Volvo - 940 :: Stalls Out While Driving And Would Not Start Up Again / Low Fuel Pressure
Apr 22, 2013
I've had this car for a little over a month, when I first bought the car it ran fine, until I drove it home. It stalled out and would not start up again, turned out I had low fuel pressure so I replaced the fuel pump. After this the car had been running fine up until a few days ago. It was stalling out and starting right up, now I am lucky if it will start up. I am still getting fuel pressure to the fuel rail. Would it be my injectors?
View 1 Replies
Advertisement
My '90 240 will not start. When I turn the key to Acc. or Start I hear a whirring sound coming from the fuel pressure regulator so I assume the fuel pump is not an issue. The engine will not even crank. I assume it is the ignition coil or the starter but I am unsure. As an FYI, the battery and plugs are good.
View 1 Replies
I have a 1988 Ford F-250 Lariat, 7.5L 460, four-wheel drive. I have two fuel tanks on it, and I've been having a really annoying, obnoxious problem with it lately. After running it for a while, I noticed that I keep losing fuel pressure, and the truck stalls. When I try to start it, it does nothing but roll over. It just won't start. I've changed the fuel filter, I know both fuel pumps are working (I turn over the key, I can hear front, back, and high pressure pump attached to the left side frame rail kick in.) It's Fuel Injected, not EFI, hence that third pump. The problem happens a lot, and it's random. I could drive for 100 miles, stop to get something to eat, come out, and it won't start.
I thought maybe it was the fuel pressure regulator, but I don't think that's the case because it still runs. I would assume that if the regulator was bad, it wouldn't run at all. I also thought that maybe it was the relay, but according to some mechanics I spoke too, if I can hear the pumps kick in when I turn the key over, then the relay is fine. The only thing I could think of is that it might be the fuel selector switch. Maybe it's going bad, shorting out or something. When I flip the switch though, it switches between fuel tanks, and the gauge reads how much fuel is in it from the sending unit.
There's a schrader-type valve up by the fuel injectors. When I push it in, it barely squirts any fuel out, if at all, so I know the pressure is low. When I push it in on a good day, it sprays out like a water fountain. Just tried starting it again - no good. Pushed on the valve, it spurted out some fuel pretty well, but still won't start. Occasionally tries to, but ultimately won't. I know the spark is good, checked the plugs/distributor cap. Can't get the sucker to start.
View 14 Replies
I purchased a 1990 Jeep Cherokee Laredo at a steal . . . I've already replaced the head gasket sealant. My biggest current concern is the fuel pressure. The car either starts up beautifully or sputters and gurgles for a good 5 seconds before finally idling normally (either occur during cold or warm starts).
The sputtering at start-up has become more commonplace as of late. If I drive away without providing a good three-to-five minute warm-up, the car will drive as normal while applying gas pressure to the peddle, then once gas pressure is no longer applied, the car dies silently; The battery stays on, but all power steering and engine power disappear and the car coast into nothingness. If I allow the Jeep to warm up significantly, it will drive as normal for hours, except for it's struggles to compensate long upward hills.
The fuel regulator has a slight leak. Worse at start-up, lessens up over time. The seal may be improperly seated, but is in physical working condition as I can tell. Spark plugs were replaced. Battery was replaced. Injectors have been tightened. There is a slight oil leak (it seems to move around a bit), but is far better since the Head Gasket was replaced. Could this be a bad fuel regulator or something else that I have missed?
View 1 Replies
I have an 89 Volvo 244 DL series. I have had a complete tune-up, and oil change just recently. Battery works great, plenty of voltage, even had the fuel injection cleaned out.
Problem is the car starts right up when it is cold, however, after driving it and let it set for an hour the car starts up slower and immediately it stalls out. I do it again and the same thing happens and then I leave my foot on the pedal to keep it running at a higher idle for a bit and then place into a gear & it goes without any hesitation. If by chance I do not leave foot on pedal and put it in whatever gear it immediately stalls out. I have driven Volvo's for years, from the 70's to what I have currently. I never had encounter anything like this and have dealt with many other issues and this one has me baffled.
View 8 Replies
My 2000 Volvo S70 just started stalling while driving: it completely dies while in motion. This has happened 4 times in the past week, both times (oddly) in the morning on my way home from the gym. Both times, it's happened we have had very damp weather, and it's the second start-up of the morning. It has happened at slow speeds, and it feels as though it is out of gas, but it is not.
