Engine will turn over but not start. it is getting spark and gas I checked coil, replaced plugs and distrib. I checked timing and firing order. Since there is spark and gas shouldn't I at least get a backfire?
View 6 RepliesI have a 1992 Aerostar with a 3.0L engine. For the past few weeks she intermittently didn't want to start but eventually always did. I replaced the fuel pump relay because she always have had problems with that. The relays are loose and get wet. Anyway, I thought i fixed it because I didn't have any problems for about 2 weeks. But one day didn't want to start again. She finally started and took her home.
Now, no matter what she wont start. I did some tests and there is gas been pumped but I don't have a spark. I put a new ignition coil and a new ignition module and still no spark. If im right, i only have 2 things left that could be the culprit, the profile ignition pickup, and/or the computer. Is there any other reason that could be the problem? I read online that in order to replace the PIP i have to take apart the distributor. Is this true?
My Ranger was running great when suddenly on the highway it just died. I towed it to local nationally known brake/ muffler shop where a good friend is the manager. He narrowed it down (guessed in my opinion) to no spark and no fuel. He thinks it could be the crank sensor, the fuel pump or the ignition module. Is there any way to pinpoint the problem without replacing parts? It will sometimes start and run for about 2 seconds before shutting off. It will not repeat this unless it sits for a day or two. I am not sure if there are different 2.3 engines available but mine is fuel injection and has two sets of spark plugs and wires.
View 9 RepliesThe last few days, when I would start my 1990 Acura Integra (morning or afternoon after sitting at work), it had just the slightest hesitation before the engine would start or "turn over", if that is the correct term.
Sometimes I just thought I did not have the clutch engaged the whole way and did not worry. This morning I went to start it and it hesitated again, but now won't start at all..makes the clicking starter sound after a second attempt, but nothing else. NO lights were left on!
The Battery (Duralast Gold 8 year battery) was replaced in Feb 2011, the Distributor in August 2011 and the Distributor in 2007. Could it be the latter?
My '92 Integra has ~280K miles. A couple of years ago the tachometer started "bouncing" up and down while the engine seemed to run fine. Some time after, it started to hesitate under acceleration. A few months ago the car died while driving along the highway. The tachometer went up and down as the engine cut off and came back on before finally dying. A tow to the repair shop lead to a tune up, changing of spark plugs, wires, distributor cap and the ignition coil. That got the car running again, with its usual erratic tach and hesitation on acceleration. Then, the car died again in a similar way while driving. I was found to have a dead battery. Replacing it got the car running again...but the tach is still erratic and the car still hesitates. I am concerned that there is still some underlying issue that has not been fixed. I sometimes think it is a loose connection because there are times when the car seems just fine, but that is happening less frequently.
View 3 RepliesI'm the original owner of a '92 Integra (~130K miles) and I have an intermittent squeal when turning, which sounds like rubber against metal in the front of the car (maybe even from the steering wheel). It happens only when turning, and only at certain positions of the steering wheel during any particular occurrence. It is speed independent but velocity dependent: it can happen on an on- or off-ramp at 50mph or turning into my driveway at <10mph, and if I move the wheel a little either way it will go away but return when I move the steering wheel back to the "squeal" position. It might happen one day but not the next day. I actually was able to reproduce this for my mechanic, but they found nothing and said the front end looks good. The tie rods were replaced at ~100K miles, and the engine mounts were replaced at ~120K miles; I got new tires at ~110K miles; the squeal doesn't seem to correspond with any of these repairs/replacements. What is going on that could be checked out.
View 1 Replies96 teg 1.8 non vtech after a while it will lose spark some times it runs for a few days then loses spark but will start up with in 10 min sometimes it just just stalls out and loses spark but restarts with in 10 minutes.
View 1 RepliesMy car dash board will start up when i turn over the key but thats all it will do i dont even get the sound like its about to start it was just working yesterday what do i check...
Honda civic lx 1992
My daughter owns a 1992 Honda Accord wagon, she cannot get it to start on colder days. Sometimes she goes out and runs a hair dryer over the engine, it works, but it is getting worse. Her husband says that is ridiculous to do.
View 2 RepliesI have a 1992 Toyota Camry. About once every 15 to 20 times I turn the ignition, the car won't start. Sometimes there's just a click and then nothing, and sometimes all the lights on the dashboard will flash for a second and then nothing, in each case the starter does not turn over. However, I discovered that instead of needing a jump from another car, if I just connect the jumper cables to the battery and leave the other end of the cable on the ground, the car will start right up after this happens. One other note, the clock is always reset after this. What is the problem and how can this be fixed?
View 6 RepliesCar had been running fine and all the sudden turn the key and get nothing. Dash lights come on and there's a click in glove box but nothing from starter. I have 0V at ignition post on solenoid with key in start position. I can short the 12V post and ignition post with screwdriver on solenoid and starter and engine crank as normal but car won't start. Further checking I have 0V key off at ignition module, 12V with key on. A connector outside firewall between ignition switch and transmission neutral safety switch. I took this apart, it was a 7 pin with 2 of 7 blank. The red wire I had 0V key off, 12V key on.
