Buick - Lesabre :: 2001 - New Plugs / Wires But Still Misfires
Jul 31, 2012
I just bought a 2001 Buick Lesabre and it was driving fine until this morning when it misfired on the highway. I was going about 40 mph and I felt a little jerk in my engine and my CEL started to flash. I pulled it over and got it towed to my house and my code reader says a p0300...which is a random misfire code. So I figured i just need a tune up so I went and bought new plugs and wires and replaced the old ones. And to my surprise...still a noisy shakey rough erratic start and idle. Before this there were no problems the car shifted properly to all gears and picked up and accelerated like a champ there were no obvious issues. Now I cant get it out of my driveway. I was wondering if any other problems could cause this misfire, and how to eliminate problems without buying parts?
View 19 Replies
Advertisement
2001 Ford Ranger 4.0 - 250k miles had the original plugs and wires ....
First things first - I changed them one at a time and confirmed the truck started and ran after each one was changed. I changed all the plugs on the drivers side with no issue. 4,5,6 ... Then I changed plug 3, rear passenger side plug closet to the firewall.
Truck will not start, turns over great, but will not start. I have confirmed I am getting spark. No clue what could have changed, I just pulled out the old plug and wire put in a new one and it wouldn't start.
My father-in-law said if you have spark check fuel. I recall seeing a post about someone breaking a cable for the coil pack but i have checked and i see nothing broken.
View 7 Replies
2001 MK4 GTI VR6 put brand new coil pack, wires and plugs in the car because it was misfiring. Was fine for about a week than I got a clogged cat code and could feel the affects. I now have no cat, no resonator, and no muffler. The car is finally driving good and then the check engine light came back. It says only a misfire in Cylinder #3 and when accelerate hard to speed up my check engine light starts to blink until I stop accelerating hard. So my guess is the clogged cat caused that cylinder to misfire but I do not know the actual solution to this. My EVAP hose is semi-pinched and when u squeeze it you can almost kill the engine. The weirdest thing of all is this: driving normal I shift in between 2000 and 3000 RPM and once i get into 4th gear about 2000 RPM......my car starts shaking badly and i feel like my engine is going to fall out. I have searched and the only thing i can think of is a bad injector...
View 3 Replies
My 2001 Buick Lesabre has always shown to run exactly normal on the temperature dash unit until recently. I checked my coolant level and it was a bit low, so I added. After I filled the radiator I have noticed a coolant leak spot on my driveway, after I drive it now. I have removed the gravel shield and have tried to pin point exactly where the leak is coming from, but cannot. Now, each time I park, after driving it, I put a clean piece of cardboard under it to try to see exactly what area the leak is coming from. Last night I put the car on ramps and crawled under to discover that the leak is located just above the oil filter and is actually dripping from the oil filter, but I still cannot see the exact location of the leak.Actually the leak does not appear until about an hour after I park the car, so it sounds like something is contracting after the engine has cooled off, but what? The leak has seemed to be getting worse each time I drive the car. How can I determine exactly where the leak is coming from without just changing a bunch of parts.
View 10 Replies
I have a 2001 Buick LeSabre (Limited), with 101,000 miles. It runs great and a very reliable car except:
After going for some driving in town during a warm day (60 F or above) doing business, the engine gets warm but within normal temperature range, and after making a stop to get groceries for eample, I have to be very careful when starting the car again. If I let the starter go for more than a quarter tourn (crank), the engine gets week and acts like it is flooded with gas, just like when we had carburators in old car and it dies after a few shakings.
So I have to wait for 15 minutes at least before I restart the engine but doing so I have to be really careful again not to let the starter crank for more than a quarter turn. However, this problem does not happen during cold weather days (say below 40 degrees F). What is going on with my car?
View 2 Replies
My 2001 Buick Lesabre 3.8 loses power at highway speeds, sets a PO101 code (MAF sensor). I have replaced the MAF sensor 3 times, as well as the coolant temperature sensor, the crank position sensor, the throttle position sensor, the MAP sensor, the intake manifold gaskets (upper and lower) , the pcv valve, the egr valve, the Idle air control sensor. After cruising at highway speed for about 3 miles the car still loses power for about 20 seconds then gradually regains power only to repeat the fault again 3 or 4 miles down the road.
Otherwise the car has plenty of power quickly achieving 100+ mph going though the gears smoothly and normally. I have inspected the intake plenum and vacuum hoses for leaks and have found none, all in very good condition. The car ha 122,000 miles on it and has been well cared for, very clean under the hood with no leaks. I did reduce the egr chimney size to 3/8" while replacing the intake gaskets and that reduced the symptoms somewhat, i.e., the car only loses about 15 mph instead of dropping to about 25 mph before recovering.
View 8 Replies
When starting my car first thing in the morning, for the first few minutes there is a loud roaring seems like. The sound subsides and the car sounds normally after a little bit. The next issue is when I start the car after it is already warm. It starts very strange...It is a little hard to describe. As soon as you hit the starter it just turns over instantly, seems almost prematurely. And when you go to shut the car off, it just seems like it makes a loud noise and the motor abruptly shuts off. I am not too educated with vehicles, and I am just looking for some input. I just purchased this car a week ago with 82,200 miles on it I have never driven a Buick before so these things may be normal.
View 4 Replies
Had issues with TBI, rebuilt. Had some starting problems after truck sat for 1 day or more, but would start after a few tries. At one point when it was particularly stubborn, starter lead vibrated off. Once reconnected, truck started, ran fine, but had some electrical humming & radio interference. The starting issue continued with some low rpm stumbling, when driving check engine light would come on at cruising speeds and go off 7-8 seconds after letting off gas.
