Volvo :: 1992 Stalls When Hot / Restarts After About 20 Minutes
Jun 26, 2013
Have swapped the following parts from my 92 240 into my 93 240 without any change in my stalling issue:
AMM, coil, ignition module, fuel relay, spun all fuses and checked hose between throttle body and AMM for holes.
Was super hot in NM today and after driving the car about 1/2 an hour it stalled and would not restart until it cooled off for about 20 minutes.
It doesn't seem to matter what level the fuel tank is. Stalled the other day when it was full.
View 7 Replies
Advertisement
My 2000 Mercedes Benz ML 320 with 203,000 miles stalls when I stop at traffic signals. It restarts after a few minutes. Yesterday it would not restart for several minutes after I stopped for gas.
View 5 Replies
1992 Volvo 240 ... I'm having car jerking problem after running for about 20 minutes at speed between 90 -110 kph. Car stabilizes again when the speed comes back to 90kph. There is no problem initially when running beyond 120kph when the engine first started up. The problem only starts after a short while.
View 1 Replies
Have a '92 Olds Cutlass Ciera 6 cyl 3300 engine. After 20-30 mins of driving it dies when I have to stop for a light. Depressing the brake kills the engine. Starts right up after but as soon as I put it in drive, it dies. If the car sits for 20 mins or so after problem begins it's okay. If I get to an intersection and have to stop, I put it in neutral. When I have to go again I rev the engine, let it die down some and then put it in drive (hard on the car, I know, but it's only way to get going again. Once I'm moving, I can accelerate and it's okay. What is wrong with my car?
View 3 Replies
1992 Mercedes 300E with 160,000 miles that I've owned for 15 years. Car runs fine for approximately 10-20 minutes and then starts to sputter and cough and if I don't increase the RPM's it will stall. If I increase the RPM's it will smooth out for a little while, but after a couple of minutes with higher RPM's it will sputter again and finally stall. After it sits for awhile I can start it up again and it runs fine for another 10-20 minutes. No check engine light is on and the car is OBD 1.
This problem preceded the weather recently turning cold. Thus far I replaced the spark plug wires as the other ones were old, but this didn't work. The spark plugs themselves were replaced about 2 years ago. At this point I'm suspecting it needs a new distributor cap and rotor (when I replaced the wires some of the cap's posts had corrosion, which I cleaned off with a brush).
View 2 Replies
my daughter has a 91 volvo 240 with a 4cyl and auto. roughly 100000 miles. it starts and runs fine but after driving it, if it is shut off for less than 30 min, then she tries to start it again, it stalls immediately. she can keep her foot on the gas slightly and drive it the distance of a parking lot, the car will run fine and not stall. i was curious if a tune up would fix this or if there is a smaller fix such as a sensor.
View 1 Replies
My 1990 Jeep Cherokee (automatic trans) will occasionally stall. The engine stops turning, the tachy goes to 0, no power steering, no power brakes. After I come to a stop I can always start it right back up. The previous owner suspected it was the ignition switch because the vehicle was stolen multiple times, column broken, etc. but I took the switch out and everything seems good and tight there. I tested the switch, not connected to the lock and I couldn't get it to duplicate the problem. It locks cleanly into each position. Start position has strong spring. I tested all the positions with the ohmeter. I drove around with the switch disconnected from the lock and wiggled it as I drove and I couldn't get it to stall. Sometimes I can go days without a problem and other times it will do it three times in a mile long drive.
I've searched the Internet for an answer but all the other posts about stalling the owners have trouble restarting their vehicle. Mine has never failed to restart after stalling. When it stalls it is a sudden loss of engine, no coughing or sputtering. The tachy drops to zero along with oil pressure, etc but the radio, lights, etc stays on. If I wiggle the key in the ignition I can't get it to start back up even if I'm coasting along at 40 mph. I have to turn the key back to the start position.
View 6 Replies
I have a 2005 GX470 with 96,000 miles. Yesterday, while going on a 500 mile road trip the car stalled suddenly while traveling about 75mph on the interstate. It would start surging and then just stall completely. I pulled over.. Let the car sit for a minute and then it started right back up with no trouble. It did this to me 4 times on the trip about 80-100 miles between issues. The last time it was while accelerating hard up hill. All other electrical functions.. Radio, lights, etc... continued to work fine. I don't recall the cel ever coming on and even if it did it wasn't on when it restarts. It was 100 degrees out.
I'm on vacation so wanted to get it checked put before we head home but curious on thoughts of what it might be? I was thinking clogged fuel filter or MAS but the fact that it restarts right up after stalling makes me ink it might be more of an electrical issue.
View 4 Replies
I own a 1992 Volvo 240 and most of my speakers are blown. I want to get new speakers (all 4 of them) but I don't want some old salvaged Volvo 240 speakers. I want to buy some nice new speakers. I'm new when it comes to anything involving changing something in a car, so what speakers will fit and easily take place of those speakers where I won't have to do any unnecessary cutting or modify in order to get them to fit (I don't want holes also).
View 19 Replies
Car has begun to idle very fast ( comes and goes ) ( 1992 240 ) ....
View 2 Replies
I just picked up this old 240 wagon with 230k miles on it for next to nothing due to a transmission issue. It stays stuck in 1st gear for about the first 15 minutes of drive time and then starts shifting perfectly after that. I took it to a transmission specialist and he thought the valve body may be sticking. I also had an experienced volvo tech adjust the kick down cable but so far its still having the same issue.
