Bmw :: 1985 - Manual Trans Will Not Shift Into 1st, 3rd Or 5th Gear
Jan 4, 2014
My 1985 BMW 635, standard transmission suddenly developed shifting problem. It will not shift into 1st, 3rd or 5th gear. It will shift into reverse,2nd and 4th gear. The car is not driven on any frequent schedule, infrequently. I can't remember the last time the transmission oil was changed.There has not been any mechanical distress,grinding of gears,etc. you just cant engage those gears. They all are moving the shifter from neutral to a up position. Is it possible that sludge could be blocking the movement of the synchronize r?
View 2 Replies
Advertisement
I just got a 2000 accent. The problems is that sometimes when I shift into 2nd and 3rd is notches sometimes. But it does not do it when i shift down. Also if I shift fast it will occur less often as when I shift low. When my friend drove the car it didnt do it for him. So maybe it is how i drive or something. I make sure the clutch is down all the way.
View 7 Replies
is it the clutch or the shifter or something else? I did have to replace the 2 shifter cables about 18 months ago as they broke, but lately, it is having a very hard time going into gear, especially 1st gear when stopped. It's so bad my wife won't drive it any more. We love our 35mpg Saturn and want to keep it running well.
View 7 Replies
I'm having a little issue with shifting into first. Once in a while it simply will not go in, like you're pushing the shifter against a brick wall. If I turn off the truck and turn it back on, it works absolutely fine. I can shift into 2nd-5th no problem at all times. Is it just the shift linkage, or...? I'm not really sure where to start.
View 7 Replies
Well I Took my truck (1985 F250 6.9L IDI C6) and went through a little mud bog got some water in the tranny, no biggy i flushed the fluids out a couple times and went to drive it. But now it wont shift from 1st to 2nd but i can manually shift it from 1-2 I replaced the Modulator and that havent made a difference. Is there anything I should look into?
View 14 Replies
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 Replies
I have an 04 Jetta 1.8T that I recently acquired and have a problem with a noisy manual tranny. Reverse is a bit noisy (more than usual) and when I get on it in 1st and 2nd gear it sounds like an awful whining noise. I have been told it could be either a bad throw out bearing or input bearing? BTW this thing shift perfect, like butter, no grinding at all.
View 4 Replies
1996 4x4, manual trans. Wants to kick out of first, and when shifting into 3rd I have no gear. Doesnt grind, just goes in as though it were neutral.
View 4 Replies
My 1997 Saturn SL2 with 5 speed manual transmission won't shift into first or second gear. When I shift into the location where first would be the car is in third gear. It shifts into 4th, 5th and reverse just fine, though the shifter is in the wrong position for those gears. I can wiggle the shifter in neutral and get it to move into the position where 5th and reverse are normally found, but it is stiff and makes a clunking noise when I move the shifter over to the far right side.
I have removed the center console and the bushing appears to be intact. Both cables are in their proper positions inside the vehicle and at the engine. One of the cables (the top one in the engine) has some wear and tear on the boot, but does not appear to be binding. Other than the stiffness and the clunking noise, the shifter seems to be working fine too.
View 8 Replies
1993 Geo Prizm with some odd 275,000 miles on it. Was at a stop sign, in first gear, and gave the car some gas. Very quickly it jumped out of first gear and stopped moving abruptly. Tried to get it back in first gear and it just stayed in neutral. Had to push it to the side of the road. Tried putting it in any gear and it wouldn't go. Then tried to have the car running in neutral and let up on the clutch and as soon as I started letting up on the clutch, something (like metal) started grinding. Pushing the clutch it (in neutral) stops the grinding. So, do I need a new clutch? New transmission?
View 11 Replies
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
View 2 Replies
Got in the car today and moved the gear selector into the manual shift mode. Usually there is no play forwards or backwards. Today there was about 3/8 of an inch travel forward before the spring tension started. I'm taking the car in tomorrow to have the console latch replaced but was wondering why encountered this anomaly in the shift mechanism?
View 2 Replies
I replaced the old auto trans that was slipping in my 2000 golf with a same year auto trans from a beetle. The beetle had 115k miles and the PO toasted the 1.8t. I replaced the TCM also and when I finished the install I took it out for a drive this afternoon and when I shift it into drive it starts out in 3rd. It will manually shift through the gears but it will not shift from 3rd to 4th. Could I have left something unhooked? Is this a solenoid issue?
