How to replace a blower motor in a 1990 Audi 80 Quattro? I looked for a Chilton and I looked online but couldn't get any info. Actually they don't make a Chilton for Audi during this year. And I couldn't locate any Haynes manuals either.
View 6 RepliesHow to change a 2003 toyota echo blower motor.... Looking for a step by step directions ....
View 2 RepliesOur 03 Civic recently went into the shop for a rotor replacement and the shop did an oil change for us while they were at it. My wife got the car back and she immediately noticed that the "AC" wasn't working. After asking a few additional questions (I'm not in the same city this week), it isn't the AC that isn't working, the fan/blower isn't turning on at all. We had the same shop check it out again and their response was that they weren't anywhere near the blower motor so this just has to be a coincidence. I could accept that but I'm still worried about a scam.
The car was in the shop just to have the rotors put on, not an oil change but they did an oil change for us anyway. (I was going to change the rotors myself but I couldn't get the caliper hangers off and it was 100+ degrees outside so I decided to have the shop mess with it), Would it be easy to sabotage the blower motor on this car?
I have a 2008 mountaineer that the blower motor runs on full blast no matter what. The switch bars go up and down but blower motor does not change speeds. also upon opening the hood I found 2 large mouse nests ,1 on passenger side fender and 1 center of engine towards the back. Are these related or could it be a switch issue. How to remove switch and test it.
View 11 RepliesA couple of months ago my Yaris was hit just behind the driver side door by a Ford F150, luckily traveling at a low speed. Other than body damage, my car seemed to be fine. After driving the car around for 2 weeks with the damage then taking it in for its 10 day repair, I brought home my wonderful little car. I live in Florida and even though it's winter, we had a rather warm day, just a couple days after bringing my car back home. I turned on the AC and ...nothing came out. So I tried it on higher settings and ...still nothing came out until I got to the highest blower setting. Suddenly it sounded like someone had turned a blender on inside my car but some air was making its way out of my blowers.
I called the shop that did my repairs and they said "well, you probably just blew a fuse. It's not accident related so we can't take care of it without charging you." My understanding was that I would not be able to get my blower to work at all if a fuse was blown, and my air certainly worked following the accident and prior to getting repairs done. If a fuse was blown, I'm willing to bet a lot of money that the shop was responsible. ...the fact that they also broke my glove compartment, got paint all over my seat, and made my car smell like a paint store also make me weary of using them again, but my insurance company swears by them. First of all, what is wrong with my car? Second of all, how do I fix it?
I have a 1990 Dodge Caravan complete with collector plates. I bought new bulbs to replace the burnt out map reading lights, but how to open the enclosure for the lights. There are no screws and no obvious places to pry open.
View 1 Replies I have a 1990 Mazda Miata, and the AC is not working. It has been switched over to R134a. I took it to a mechanic to have it recharged a few weeks ago. He said that one of the o-rings was cracked and so it was leaking around that. He filled it up and put some stop leak in it and for awhile it seemed to work fine. Then it stopped blowing cold air. I took it to a jiffy lube just to have the level of coolant (correct term?) checked. The person there told me that it was very low and was leaking around the valve stems. I tightened the valve stems and re-filled it. After 24 hours it had stopped blowing cold air again. I got a price quote on a new compressor and it is about $500.
So - my question is this - should I just put a new compressor in or is there something cheaper I could try first?
I have a 1990 buick lesabre motor is a 3800 and it runs fine until the motor warms up and then when i shut it off it won't restart for about an hour after i shut it off. It's not over heating it has a new fuel pump.
View 4 RepliesMy '04 Phaeton was towed Nov. 24 - completely dead, blower motor fan would not turn off...even powered OFF, with key out of the ignition! Both batteries were then drained, had to be replaced to diagnose...
Ended up being blower motor fan resistor. The tech said the ESP/ESC (?) light was "now on" where it was NOT on before all this. He did not run a diagnostics, not sure why. And not sure why service manager didn't mention it before I paid and checked out. :/
But NOW the car is doing some funky things.... upon start-up, whether pulling out in drive or backing out in reverse, the brakes (or SOMETHING ??) seem to be erratically grabbing, there is an awful grinding/scraping noise, the car jerks and stutters and hops, just for a few seconds, then something seems to "give"/"release" and the grinding and scraping and jumping stops and I roll on like normal. BUT the ESP light (that is now CONSTANTLY on), BLINKS/FLASHES when this grinding and stutter-stepping happens. It sounds awful, it feels awful, and it's making me nervous. Of course I contacted VW service immediately, and they're saying I can bring it back in to run diagnostics.
I know for a fact the car was completely dead, NOTHING worked, as both batteries were "fired" according to VW.....so nothing between the car dying and the batteries and blower motor being fixed transpired -- except the towing. And my guess is the had to DRAG it onto the flatbed in PARK b/c it would not take a charge at all to put in NEUTRAL.
I have a 2001 GMC Jimmy and I am having an issue with the blower motor. Speeds 1 and 2 do not seem to work. Speeds 3 and 4 work fine. This is the manual climate control not the automatic. I searched and it seems everyone usually has a problem with the high speeds & not the low speeds...
