I have a 92 Volvo 240 (250k) with EGR (California car). I live in Alabama, no EGR needed here. There is check engine code that points to the EGR. It has been exhibiting all the symptoms of a defective EGR for quite a spell, check engine light just showing up recently.
Should I clean it, replace it ...or just take it off entirely. If I remove it, what needs to be done with that removal (such as ECU adjustment, replacement)?
1994, 960 ... The vacuum controller has two "vacuum lines" attached to it. Should both lines have vacuum present? I keep getting a 241 code with sporadic idle and check engine light.
View 3 Replies2004 XC90 T6. Local Volvo dealer (Bangkok at the time) said my check engine light was due to the O2 sensors going bad. I changed out the one under the car, then my wife threw out (accident) the other so I didn't change the one accessible from the hood. The check engine light went away so I figured that was that.
Fast forward a year later, I buy an Autel Maxiscan MS509 and now I'm getting check engine code P0455 which is probably the O2 sensors I didn't replace. Other than deductive reasoning, is there some way to look at the data on my OBD reader to confirm which O2 sensor is bad?
I have a 92 volvo 240 and have recently got a check engine light. I got a code reading of #241 on number 6 terminal. What that means and how to correct this problem?
View 1 RepliesI bought a 2005 Volvo V70 with 75,500 miles on Nov. 13. On Nov. 15, the check engine light went on, and I returned to the dealership for a solenoid replacement. The check engine light went on again on Nov. 17, oil pan replaced. On Nov. 19, the light went on again, timing belt replaced. On Nov. 22, the light went on again. Each time the code was the same--sometimes in conjunction with other codes--but one code was consistent. We returned the car on Nov. 22 and asked for a refund in keeping with the Massachusetts lemon law (an attempt at repair 3+ times). The dealer refused, saying the check engine light and computer code were not the same as an attempted repair. He took the car and said he was going to call Volvo Tech in. However, he says the light "went off" and never came back on even though his staff has test driven it 170 miles in the past three days. He's "releasing our car" to us, even though he has made no repair. Tell me--is trying to address the same computer code considered a "repair"?
View 13 RepliesI had a Check Engine Light a couple months ago, and I took the car to the garage to have it checked out. They told me they got a Fuel Pressure Sensor malfunction code, and that the sensor had to be replaced. I did so myself, an it is ridiculously easy, and the car worked fine. I noticed the Check Engine Light blinked a couple of times while I was driving, but never got steady. A couple of days ago, it did. Out of a bad gut-feeling, I purchased a ODBII scanner, and I scanned the car myself. I got the same error code as the garage did, but the sensor should be fine.
View 5 RepliesWe are considering the purchase of a 1992 Volvo 960 sedan. We have two young daughters who both need to be using child seats. I cannot work out where the anchor points are for fitting the seats.
View 1 RepliesMy volvo is running fine but the ETS Light, OIL light and Check Engine LIght are constantly coming on and off intermittently. In March of 2011 the independent volvo specialist cleaned the throttle body and a cracking turbo hose. In September 2011 the dealership recommended to replace the dipstick tube and to reseal angle gear. In October 2011 the dealership tech notes possible internal failure to the transmission shift solenois, oil pump seals and an internal failure to the electronic throttle module. Recently I had the oil and filter changed and the check engine light reset but days later the lights all are back on. I am unable to smog the car until these light issues are resolved.
View 1 RepliesI own a 2002 Volvo S40 Turbo with the following problem. Every now and then the "Check Engine" light comes on. Then, when I turn the ignition off, the car shakes violently for several minutes. Last time this happened, I took the car to the dealer, and the computer diagnostics came up with this message: ECM-44 MISSFIRE, EMMISSION LEVEL, FAULTY SIGNAL INTERMITTENT FAULT. What is wrong, and how it can be fixed?
View 6 RepliesI have an '03 S60 - nonturbo with 239,000 miles. I've never had any performance problems with the car.
Here is the situation - The check engine light has gone on 3 times in about the last 2 months. It just happened for a fourth time today. Each time it's exactly, almost exactly the same distance from home, from a cold start on a hot day.
Same code each time. I don't remember what it was - something to do with the air mass meter - it was on the paperwork from the dealer that I can't find right now.
First time the code came on was two days after getting the air filter changed so I suspected they didn't assemble the air filter case properly. I brought it into the mechanic. They recommended pressure cleaning the throttle body and changing the air mass meter. I opted not to do it and they just reset the light.
Second time I remember putting oil and an oil additive in (Lukas oil) to top off the oil in the car before I left.
Brought it back to the dealer and when I spoke to the mechanic at the dealership.He said I could do the throttle body cleaning and change the meter, but that wasn't the problem. He warned of some sort of internal engine problem suggesting that an oil path from the top to the bottom of the engine is clogged and causing some sort of other ambiguous issue in the engine.