View 10 Replies
99 grand prix gt. 4t65e trans. 170k miles. way above avg for life expectancy. 1-2 shift is ok. Will not shift into 3rd. If you keep increasing vehicle speed to about 45 or so, it will shift into 3rd and than immediately into 4th. 45mph is about 4k rpm. I can see the tach drop to 3k rpm for 1 sec or so and than it drops to 2k approx. It will stay in OD and does not slip. If I stay at 50mph or so and punch the gas, I can make it shift into 3rd gear and it will stay in 3rd as long as i give it 2/3 gas. Once i left off the gas it goes back to OD. Any theories why it wont hit 3rd on the way up but will easily drop from 4th down to 3rd whenever I want? I know, its time for a rebuild.
View 2 Replies
Everything was working perfectly. I stopped at McDonalds to get a bite to eat. When I left McDonalds, the car would not shift out of first gear. I have checked the transmission fluid and it appears to be good. I shifted from Park to low, and low back to park several times making sure there was no problem there. I noticed it also kicks hard when going into reverse, and it kicks hard when going into drive. When it is driven it will not shift out of first gear.
View 8 Replies
i have a 1999 mazda troy lee b3000. The truck has a 3.0 flex fuel and 4r44e and when you go to drive it. turn the key engine fires up but the trans won't shift into gear. Here is the back story.Bought the truck brand new in 99 I'm the original owner it was a daily driver up until 2 years ago. the truck has over 300k miles and still ran great but the camshaft was starting to go. I was gona replace the cam but came across a killer deal on a new engine. picked up another 3.0 flex fuel with 50k miles. drove the truck into my garage removed the old engine installed the new engine. got in the truck turned the key and the new engine roared to life.
I went to put the truck into gear so i could get it out of the garage and go for a test drive and nothing. went to put it in drive and again nothing. no matter what gear its put in it doesn't move at this point i was confused and decided to quit for the night. That was in 2011 its now 2013 the truck has just sat there sense then. I've tried anything and everything even went as far as swapping transmissions and computers with no luck. I took the trans apart I don't know how many times can't find anything wrong with it.
View 4 Replies
I own a 2002 Escape, 4WD 4cly manual trans. A couple of days ago, when I left work I stopped at a stop light. I shifted out of gear while I waited for the light to change like I always do. When I went to shift back into gear, I couldn't. I found that if I turned the key off, with the clutch disengaged, I could shift into gear without a problem, start the car up and drive away.
Since the first time this has happened, it has happened a few more times, always when stopped, once or twice while slowing down to stop (low RPMs). Besides all that, the car shifts fine while driving.
View 1 Replies
2003 Ford Exploreer 4x4 5R55W Auto Tranny. From driving the car it does not shift into 2nd or 5th gear. The O/D light flashes, and the check engine light comes on. Gives Code P0775, which indicates a problem with Solenoid 2.
This weekend I changed the Shift Solenoid Pack with a brand new one from Ford, and the exact same problems still exist. It's as if I hadn't done anything to the car. I have read somewhere that 2nd and 5th gears share a band in the tranny, could the the problem.?
View 14 Replies
My 2011 F150 limited started great bout 3 blocks away from home. The truck glitch. Then it wouldn't shift out of 3rd gear even at take off it was in 3rd. There was also a delay going from fwd to rev. With a clunk as it when in gear. I took it to the dealer ship. EVS Ford Random Lake WI. They were great fast and explained the prob to me. They had to reprogram the tranny. The temp sensor was wigged out n didn't know its own temp so it went into a fail safe mode.
View 1 Replies
My VSC and check engine light have come on. In addition now the auto trans will not shift past 4 gear with in auto or with me doing it manually. My local shop who has worked on this car before and is very good put the computer reader on it and got a P0500 for vehicle speed sensor "A". Today they put it on the real monitor and it reads a different code that says check engine code but does not reveal the code to read.
I really don't want to go to my dealer and get it hard. The car has 175,000 and until now has run great. I tried the gas cap fix to no avail. The shop did a reset when i first got there and it last 75 yards.
View 6 Replies
I have a 2004 Hyundai Santa Fe, has 99,000 miles 3.5L. After changing the alternator (alternator did die and drained my battery, the shop recharged the battery) now it seems be stuck in 3rd gear and does not wont to shift (it is a automatic). Fluids are good, transmission was flushed between 50-60,000 miles.
View 3 Replies