View 9 RepliesMy wife heard a humming noise on a 200 mile trip to Long Island last week. It was loud enough that she was concerned about it and took it into a Toyota dealership to have it checked out. Of course, the noise went away, and they assured her that the car was perfect!
When she came home, I drove the car and the noise came back. Radio was off and the frequency of the noise changed with the AC/heater blower speed. Turn blower (fan) off, and the noise completely disappears. Before I got home, noise disappeared again with the fan on. I believe it is a bad bearing in the blower motor.
I'm getting this weird chirping noise from what sounds like the A/C and Heat fan. When I turn it down it is noticeable and sounds like something needs oiled. Kind of like pieces of plastic hitting each other over and over again. When I turn the air up there's no noise but probably because the air rushing out is so loud. I'm thinking I may need to take something out and oil it up. Too cold here to do my own thorough investigation.
View 4 RepliesMy prius that I got about 1 1/2 years ago (2013 model) was making some noise. After conducting a few experiments I came to the conclusion it was the heat that was causing it. I removed the glovebox and lower plastic panel as well to see if it was actually the blower that was making the noise. And it was the blower.
So now it's like 20 degrees outside and I haven't used the heat because I didn't want to blow something so gotta get this fixed ASAP.
Like I mentioned glovebox and lower panel are open I've removed 2 of the 3 screws necessary to remove the blower. So the problem lies with the 3rd screw. There is a plastic socket with wires that is preventing me from reaching the 3rd screw so I have to remove that socket. So I have a couple pictures and how I can remove this so I can access the blower motor.
Also isn't it strange that the car isn't even 3 years old and the blower is giving me problems?
How to replace blower motor in 01 Prius. There are no way to get from to it from under the glove box.
Blower motor was working fine. I decided to remove cabin filter. Filter had not been changed for very long time. There was a lot of dirt, pine straw and leaves on top of the filter. When I removed the filter a lot of dirt fell inside the motor. Ever since then motor is working on and off. Often have to hit under the glove box and it works again for a while. Tried to remove the blower but could not get to it.
Several weeks ago, the blower motor in my 2010 stopped blowing. It came on within a day or so, but failed again, so I replaced it with a new part from Rock Auto: TYC 700249.
The new fan just stopped again. I plugged the harness in and out several times and it did briefly come on a few times, but clearly something else is going on.
I don't know if it's relevant, but after I took out the OEM fan, I experimented by removing the plate from its back that has wires and capacitors (actually, I don't know what I'm talking about) and connected the main prongs directly to a 12V battery. It came on right away. I installed the new fan anyway, figuring it was the plate/wires assembly portion that was bad. The "resistor?"
I recently got another blower motor for my vibe. Got it installed but nothing happened. I replaced the resistor as well. Once I found the secret hidden fuse panel I found that the 40a fuse was blown. I replaced it and it blew instantly upon turning the ignition on, the resistor was unplugged at the time. I am wondering if there could be a short in the wire harness.
The blower went bad a while ago and blew a resistor, I replaced it and it ran for a while until some smoke came out of the dash and then nothing.
So my AC only works on 4 (no 1, 2, 3). I replaced the resistor as is often the culprit. NOTHING. Still only works on 4. So I unplugged the resistor all together, still only works on 4. So, either my new replacement resistor is also bad (unlikely), or it's the blower motor.
View 1 RepliesMy girlfriend has a 2005 accent and recently the blower motor started working intermittently.. After a couple of days of it coming on and off it now wont come on at all.. After checking the 30amp fuse under the hood, and the relay they all seemed to be in good shape, I even swapped them out with other fuses and relays to make sure that wasn't the problem. I checked for power at the Motor and it has 12 volts going to it when the fan switch is on.. so I pulled the blower motor itself and connected it directly to a 12 volt source and it worked, eliminating the possibility of the motor itself being seized. Now I read up on a few sites on how to check the resistor, so I did a few continuity tests on the resistor itself and didn't see anything out of the normal.. What I should check next or what the actual values on the resistor check I should be reading..
View 1 Replies12 Santa Fe, I decided I better give it the once over. I found the cabin air filter was pretty bad and that surprised me because I don't drive in dusty areas etc and usually don't drive much at all any more since I got a company car but anyway....to the question: AFTER I changed the filter, making sure the airflow arrow was correct, I noticed that the blower motor is much noisier than before especially when set on the higher fan speeds. The sound is much like a off balance fan with a bit of a thump to it. Could I have dropped some of the dead bugs into the fan when I changed the filter? I was careful and didn't see anything fall into the fan area but the noise is annoying as heck. Is this something that would be covered under Hyundai's warranty? Headed to the Florida Keys Saturday and not looking forward to hearing that racket all the way down there.
View 3 RepliesToday i had my ac running and switched the speed from 3 down to 1, then poof totally went off and will not come back on at all. I tried replacing the resistor, still nothing. Next tried the blower motor, still nothing. Then replaced all the fuses, still nothing. The compressor is kicking on. Can here the click under the passengers side when turning ac on, but the blower motor is not coming on.
View 1 RepliesWhere blower resistor is located?
View 6 Replies