Buick - Lesabre :: 1997 - When Using Turn Signals, Arrows On The Dash Stay Illuminated
Apr 2, 2015
I have a 97 Buick Lesabre, when I use the turn signals (Doesn't matter right or left) the arrows on the dash stay illuminated. The turn signals aren't turning on, on the outside of the vehicle either. The hazards work just fine though (Blinking on the dash and outside of the car). I replaced all four flasher bulbs (2 in the back 2 in the front), nothing. I replaced the dual filament tail lights, still nothing. I replaced the flasher unit under the dash, still nothing. Where's the next place to look?
Other interesting information : This happened a day after I took the car through a drive through car wash.-Since I've had the car, the turn signals have never self canceled (As in after executing a turn the blinkers stay on)....
View 6 Replies
Advertisement
I have a 00 buick lesabre that I am having problem with no turn signals. It first started with the infamous fast blinker on drivers side, so i replaced all the bulbs , so when that did not fix the problem, i thought it was the socket, but it turned out ok, so i replaced the flasher and after that, I have no blinks at all, haz work but no blinkers. i tryed old flasher but still no blinkers. i checked the fuse that runs the blinkers, it was ok. I replaced it anyway.
View 8 Replies
The car (97 Buick Le Sabre with 3800) ran fine and started fine until one day last week it did not turn over. After about 10 minutes it was tried again and this time it did start. It was used regularly with no issues for the next few days. Then one morning it didn't start (or turn over) and hasn't really been successfully started since. The battery is good and cable connections too. So my mechanic figured it was probably the starter. Since I had this weekend free, me and my friend replaced the starter. But it still did not start. We then turned the ignition to run and crossed the solenoid terminals with a metal tool and then the engine turned over and ran for a brief period (around 5 to 10 seconds) but then killed.
This procedure was duplicated a few times. So we figure it wasn't the starter, the battery, or most of the larger cable connections. The tension wheel had failed on it in the recent past so we wonder if when the belt blew out if it had hit and weakened a wire somewhere that has now failed but difficult to locate. We also wonder if the car's security system maybe failed and it thinks the car has been stolen. This might explain why it won't start or stay running when ignition is circumvented. Note: the panic button on the key fob works properly. All of the fuses were checked and none were found to be blown out. What the root cause of this problem might be and how to repair it?
View 7 Replies
Every once-in-a-while I've noticed a "security" light is illuminated on my dash-board. When this happens, I can't start my 92' Buick LeSabre for about 5-minutes or so. Aggravating, to say the least. Is there something I can do? Including "disabling" it?
View 2 Replies
Pulling into work this morning I noticed my check engine light was flashing. The car (1997 Buick LeSabre, aka The Rolling Couch) was still running and everything seemed normal. I turned off the car and then went back out 3 hours later and tried to start it. It would not start, and the symptom is not one I've had any luck Googling. When I turn the key, it makes a sound, but it's not a click. It's the normal sound when ignition starts, but the engine does not crank at all or turn over. It just makes a single ignition sound and then nothing. Could this be a belt? The starter? I have not taken it anywhere or pulled the error code yet.
View 13 Replies
2000 lesabre picked up this car cause person didnt want to deal with problem any more. car starts n runs fine, but all instrument panel warning lights would come back on as if you turned on ignition but didnt start engine. everything fine for about 2 seconds after starting, then all lights come back on, gas gauge plummets to empty, and radio and door locks go dead. read alot of forums but this problem not to common. finally found one that said rear integration module replacement fixed it. so i unplugged it and opened the case n looked for bad solder or burn but couldnt see anything. flexed it a bit looking for cracks- nothing. put it back in and car worked great for 2 days. hooray! not so fast! left it outside the 2nd nite, went down to 22 degrees,- same problem. figured id try a used one from a boneyard. working great going on 2 weeks now, cold weather and all!
View 1 Replies
Just bought a 97 buick ltd and no matter what setting you put it on no air of any kind will blow from the vent.
View 3 Replies
What are possible causes for"check engine light" being on continuously. 1997 Buick
View 3 Replies
My Buick LeSabre, 2000 model, has had the wiper motor replaced 3 times in an attempt to solve this problem. The multi-switch has also been replaced. The rain sensor on the windshield was disconnected after the 3 motors were put in just to eliminate a potential cause. It is plugged back in now.The problem is intermittent as well. When you are driving, the wipers engage and nothing will stop them.The car has a little less than 80,000 miles on it.
View 2 Replies
When I turn on my a/c I get a constant clicking noise. Very annoying.
View 4 Replies
99 Buick LeSabre ... I only have one low-beam working, the other low-beam bulb went out today ... When I switch to high-beams, the high-beams come on, but I cannot turn them off via the manual light on/off switch on the door panel ... The Twilight Sentinel works properly, and will shut off the high-beams per switch setting ... During the daytime, the high-beams will just stay on till I turn off the car, manual headlight switch won't turn them off ...
View 1 Replies
No B5 posts since the variant has been running well....'til today, when I noticed irregular turn signal operations. This is for a B5.5, 2002. Occasionally they'd work as they should, but much of the time they'd blink a few times then stay off.
Continues to happen after shutting down the engine and restarting (was wondering if that would reset anything). I recall some sort of relay problem with the turn signals. Does this sound like what's going on?
