I have a 2001 Audi TT, every time when I push the gas pedal down the car is shaking(not whole lot). I replaced one of the injection coils but still does the same thing.
View 7 RepliesMy 1995 Audi 90 Sport needs to have the acceleration pedal pushed very far, about half way, before the car begins to to move, also when the pedal is put all the way to the floor the vehicle only goes to around 70mph. And finally I am having trouble finding a shop book for the vehicle.
View 7 RepliesI have a 2001 F-350 Diesel 4x4 crew cab 8ft bed dually 7.3 diesel 6 speed. The issue is that the parking brake pedal is extremely hard to push. One day it pushed down and ratcheted into a locked position as normal and the next day I couldn't push it more than an inch down. I have rear disc brakes with internal drums in the rotors for the parking brake assembly. I replaced the shoes and hardware (which were fine) and I still have the same issue. I removed the front single cable from where it splits into the two rear ones and the foot pedal depresses smoothly and with the touch of a finger with no load on it. What else is it? The only other thing is one of the rear cables unless I am missing something?
View 5 RepliesMy 1995 Audi 90 Sport needs to have the acceleration pedal pushed very far, about half way, before the car begins to to move, also when the pedal is put all the way to the floor the vehicle only goes to around 70mph.
View 2 RepliesI have a 1995 Mustang convertible 3.8. Shakes when its started at an idle and as u push the accelerator, the shaking gets worse, in park, neutral, drive, doesn't matter. I have replaced plugs, wires, coil, torque convertor. I took it to precision auto tune and they said everything checked out computer wise but there is deffinately something wrong. Car shakes so bad its insane.
View 2 RepliesI've a wired problem, my Elantra 2008 gas pedal is being stuck on the first push down only, when the car parked for more than 3 hours for example, the first press on the pedal i feel it very hard then it accept the pushing with a sound as if something is stuck and got released, after the first push it become very normal till i park it again.
I greased the pedal but noticed it may be the throttle cylinder at the engine where the gas wire is going around, i tried to accelerate the engine by turning this cylinder and it is being stuck at the first then is loosen, i tried it spray it with WD40 but it is the same.
I have a 2000 LeSabre and every time you start the car and then push the gas pedal down it's hard to push, then it will break free and work normally for the rest of the drive, but the next time you get in to go somewhere else, it will do the same thing. If you "POP IT" real quick with your foot it will work just fine until the next time. Is this a cable issue?
View 6 RepliesI am a first time owner of a 2015 VW Golf TSI and TDI, previously drove an Acura RSX.
I am noticing on both cars, more so in the TSI, that off a dead stop, when I push the gas pedal there is a hesitation/acceleration delay that I am not used to.
Is this normal? I just want to make sure that nothing is wrong with my cars as I am not well versed in this stuff.
Also, if it is normal, what is the cause behind this? and can it be modified to remove this lag?
I just changed all my flex lines to stainless steel and my pads and rotors were replaced. I had some issues with calipers dragging. I used a power bleeder to bleed the brakes all the way around. Now my pedal feels really weird. If I push the pedal fast it brakes hard then it goes to the floor. If i just push it soft, it will just slowly go to the floor without braking at all.
View 3 RepliesI have the limited with the push start. In order to start the car, you have to push the brake in so far and then push the push button. Lately the brake pedal is really hard to push down after its been sitting for an extended period. Once its started, all is fine. Its almost like I've pumped it a few times first, but its not the case.
View 11 Replies1996 Jaguar XJ6 4.0 Litre Base, 43000 miles... While driving, this car, suddenly accelerator pedal becomes very hard to push and car will not move at all even if you press hard pedal to the floor( Requires a lots of force). If I put brakes on, shift the transmission to reverse and to then to drive, it will start moving again. No check engine light comes on and there are no codes stored in computer. This never happens on cruise control. Car starts flawlessly even on cold morning. Battery is new and charging system works fine. Spark plugs were changed at 30,000 miles so also direct ignition coil on cylinder No.3 .....
View 3 RepliesI recently had my rotors replaced and when I left the garage I noticed I had to press the brake farther than normal. A few days later, I have to press the brake pedal almost all the way to the floor. My brakes sound like there is an air leak when I push the pedal. Sometimes it stutters at the top of the push.
