Buick - Lesabre :: Parking Brake Pedal Doesn't Come Back All The Way
May 14, 2014
I have a 2000 Buick Lesabre with 226k and my parking/E-brake annoys me. The brake isn't stuck or anything, but the pedal doesn't come back all the way, at least not enough to turn off the brake light or accompanying dinging. Most of the time, the cable is disconnected from the pedal to keep the light and dinging off unless I have to use it. Is there any way to adjust the parking brake to get the pedal to fully return or is there something else wrong with the system?
View 19 Replies
Advertisement
I have a 99 Buick LeSabre and it died while I was pulling into a parking lot. It wouldn't start back up. I tried listening for the fuel pump and nothing. It's not priming or making any noise. Once I got it home I replaced the fuel pump relay. Still nothing so then I changed the fuel pump. Still nothing. I'm stumped. I'm going to check all the wires tonight to make sure I got them on right. Is there any other relay or fuse on these cars that I can check?
View 3 Replies
My brake pedal needs to be practically be pushed to the floor for the car to stop. I went to a Munro Muffler and they replaced all brake pads and turned the rotors. The problem of the pedal to the floor did not go away. The Munro tech struggled with this then popped me with this estimate - brake lines master cylinder to ABS / brake lines ABS to front brake flex hoses connections, / brake lines - ABS to rear junctions fittings at the passenger front door. Also they want to sell me a rear wheel bearing because the temperature at one point was very high. The total estimate is $840. I can remove the Rear wheel bearing to bring the estimate down to 500. I asked if we could do lines from ABS to Master Cylinder only and the tech advised against it. I feel like I am about to get ripped off and am going for a second opinion.
View 19 Replies
I have a 2000 LeSabre and every time you start the car and then push the gas pedal down it's hard to push, then it will break free and work normally for the rest of the drive, but the next time you get in to go somewhere else, it will do the same thing. If you "POP IT" real quick with your foot it will work just fine until the next time. Is this a cable issue?
View 6 Replies
I was wondering my buick a 1995 lasbre it cranks up fine and the engine light comes on and off when i start driving it cuts off and cranks right back up people say its the crank sensor...
View 1 Replies
I have a 1996 Buick Le Sabre. There is a bad water leak onto the passenger side back floorboard. I have taken it to the dealer and two repair shops. They are stumped. A hard Florida rain can get 2 inches of water on the floor. Tried re-gluing the rubber seal. That did not work.
View 5 Replies
I currently have no brake fluid in my car because it keeps leaking out (leaks while actively being used). The leak is between the power brake booster and the brake master cylinder... Is there any type of gasket I can get to better fill the gap between the two pieces of metal? Is there some way to tell which of the two pieces is creating the leak to narrow down which to purchase?
View 1 Replies
In Oct. my wife took the car 40 miles from home, lost the brakes, and limped into a gas station. The guy there gave her a bottle of brake fluid and some stop leak. He suggested equal amounts of both and limp back home. She drove back and went to the machanic in town. He wanted $365 to replace all of the brake lines. He said there may be brake pressure problems and he will address them later. Recently I loaned my son the car so that he could deliver newspapers.
After 2 weeks we needed new front brakes. I had brake pressure problems. If the brake pedal did not feel spongy then the brakes felt inconsistent-sometimes high and sometimes down to the floor. There was a sticky passenger front caliper that was replaced. The brakes were bleed and are still spongy and inconsistent. I noticed that the reservoir cap is not good. Could the cap be the cause of the sponginess? There are no leaks around the master cylinder and there are no leaks. Should I replace the master cylinder? 1996 Buick LeSabre 3.8L....
View 2 Replies
I just had a remote start installed with a turbo timer that works off of the parking brake being engaged. No matter how hard I press it the light does not go on, however when the installer probed the sensor to ground it, it worked fine.What part this is that needs to be replaced. The stealership quoted me at 200 something for a whole parking brake assembly.
View 14 Replies
I have a 2010 toyota camry that needs a parking brake adjustment. the car still stops with the transmission even if the parking brake pedal is pressed down. I changes the pads in the back and it seems to be a little better, but it's not as good as other Camry's I've been in. Where to look as far as the adjustments go? and possibly how if it's not the usual method.
