Volvo XC90 T6 AWD (2004) Changed my battery and now my turn signals won't work, won't show from display panel (interior) or light up (exterior), and my fog lamps are also not working. Used a memory settings save backup and checked fuses but can't figure out what's wrong. Electrical worked fine before battery change. Battery was aftermarket (non-OEM).
View 2 RepliesI have a XC90 and starting recently the air volume doesn't work anymore. To be exact, you can feel very light air coming out of the vent even you turn the air volume to max. I went to a shop and was later told nothing wrong with the fan or the resistor. So they suspected it could be something wrong with the computers but since they normally work on American/Asian cars, they dont have the software for European cars to proceed further. On the way back home, I suddenly felt some steady air coming out, but it keeps at the same strength no matter how you play around with all those air volume buttons.
View 1 Repliesi drive a 2007 XC90 V8 with 76000miles and recently i got a power system failure message and battery light went on , so took it to my mechanic and he tested the car and it was tuning out 11volts so he concluded it was the alternator, so he recommended changing the regulator and i got a new regulator made by Bosch and it was installed and upon starting the message came back on and the battery light as well and upon testing it was producing 15.4volts , now its overcharging , what do i need to do ? should i buy another regulator ? as my mechanic says alternators hardly ever get damaged but the regulator is the one that usually gets damaged...
Attached File(s) :
- regulator1.jpg ( 314.57K )
- regulator_2.jpg ( 290.61K )
I have an 05 Freestar with no instrumentation and no error codes. None of the gauges work and most of the warning lights are lit when the truck is running. No A/C and no ABS while driving and turn signals work, but do not display on the dash. It appears that two separate code readers are not acknowledging the computer. The battery and alternator check out good and there is no drain on the battery when ign switch is off.
View 5 RepliesHow do u remove and install the turn signals in the mirror?
View 6 RepliesHow to install load resistors in the front turn signals to fix fast blinking after led changing? I have two 6 ohms 50 watts resistors but I don't know how to install in the front turn signals.
View 7 RepliesMy xc90 will crank but not start 99% of the time
Here are the following codes
(P0336) - Crankshaft Position Sensor A Circuit Range/ Performance
(P0040) - O2 Sensor Signals Swapped Bank 1 Sensor 1/Bank 2 Sensor 1
I have replaced the following
1.timing was off i have corrected this using the correct locking tools and VADIS
2.fuel pump was leaking - replaced along with filter
3.coil packs have been replaced along with spark plugs
4.replaced the crank position sensor and cradle
5.replaced the starter motor just for the hell of it
I have had the car running 3 times but this only occurs rarely and once i turn it off it wont start again . I have herd it could be 1 of 3 things .
fly wheel, starter motor emp messing the crank position sensor signal or gearbox has not got the correct earthing to chassis or bell housing to engine
I checked the 3 grounding points on both sides of the fenders and sanded the contacts ...
My 2004 Volvo XC 90 has a severe "thump" in the front end, which is then followed by a very brief (split second) internal (meaning dashboard lights, hi-fi, dome lights, etc) power failure. Initially, the power failure would last only a split second and then car would continue running as normal, and there we no error codes or check engine lights.
But on the last long drive home, the "thump" was harder than usual, and the lights internally completely went out, hazard lights could not be turned on, blinkers could not be switched on, hi-fi went out, etc (though the electric windows would work). I pulled over, and turned the car off and restarted it, and the yellow exclamation point dashboard icon/alert lit up, and a service message flashed referring to the anti-lock brake failure, and that the SRS needed to be checked.
This problem has been occurring for a couple of months, and is very intermittent. Before this last incident, I took it into the dealership, who could not figure it out,. Now that I have an error code, I have it at another dealership, who seems equally mystified and have told me that they don't think the error code of check the SRS is going to fix the problem. The engine thump, followed by electrical failure seems really weird....
I just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?
I recently bought a 2004 XC90 T6. It has several issue and one strange issue is the sluggish performance: the vehicle sort of hesitates, requires quite a bit of acceleration effort to get up to speed, feels 'heavy', and in general does not seem to have the right amount of power. What makes the issue strange is that performance improves, noticeably, when the car is starting to run out of fuel, or when the "low fuel" light comes on. It is not a placebo effect: i've verified it several times that soon after the light is on, the vehicle becomes a lot more responsive, accelerates well, engine seems to sound quieter a little even.
