Volvo :: 1992 960 Wagon Making Moaning Noise When Making Significant Turn At Low Speed
Aug 29, 2013
my 1992 960 wagon with 332K miles today started making a moaning noise when making a significant turn at low speed. At first it seemed to be only when I was accelerating but if that was true, it now is doing it at any low-speed big turn. Tonight, turning around in the driveway, it added what I call juddering during the turn. So naturally I am concerned.If it is something as minor as power steering fluid I might trust a local gas station to fill it up, but probably not any more than that. (There used to be a dealer about 45" away, but they seem to be gone now, and the closest one is hours away. I am 250 miles and one week away from my own trusted mechanic, so I hope it is something like fluid!).I haven't noticed any puddles on the driveway where it is parked, but I suppose it could leak out only when the engine is on and the car is moving.
View 4 Replies
Advertisement
I have a 1992 850 Estate (wagon) which has been making a funny noise when driving. I cannot locate it. The noise only happens when driving, I have never herd it when stationary. Most often when cold but not exclusively. I have examined all the items attached to the engine driven by the serpentine belt all run smoothly. The belt was changed just after I bought it.
I have checked the wheel arches to see if the tyres rub but no. The suspension is fairly new with new anti-roll bar links fitted for last MOT. The noise sounds like a dry bearing and is a combination of a rub and a screech, there is no loss of coolant but I suspect the water pump or one of the tensioning rollers to be at fault. The last owner told me that the belt had been changed a few months before I bought the car (off Ebay) but he did not say anything about the rollers or water pump and I did not ask.
One other point is that when I bought the car I had to add a full 5 litres of oil to the sump due to their being no oil on the dip stick. Since then the engine has run well (good engineering) but this noise is happening and as I have said it is driving me nuts.
Attached File(s)
volvo_011.JPG ( 588.86K )
volvo_008.JPG ( 530.3K )
View 5 Replies
"I have a 2001 XC70 WAGON and is making big noise while moving, bigger the speed bigger the noise, engine in idle and in N (while in speed) the same. Could this be because of tires?
View 2 Replies
I've been having this moaning noise coming from either my wheel bearings or something else. I'm not quite sure what exactly it is, but it's real bad when I'm making left lane changes and going straight. when I turn right, or lane change right, it's silent.
View 5 Replies
I have owned a 2002 Volvo S60 2.4L for the past two years, and she has served me well. However, I have been having issues lately. She has hit 179,400-ish miles and with age things have started to fail. I want to know how much it will cost to fix these things and if I can do it myself.
There is a metallic popping noise coming from the right front side of the vehicle every time I make a turn (I haven't particularly noticed if it's a left- or right-hand turn when it happens.) I have been advised by my father that it's probably a CV (constant velocity) joint. Is that what's causing the noise?
My right front headlight has gone out, and I've replaced the bulb as well as the fuse, but it's still out. Could it be faulty wiring? The left front blinker has stopped blinking, I hope that's as simple as changing out the bulb.
The shift is automatic, but in the mornings (I've noticed it's mostly when it's cold outside) I attempt to move the shifter out of park and it won't budge for several minutes. Sometimes I have to turn the engine off, and then turn it back on for the shifter to move.
One last question- how often should I change and/or flush my transmission fluid and the filter, and can I do that myself or should I take it to the dealership? (Which I am reluctant to do.)
View 4 Replies
At 120k miles, my 2003 Camry LE 2.4L started to make some noise when making sharp right turn at low speed (below 5mph) going forward. It sounds like the tire rubbing the fender or somewhere, not metallic, and it's periodic, at 2-3Hz or so. It comes from somewhere on the driver side but I'm not sure. The car doesn't make noise when turning at stop or backing up or going straight, and the noise seems to disappear if turning at higher speed (maybe the turn is not sharp enough).
First I suspect the tire is rubbing the fender. But after inspection, no rubbing marks can be found, and there seems no rubbing when the car is parked and the wheel turn all the way to the right. Then I suspect a bad CV axle. But the boots seem in good shape with no leaking grease, and there's no noise when backing up.
View 1 Replies
So I got my Haldex fluid and DSG fluid changed two weeks ago. When I picked the car up I noticed a vibration when I was making tight turns. Last week I called the dealer and told them. They said to drive it a bit more to see if it works it self out. But now after getting back from H2Oi, it still is doing it but not as bad.
Its a vibration you can feel and a rumble you can hear when making a tight turn at slow speed. Like turning into a parking space or turning at a stop sign. What would this be? I searched but couldn't find an exact answer.
View 1 Replies
My girlfriend has an 04 Passat Wagon (dunno how many miles on the odo), and it makes a groaning noise that gets louder and more pronounced the more she cranks the wheel. She took it in a few weeks ago to a place that specializes in European cars, and they changed the serpentine belt. Since then, the issue has gotten worse.
My very limited knowledge tells me that it might be the power steering pump, but I know next to nothing about this sort of thing, and even less than that w/re to VWs, except that the Germans sometimes engineer things a bit differently than most of the rest of the world. For all I know, the car doesn't even have a power steering pump and uses some other sort of electro-mechanical method to operate.
View 5 Replies
My '92 Ford Tempo's balancer has been making noise at idle; worse when in gear. I replaced the tensioner pulley and belt. It has a 2.3 (4cyl), with 45,000 original miles. My mechanic said it can't be replaced without pulling the engine. Is it safe to drive, especially long distance.
