Acura - Legend :: Sticky Clutch - Pushed Pedal And It Would Not Return Or Allow Gear To Engage
Aug 15, 2013
1988 Acura Legend, 2.7L 6 cyl., 181,000 miles only do 6,500 miles a year to train station, parked inside, runs great. Last week parked out in hot sun, '90s, for 8 hours. At first, no problem. When did errand and returned to car, pushed clutch pedal and it would not return or allow gear to engage. "Jammed" into 1st, then could not shift, shifted slightly by pulling up on clutch pedal with my foot. Parked overnight, cool, next morning seemed to be fine and crept to mechanic. Mechanic road tested and found no problem and now seems to be working okay. Would parking in sun, high heat cause "clutch cylinder" to "seize" or "freeze"? Is there a "fix"? Also, increasingly hard to get parts for this car.
View 6 Replies
Advertisement
My clutch peddle made a slight "snap" sound last night and now it is very difficult to get the car to engage in a gear while sitting still, while moving it does ok, but not nearly as smooth as it should be. The other odd occurrence is that while the motor is running and the car is not moving, you can't shift any gears at all, but as soon as you cut the motor, all 5 gears and reverse are easily accessible. Why the sound at the peddle and the trouble in the gear shift mechanism? I am only an advanced beginner with car repair, but I think think this is really bad... 2007 Honda Accord Manual Transmission
View 8 Replies
I recently had the clutch replaced on my 2001 Subaru, now the clutch pedal is sticking, could this be related to the clutch replacement or is this something else? I didn't have such a great experience with the mechanic that did the work so I don't trust him to tell me truthfully whether it's possibly a warranty issue or not. The problem happens intermittently. I'll push down on the pedal and when I release it it will only come back up half way. If you tap it with you toe it pops right up. Doesn't seem to impact the functioning on the vehicle.
View 3 Replies
My B5's clutch started not returning by itself when the really cold weather started. When it gets warmer it starts to spring back up. I called the dealership and the initial cost of looking at it takes me somewhat aback. I've already spent quite a bit on it last year. Reading some of the threads on other car models I've seen mention of clutch master/slave and fluids.
View 10 Replies
Experienced a chatter in the clutch pedal with the a/c on when clutch pedal is pushed in. To me it feels like the throw bearing isn't disengaging the clutch fully, plus my clutch is kind of high once full disengage unless its normal.
View 5 Replies
Over the past week I have noticed leaking brake fluid and after my STOP Brake failure light came on I topped off the brake fluid and it is down to a low level again. I also notice that the clutch pedal (manual) does not return all the way when the brake fluid is low and I assume they share the same fluid. I'm going to take it to my mechanic but could this be a clutch problem or just a fluid leak.
View 1 Replies
So... I have a 99 Subaru Outback 5 speed that I love the hell out of. Anyway, recently my clutch pedal has started momentarily sticking mid return. The clutch appears to be fully engaged, but the pedal sticks, or hangs for a moment before popping the rest of the way up. Once, and only once so far, it stuck completely just for a moment before returning after being depressed again. I'm not sure how concerned I should be, and given that the car is new to me I'm still trying to familiarize myself with it.
View 4 Replies
So, I think that my clutch pedal return spring broke yesterday in my Focus 07 Hatchback when I was at a stop sign. I let out the clutch and felt and heard something like a small cable breaking. Now the clutch still operates fine, but it is softer than before. If it is indeed that little spring, can I still drive it around for a few days until I can get it to the dealer?
View 2 Replies
My clutch has been feeling very strange lately, and has had a mind of its own. I have looked underneath myself, and have even taken it in to two transmission speacialists and they can't figure it out. The master cylinder isn't leaking, and the slave cylinder is fine as well.
Here's what is going on with my clutch...
- I will push in the pedal, and there will be ZERO resistance until about 1 inch from hitting the floor, then all the pressure is there, and I am able to shift. However, sometimes I won't even be able to put it into gear because the clutch won't engage.
- Then I will pump the pedal, and slowly I will gain a little more room on the draw of the clutch, and it will feel fine. All the way to the point where a few days later it will be driving like new.
- Then it will start feeling funky again a few days later and the cycle starts over.
I drive a 2003 GTI 20th AE.
View 6 Replies
Today I went to start my car and let it warm up and everything worked fine and it started regularly but when I went to go drive the car and put the clutch in the pedal didn't return and I could not put it into gear, need to identify the problem.
View 4 Replies
I recently found out my motor mounts are bad. Almost a year ago I noticed I was leaking coolant so I just filled it with water every time it was empty. Now I have been getting an overheating problem if it's not filled to the right amount. Just yesterday the problem got worse as there is green gunk at the opening of the radiator and it's always hot. The reservoir is filling up with hot water a lot of the time. My radiator will be empty when that happens. As I was driving the gauge was reading hot. Turning on the heater didn't work much. I tested it tonight, with the radiator full and 2 cups water in reservoir. Drove it a few blocks and turned off car. Radiator had lots of pressure and hot. The reservoir was same level.
