1994, 960 ... The vacuum controller has two "vacuum lines" attached to it. Should both lines have vacuum present? I keep getting a 241 code with sporadic idle and check engine light.
View 3 RepliesJust got a 35 on my check engine light. From the list of codes this has to do with a radiator fan control, but the fan is not electric. It's a 1994 Ram with 5.2L 318 engine. I'm confused, what does this mean?
View 7 Replies2004 XC90 T6. Local Volvo dealer (Bangkok at the time) said my check engine light was due to the O2 sensors going bad. I changed out the one under the car, then my wife threw out (accident) the other so I didn't change the one accessible from the hood. The check engine light went away so I figured that was that.
Fast forward a year later, I buy an Autel Maxiscan MS509 and now I'm getting check engine code P0455 which is probably the O2 sensors I didn't replace. Other than deductive reasoning, is there some way to look at the data on my OBD reader to confirm which O2 sensor is bad?
I have a 92 volvo 240 and have recently got a check engine light. I got a code reading of #241 on number 6 terminal. What that means and how to correct this problem?
View 1 RepliesI bought a 2005 Volvo V70 with 75,500 miles on Nov. 13. On Nov. 15, the check engine light went on, and I returned to the dealership for a solenoid replacement. The check engine light went on again on Nov. 17, oil pan replaced. On Nov. 19, the light went on again, timing belt replaced. On Nov. 22, the light went on again. Each time the code was the same--sometimes in conjunction with other codes--but one code was consistent. We returned the car on Nov. 22 and asked for a refund in keeping with the Massachusetts lemon law (an attempt at repair 3+ times). The dealer refused, saying the check engine light and computer code were not the same as an attempted repair. He took the car and said he was going to call Volvo Tech in. However, he says the light "went off" and never came back on even though his staff has test driven it 170 miles in the past three days. He's "releasing our car" to us, even though he has made no repair. Tell me--is trying to address the same computer code considered a "repair"?
View 13 RepliesI had a Check Engine Light a couple months ago, and I took the car to the garage to have it checked out. They told me they got a Fuel Pressure Sensor malfunction code, and that the sensor had to be replaced. I did so myself, an it is ridiculously easy, and the car worked fine. I noticed the Check Engine Light blinked a couple of times while I was driving, but never got steady. A couple of days ago, it did. Out of a bad gut-feeling, I purchased a ODBII scanner, and I scanned the car myself. I got the same error code as the garage did, but the sensor should be fine.
View 5 RepliesI have a 92 Volvo 240 (250k) with EGR (California car). I live in Alabama, no EGR needed here. There is check engine code that points to the EGR. It has been exhibiting all the symptoms of a defective EGR for quite a spell, check engine light just showing up recently.
Should I clean it, replace it ...or just take it off entirely. If I remove it, what needs to be done with that removal (such as ECU adjustment, replacement)?
I have a generic question about the check engine light on my 1994 C10 pick up. I have the 4.3L V6 auto and the check engine light comes on after I run it for around five minuets then it goes out after around ten minuets. My question is, does it have a change oil reminder and if so how do I reset it?
View 1 RepliesI had to change the battery in 1994 Volvo 850, and now the radio won't play because it needs the "code" to reset it. However, the owner's manuals are long-gne, and I don't know what the code is. how to re-set the radio without the code?
View 1 RepliesI own a 2002 Volvo S40 Turbo with the following problem. Every now and then the "Check Engine" light comes on. Then, when I turn the ignition off, the car shakes violently for several minutes. Last time this happened, I took the car to the dealer, and the computer diagnostics came up with this message: ECM-44 MISSFIRE, EMMISSION LEVEL, FAULTY SIGNAL INTERMITTENT FAULT. What is wrong, and how it can be fixed?
View 6 RepliesI have an '03 S60 - nonturbo with 239,000 miles. I've never had any performance problems with the car.
Here is the situation - The check engine light has gone on 3 times in about the last 2 months. It just happened for a fourth time today. Each time it's exactly, almost exactly the same distance from home, from a cold start on a hot day.
Same code each time. I don't remember what it was - something to do with the air mass meter - it was on the paperwork from the dealer that I can't find right now.
First time the code came on was two days after getting the air filter changed so I suspected they didn't assemble the air filter case properly. I brought it into the mechanic. They recommended pressure cleaning the throttle body and changing the air mass meter. I opted not to do it and they just reset the light.
Second time I remember putting oil and an oil additive in (Lukas oil) to top off the oil in the car before I left.
Brought it back to the dealer and when I spoke to the mechanic at the dealership.He said I could do the throttle body cleaning and change the meter, but that wasn't the problem. He warned of some sort of internal engine problem suggesting that an oil path from the top to the bottom of the engine is clogged and causing some sort of other ambiguous issue in the engine.