View 7 Replies
I have a 1998 Volvo S70 with 140k. 2.5 litre 5cyl automatic. For sometime now my lifters have been making noise especially at start up. I'm up to date on my oil servicing using Volvo filters and a 20-50w motor oil ( as recommended by my mechanic ) but still the noise continues. In the past I have used additives to the oil but still the problem continues. Maybe I'm using the wrong one.
View 7 Replies
My 1992 240 wagon (injection) is intermittently stalling, and missing. The lambda light is on the dash. Last year it was doing something similar, but not as bad, and I took it to Volvo and they cleaned the throttle body and said it should be ok, and it was for a while, but now it's worse. Ignition parts are mostly new, I doubt it's that. When it stalls it nearly always starts straight away. When it's missing badly but not stalling, pressing the acc peddle does nothing, until it eventually catches on and revs properly.
I also find that when I have a full tank it's not so bad. When the tank was nearly empty it was particularly bad - it's winter and I was suspecting there was condensation in the tank.
Is there a 'backyard' way of getting the error codes? This could be a good start.
View 14 Replies
My 1990 Volvo is making a terrible noise at about 20-30 miles per hour. It only lasts a few minutes but it sounds like a plane taking off underneath the passenger seat (wagon). Had the muffler replaced, but it didn't fix the noise. I also have a high pitched noise at freeway speeds.
View 2 Replies
My 1992 960 automatic wagon with 326K miles has started to kind of lurch into low gear, especially from a stop or a rolling stop where I am not giving any gas but not using the brake. Then when I do give it some gas, it doesn't do anything at first, then it clunks into motion, and it seems to me the rpms are pretty high (3K). Once it gets going it seems fine, and it upshifts and downshifts as expected (well, occasionally it clunks changing gears at highway speeds, but it has done that for a long time). Yesterday during stop-and-go traffic (more than 100 miles worth) I was so stressed out wondering if it was going to completely die.
The winter mode arrow indicators have been stuck On for years, by the way, but it has never acted as if it thought it really was in winter mode (where you start up in third). They didn't think it was worth fixing, as it would have been very expensive and wasn't really affecting anything. I don't think my current issue could be that, though -- surely it wouldn't be clunking into gear then?
View 3 Replies
Recently I overhauled the engine put new rod bearing and had it bored and honed. As well as new pistons. when i first started it, it ran fairly good except for the tappets making noise but i thought this was normal. after 40 miles the tappets were still making noise and the oil light began flickering. I replaced the oil pan o rings with no luck. i also took the pump apart to check that and still nothing. I have a feeling a main bearing might have been put in the wrong spot. What should i do next to confirm this? what should i do from this point on?
View 4 Replies
We just bought a 2011 XC90 in Jan 2011. About a week ago we noticed that when you are using the brake and turning a corner there is a weird noise coming from the front end. It only does it at low speeds. It doesn't do it if you turn and you are not pressing the brakes. You can also feel it in the brake pedal as well. I hope this makes sense. We love this car and really don't want to regret that we bought it. Just really confused on how a 2 month old vehicle can be already making a weird noise.
View 17 Replies
I have a '99 Volvo V70 XC AWD that is making a high pitched whine that sounds kind of like a siren at times. Usually goes away if I'm driving at high speed on the highway. It's more pronounced during in-town driving on acceleration/deceleration. Turbo?
View 3 Replies
I drive a 2006 Volvo V50 with 65k. Recently the car started making a noise and the dealership told me that I need new front wheel hubs because my bearings are shot. The car has always been well within the weight limit, has never been through deep water (we do line in the pac NW so there is a decent amount of rain), and has had complete service at all of the maintenance times. I think that under 125k bearings should not be giving out and that volvo should replace the bearings for free - the mechanic is telling me that there is no set time for bearings to wear out - it can happen at literally any time/mileage/age and it would not be the company's fault. Who is correct?
View 10 Replies
We were driving last weekend in a heavy rain storm when our 2004 XC70 started making a loud siren noise. The noise increased with acceleration. We pulled off the road, turned the car off. When restarted the sound was gone, but then returned again when driving in heavy rain. Any clues as to what is causing this noise and if it needs attention?
View 21 Replies
I've had my MY 08 R32 (Australian delivered) for almost 4 months. It's done about 8300kms so far and I've noticed awhile ago that the car makes clunking noise when I'm turning the steering wheel a lot at low speed (eg. car parks). I'll probably book in for a oil change and ask the service centre to look into it.
View 6 Replies
So ive been having issues with my trans 6 speed manual making noise and took it to the dealer. They more or less told me the trans is done, something with the linkage, need a new trans and clutch. They also told me my warranty was void because there was indication of a cold air intake before i bought the car and have reason to believe it's due to abuse. I've only driven this car 3,000 miles and have taken care not to beat or sport shift the car to avoid this very problem. I can't argue the fact that the previous owner could have very well driven the car hard and the problem might have been a ticking time bomb. I guess my best bet is to find a used trans and install myself but really dont know where to start.
View 24 Replies
I have a 2001 accent 5-spd. I was on my way to work and I was making a u-turn when the car suddenly died. I tried to start it back up but it didn't even sound like it was turning over. I tried to bump start it or do a rolling start and nothing. I had to go to work. When I returned to it 8 hours later I again tried to start it and nothing. When I turn the key it makes a "whirring" or "humming" noise, kind of like a vacuum noise. When I had someone else try to turn it, I noticed the belt was turning, but the engine wouldn't crank or make any attempt to turn over. Just the belt was spinning and no engine crank. What could this be?? Could it be the crank position sensor?
View 1 Replies
