My 1988 240DL wagon....the engine temp gauge is not working? is see the wire that goes to the sensor in the engine block, it is there and connected to the sensor. is there a way to test the wire? I have purchased a new sensor, but I have not replaced it yet.
View 1 RepliesI was recently given my first Volvo. Its an 88 240dl. While driving my temp gauge climbs up to the red and sometimes hovers inside of it. It normally climbs up at stop signs and comes down on straight always then climbs right back up close to red. When the gauge was in the red i stopped the car and popped the hood open to see that the engine was not actually overly hot.
first i replaced coolant. nothing
then i replaced the thermostat. nothing
flushed radiator. nothing
Today i finally had enough and decided to switch out the water pump with a new one hoping that it would solve the problem seeing as it still had the factory one on. It did nothing. the gauge continues to climb up. I did replace one of the two senders in hope that it would fix the gauge reading but nothing.
My 1988 240DL is miss firing #4 cylinder. I cannot get it to fire. this is what I have done:
Swapped plug wires with the #3 wire. Miss fire does not follow the wire
Swapped plugs with #1 plug. Miss fire does not follow the plug
Tested injector power with a tester and it lights up properly
Replaces #4 injector with a new one, still miss fires.
Replaced cap and rotor
Compression test shows 150 LB in #4
sworn and thrown a few tools, still miss fires.
Spark seems good with the plug out and grounded on the block. What else should I test and or try...
i have an 88 volvo 240 wagon with 89K miles on it... it's been passed down through the family, is in great shape and is a joy to own. i have always have it serviced at the volvo dealership and recently had a bunch of work done to it including complete lube, oil and filter change, replaced the radiator overflow cap, replaced a leaking valve cover gasket, replaced the oil pan gasket, replaced the rear diff gasket and added oil, and replaced the sway bar links (it was an expensive visit).
to my dismay, on the way home, accelerating hard up a hill, something under the car started to rattle and black smoke started coming out of the back of the car. i took it back to the dealership and they replaced a leaking seal that they said was the problem, on the way home, same thing with the rattle and smoke happened on the same hill... maybe just stop driving on that hill, right? so i took it back and they changed the oil again (the oil levels were a bit high) and said they couldn't find anything wrong... drove the car home and seemed not to have the problem (though i did take it easy on the hill).
so today, i take the car out for a drive (usually just drive it on the weekend), and accelerating hard up the same hill i get the same rattling and black smoke that continues until i let off the acceleration. by the time i get home (a couple blocks later), it's like nothing ever happened.
Is it safe to drive as long as i don't accelerate hard? Never had this issue before all the work was done, kind of seems like i should take the car back to the dealership, but this would be the 4th time for the same issue...
I have a 2005 mk4 gli and the other morning I went out to start my car for work and all I got was crank no start. I then realized my fuel pump wasn't priming when I opened the driver door. After work I came back and checked the fuel pump fuse and swapped the relay with another I had, still nothing. A buddy of mine came to me and decided to check the connector at the fuel pump for power, using a power probe I believe he hit all or the majority of the wires with 12v of negative and/or positive power. He then unplugged the connector and plugged it back in and the car fired right up. But I noticed that my fuel gauge, engine temp gauge, and outside air temp readout were all not functioning.
View 1 Replies2002 ford sport trac.I have been having an ongoing issue that started with the engine cranking but would not turn over until an hour passed. After replacing multiple parts (cam shaft sensor, crankshaft sensor, ignition pack) I am now down to poor fuel economy as the last of the issues (roughly 12 in the city and 15 highway). I was told the issue may be the engine coolant temperature sensor going bad so I decided to replace it. I found this was very difficult due to it being a plug and locking pin design and in a very tight spot in the engine.
I tried to purchase a replacement and the parts store kept trying to insist on selling me a part with threading. I finally found someone that figured out the issue and found the part for the 2001 sport trac had the same plug style with clip that did fit but was shaped a little different on the sensor end which I assume was due to being aftermarket. I noticed that there were two plugs side by side and the one easiest to access was on the left and I was told the one on the right was the sensor that gave the temperature reading to the gauge.
After installing the engine coolant temperature sensor I found the temperature gauge on the dash now will not respond and is sitting below the cold end of the gauge completely off. Is it possible this is because the part was for a 2001? Is the sensor on the left (passenger side) the engine coolant sensor?I would hate to put the old sensor back in just to test if that's the issue due how difficult it was to put that locking pin back on. What to check that could resolve the gauge issue before pulling this sensor back out?
I just purchased a 1986 Volvo 240DL, it runs great, but slow and the Ac is like ice. Only real issues are a rattling coming from the rear(exhaust mount I think) and
most importantly the steering is super light. No effort required at all.
I just got my 1996 volvo 850 turbo wagon running, after I replaced a valve, lapped all the valves and replaced all valve stem seals/full stage zero(timing belt, plugs, wires, cap, rotor, thermostat). Boy was she a strong runner, for the whole day it was running. I do admit to abusing it quite a bit. But what else would you expect from an 18 year old kid who just rebuilt his first volvo engine ? Now, i will note that the car had horrid previous owners, that took no care of the car(ran it low on oil and who knows what else). I know I ran it out of oil once, on the way home from buying it.....the guy did not put the oil filter on tight enough, and it blew the oil filter seal out. Luckily volvo's have low oil sensors. after i rebuilt the top end my engine was throwing out blue smoke for a while, but i thought it was just a bad turbo bearing.
Anyways, to cut to the chase; My engine sounds like this one. [URL]......