Had 1 day lest week when I drove a bit more then normal (150+) but ran fine other then engine light. Next day started, but ran horribly rough with violent back fires. At one point stalled and would not restart. It looked and acted like it was flooding itself out and poor spark. Less then a year I replaced cap, rotor and coil. Now I have done all new plugs and wires. Now it appears I have no spark. I had been in the dash messing with the blower motor relay 2 days prior to the stalling and not starting.
Does the ECM control spark? Cant it go bad slowly? And if I had to do alot of cranking of the engine to get it to start, would that have any thing to do with it going bad?
View 14 Replies
Today I ran into a problem while i was changing my spark plugs ...two of the plugs were completely covered in oil. I mean oil was literally dripping off those plugs. I have a Passat 1999 2.8L V6. What could be wrong.
View 3 Replies
While I was installing my side mirror turn signals I noticed there were two plugs tucked away in plastic not connected to anything. One is towards the outside of the door. As if it was to be connected to the door handle sensor that comes with the push button start package. The other one was towards the inside of the door, as if it is used with the lane assist or even side mirror turn signals. I never really messed with them as I was following the DYI. I should've checked to see if they were wired to the turn signals so I wouldn't have had to run the wires all the way to the fuse block. Below are the pictures of what I'm talking about.
Front/Inside of door
Rear/Outside of door
View 1 Replies
I want to change the spark plugs and wires in my 1996 Ford Escort (1.9 Engine).
The problem is trying to remove the No. 1 spark plug boot and spark plug. Both are located behind the alternator and are difficult to get to. I tried a boot puller but could not get easy access to the boot to pull it off the spark plug. The other three boots and spark plugs are readily accessible.
Is it sufficient to place the dielectric compound just inside the opening of the boot before placing it back on the spark plug, or should it be placed on the metal clip that is ~2-3 inches down inside the boot?
View 2 Replies
I have a 2007 Honda Fit that seems to misfire when idling both in park and drive. It occurs with the A/C on and off. We have changed the plugs and all coils and it continues. This car has 56,000 miles, the problem started at about 40,000 miles.
View 15 Replies
I have recently noticed that my car will stall out when I get up to about 20 mph. My car starts fine, no check engine light on. I has a tendency to just die in the middle of the road at times too. I have changed the spark plugs, spark plug wires, and a new fuel filter. Do I need to change the mass air flow sensor? Or the crank position sensor? I have no problems starting the car either. Runs good when it runs.
View 10 Replies
Where is the relay box for turn and hazard signals in 98 Buick LeSabre custom? my hazards ans signals don't work switched fuses but didn't work. Where the box is I've never owned a Buick til now. there isn't one under the hood just the main on the driver's side.
View 1 Replies
1996 buick lesabre custom 3800. The car stalls from time to time, and the fuel pump, power windows, power seats, and power mirrors all stop working. Most people who have had this problem cleaned the ground bus on the drivers side under the carpet. I have done this, and the car has not stalled yet, but I haven't driven it far because I have noticed the fuel pump relay and power windows relay are getting extremely hot to the touch after 5 minutes or so of driving. Why these relays are getting so hot? I cannot afford to keep getting the car towed home.
View 1 Replies
I currently have no brake fluid in my car because it keeps leaking out (leaks while actively being used). The leak is between the power brake booster and the brake master cylinder... Is there any type of gasket I can get to better fill the gap between the two pieces of metal? Is there some way to tell which of the two pieces is creating the leak to narrow down which to purchase?
View 1 Replies
My car would not start yesterday, and I realized the fuel pump was not running. So I bought a new fuel pump today and put it on, the car still won't start, the fuel pump still does not run and I have been told to check the relay. I cannot find the relay for this car.
View 7 Replies
I have a 1995 buick Lasbre and my engine light is on my car would cut off every once and a while. but when it does it cranks right back up like its a sortage in the wires people say it is an electrical problem i thought it was my crank sensor but my car has never had a problem cranking up it sounds wonderful when it cranks up so whats my problem....
View 3 Replies
My '98 Buick's AC works well when I take it to a mechanic. But when I leave after they say, 'it seems fine now,' a few miles later the cold air starts blowing through the defroster vents, still nice and cold. Then it comes back down to the dash and then goes back up to the defrost. But sometimes it stops blowing altogether, it doesn't blow anywhere! Nothing, not even warm air. And then later everything is fine again, until it happens all over again and I take it to another shop when I hear 'it seems fine now.'.
View 2 Replies
I have been to a few different repair shops for my 2000 Buick Le Sabre shimmy problem with no luck. I have a really bad shimmy, while accelerating between 45 and 50 mph, and it seems worse on an upgrade. Past 50 mph, it smooths out. Over the past several months, mechanics have checked the balance of my tires and rotated them, done front end alignment, rear alignment, replaced the right lower control arm, the right sway bar link and the right wheel hub. Still no luck, so it came down to the determination that it must be a bad tire. Now I have 4 new tires (it was soon time to get them anyway), and I still have the shimmy. What else can we look for? My local mechanics seems stumped. I have not taken it to a Buick dealership, however...
View 9 Replies
Driving my car over the week-end and experienced a lot of hesitation when I stepped on the gas. The car seemed to delay in kicking in to the next gear.I stopped and checked my transmission oil and realized I didn't have much transmission fluid, practically none. So, I added a quart. My question is what should I do now. I know it probably doesn't have enough but I don't know how much to put in. Or should I just have it changed?
View 12 Replies