Btw according to the car computer it gets 31 miles to the gallon.
Third time- I topped the car off with oil (cheap 7-11 oil). I drove the same distance and the light went on.
The second two times the light went off on its own.
Fourth time just happened on a quick errand. Car had been sitting for about 3 hours since it last ran. When I ran it earlier today I didn't have the light come on.
I should note that several years ago (at about 180,000) the engine had some sort of check valve at the back of the engine replaced twice because it was whistling.(With the whistling the check engine light did not go on). The second time it was replaced they did an oil cleaning procedure that cleaned the oil path from the top to the bottom of the engine.
Is this really a devastating engine problem? What's going on?
Now that I have VCDS, I see a problem I never knew I had ... An error on the Air Con. I am not aware of any issue, it appears to do what I ask it. I cleared the error and it appears to appear again on a scan.
On reading the self study guide this looks like it might be an obstructed flap for the recirculation. I will have a close look next weekend.
Address 08: Auto HVAC Labels: 3D0-907-040.lbl
Control Module Part Number: 3D0 907 040 J
Component and/or Version: Climatronic D1 2031
Software Coding: 0000001
Work Shop Code: WSC 01065 000 00000
VCID: 254B0F7DE8FA196
1 Fault Found:
01274 - Air Flow Flap Positioning Motor (V71)
014 - Defective
My 1999 Camry - 4 cyc has a trouble code of P0136. Auto Zone told me it is a defective bank 1 sensor 2. As per the repair manual, the front passenger seat has to be removed to get to the sensor's electrical connector but an internet video shows that the driver seat has to be removed. Replacing the heated bank 1 sensor 2 on a Camry before?
View 9 RepliesI have a 2002 volvo S60 2.4T that I just had the check engine light come on so I pulled the codes and here is what I found,
PO403
PO611
P1378
P2623
So my question is what does this mean ? what is wrong ?
Just bought my volvo several days ago. It was throwing check engine codes so I had it scanned and it came down to a vacuum leak. I found the spot where it was leaking which was a little piece to the left and slightly behind the exhaust manifold, slightly behind and beneath the thermostat housing. It went from a hard plastic vacuum line, to a 1.5 inch rubber vacuum line which plugged into a nipple on the exhaust manifold or something behind the manifold. the rubber section had 3 large holes in it, so i replaced it with more rubber vacuum line. same length and same inner diameter.
What I did notice when I replaced it was that it was too large for the plastic line, slid on way too easy, but i had to fight it onto the nipple. The check engine codes went away for 2 days(I drove about 150 miles over that time) but today, the check engine light came back on, went to auto zone, had them scan it, came back with vacuum leak. So when I got home, I popped the hood, sprayed some carb cleaner by the replacement vacuum job I did, and sure enough the idle changed. What the proper replacement hose is for that area?
[URL] ....
The Check Engine Light is on. Diagnostic Codes: P0722, P1618, and P1633. Do these mean the output speed sensor/connector wires should be replaced? Is this a DIY job?
View 1 RepliesMy mothers 2004 Volvo S40 (original body style) has an illuminated check engine light. Dad took it to their local dealer. Unable to get a code from the cars computer and guessing the problem might be with the fuel filler cap seal, the dealer sold them a new fuel filler cap, offering them a refund on the cap should that solution not work. It did not.
View 2 RepliesA few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
I have a 2007 XC90 3.2 RWD with around 112,800 miles.
On acceleration, there is a rattle (not a valve knocking) that gets quieter once a steady cruise is achieved. At idle in gear, a very quiet rattle can be heard. When transmission is slipped into neutral, the rattle goes away. The engine shifts normally, accelerates normally and gas mileage is steady at around 20.5 mpg (mixed city and highway). I am using 93 octane gas. This week the check engine light came on.
Issues with check engine light coming on and staying on. The dealer says it is either a gas cap problem or the type of gas being put in the car. Dealer recommends only using Shell fuel. The car drives fine and am wondering if this might be sensitive fuel detection.
View 2 RepliesWe bought a new 2012 Volvo XC 70 wagon. It only has 6,000 miles on it and the Check oil light has gone on three times. Each time it has required approximately one quart (which the dealer claims is "within specs" for this engine). I believe it satisfies the lemon law criteria in PA since it has been back to the shop three times in less than a year. Should I insist on a replacement or is this "normal" wear for this car.
View 19 RepliesLifting a 2AZ-FE block to get it on an engine stand. Block is already on the ground. I need to confirm engine lift points for this block. ( block & cyl. head without trans-axle ). Couldn't find anything in any of the docs & refs that I have & searched. I would rather not lift it by the cyl. head lift points since the head bolts are a weak point on this block.
View 3 Replies