View 1 Replies
Just changed the fuel pressure regulator on 1993 volvo 850 (non turbo), now the idle goes up and down then stalls.
Also changed IAC, but with a used one from a previously working car.
View 3 Replies
I have a 2006 S60 2.5T with 40k miles. My check engine light went on and stayed on for two drives. Then turned off and hasn't returned for next couple of drives. Error code says fuel pressure regulator. Should I bother to bring it to a mechanic or since the light went off (didn't burn out -- it momentarily turns on when I start the car) should I assume all is well?
View 2 Replies
We just brought a 2000 S70 Volvo 5 cyl. sadan. There is a problem when we start it up. Initially it starts up fine, but when you put it into drive, the rpms do not stay constant enough to keep the engine from stalling out. When you restart it, the problem repeats and repeats about five or six times, until the problem corrects itself. If in an effort to increase the rmps by applying the gas pedal, the problem may cease, but not always. Once the rpms remain constant, there are no longer any problems with the engine.
This problem is not a constant. It mostly happens when the engine is cold, but it can also happen when the car has been running and then turned off. When you turn on the warmed up engine, the problem happens again. Because we anticipate the repairs on a Volvo are likely to be expensive, we would like to have an idea of what could cause this problem and an anticipated cost.
View 2 Replies
I had a Check Engine Light a couple months ago, and I took the car to the garage to have it checked out. They told me they got a Fuel Pressure Sensor malfunction code, and that the sensor had to be replaced. I did so myself, an it is ridiculously easy, and the car worked fine. I noticed the Check Engine Light blinked a couple of times while I was driving, but never got steady. A couple of days ago, it did. Out of a bad gut-feeling, I purchased a ODBII scanner, and I scanned the car myself. I got the same error code as the garage did, but the sensor should be fine.
View 5 Replies
My truck starts and runs fine cold. after 10 minutes or so of driving, it starts choking and stalls. If you try to start it, it will not. If you wait about 3 minutes, it is fine, starts , and drives ok, for about 3 minutes. I have replaced, plugs, fuel filter, battery, and a ignition module, as well as cleaned the opening of the throttle body
Ford has ordered a fuel pump, I am thinking it could be the
-Throttle position Sensor?
-MAF sensor?
-fuel pump?
It puts out code p0191 for low fuel pressure. Ford is scheduled to install new pump in am, but I don't want to spend a grand if it is just the TPS or MAf?
View 1 Replies
I need to check the fuel pressure to verify if my fuel pump is functioning. What is the procedure and PSI?
Assume that I open the valve on fuel rail with engine off, then connect pressure tester kit, put key in ignition to "on" position, then pump up to specified PSI???
View 3 Replies
My cousin was driving his car last weekend and the car shut off on him, after we towed it home i hooked it up and got the following codes:
2 Faults Found:
012555 - Low Pressure Fuel regulation: Fuel Pressure Outside Specification
P310B - 001 - Upper Limit Exceeded - MIL ON
Freeze Frame:
Fault Status: 11100001
Fault Priority: 2
Fault Frequency: 2
004767 - Low-Pressure Fuel Pressure Regulation: Pressure too High
P129F - 001 - Upper Limit Exceeded - Intermittent
Freeze Frame:
Fault Status: 00100001
Fault Priority: 2
I cleared the MIL and its off but its still throwing the second code.. What would cause this? failing fuel pump?
View 3 Replies
I've been trying to diagnose a problem i've been having. Every now and then after driving for about 30 miles, my car won't start for about five to ten minutes. I've had no problems while driving.
- The engine cranks, but doesn't turn over
- I can hear the fuel pump engage when i turn the ignition
- My crank sensor was replaced last summer, my SRS relay is good, as is my fuel injector relay
- Spark plugs and distributor cap are new
- It's a Regina fuel injection
I'm thinking RPM sensor at this point, but i'd hate to replace it if it's not the problem.
View 5 Replies
I'm really bad with cars but I'll try to be as specific as possible.
Car: 2002 VW Jetta
Basically the car will just stall out of nowhere while driving (not stopped at a light), I would say usually about 10-20 minutes after I started driving. After this, when I try to start it, it makes that noise like it is trying to start but the actual ignition doesn't happen. it usually takes me about 15 minutes to start it up again.
