Buick - Century :: 2002 Died At Stop / Check Engine Light Is On And Taking A Bit To Start
Nov 30, 2013
The car died on me the other day at a stoplight but started up again (It resisted for a sec but then caught). Now it's taking a bit to start and sounds very faint when it finally catches and the turn over is slow. I'm no mechanic but I can replace parts. I'm just wondering if it's the fuel pump or injectors, maybe low fuel pressure. I haven't had a chance to do anything to it. Where to start?
View 3 Replies
Advertisement
My problem is my 6 CL died going down the road I got to stop light & she quitly died. I got it started after a few tries & made it to BK, kept trying to start sounded like choked for gas. Hour later starts goes 1/2 mil dies call towtrk. Changed fuel pump(not so bad) fired her up, first couple times ran a sec. and died.
3rd time a charm it started & idled (a lttl ruf) for 20 min.& wife takes it to gas station shut off & restarted no problem & back home. 1 hr later I get in to run an errand & it dies I push it hm pop hood seems awfully hot. Is there a way to test the CPS unit?
View 4 Replies
2002 Buick century will sometimes not start. Seems to correlate with warmer weather and happens after long drives. I try to restart within 10 minutes of turning off and it will start and then in a few seconds the car shakes and the engine dies. I can restart multiple times, but it will always die in a couple of seconds. If I wait an hour and retry, no problem. Once someone banged on the gas tank and that solved it. Mechanic cannot diagnose problem unless it dies while he is there. Should I replace the fuel pump or could it be something else?
View 4 Replies
Most of the time it has no problem what-so-ever, but once in a while it just doesn't start. It will turn over and over but that's it. Most of the time if I just let it sit for a few minutes (5-20) it will start right up no problem, but I've noticed when it does it often revs up as if I had my foot on the gas. (that took me a while to realize since I often touch the gas anyway.) Once it's running it runs great. The idle settles down to normal after a few seconds and the car runs as if there was no issue. It does this randomly.
I can drive it for days or hours with no problem, and then suddenly it just decides to leave me stranded. Usually i wait and it gets me home, but a couple times it didn't. I've drained the battery twice on two different occasions months apart trying it, and waiting and trying it. Both times with barely enough juice the following day to turn it over, it fired right up, rev'd the engine, then ran fine. I don't think it's an issue with fuel because on one occasion while trying to start it I laid into the peddle until I could smell gas under the hood- and it never has issue while running, only on start-up.
So far the only thing I've done is replace the spark plugs- it runs better now, but doesn't start any differently.
View 7 Replies
I have a 2000 Buick Century that only has 70000 miles on it. I have an issue that when I drive the car for a while, the transmission will shift hard after stopping at a light or stop sign. It only does it through the first three gears. If I shut the car off and let it sit for a few minutes and start it back up, it shifts fine through all of the gears. I have not had the change to change the fluid and filter yet. The fluid looks clean and is always full. I have read that there has been a common problem with a pressure control solenoid in the transmission needing replaced to correct the hard shifting. I am not getting any kind of error codes from the PCM, so I am not sure.
View 4 Replies
I have a 96 Buick Century Special with the 3.1 six cylinder engine. Starting on March 18, 2015 my car has started blowing the Injector Coil fuse any time I take a fast left-hand turn. It never does it during a right-hand turn. I have now replaced the fuse a total of 5 times since March 18.
View 1 Replies
Only two weeks ago I had the crankshaft sensor and the ignition module replaced in my 1992 Buick Century (3.3L V6). Without any warning, the car abruptly died while cruising. Are there any things outside of the ignition module or cranshaft sensor that can cause these things to fail? Was the mechanic supposed to disconnect the battery before replacing these items? Can a short-circuited spark plug cause the ignition module to fail? Can a mis-alignment of the sensor cause any damage? Could there be a hidden frayed wire that short-circuited?
View 8 Replies
I have the GM shop manual and I have gone through the flow chart for an engine which cranks but does not start. I have confirmed that there is fuel pressure and spark, but the injectors do not fire when cranking. I have gotten to the final troubleshooting step of disconnecting the crank angle sensor connector, jumping A and B terminals on the connector, and momentarily grounding the jumper with a test light. The injectors fire as confirmed using the GM injector test light (in place of an injector). The flow chart conclusion is that the crank angle sensor is bad or misadjusted or the connector is making a bad connection. I have replaced the sensor twice and adjusted it using the GM adjustment tool. The connector terminals appear clean and undamaged. 1989 Buick Century 3.3 liter ...
View 5 Replies
2000 Buick Century Custom with 140K miles: Service Engine Light came on. Re;placed gas cap, light still on. Took to dealer who replaced HO2 sensor, light still on. Took to dealer who found no problem but charged $100 for looking. Light still on. Took to dealer who said it needed two major parts. Light still on. Took to another mechanic who could find nothing wrong. Light still on. Is there hope?