Btw according to the car computer it gets 31 miles to the gallon.
Third time- I topped the car off with oil (cheap 7-11 oil). I drove the same distance and the light went on.
The second two times the light went off on its own.
Fourth time just happened on a quick errand. Car had been sitting for about 3 hours since it last ran. When I ran it earlier today I didn't have the light come on.
I should note that several years ago (at about 180,000) the engine had some sort of check valve at the back of the engine replaced twice because it was whistling.(With the whistling the check engine light did not go on). The second time it was replaced they did an oil cleaning procedure that cleaned the oil path from the top to the bottom of the engine.
Is this really a devastating engine problem? What's going on?
Have a Volvo XC70 and LOVE it! Recently ETS light came on and Check engine has always been on, mechanics did not seem to worried in past. As of the last month seemed to be issue with thermostat... Car would warm to normal when idling and driving below 25 mph... once I accelerated needle would drop and thermostat would go to baseline... Could feel faint warm air, but was only getting cold air coming from vents... Thought it might be thermostat stuck open?
Called my trusted mechanic and he recommended going to a radiator specialist, felt he might not be able to solve. Went to new shop today, after dropping off at 8am when they opened and not hearing from them until 4:45pm, 15 minutes before they close... Car is fixed, or so they say. Hot air is indeed coming out of vents and needle is staying where it should without falling...
BUT, now there is a strange smell (sulfur"ish") coming from the engine, and the car is shuddering and vibrating, bucking almost when car comes to a stop and then accelerates. ETS light is back on and check engine is now flashing!?! Tried going up hill on the way home and could not go faster than 20mph? None of this was happening before I took it in to the new shop today? They changed oil and oil filter and flushed radiater?
My mother in-law has a 94 Chrysler LHS, 3.5 V6, auto, 66k. Yesterday she was driving home and said the check engine light was on. I went to check it out and the light was not on. The light come on when the key is turned on but goes out when it is started. This is not an OBD-2 car it has a little blue plug and i do not have a code reader for it. Took it to auto zone and they do not have a code reader for this car. Auto Zone and Pep Boys both told me that if the light is off there will not be a code. Further checking on the internet I found out you can get a two digit code by turning the key on and off and count the flashing check engine light. It worked I got code 12 and 51. 51 means lean O2 sensor. If this is true that why does the CEL not stay on. How can I test the O2 sensors?
View 2 RepliesI can't find a listing for a 511 diagnostic code for my 1994 960.
View 1 RepliesI have a 2002 volvo S60 2.4T that I just had the check engine light come on so I pulled the codes and here is what I found,
PO403
PO611
P1378
P2623
So my question is what does this mean ? what is wrong ?
The Check Engine Light is on. Diagnostic Codes: P0722, P1618, and P1633. Do these mean the output speed sensor/connector wires should be replaced? Is this a DIY job?
View 1 RepliesMy mothers 2004 Volvo S40 (original body style) has an illuminated check engine light. Dad took it to their local dealer. Unable to get a code from the cars computer and guessing the problem might be with the fuel filler cap seal, the dealer sold them a new fuel filler cap, offering them a refund on the cap should that solution not work. It did not.
View 2 RepliesSo this little gem of an SUV has been good enough to me over the year that I have had it, but it is one of those used vehicles that has me scared to look underneath cause there is always something a miss.
I have been having some power problems and the OBD check engine light has been coming on. The engine like to putter like if it's not getting enough fuel from a clogged fuel filter when it gets going, hot or cold. Have confirmed that the fuel pump is with proper voltage and pressure. Though haven't noticed a big difference with the new filter. The check engine light cycles a code of 21, which is refinanced to the O2 sensor, both upstream and down stream. That tells me that there are TWO O2 sensors for this model. And research has confirmed this. One ahead of the cat and one behind the cat.
Here's the kicker, I only have one O2 sensor at the head of the cat and the location of where the second one would be located is only a solid section of pipe from cat to muffler. I haven't been able to track down the plug connection for the second sensor and these codes and problem only came after I gave the Jeep a tune up.
1994 Jeep Grand Cherokee Limited V8
I have a 2007 XC90 3.2 RWD with around 112,800 miles.
On acceleration, there is a rattle (not a valve knocking) that gets quieter once a steady cruise is achieved. At idle in gear, a very quiet rattle can be heard. When transmission is slipped into neutral, the rattle goes away. The engine shifts normally, accelerates normally and gas mileage is steady at around 20.5 mpg (mixed city and highway). I am using 93 octane gas. This week the check engine light came on.
A few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
Issues with check engine light coming on and staying on. The dealer says it is either a gas cap problem or the type of gas being put in the car. Dealer recommends only using Shell fuel. The car drives fine and am wondering if this might be sensitive fuel detection.
View 2 Replies