Then I dug into the steering column area. 12" or so down from the key there is a connector with a rod coming from the key area down into it. I assume this to be the ignition switch. The rod is supposed to move and is attached to a plunger that pushes into the connector. I assume this rod is attached to the key. When I turn the key the rod never moves. So I thought ok clamp some pliers on the rod and push it into the connector manually, it should make connection and start the car. When this had no results I am now at a loss as to where to go next. Further thought, how did I get the 12V readings in several locations with key on if ignition switch appears to be faulty. I'm not sure if it's faulty or not, things don't add up. I didn't dig into the steering column where the key is yet because I will have to remove airbag and steering wheel to do so.
1992 Fod Explorer XLT: When I attempt to turn over the engine, the flywheel spins, but the engine doesn't. This is a very gently driven vehicle. I drove home hone day, backed into the driveway and unloaded the groceries. The next morning, when I tried to start it, the engine will not turn over. I dropped the starter and tested it--all good. While I had the starter off, I found I could spin the flywheel freely--appears to not be attached to the engine. It's tight with no play whatsoever. Last year I had a new flywheel installed--something I would do myself, but decided I'm at the age, I'm just not up for it. It's been running great for 18 months with no problems. There was never a noise. This just happened one morning. I thought the crank may be broken, but that seems unlikely since it was driving great until the next morning.
View 13 RepliesWe have a 1992 Pontiac grand am 3.3 liter our problem is the cps sensors supply wire is reading .332 of a volt the ecu power supply is reading 12.0 volts have not done wiring before this was for a friend. the motor was in pieces in the trunk all back together now but no spark, seems like a electrical short somewhere but a new to electrical diagnostics.
View 1 RepliesVEHICLE: 1992 Ford Explorer, 4.0, 4wd Automatic, CALIFORNIA EMISSIONS w/ 59,000 Miles...
PROBLEM: Engine rolls over great, BUT No Spark, No Fuel
Here are the tests I've done:
- Each and every relay √
- Each and every fuse √
- Ensure inertia switch hadn't popped √
- Directly connect 12 volts to pump & pump came on √
- By-pass inertia switch √
- Replace PCM √
I'm thinking it's time to start checking grounds and chasing wires....
My Neon needed a water pump. At 204K miles the timing belt should be replaced also. The pump and belt were replaced. The motor started and the car drove about 1000ft. and stopped. There was no more spark. The car was checked to make sure that the timing belt is on correctly. The cam points to top dead center when the #1 cylinder is at peak and the crankshaft is at top dead center. Both marks align. When the key is turned the starter tries to turn but the engine does not spark. Electricity goes to the coil pack. 1998 Dodge Neon 2.0L SOHC 4 cylinder....
View 2 RepliesI have a '92 Honda Accord LX and has 200,000 mi. When I tried to start the car it will not start. The engine will not turn over and a rapid clicking will follow a few seconds later. I do not think its the battery b/c the radio still works as well as the lights. I'm suspecting it might be the starter motor or the solenoid?
View 2 RepliesCar: 1992 GMC Sonoma 2.8L Manual,
Miles: ONLY 197,000 miles...
Symptom: Sometimes won't start (not even turn over) when engine is warm. It doesn't die or anything it just won't start if i've been driving for more than an hour and I say, stop to get gas or something. It doesn't make an sound, not even a click. This has only happened to me about 3 or 4 times in the last 6 months.
Fixes: I have not had a mechanic take a look at this yet. They usually complain about other things when I bring it in. Little things like "your brakes are almost gone" (big deal, I don't need breaks because it is a stick shift) or "your tires are showing their metal wire" (big deal, I've had a front tire blow out before at 70 mph... on this same truck come to think of it).
Current workaround : The following three things work to get it started every time:
1. A jump starts it right up
2. Push start starts up real easy (I've done it by my self on flat pavement
3. Wait for an hour or two (not always an option)
Feeble attempt to diagnose: My feeling is that the starter motor is beginning to go but are there other things that can cause this before I pour money into fixing the starter?
'92 Dynasty is a good runner, but, once the engine gets warmed up, I shut off the engine at my own risk. If the car sits for a while with the hood open, it will start again, but attempting to start immediately after shutting off will result in the engine spinning over but no sounds of attempted ignition. It seems that once the coil is cooled down to slightly more than body temp the engine will start like nothing was wrong.
View 3 RepliesI have a 1992 Toyota Corolla that will not start in the summers when the engine gets hot This is the 3rd summer it has happened as I attempt to run errands on the weekend and make several stops. After the 2nd or 3rd location, the car will not start. I must wait 30-45 min. for the car to cool down. I have called tow trucks before and by the time they get to me they are able to start the car. They always check the battery and tell me it is fine. I even bought a new battery just to make sure the first summer it happened. Obviously something is heating up, but what?
View 4 RepliesThis Geo Metro 3 cyl engine cranks with spark, but won't start. I replaced the fuel pump, fuel filter and fuel pump relay. The fuel pump does not make a noise. What could it be?
View 12 RepliesWhat may have my son fried by reversing the polarity while jumping the battery in his 95 GMC pickup? The smaller wire coming off the + terminal was burned through,so I spliced that. The engine cranks but there is no spark.
View 3 Replies