Windstar :: 1998 - Oil / Moisture In Throttle Body And Air Duct Hose
Feb 22, 2008
I have a great running 98 Windstar. It does not overheat. The oil looks like it needs to be changed but it is not Coffee Colored, as the picture. The PCV valve looks clean, and rattles. I replaced the small 2 inch hose at the PCV valve on the back valve cover since it looked weak in the middle and may have been collapsing. I no longer get the big puddles of OIL/WATER on the ground, that I use to. I cleaned the oil/water out of the Intake Hose of the Throttle Body, but I still see some of the mixture underneath the Air Instake hose after a long drive.
I will go by the Ford dealer and buy another PCV valve, and replace the small curved hose going to the top of the engine near the Throttle Body that the other end of the PCV connects. Someone suggested that this could be cracked, and it does have some small cracks in it at the bend.
I have read that the 99-00 had a design problem with the Valve Cover, and it allowed oil to be sucked out and give similar problem. But since this is a 98, I am just looking for pinched hoses, or leaks. Car runs great, and hoping that I can find the reason that oil is being sucked into the air intake.
Do I have it correct that during normal operation, that the moisture and gases are sucked up out of the engine thru the PCV and into the top of the engine. And that the other Valve cover hose is going in the other direction or from the throttle body to the Valve cover?
Just trying to determine if the oil/moisture mixture is coming from the front or rear (PCV) valve cover. Getting no codes on the engine.
View 14 Replies
Advertisement
The inter cooler to throttle body hose and it seems to have coolant all over it.
View 12 Replies
93 fleetwood - bought new - sounds like water sloshing around behine the radio in the a/c ducts. also when fan is on, it blows out fog, like moisture in vents/ducts. is this a water drain/hole plugged up allowing water to flow where it isn't suppose to. i can picture water flowing out of the vents in a heavy rain.
View 1 Replies
I searched but couldn't immediately find anything about this particular line. I've been struggling with a rough idle for the past couple weeks, throwing codes that I'm running to lean all the time. I cleaned the throttle body and MAF, and was in the process of replacing the MAF and noticed a small hose fitting behind the MAF but before the throttle body was pretty much split in half. I don't know what it's for and I'm replacing it regardless, but could this be the source of my problem?
View 5 Replies
From cold, I start the van up, and if I just slightly crack the throttle it will start running rough. I think it goes away under heavier throttle...might just be that the rpms are up I can't feel it anymore, I don't know. It will idle just fine, and after it warms up it also seems fine. Where to look?Also I sometimes hear a very small, high pitched, vacuum leak from under the hood. What are the most common items that go bad, that I should look at first?
View 4 Replies
2006 Honda CRV, throttle by wire. How can you get the throttle plate open to clean the throttle body etc.
View 4 Replies
we just replaced a pressure hose that broke and now the engine light blinks 30 times and then goes off and then blinks again plus the engine seems to be shaking allot.
View 1 Replies
On the manifold there is a metal/steel pipe that the heater hose hooks to. That pipe is leaking anitifreeze. It has a small hole in it. Is this pipe replaceable or is it part of the manifold.
View 19 Replies
So while driving yesterday I had a EPC and Check eng light come on and go away shortly after... maybe 1hr of drive time. Any way I took into dealer today to have them scan and they stated it was an issue with my throttle body.
Now as soon as he told me that he also said he can not do any work under warranty on my engine due to Stage 2 software and intake/down&mid pipe...... no big deal as I figured he would say something like that anyway. Should I take it apart and try to get it cleaned..... or what?
Its a 2010, with roughly 21k miles.... Had APR stage 2 for a few months now and this is the first thing that has come up.
View 3 Replies
So i recently bought a used 2003 camry le 4cyl with 72k miles on it. So it's still in good condition. Previously I had a 92 camry 4cyl which is run with throttle cable. The new generation camry's now are drive by wire or driven electronically. So I decided to check out the whole car and looked into the throttle body, the out side of the butterfly plate, and notice some thick black substance. It seems like grease or oil. I don't know if its there to lubricate the motor to run the plate or just oil.