View 1 Replies
, My 1997 Buick Lesabre transmission slips at random when I shift into overdrive. I have my mechanics look at the transmission and have them drive the car to recreate the problem and what do you know the car doesn't do it. I made a post about this problem a while back and it wasn't the A/C that was the problem. I do not drive fast in the car and I checked the Transmission dipstick and the fluid is still red and at the full mark. I brought my car to Auto zone to check the codes but all i get is a loose gas cap.
View 14 Replies
Having a problem with my 1997 Buick Lesabre. It's a v6, automatic 4 door, and I live in good ole HOT Florida.
Anyway for about two weeks ago I went to start up the vehicle and it would turn over, run for about 2 seconds, and then turn off and did that about 5 or 6 times. Knowing very little about cars I had a friend try to jump me, and nothing, still wouldn't turn on. So I left the car there, came back five days later. It started and ran, and I drove straight to the mechanic. I had noticed my belt whistling a little so he put on a new built, fix a power steering pump fluid leak, and put on a new belt tensioner.
Anyway, I pick it up a week ago and it starts up no problem. Today the problem has started again. Some times now though it will start up, run for a little while and then just shut off. Doesn't seem to make a difference whether I am idling or not. Sometimes now though it will turn over, but not actually fire up and start.
View 8 Replies
Lately I have been noticing a very small drip of coolant on the driveway under the water pump. Most would assume this to be coming from the water pump, right? Problem I have, is I can drive the car say 10-15 miles, return the car to it's parking area on the drive (previous spot cleaned and dried) and monitor thru out the day, some 10-12 hours, NO DRIP! I can forget about it, return the following morning only to see it has dripped overnight! I have visually inspected the coolant elbows at the tensioner and dry as a bone. I see no damp areas near the water pump pulley area. You might ask if the upper and LIM work has ever been done and the answer is yes, the local Buick dealership did that a few years back.
The coolant levels rise and lower normally depending on engine temp and it's hard to see any loss of coolant when looking at the reservoir when cold. I have read there is a small weep hole near the output shaft of the water pump which allows a release of coolant to protect the bearings of the water pump. Could this be where the coolant is coming from? I wouldn't mind replacing the water pump and even the coolant elbows while I have every thing apart, but I would hate to do that only to find it was something else, maybe an easier fix!
View 2 Replies
My sons 97 LeSabre runs and drives like a top most of the time. Twice now though over the last three months it has died on him. Both times the car stalling out has been preceded by a high pitch whining noise that seems to be coming from the fuel pump. The first time, it would restart and run for a few minutes with the whining sound then die again. We towed it and let it sit a couple days and found that cleaning the MAF sensor may fix it. We did this and it worked.However, yesterday afternoon he and a couple friends ran into town, about a 20-mile drive, to run a couple errands. Drove around in town for about 30 minutes and it started the high pitch whine from the tank again and made it a couple miles across town before it died again. Pushed it around the corner to a gas station and parked it. A few hours later, my wife and I went to go get it, didn't know if I would have to push it or tow it, but I turned the key and it started immediately with no whining noise, so I drive it the 20 miles home without incident. The outside temperature yesterday was in the mid 90's and humid, and thinking back to the first time the car did this, the weather and circumstances were almost identical? When used to go to work out, or to work, or just little drives around there seems to be no problem. The car has even run this 45-50 mile round trip without incident numerous times, but at different times of day with cooler temps, and some lengthy waits between driving times.Does this sound like a fuel pump or sensor that could be failing? And why would it only act up under high temp situations? Almost like it was vapor locked, it had plenty of fuel, and didn't make a difference earlier in the heat even opening the gas cap to relieve any pressure? Completely stumped here?
View 5 Replies
1997 buick lesabre, 4 door, v6. It was having problem stalling out. This weekend a friend and I lifted the car and replaced the fuel filter and fuel pump. Drove great Saturday and Sunday. Today I get in the car, starts up without a hitch. I start heading down my street and realize I am having to push my brake pedal in ALL THE WAY to get it to stop and even then it's slow to stop. So I back up, pull the hood and check the brake fluid. Sure enough, it's low, so I run to Advance, grab some fluid and fill it up the max line and think i'm ok. Start the car up, pump the brakes a few time and notice nothing new. I get out and realize I have a very steady leak in front of the right rear wheel of fluid. It's a steady drip in two places. Is there something I could have done to have caused this. The only line we messed with on Saturday was the emergency brake line and it's clearly working (I tested it).
View 1 Replies
I was driving home and the dash lights went out. I checked all of the fuses and they all check good.
View 14 Replies
My amber ABS dash light in my 2003 F150 came on the other day. I changed out the rear pumpkin sensor, ohmed the front wheel sensors (they were within specs posted in FTE forum) and changed out the master cylinder pressure switch under the hood (my left/rear bulb was burnt out around the same time the ABS light came on). After doing all this the light remains....so I had the ABS code read and mechanic advises code C1206 was present. He recommended replacing the "dump valve on the frame rail". He also advised this is a very expensive fix so I might just want to live with the light being on all the time. What should my next steps be to get rid of the ABS light and get my ABS system working properly?
2003 F150 SuperCrew 4X4
4.6L V8 , 285/75/16 tires , 127K miles
View 5 Replies
Every time I use my left turn signal it tends to get stuck and stay on...never turns off unless u get luck enough to jiggle it a little... So I have reverted to not using.. Why this could be happening? Its funny cause when it gets stuck it even stays on when i turn the car off so i end up disconnecting the battery...any way to stop this? 2000 buick park ave.....
View 9 Replies
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 Replies