First question is what could it be? The second question is, could this have been caused by the rotor replacement? Seems awfully coincidental.
We have a 2004 Honda Accord V6 with 178,000 miles and the car is giving us some issues. We can drive the car for 10-15 minutes with no issues. Then when we push on the gas pedal, the car will not go any farther and the engine just revs. If we turn the car off and restart it, the car will continue to drive. There are no check engine lights on the car. Could these be a transmission issue?
View 5 RepliesWife just called on her way home from work and said the brakes grind when she pushes the pedal down. 08 with 39000. What am I in for and what kind of tools do I need? I'll pull off the wheels in the morning and take a look. Everybody seems to say the newer trucks go bad in the rear first,and she never uses the e- brake.
View 10 RepliesI have a Camry at 120K now. Front brake pads was placed at 85K and was told by the maintenance person at that time that brake rotors couldn't be resurfaced since they were close to the minimum thickness.
Braking seems still fine these days. I don't hear any high-pitched noise or feel obvious vibration/pulsation when the brake is applied. The brake pads are still within a good range of thickness as the last check was made a couple of months ago.
But the brake pedal is softer than before so that now I have push harder to get car stopped. It that a warning sign which indicates it is time to replace the brakes rotors and pads?
I've been noticing severe power loss lately . I know the 12 camry i4 has a bit of lag when acceleration but it's a bit worse now . I do have weapon r header , injen intake and magna flow muffler. I've cleaned the intake filter but sometimes the car feels as though it doesn't want to go then it does. I have to push the pedal down hard . I also have res delete.
View 9 RepliesRecently the brake pedal on my 2002 Prius has been a little harder to push for the first mm of travel it almost "sticks" requiring slightly more effort once it moves past that point it is normal no fading or extra effort required this problem has now progressed to the point where the pedal is kind of crunchy for the first 5mm of travel and occasionally will not return right away causing the brakes to drag a little but again pressure required to stop is exactly the same no fading etc
I am thinking since I live on 2 miles of dusty washboard dirt road and some grit has worked its way into the bushing .
I have a 1997 ford aerostar van that i recently acquired through some family,when i got it it was running fine but has recently started having troubles.The Question i have is this i put my car in drive or reverse and push the gas pedal the car doesn't move.....we have tried putting transmission fluid into it and that worked temporarily. What it could be except just a bad transmission?
View 2 RepliesJust noticed a clicking noise every time I push the clutch pedal down, I had my wife push the pedal while I listened under the hood and no noise it's coming from the clutch assembly under the dash! It's a 2013 only 4000km's on it so it's not like anything should be worn from over use etc. It's when I had the radio off driving I heard it, not super loud but more curiosity if it's normal noise from a clutch assembly.
As well the odd time I hear well my wife heard and pointed it out to me, when I push the brake pedal (more when we get in the car in the morning after sitting overnight) the same kinda sound more like when brake pad's are gently popping loose I guess you could say!? Like I said its mainly only after sitting for awhile, but we did hear it the odd time just as I go to slow down and only a quick 'click' again not deadly or anything more annoying that the car is brand new and we went brand new cause we were tired of creepy older cars we'd previously driven! I'm wondering if that may be exactly why its doing it since its new and need's to be used a bit to loosen up, this is the actually the first brand new no previous drivers car I've had!
The clutch on my 2003 Toyota Tacoma has been acting funny for a while. I have to pull the pedal back up with the top of my foot about half the time, otherwise it acts like the clutch isn't all the way disengaged when I push the pedal to the floor. The master and slave cylinders have both been replaced as well as the clutch pedal mechanism itself (thought it might be the spring). I adjusted the push rod a little bit and it seems to have worked slightly but it's definitely still a problem.
View 3 RepliesWhen i am driving more enthusiastically, i notice when i make, say, a 90 degree turn and then push the gas pedal down midway through the turn, i get a clunkish sound or a stutter. Its not loud and i can only feel it through the steering and through the car. It almost feels like it is shifting power to the rear, but i would think that it would do it smoother....
View 1 Replies