In addition to this, when driving, the RPM seems to randomly drop off often, and the car also jerks frequently, especially when I press on the pedal quickly.
View 5 Replies
I recently bought this car in its current no start condition after sitting 3 years. Initially I jumped it off and it just cranked, no attempt to start and no noise from either fuel pump.
I checked the fuses and the fuel pump relay behind/under the radio and it clicked and was dated 2006 so it had been replaced. I assumed it was replaced when the under car fuel pump was replaced at it was a replacement.
I sprayed a little starting fluid and it fired right up and ran until used up.
I ordered both pumps and strainer and installed the under car pump earlier this week. The in tank pump and strainer looked horrible and original. There was a small issue with the return line on the in tank fuel pump sending unit when I removed it that required brazing which I got back from the shop today.
This afternoon I installed the in tank pump & strainer on the sending unit and installed all that stuff. I spliced in a quick disconnect in the wiring harness for easy separation/installation next time.
Jumped the car again [yeah needs a battery] after everything was hooked back up and no in tank pump heard with key on to prime several times and no start although I hear the under car pump quit after attempting to start and they turned off.
Is there any other fuse/relay to check? If the under car fuel pump is evidently working, wouldn't it pull fuel without the in tank pump coming on? There's about 3 gallons in the tank. I'm going to test if there's current to the in tank pump tomorrow.
View 8 Replies
its 1986 Ranger with a 2.9L V6 Auto 4x4, well to start with it seriously over fueling also it idles very roughly and even stalls out sometimes, when I'm trying to hold it at a speed it acts like it is missing (I guess that's from over fueling as well and it also pukes out lots of black smoke, it goes through way too much gas for a V6), but when I speed up fairly hard it acts fine until I try to maintain speed again, I have already put a tune up into it and a new EGR as well a fuel regulator and how to fix it?
View 14 Replies
1997 Volvo 850 Engine Problem? My customer question is, during the times my customer drive, When my customer start the car & when my customer put it on drive, the engine shuts off. My customer was wondering what was the issue of the problem , ALLDATA 10.53 & what's causing it to happen.
View 2 Replies
so my car doesnt want to start so i am going to check a few things.
first how do i check my fuel pressure or the location?
View 5 Replies
We've had two problems within the last week with our 2002 Sport Trac (4.0l SOHC engine w/167,xxx miles). They may be unrelated, but I suspect there's good change they are. Both incidents happened while my 16 yo daughter was driving, so there's only very limited info on what happens. Both times, when I get there, it starts and runs fine. There is no CEL.
The first time it apparently stalled as she neared her destination after driving only about 2-3 miles at 35 mph or less after a cold start. She was slowing to pull into a parking lot and reported the dash lit up with warning lights, no power steering assist and no power brakes and no power from the engine. When I arrived it started and ran normally. She had fulled up the day before after two days of heavy rain, so I suspected water in the gas. I drove it more than 200 miles within the next 24 hours under a variety of conditions and filled up at a different station. I experienced no problem what-so-ever, and didn't bother adding any dry gas.
Then 5 days later (still on my fill-up) when she tried starting it after sitting all day, she reported the engine started but ran rough before stalling and never idled normally.
Doesn't the fact there's no CEL eliminate a lot of the upstream part of the control system......like sensors and actuators? This leaves things like the downstream parts of the fuel and ignition systems. I.e. from the fuel tank / pump to the injectors and the downstream parts of the ignition system.
What are the possible culprits? Fuel pump, fuel pressure regulator, injectors, ignition module, spark plugs, and....... what else? (I'm not that familiar with what these engines have) And of the possibilities, what are the most likely causes.
View 4 Replies
After replacing the intake manifold gasket for the second time, the truck would not start. Thought for sure it was my putting the distributor in wrong. After reviewing the forums, I am sure it is installed correctly. I have spark but no start. Engine cranks over nicely, but acts like it needs fuel. I hooked up a fuel gauge, turned on the key and get 56PSI. Lower than the 60 required. The pressure then slowly goes to 50 PSI. I pinched off the return hose and had the same readings. Pretty sure I need to replace the fuel pump. Is there anything else I need to check. I replaced the fuel pump a couple years ago with a Delphi unit. Maybe this is just a weak link for these trucks. My truck has a little over 100,000 miles on it.
View 14 Replies