I do not know much about cars. I am slowly learning after purchasing this vehicle. I verified that the air filter is clean. It has synthetic oil put in. I recently changed the spark plugs (very proud of that), that did not seem to improve the performance. My plan is to purchase and configure VIDA diagnostic tool and scan the vehicle while driving. It might also be worth mentioning that the vehicle is getting very poor mpg, averaging to 6 km per little.
One important note: the MAF sensor is faulty: i drive with it being unplugged, however when it is plugged in i experience the same as described above. I know it is faulty because when it is plugged in and the car is started up, the RPM goes to 2000+ and there for up to a minute or longer. If the MAF is unplugged this does not happen.
I just joined this forum some minutes ago, I own of a 2004 XC90 T6 AWD, delivered to me a couple to days ago, just barely getting to know the car, hear a knocking sound from the front passenger seat when i drive on rough roads, and this morning check engine warning sign remained on while driving out, had to park the car at home.
View 4 RepliesI just found a nice Prius C for sale with little damage to the front right corner, no frame damage or anything, just some bodywork needed. So, after it was fixed up. I brought the car back and there is weird issue that I have - turn signals and Hazard lights dont work. When I turn it on, i can hear clicks from it, but I dont see lights blinking on the dashboard and my head/tail lights dont blink as well.
View 5 RepliesI have a 2003 Chevy Malibu - periodically, they turns signals decide not to work. I don't know that one thing in particular causes them not to work. What could be the issue and is this something I can fix easily (I'm a novice), cheaply and quickly myself?
View 2 RepliesToday, I replaced the flexible coupling in my steering column. All went well and seemed great until I realized my turn signals were not working. I tried the hazards and promptly heard the 10amp fuse blow. I took the paneling back off and realized that the wire bundle to the turn signal was being pinched above the steering column.
After lowering the front of the column down and removing the wires, I noticed that there was some damage. One wire (blue) was cut and a few others had damage to the sleeves. I repaired the sleeves and fixed the broken wire. The turn signals now work perfectly fine, but when I activate the hazards all the signals go dark. I cannot find any blown fuses and the relay appears to be working just fine for the turn signals.
What is the easiest way to change the flasher?
View 6 RepliesRecently my tail lights went out and my turn signals dont work either, the light for the turn signal on the dash doesn't light up either. My brake lights do work tho and so do my reverse lights.
View 3 RepliesI recently bought an 08 Sonata from a used car dealer which has 65,xxx miles. Last week my turn signals would work intermittently, and now neither the turn signals or the hazards work. I put in a new relay and a new turn signal switch, to no avail. When I turn the hazards on, the relay clicks once then nothing. When I do the turn signals, nothing clicks. Is there another relay I'm missing somewhere?
View 14 RepliesThe back turn signals on my 93 ford taurus wont work but the front ones do. i checked the fuses and the bulbs and everything was good. the brake lights work and the head lights but no turn signals. same with the hazard lights. front ones work but no back ones. what should i try?
View 1 RepliesSo after a pretty harsh storm last night I was driving today and my wipers came on. Went to turn them off and nothing. My headlights and turn signals won't work either. When I pull the stalk to turn my high beams on my wipers go off. Parked the car and the dash lights stay on without my key and the wipers randomly go on and off. The blinkers in the rear remain lit with the car off as well. At work right now so nothing came up when I searched briefly but do any of you have any insight as to why my car is possessed? Going to check grounds when I get home.
View 4 RepliesI noticed yesterday morning that my turn signals were not working on my 2000 F150 4.6L 4X4 XL truck and I need diagnosing what the cause is. The hazards, windshield wipers and my brights still work so I was not sure if it was just the switch. I have done the following:
* I went and got a new turn signal flasher at the parts store last night but when I went to put it in under the fuse box under the hood it was to big to fit into the holes. By this time the dealer was closed and I couldnt go and get a new one from them. (I wasn't sure if both needed to be replaced at the same time).
* Since there are two under the hood i just swapped the positions and still nothing happened everything worked accept my turn signals still worked. (by swapping I mean I took the one that was in fuse location 301 and put that one into 304 and 304 into 301.)
* I went to my owners manual and checked every fuse to make sure that anything related to my turn signals and flashers etc were not blown and they werent.
That is were I am at. I don't think its the switch but is that a common thing to go out?
I've got a 98 Silverado. Break lights and rear turn signals won't work but tail lights and reverse lights work. Also the brake light on the cab does work.
View 6 Replies