View 6 Replies
My acura legend is now starting to not shift in d4 or d3 after it has been driven for awhile.... It only shifts to 2 and 1.... So I drive it in 2 but it doesn't sound right or drive right I can definitely tell the difference... What is going on what should I do???
View 1 Replies
I have a 2007 Tacoma 4 cylinder 5 speed. The clutch pedal started sticking about a month ago and has only happened a hand full of times. When the pedal is pushed to the floor it would stick, I thought it was hanging up on the floor mat at first but that was not the case. I went out to move the truck today and the pedal immediately stuck to the floor. Like usual I tapped the pedal kind of on the side to get it to release. the pedal then came back up. But now it wont push back in at all!!! There is only 1/2" of travel on the pedal and stops solid. It's like it is binding up on something. The spring seems to be in place the right way and nothing that I can see obviously wrong.
View 4 Replies
My 1991 Acura Legend LS does not start in cold weather and in the morning. Once it does, it keeps on starting and runs great. Prior to catching and starting it rattles and shakes and when I press the accelerator, it makes sounds like it is not getting enough air. The problem occured abruptly after a mechanic tried to find out why the radiator fan does not come on. That has been fixed by putting a new relay. The car has 176,000 miles and has never given starting problem before.
View 6 Replies
My car doors creak very loudly when opening/closing. It's embarrassing. I have tried 3 different sprays: Silicone spray, WD40, and PB Blaster! None of these worked and now I don't know what to do. I'd like to fix minor problems myself instead of always having to go to a mechanic and having them charge me an arm & a leg. The only thing I do notice on the hinges of the doors is rust. I have had this car for 1 1/2 yrs and they've been creaking for about 6 months. I live in the city and nowhere near the ocean or out in the country where you find sand. So I just don't understand why this happened.
View 6 Replies
1991 Acura Legend 6 cylinders
For about a week, my car was hard to start, and very sluggish upon acceleration. By Friday, the car was not getting over 20 mph, chugging, and semi-backfiring. I took off the valve covers and found quite a bit of oil in the 2nd cylinder, along with a crude covered ignition coil. I replaced all 6 spark plugs (properly gapped) and bought a new coil for the #2 cylinder. I also replaced the valve cover gaskets, and all 6 rings to prevent more oil seepage. After putting everything back together, making sure wires were correctly aligned, the car will not start. It cranks, but does not turn over. I put the old coil back on, and it did the same thing- crank but no start. Have I lost compression? How can I restore compression? The engine sounds so close to turning over, but not quite there. I'm stumped.
View 10 Replies
I have a 91' Acura Legend (lots of miles 179K) and makes a sound of a sick lion/ steel hammer. When I turn it on, automatically it rev's the RPM's to 1.5-2000, and I will usually wait a few minutes before it reduces RPM. When I put it in any gear it will make a pound (like steel) from the hood. When in drive I have to slowly accelerate or the pop continues then follows with a sick almost grinding (like a Lion has a sore throat)sound. If I barely push on the accelerator it will drive slightly normal or (sometimes) slam on the gas. What do you think?
View 3 Replies
I have a '93 Acura Legend type 2 which I love. However, last week I jumped it because I don't drive it much, unhooked the jumper cables, let the car run for about 10 minutes; I was ready to go so I turned on the headlights and the car immediately just died, like COMPLETELY. No lights, clicks or any electrical activity of any kind. Complete deathly silence. I assume it's either a main fuse, relay, or else (gulp) a short somewhere.
If this could be a fuse or relay, which one(s) it could be?
View 3 Replies
My 87 Acura Legend with 210,00 miles has an automatic transmission slipping problem. Car will not start moving when in the D position (slips), but if i shift manually to 2 , then S3 , it shifts ok except for some shuttering when shifting to D at about 35 mph. It also does not lock into Park when shifting to P position( car will roll when on a hill.) The shift cable and adjustment are ok. The S3 light does not blink and there are no codes stored. The trans fluid was changed 5,000 miles ago and level and condition are both good.( I have only used Honda fluid for the life of the car and change it every other oil change.) I removed the shift solenoids to find all of the screens clean and all solenoids clicked when 12v applied. At this point i realize i probably have an internal problem (possibly bad clutch pack?) My question is why doesn't the parking pin lock? Is this related to the slipping problem?
View 2 Replies
OK, so go out to my 1994 Acura Legend, crank it, hear a loud hum that doesn't go away, then bluish smoke appears from under the hood. Immediately shut off the engine and open the hood to release the smoke. Haven't touched it since.
View 3 Replies
What is wrong with my car. It drives fine for a while every day then out of the blue starts hesitating and sounding like it wants to shut off when we're at a traffic light. It gets worse when I am making a turn, like it hesitates to pick up speed and starts like sputtering. When my car does this the muffler starts smoking really bad. The smoke is not a black color it is white. When it feels like it's going to turn off, I have to put it in Neutral then it stops. They did say the fuel pump wasn't bad so I am assuming spark plugs??? What may be causing this problem?
View 3 Replies
