Yukon :: 1999 - ABS Light Comes On / Speedo Goes To Zero And Trans Won't Shift
Aug 28, 2013
A couple weeks back my 99 yukon died after hitting a large bump, found that the IGN A fuse was blown and kept blowing new fuses so I started digging and I found a slightly bare wire from an old remote start install that was touching the steel dash, problem solved I think. A few days go by and the ABS starts cycling about every 10 or so brakes, which is wierd, then ABS light comes on speedo goes to zero and trans wont shift, stays in 1st gear but every now and then speedo starts working trans shifts and you can drive but then speedo drops and wham feels like nuetral but really its back to first gear only if you rev it high enough, then the speedo starts on off on off on off gears work then dont then do and so on. What the heck is going on ?
View 3 Replies
Advertisement
Just fully rebuilt transmissin 4r75 replaced all planet gears clutches etc. Now with it all back together the speedo does not work on truck goes into limp mode. I replaced the vss sensor an no luck
View 8 Replies
I have a abs light on, no speedo until 30mph, cruise works, overhead display went dim and the overdrive light flashes while moving until the speedo kicks in. I pulled the abs sensor rabs only and ohmed out at 2.7 cleaned and reinstalled with no change in the problem I also disconnected the battery's and reconnected. What should the sensor ohm out to? What can I check next? I drive the truck daily.
View 1 Replies
My Yukon, with 140,000 miles, will sometimes start/fire up right away but other times it sluggish to start and then when it finally does it will shake for a while. Also, sometimes when idling at a stop light it will shake. It will also shake sometimes when I get around 60-70 mph. The rpm's are fine.
I replaced the fuel pump last spring and had a tuneup last summer. What could be causing this? I've had my mechanic look at it and he's hooked up his handheld diagnostic tool to it and it never shows any codes.
View 2 Replies
I drive a 2008 Elantra and had a mouse chew the wiring harness from the output speed sensor on the transmission to where the wires diverge from the Engine harness. It was still able to drive but the transmission stayed in third gear, the cruise set light stayed on and the check engine light came on.
I had noticed sluggish shifting before this happened and assumed the speed sensors needed replaced so I purchased the input and output sensors (42620-39200 & 42621-39200) and that is when I noticed the wires missing. I've checked the harness for other potential mouse foolery, took the old connector to the output sensor soldered wires to it and reconnected them to the engine harness. On a test drive after rewiring and replacing the sensors the car still stays in third and the set light is still on however the check engine light is not on anymore. At this point I'm clueless what to do next besides drive it to a dealer.
View 2 Replies
99 grand prix gt. 4t65e trans. 170k miles. way above avg for life expectancy. 1-2 shift is ok. Will not shift into 3rd. If you keep increasing vehicle speed to about 45 or so, it will shift into 3rd and than immediately into 4th. 45mph is about 4k rpm. I can see the tach drop to 3k rpm for 1 sec or so and than it drops to 2k approx. It will stay in OD and does not slip. If I stay at 50mph or so and punch the gas, I can make it shift into 3rd gear and it will stay in 3rd as long as i give it 2/3 gas. Once i left off the gas it goes back to OD. Any theories why it wont hit 3rd on the way up but will easily drop from 4th down to 3rd whenever I want? I know, its time for a rebuild.
View 2 Replies
I have 1995 Toyota Avalon w/173K miles. It’s in good shape mechanically and cosmetically. My 16 yr old daughter is the primary driver. I have extensive service records and have replaced the springs/struts, o2 sensors, and a few other bits. My question is related to hard shifts and a check engine light. During the summer the trans shifts normally. In the fall & winter, when temps dip below 50 degrees, the trans shifts harshly and the check engine light blinks indicating a trans solenoid is defective. The trans fluid has been flushed twice, most recently in Oct 2008 at the Toyota dealership. My theory is the techs filled the trans with a heavier weight fluid than is necessary and that is triggering the codes.
View 1 Replies
i have a 1999 mazda troy lee b3000. The truck has a 3.0 flex fuel and 4r44e and when you go to drive it. turn the key engine fires up but the trans won't shift into gear. Here is the back story.Bought the truck brand new in 99 I'm the original owner it was a daily driver up until 2 years ago. the truck has over 300k miles and still ran great but the camshaft was starting to go. I was gona replace the cam but came across a killer deal on a new engine. picked up another 3.0 flex fuel with 50k miles. drove the truck into my garage removed the old engine installed the new engine. got in the truck turned the key and the new engine roared to life.