View 4 Replies
So my parking brake doesn't engage when the lever is pulled. The light lights up on the dash saying the parking brake is engaged but the brake I not engaged. It hasn't been a huge problem for me since my Jetta is a 6-speed but I would like to fix it some time soon. Looking for a DIY? I did a quick search and didn't find anything really.
View 3 Replies
The other day I backed out of my garage and didn't notice that the parking brake was still engaged. The car rolled out without a problem.
Only when I put it in drive did I realize that the parking brake was on, since the car didn't roll forward. I also got an audible alarm.
View 14 Replies
This morning I drove my car to see my dentist. When I parked I engaged the parking brake as I always do out of habit. However this time when I was done at the dentist and got in my car I tried to disengage the parking brake pedal and it wouldn't release. It kept going lower. Now I think its pretty much floored. I had to leave the car in the parking lot as it started to rain heavily. How to release the brake pedal. ? I think it must just be a stuck lever or gear thats preventing the release mechanism from working. Any pics or have dis-assembled a parking brake pedal on the phaeton before.
View 4 Replies
Parking brake light stays doesn't come on when the parking brake is engaged. The light DOES come on when starting the vehicle and the gauge cluster cycles through its start up procedure. Couldn't find a fuse that would fix my issue...does one exist?
Truck is an '02 F250 w/ 7.3TD and 6 speed manual.
View 2 Replies
It seems about once a week the rubber cover that goes over the food pedal for the parking brake comes off. I've been careful to replace it correctly but it still keeps happening? Btw it's a 2010 v with atp ...
View 9 Replies
I went to adjust my Santa Fe's parking brake (pedal version) and am trying to troubleshoot. The pedal goes all the way to the floor, something like 11+ clicks....
I jacked up the rear end, pulled the tires off, rotated the drum so that I could access the adjusting nut and used a flat head screwdriver to rotate it all the way back to where it wouldn't rotate anymore. After that I clicked it ~5-7 clicks. Same process on each side.
Went to go test the pedal, still goes to the floor, same number of clicks, etc.
Tried to locate an adjusting nut for the pedal but cannot find one, if one exists. The fuse box sits perfectly in the way but I was able to view everything with a little bit of effort and still couldn't locate the mythical adjusting nut.
I know I did the adjustment on the rear brakes correctly so it's an issue with the pedal/cable/nut.
View 17 Replies
2001 Ex limited 4x2 w/50k miles-- The parking brake pedal will not depress...at all....not even a millimeter. Feels like it is "locked".
View 2 Replies
The switch for the parking brake pedal light self loosened (a known issue with this switch) over the past six months and today it finally fell off the pedal assembly. The only way I can see to do the repair is to remove the three fasteners that attach the parking brake pedal assembly to the dash and drop the pedal to the floor to refasten the switch. It appears to be possible; however, there are lots of stuff around the assembly that might get in the way of dropping the assembly so I raised the white flag and called it a day.
View 2 Replies
I was driving my 98 Tahoe yesterday making a visit to my sister. pulled the truck into the drive-way, put the gear selector in park, stepped on the parking brake (a habit I've had for years) and YIKES! the peddle moved down with no resistance!
my parking brake light stayed on even after I released the parking brake peddle, which didn't spring back, but I pulled it back. light stayed on when I started the truck although I think the brake never engaged in the first place.
I drove the truck and didn't notice any drag at all. after driving a few miles I stopped the truck and felt the wheels for excessive heat but didn't experience that. my guess is the cable broke or came off and didn't engage the parking brake in the first place. sound correct?
View 13 Replies
The adjustable brake pedal on my excursion works fine, but the throttle doesn't and never did adjust. It just doesn't move at all. Why? Just a bad electric motor on the adjuster? Just curious if there is something common that fails before I delve into trouble shooting it more.
View 7 Replies
Ever since I've had this truck my parking brake has acted like this. My buddy has an '03 and his acts the same, but I figured I'd ask the question.
9 times out of 10 to set the parking brake, the pedal goes almost to the floor and doesn't seem like it really does anything. The other 1 out of 10 it goes half way and feels like it actually sets. Is this normal?
View 14 Replies
