... Local shop wanted to charge $140 just to evac. Bought vacuum pump and gauges/hoses. Evaced the system, held -30 for 45 minutes. Started car and proceeded to add freon... Compressor would not engage. Low pressure showed 90lbs but would not take any more and compressor wouldn't engage...
View 7 RepliesI just put new rear air shocks on my Buick Lucerne. I noticed the back in my car bounced more than once when I tested them. After starting the car I hear the air compressor run for about five seconds. This seems to have no effect on my new shocks. The old shocks had holes in the bladder. What tests can I perform to figure out what's wrong?
View 8 RepliesMy wife's 2007 Buick Lucerne wouldn't start the other day after sitting maybe 20 minutes with the headlights on. She had to call AAA for a jump start. It starts fine now. I took it to an autoparts store, the battery shows 90% life left. Brought it home, charged in 10 minutes using my car charger. My question is, what could cause the car not to start so easily? I am skeptical the battery was the culprit. How can I check the alternator, etc? Any other thoughts?
View 9 RepliesMy wife's 2007 Buick Lucerne's directional signal is acting odd... When you turn it to the left-hand blinker, the pace is not the normal factory pace. After two or three cycle it then starts blinking on and off VERY quickly, like those blinkers you see on junkers periodically. The right blinker is normal pace as are the hazards lights. I am looking for potential causes before I bring it in for repair. I can't say anything trigger it, other than I noticed it after a car wash. Electrical problems are not my thing.
View 5 Replies