I went to put the truck into gear so i could get it out of the garage and go for a test drive and nothing. went to put it in drive and again nothing. no matter what gear its put in it doesn't move at this point i was confused and decided to quit for the night. That was in 2011 its now 2013 the truck has just sat there sense then. I've tried anything and everything even went as far as swapping transmissions and computers with no luck. I took the trans apart I don't know how many times can't find anything wrong with it.
View 4 Replies
2008 f250 abs light, check brakes fault, speedo don't work! I was hauling a car the other day and all of a sudden all these lights and faults came on then my speedo quit working and also the odo don't calculate mileage. I changed the speed sensor at the top of the rear end and still nothing. Cruise control also don't work..
View 14 Replies
So when I try to kick into 'passing gear' in this '01 f250 5.4l, i get no tranny shift. Whether I'm in tow/haul mode or not.
View 10 Replies
Iv got a 2003 6.0 stroke with 212k miles on it. Runs like a top. Done a slew of work from injectors to hpop, 2 alternators, intake, exhaust. NO tuner! Stock. Anyway recently I started the old girl up, warmed up a bit and shifted into reverse and truck did nothing. Went to drive and same thing. Held brake and revved it up and it dropped in gear. Shifts fine after that. No issues other than the occasional NO shift from park problem. Iv dropped pan and replaced all filters recently.
View 2 Replies
The kid at body shop called, he has the cab ready to swap onto the 04 gas job except for the shifter cable at the trans. I have never done one either, and do not know how to take it off. I thought it was like the old trans where it was in a plastic grommet, but the cable almost looks like it is grafted to the trans. How to get the cable off the trans shift arm?
View 2 Replies
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 Replies
I have a 2006 F250 with the 6.0 PowerStroke and automatic transmission. I just purchased this truck at an auction about a month ago.
Today I notice the transmission is not shifting into overdrive. No warning lights. If I press the tow/haul button in no change but the tow/haul light does come on. If I press it again (to turn it off) the tow/haul light goes out but still the transmission will not shift into overdrive.
This leaves me at about 2000 RPM at 68 MPH. I just had a Ford dealer perform Transmission service last week. (20,000 miles after the last recorded service.)
I am already not happy with the service I received at the dealer so I am really hesitant to take it back to them if it is something not related to the transmission service they performed.
View 5 Replies
I have a 99 f250 with some procomp (325s) that are 12.5 wide with a 6in lift my superchip tuner can change the trannys shift points but I am pretty sure a new gear ratio is needed. I dont do a whole lot of off roading with it its mainly my driving around and highway rig whats a good gear ratio that would work for me
View 9 Replies
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 Replies
Every time I replace the fuse(under the hood) it blows almost immediately and no interior light work. When on all doors and overhead lights do work so I don't believe it's one of them shorting. Even tried bigger fuse.
View 5 Replies
Having issues with the gauges in my truck. Usually only in the mornings, the tach will quit working and the speedo will go to 70 or 80 (this morning 100), the check gauges light comes on and the tranny is stuck usually in 3rd (auto). The indicator light for the gearshift (P,R,D,3,2,1) also goes out. I swapped out the fuel injector spider a while back and that's when the problem began.
View 1 Replies
2006 Azera air bag light stays on all the time in the speedo cluster panel when I start the car. Is it a fuse problem, sensor problem etc? Is it covered under the recent recall?
View 1 Replies
Bought a truck that has the speedometer face that reads KMH on the top in the big numbers and MPH in little numbers. Ideally, is there an decal or plate I can affix in front of the KMH plate that will reverse those so that MPH is the more prominent? Or, worst case, where can I get a new plate for the instrument cluster. It's a 2012 F-350 XLT gas.
View 10 Replies
2005 Dodge Neon SXT 2.0 engine
At first I would have an intermittent jumpy speedo then today it got worse and all of a sudden the check engine light popped on. Got it scanned and had three transmission related codes come on including the gear one incorrect ratio code (can not remember the other three). My first suspect was the VSS output. Replaced the sensor and took it for a test drive; no speedo no shifting. Took it back and and got a new one same issue with the replacement.
The tranny fluid was recently changed just after 203,xxx miles. Believe I am the third owner of this car. Seems to have been well cared for in the past. Recently also did some other work that was not transmission related when I first purchased the vehicle.
View 8 Replies
