I have access to the fuse panel but I need to remove the panel to reach the relays. I need to change the socket in the relay panel because one is burnt out. I change the K(headlight)relay and when my car is off and key out of the ignition my lights are still on.
View 10 Replies- Fuse Box - Part # 3C7T-14A067-DC Engineering Number on white label.
- Ford Dealer Part # 3C7Z-14A068-DB
I have a 2004 Ford Excursion 6.8L 4x4 that has a bad fuel pump relay. I am looking for a used replacement fuse panel.
Of all these number and letters which of them tells me the real part number? Does the last two letters mean anything "DC" or "DB"?
So I don't get one for a diesel, what is the prefix for the diesel? I am assuming the 3C7T is gas and the year model?
Also, will this fuse panel interchange with a F250/F350 6.8L or do I need to stick with a fuse panel from an Excursion?
I attempted to remove a 7.5 amp fuse from the interior panel under the dash on the left side. Using the fuse removal tool in from the fuse block under the hood, I grabbed one and worked it out slowly.
When I got it out, the metal prongs were broken off of the plastic housing. I thought this was weird and looked into the fuse block trying to see if I can see the prongs. No luck!
I attempted to pull another fuse to see if it will come out and sure enough, the metal prongs are broken off in the fuse block. I tried again to see if I could see the the prongs but again, no luck!
I put the plastic housing (top half of the fuse) back into the slot and the electronics for that fuse is working. However, I am concerned that something is wrong and causing the fuses to break when attempting to pull them out.
95 850... What is the magic trick to getting access to the bottom section of the fuse panel under the hood. I have removed the 4 torx on the black cover, then the 3 gold torx, then the screws holding down the incoming cable bunches. But no matter how hard I try I can only pull the white fuse panel up a certain amount, I can get it to pivot on the lower fuse tray, but can not seem to be able to figure out how to either pull the lot or disconnect the top part from the bottom part - so as to move the top part out the way! There just does not seem enough give in the wires....
View 2 RepliesMy 2010 II has two power sockets, one under the radio, and another inside the center console. The center console one does not work, whereas the other one does. I checked both the fuses, and even swapped the two fuses. I also checked several other fuses just to be sure. No fuses are blown and nothing changes by swapping the 2 power port fuses.
View 8 RepliesI think I have a bad socket on my taillight/brakelight on my driver side. Passenger side works fine. Bulbs are not the issue. All other lights functioning. Found a bad 7.5amp fuse on driver side fuse panel. Replaced and still, no taillight.
Any other fuse or cause for the driver side tail light only to stop functioning?
The horn on my 2010 golf recently went out, so I'm thinking that one of two things happened. Before the horn went out completely, one tone died, then about two months later it stopped working completely. When I press the horn, I hear a click coming from the dash. So, I think it's either a bad relay or both horns went out. How likely is it that both horns go out within a few months of each other?
Anyway, I bought a new horn relay, but how to access the relay panel located in the dash. How to remove the dash sections, or is there a good write up?
Owner of a 2005 Escape and trying to figure out which relay on the interior fuse panel is the Accessory Delay relay. I think this might be causing a battery drain when everything is shut down. A diagram of the relay side of the panel.
View 5 RepliesB5.5. Here is what happened: Was driving as usual, running low on gas. Cluster was showing zero miles left for last 10 miles. I successfully made it to the gas station. Trying to open lid - maybe on third press it popped. I thought I'm just imagining things. Drove home another 5 miles. Trying to open trunk - same as gas lid, eventually opened. I turn engine off. No dome light. None of the dome lights working. Everything else appeared still has power. Trying to open trunk again - it's dead. Trying to start the car - does not start. Trying to go home and lock with remote - not working. Lock manually and went home.
Next morning went to check fuses - all OK. Everything still not working just the way I left it. When ignition key turned - cluster comes up. When starter should crank I can hear small click inside relay panel and lighter power turned off momentarily as usual, but no crank. No messages on cluster. Dome lights, door locks by remote and starter/engine don't work. Gas lid and trunk don't work even from driver's door. If I press power lock on driver's door it will lock and immediately unlock all doors.
I did check power on fuses. Three engine related fuses don't have 12V on them. The fuses are 28, 29 and 34, or second and third up from bottom left and fourth up in second column from bottom left. Fuses itself are good.