View 8 Replies
The Buick Century has about 22,000 miles. The Service Engine Soon light has appeared on the dash. The instruction manual is not clear. What would you recoomend? What might cause the light to appear?
View 15 Replies
I was told by the dealer it would be over 150 to scan and do a fuel trim on my 02 Explorer, XLT, 4.0, Auto. I can't afford the scan or a garage. I paid 4200 for it and a short time later it starts surging at stop lights then it starts sputtering when idling and taking a while to start. Next it stops accelerating past 2.5k, then works well a bit then stops accelerating past 50 miles an hour. Then it works with an 02 disconnected then starts acting up again. It now either runs normal, wont accelorate past certain ranges, or starts then quits 3 seconds later, unless I unplug the MAF then it runs 15 seconds then stalls. Through all this symptoms come and go. Always banks 1 and 2 lean.
Symptoms
Knock
Rough Idle
Slow Starts
Hesitation
Lag
Stall
Replaced
02 Sensors
Fuel Filter
Injectors
Plugs
Plug Wires
Tested
Maf
TP
Temp Sensor
Cam Sensor
Crank Sensor
All EGR Components
Idle Valve
Coil Pack
For any air leaks.
Fuel pressure 37 or higher
Clean Fuel Pump Strainer
Flow tested pump
Checked air filter
View 9 Replies
I am having some trouble with my 02 Buick recently. The acceleration from a stop is very sluggish and gear changes come slowly, although they still seem to shift smoothly. The first thing I did was check the fluid levels and I can find nothing wrong there. The trans fluid was last changed 3 years ago, but the level, color, and smell are all normal so surely that couldn't be the culprit ?Unfortunately, that about exhausts my diagnostic skill.
View 8 Replies
My 1992 Buick Century frequently shuts down when coming to a stop or slowing down to make a sharp corner. I'm always able to restart it. I thought it was a torque converter lockup problem, but my transmission specialist said the transmission is okay. Last month, after the car died completely, I had the crankshaft sensor and harmonic balancer replaced by Firestone. Could it be the same parts that malfunctioned? Or, could it be another issue?
View 12 Replies
I was driving my trusty 2002 152K miles, and came into a very long and very slow traffic jam on the side of a mountain. After about two hours of mostly stop and very little go, my CEL light came on. I am also seeing the "general fault" symbol, but it should be noted that my PS symbol has been showing for about a year because my PS died and I just didn't fix it.
View 11 Replies
I have 2003 Buick Century. I started having problems with the car after coming to a stop, accelerating - the car starts to go hesitates, then jerks a bit to go. This does not happen every time after a stop but when it does the service engine soon light comes on. Initially I got the P0401 code (I think) and took it in to a mechanic. They could not find anything wrong with the car but did clean out the EGR valve, that didn't work, they worked on my transmission and replaced other parts, still no success.
I took the car to another mechanic who replaced the EGR valve and several other small parts. I still had the problem but this time the error code was P0420. I took it back again and replaced the spark plugs, O/2 sensor, catalytic converter. That hasn't fixed the problem. The mechanic said that they have taken my car for several test drives and the car has not demonstrated the problem. The error message still reads P0420 even after all of the parts have been replaced. The 2nd mechanic has washed his hands of my problem.
View 2 Replies
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 Replies
I have a 2000 Buick Century that I cannot get to start. While my wife was driving home it started to sputter (like running out of gas) and did a little back firing. She made it home and I put in some gas (Just to make sure) and the care cranks over but will not start. I have replaced the fuel filter, checked the spark plugs and replaced the CAM Sensor. The car still will not start.
View 5 Replies
My 03 Buick century is overheating. I changed the thermostat and the water pump. And still overheats as soon As I start driving. I am also getting when it is overheating some misfiring in cylindar 1. I am going to reflush and bleed the coolant even though it seems to be full . i dont think it is disappearing. Is it Possible i have a blown headgasket or intake manifold leak?
View 4 Replies
I have a 1987 Buick custom 3.8L that will not run or start with the EGR valve connected to the evr selenoid. How can I verify if it is the EGR valve or the vacuum solenoid? When I connect the egr to the vacuum solenoid the valve opens all the way up and the engine stalls.
View 5 Replies
My 2004 Buick Century is parked outside, it starts up fine and runs fine every morning and anytime it sits for a period over an hour in any kind of weather including minus 25 degrees. Sometimes when I shut it off for say 15 minutes or half hour and then go to start it again it will crank over fine but not start up. I can try several times, same thing.. But then if I leave it alone for maybe another half hour and try it again it starts and runs fine. also no warning lights etc. It's like something needs to reset itself. What is causing this ?
View 3 Replies
Replaced sensor, light stays on.Removed sensor, grounded the probe, light goes out.Replaced antifreeze, bled system twice, no air or oil.Getting desperate. Removed and cleaned battery to body ground strap.Removed and cleaned battery to engine ground strap.Today found out there is no error code in the OBC but the light is still!
View 1 Replies