View 5 Replies
I have a 1992 Toyota Camry EL that has been running fine - up until about 3 weeks ago. It has developed a problem of stalling when idling, sometimes, not always. My mechanic has replaced the vacuum hose to the idle air control after finding it was cracked. It kept on stalling after that. Then he replaced the exhaust gas recycling valve assembly, but it still will stall at times. I have noticed that sometimes the engine will rev way up then way down while I'm sitting at a stop light. This morning it stalled while I backed out of a parking spot. Only 95K miles on this car, and I would like to keep it going if possible.
View 2 Replies
Purchased a new-to-us 1st gen dodge pickup, a 92 D150 v6. It's used once or twice a week at max and only has around 90k miles on it.
So a few months after we bought the truck, it stalled, or more like choked, out while driving on these country, hilly roads, at around 50 mph.. it happened once and we didn't think much of it. It happened again not too long after that, though, and we discovered we could push through the stall/choke by giving it a lot of gas.. it sounds terrible, and shakes and sputters, but eventually catches back and starts to run normal.
As months passed, the problem happened more often. So we changed the spark plugs and wires recently. No difference. In a given 40 minute trip along 45-55 mph country roads, the truck will choke and sputter at least 5 or 6 times. It's now so bad that sometimes giving it gas isn't enough to fix the issue and we have to pull over.
We've got an appt scheduled with a mechanic, Our friends think maybe it has to do with the choke plate or carburetor. It seems to happen more often if the AC is on, and other than this, the truck runs great. It starts up fast and idles fine.
View 12 Replies
1992 240. A couple days ago, the car started fine, but immediately started running erratically, feeling like it was about to stall out at lower speeds and then, whenever I gave it a lot of gas, it would stall out or nearly stall out.
Then, after about 5 minutes of driving and then stopping the car, it took about 15-20 seconds of turning over to start. After 10-15 minutes of driving, all seemed fine and it started totally fine after that a little later that day. Next day, same issue takes a lot to start, stalls when I press down on the gas a lot/suddenly from low gear.
Not sure if it has anything to do with it, but we live in Los Angeles and it's just now started to get "cold", with our first chilly day same day this started happening, on Monday.
Not sure if it's the air intake or a fuel injection issue....
View 1 Replies
My "bulb out" dashboard indicator came on and after checking all lights I could not find a burnt out bulb. I took the car to the local dealer and they told me the "bulb failure relay" was bad and needed replacing. I decided to try and replace it myself but so far I'm not doing to good.
I found this picture on another website and also read that the realy is permantly mounted to the relay board. Also, when I looked at pictures of the replacement relay they lok nothing like the original.
So now I'm wondering how the heck do you take the old relay out and get the new one in that doesn't at all look like the original?
Attached File(s) : RelayPanel760960A.gif ( 31.06K )
View 9 Replies
I own a 1992 Volvo 740 wagon, non-turbo. Super solid car up until a month ago when it developed a grinding sound and vibration when slowing down from 15-0 mph. There is no noise or pulsating at any other speed when I apply the brakes. This happens with tranny in N or D. I replaced the front rotors and pads about a month before this started happening.
I suspected the rear brakes so I also replaced the rotors and pads but I was still getting that grinding/ vibration. The next thing was to replace the hub/bearing assembly, I only did the drivers side because I banged it up pretty bad when replacing the rotors. This also had no effect on the grinding. I also noticed that when driving at moderate to fast speed I hear a humming noise, almost like big truck tires make. This is especially noticeable when letting off the gas and coasting. Could this be a tranny issue?
View 3 Replies
92 Dakota 3.9L ... Starts and runs great. Engine shuts down, usually within first 30 minutes after starting. No shutter, just as if you turned off the key. It has not been an everyday occurrence.
I can wait 2 minutes or spray brake cleaner in the intake and it will restart. It will run the rest of the day and never happens again on the same day, even with multiple restarts and driving 100 miles.
I have installed a new ASD relay, new fuel pump relay, new fuel pump, new crank sensor and new air valve controller on the intake. They can't seem to catch it when it happens.
View 2 Replies
Wife's daily driver often stalls when coming to a stop. I changed MAP, TPS, Fuel filter; Reputable mechanic changed IAC, Plugs, Wires, Cleaned Throttle Body. We reset computer and relearned idle several times, ok for a while then starts stalling routinely again. What to do next? Owner, driver, wife is getting frustrated with the big money spent to no avail to date and I am worried it will stall at a dangerous time, when she is driving. She loves the car - has had it for 20 years and wants to keep it. I need it to be safe and reliable for her.
1992 Pontiac Firebird 3.1L, Auto, Air
View 3 Replies
Why my 92Honda accord lx stalls when the d4 light flashes
View 2 Replies
Cranks strong, I have fuel to the rail, 12V at the injectors and spark. Have changed crank sensor and 2 relays?
View 3 Replies
I just got caught in the rain, literally, a freeway ramp was partially flooded, saw other cars go through a "puddle" and with safety distance proceeded. About 9 feet away from the edge of this water accumulation my engine sputtered and turned off on me and I recall seeing some, but not much white smoke coming out of the hood. I didn't leave the car as when I look right next to me I saw only water, about 1/2 the height of my tire surrounding me. AAA came pretty fast and pulled me out of that wet mess and mentioned it could be just as simple as overheating. It's about 2 hours later and I tried my engine but all it does is struggling to turn on. I turned it off immediately. I checked my coolant level - empty as it can get, and also my dipstick in the oil seems to be not right. Transmission fluid is fine though. Could those two fluids be the problem to why my engine is not starting? Or could it be that something got too wet? Once I turn the key in the 1 position shows electricity is fine and all lights come on with Overdrive and SRS going off after a short while. 1992 Volvo 240 ...
View 4 Replies