Here I Got my first suspect: power for all 3 fuses above coming from same relay. I thought if I jump these fuses to live 12 Volts I might be able to start engine. I did jump one fuse at the time. I've heard fuel pump came up but nothing else happened. I understand that it can also be Motronic control for this relay. I pull my OBD reader, but found no codes or freeze frames. I don't have WAG reader.
But Motronic should not affect doors and dome lights (I think so but not sure), unless CAN bus shorted or something. Lights and doors can be related to Central Control and Convenience module, which supposed to be under driver seat. I had rear driver side carped wet few times when I just bought the car, but not lately, not in 6 months. I still think water damage can occur much later after exposure.
So here are mu suspects: Engine power relay, Motronic or Convenience module. It might be something else.
I need to get to the filter in the rear ac panel. What is the best way to go about removing the Panel? How much do I have to remove?
View 6 RepliesI just purchased a 2011 Sonata. The low beams are not working and I am trying to diagnose the problem before I take it to the dealer in case it's just a blown fuse or bad relay. I have read through the owners manual and looked at both fuse compartments for the fuse and relays and to no avail. So, looking for the location of the low beam fuse and relay? I know there has to be a fuse for the headlights somewhere lol. Maybe I am missing it because of an abbreviation or something. What is the fuse name and I can go from there.
View 2 RepliesJust noticed I have no more horn... I had car alarm issues for a while and the alarm would sound all day in the parking garage while I was at work (was keeping the car unlocked at home...) Finally fixed the hood pin.
Going back to the horn, the horn fuse was burned in the hood relay box, and when I replaced it and tried the horn again, it burned again... Where to start? Do I go for new relays, new horns, new wiring or all of the above...
I have a 2000 LS, V6, that won't start, had the battery and alternator checked and are fine, last week i notice when I turn the switch to start up there was a 1 or 2 second delay then it would start, the other day the wife called me at work to tell she she was out and it wouldn't start as I was talikng to her she tried it and it started right up, didn't do it again until this morning, check the fuses and all were ok, it started 2 times then about 30 minutes, nothing, and i mean nothing, the security on the dash doesn't indicate a problem, I turn the switch everything lights ups as it should, everything works(radio...etc.) go to start and nothing but click, sounds like it comes from the fuse/relay box under the hood, starter maybe? relay?
View 3 RepliesWell, it's starting to look like I may have to build my underhood harness from bits of multiple harnesses. I found a 2000 Excursion harness, but the engine plugs and wires were hacked off during engine removal.
After in-depth study of wire diagrams, it looks like I can just get a pickup harness and combine it with the aforementioned damaged Excursion harness to get what I need- and do it for about 50 bucks.
I also notice that there are a few Ebay sellers who just sell the fuse/relay box with the wiring harness hacked off of it. So my question is- how do you remove the wires (including the terminal ends) from the fuse/relay box? I've fiddled around with my burned up parts and can't seem to figure it out.
I have a 03 for excursion and I am pretty sure i blew the relay for the fog lights today but looked in the glove box and everywhere for the owners manual and cannot find it anywhere in site... Looking for a diagram or can take a picture of where the fog light relay is and post it on here and which fuse or relay it is ?
View 14 RepliesI recently got a ranger from my buddy and it keeps blowing the EEC fuse in the engine compartment. We have replaced the EEC relay and the EEC power relay. As soon as you turn the key it is blowing the fuse.
View 1 RepliesMy 1999 Volvo has been diagnosed by a Volvo dealer to have a bad "cooling fan relay". Another shop analysis states the "cooling motor fan assembly module" is the problem. Are these one in the same? Can I replace it with one from the salvage yard? Are there any bad omens with messing up other electronic components If I make the repair myself?
View 9 RepliesI just noticed today there's a flashing blue LED in the fuse panel of my 2006 Camry. Just wondering if this is normal or if it indicates something is wrong?
View 2 RepliesIs it a big deal to remove the left rear interior door panel? The dealer replaced the door glass and, naturally, the tech didn't align the glass correctly. I'll align the glass myself.
View 2 RepliesI have a 2008 passat and i want to remove the driver door panel. Well I did the search found what I need to do it, but every search result says to pry off the window controls. I was tugging and pulling all this morning and never could get it off.
View 4 RepliesHow to remove the window control panel on your door panel on a 2010 prius? I'm not looking to remove the whole door panel I just want to take the little panel that has the 4 window controls off.
View 3 Replies