View 8 Replies
When cranking there is no fuel from the throttle body. Dropped the fuel line on both sides of the filter that was replaced last fall and have good flow before and after the filter. If I spray starting fluid down the throttle body it will fire. Switched out the throttle position sensor and idle air control valve to no avail. It used to die after warming up every so often at a stop light but would start right back up, now it just quit and wont start ???
View 1 Replies
Would a corroded throttle body cause a false code P0332 knock sensor.
View 4 Replies
I cleaned my throttle body this afternoon.
My car started fairly easily, and I continued with running it to 4k RPM a few times, then took it for a ride. I floored it a few times, as suggested, to clear everything out.
Now, my 2004 J-VIN Camry is running around 1200 RPM, it was at about 650-675 before the cleaning. Is this normal? Do I need to d/c the battery to reset the ECU so the car can re-learn with a clean TB?
View 5 Replies
My prius has a coolant leak, which look like it's coming from the throttle body. The stealership recommends a new throttle body. The mechanic said he has not seen coolant leak from the throttle body before. Is this the only fix to replace the throttle body?
View 8 Replies
What Is that little hose for? I can Smell the gasoline whenever i start the car in the morning. It is cracked But i recently heard a z-zzing Under the hood. Is it an expensive hose? What about the hose clamp.. it looks weird.. is its special for that application ? I wanna replace it myself but I don't want to do it wrong and turn my car on fire.
View 4 Replies
I have a 2012 Camnry I4 and want to clean the throttle body.
Is this throtte the type that I can manualy open valve by hand without damage, or does the pedal need to be pushed to open, to prevent computer or throttle timing issues?
View 7 Replies
The rpm with the A/C on are 550 , I was told to replace Throttle body, I did, rpm continue the same,when im driving and I stop the car start vibrating, some one told me that i have to program the new throttle body , how can i do that?
View 3 Replies
I've tried searching everywhere, but can't seem to find the torque for the 4 bolts holding the throttle body to the plastic intake. This is on a 2az-fe engine in my 2004 camry. I imagine the torque would be the same for any Scion, RAV4, etc. that has the same engine.
View 4 Replies
My 97 Suburban died and will not start. Things I have done:
1 Changed fuel filter
2 Changed fuel pump twice
3 Checked fuel pressure 60psi
4 Changed plugs and wires
5 Changed rotor and cap
6 jumped switch to make sure pump runs
The Suburban will start only if I pour gas in the throttle body and will idle as long as I continue to pour gas in but will die when I quit.
View 7 Replies
About, one month ago my car shut off while driving(pretty scary at the time). I pulled of the road and attempted to start it again. Everything looked good there, but as I was making my way home from work it started to act funny. It would not acknowledge me depressing the accelerator. When I got home, I ate supper, then went to have a look.
The car would turn on, but not acknowledge me pressing the accelerator at all, It did however go up to 30 mph at a snails pace as if it was coasting down a hill. I plugged in my code reader, and it read that the Throttle Body Valve was stuck open. I took it off and tore into to it a bit. I noticed the gears inside the TB itself were corroded and the butterfly valve was locked up.
I replaced the part, and tried to turn my car on with the new TB. All the dash lights are in working order, however upon turning the ignition to crank the engine, the whole car system shuts down. No lights no nothing, besides the car door open sound. The car will remain like this regardless of the key position until I have reset the batter(take off the terminals and put them back on) to which the process repeats itself.
The code reader says no codes are stored because I obviously reset the battery. So now am at a standstill.I believe the old TB froze up, because I had to run in through 3 ft standing water during a storm, and then deployed shortly after(I'm in the service) for a few months while letting the car sit.
View 1 Replies
I cleaned the MAF in my 2008 (58k miles) with CRC MAF cleaner and cleaned the throttle body as well. There was a small puddle of oil in the intake manifold from the previous owner overfilling oil so I cleaned that up as well.
View 19 Replies