I did a compression check, all cylinders at 180 psi. all my lifters look good. I had a few plugged oil passages in the cam cover, but none that go to the lifters. i pushed on all valve springs, they look good. i used a screwdriver and hammer to check if the valve guides pulled out, and the valves are solid in place. I was still making boost even though the engine was knocking like this, so i know its not a rod bearing, because the knock sensors would have picked up on it and dropped the boost.
I have an '89 740 wagon, Bosch ignition. It will not start. If I spray starter fluid, it will fire, then immediately die. I have replaced already both fuel pumps, noise suppressor/fuel injector relay, fuel pump relays.
I installed a fuse in the fuse box, which was empty when I purchased the car. And the engine instantly died. It did start up when the fuse was removed, and I drove it back across country. The idle got worse until it died and would not start back home.
We bought a new 2012 Volvo XC 70 wagon. It only has 6,000 miles on it and the Check oil light has gone on three times. Each time it has required approximately one quart (which the dealer claims is "within specs" for this engine). I believe it satisfies the lemon law criteria in PA since it has been back to the shop three times in less than a year. Should I insist on a replacement or is this "normal" wear for this car.
View 19 RepliesI am new to my car. It is an '95 turbo wagon with a 5 speed conversion and a ARP orange ECU. The issue is the car is holding shift rpm for 4-5 seconds after I take my foot off the gas. Since I am taking the load off the motor when I clutch in, it actually climbs higher before it drops off. Needless to say it is not really drivable in traffic that way! The idle rpm is ok and the car pulls really well when accelerating. I have checked for vacuum leaks and I am heading for the Idle Air Control valve. I don't think the engine has any other mods and it is pretty high milage (188k).
View 1 RepliesMy 1989 740 Turbo wagon cuts out while I'm driving. It only ever does it at about the point when the engine first reaches its normal operating temperature. It can cut out while idling or when driving at normal speed. I'm not sure if it's related to temperature or time (it usually cuts out at about the 5-8 minute mark), or if this is simply coincidental. It does it nearly every day.
It's definitely caused by the fuel pump relay cutting out. I've replaced this already, with no improvement. Something is causing the relay to suddenly lose an input.
Once cut, it takes a few quick flicks of the key to the START position for the fuel pump relay to receive power again. It will then drive faultlessly for the rest of the day. Although, if allowed to sit and cool for many hours, it will sometimes do this again.
I have a 1988 Volvo 240 DL station wagon that has been in my family since just before I was born. It has somewhere around 300K miles on it (the odometer broke 7 years ago at 250K). It drives around town more or less fine, usually. But sometimes it loses power on me. Usually this happens when I take it on highways, up big hills, in situations where I need to accelerate quickly, etc. It just starts to slow down, and I have to downshift and ease slowly through whatever stretch of road I'm on until I can get back up to speed (usually on a downhill). It's not totally consistent--sometimes it has this problem, other times it doesn't.
The car will go through stretches where it runs fine, then I'll have this problem on a highway, and then it's a little more likely to happen for a period after that (even on surface streets). This has been happening in some form for a few years. When I first had the problem, it happened continually until I heard a terrible rattling in the engine. When I took it in, they found that a spring in the piston/cylinder had broken off and shot up, breaking the cap off one of the cylinders (sorry for the lack of a more technical explanation).
When they fixed that, the problem seemed to go away for a while, but eventually came back (though there has been no rattling since). The most recent time, it had been running around town just fine. Then I took it out on the highway and really lost power--had to slow it down to 35-40mph going up a hill on a 55mph highway. For the rest of the drive it struggled up hills, even as low as 2nd gear. But on my drive home (about 1.5 hours later), the car ran smoothly (though I continued to baby it, and there were fewer upward hills). Since then, even around town it sometimes feels like it might lose power again, but it never becomes a huge issue because I haven't demanded a whole lot of the car.
After that long-winded explanation, I'm wondering: could this be something as simple as spark plugs? Or is this definitely a bigger issue with the engine? If it's a cheap fix, I'm happy to go for it, but if it will require putting several hundred (or more) into the engine, I'm inclined just to let it limp along until it's finally time to take the car out back and shoot it. Figuratively, of course.
I have an 88 volvo 244Dl with major hesitation while driving down the road. I recently had a no start issue and after a week at the shop it was fixed. During that repair it received: New Dist, cap, rotor, timing belt, coolant sensor, plugs, wires. With the hesitation I checked vacuum lines, cleaned T/B and MAA.
One thing I noticed, which seems weird... When the engine is hesitating, missing.. the radio becomes somewhat staticy. The reception of the radio mimics the hesitation of the engine.
I have a 1990 volvo 240 dl and the gas gauge no longer works. Just wondering if there's anything I can do to fix it.
View 1 RepliesDriving home from work today, normal day in the high 60s, my temp gauge randomly stopped working. It was right at the 190 mark where it should be then a few miles from my house it just dropped to 0. When I got to my house and turned it off the fans stayed on for quite a few minutes.
I went inside and looked around on a few different forums. Most people said it was the thermostat or some sensor that could have crapped out.
Probably 30 minutes later I went out to restart it hoping the problem magically disappeared and it actually did. Start up and went straight up to 190 as it should. Turned it off to no fans as usual.
What this could be? Could it just be a sensor on the way out? Still under warranty so might try calling the dealer tomorrow when they open to ask for their input.
Just as reference my car is a 2011 with about 48k and is revo stage 1 for about 3k.
My 2001 Malibu v-6 temp gauge is not working. I have replaced the temp sending unit and it works for a few weeks unit it goes out. What keeps killing the temp sendor?
View 6 RepliesIt stop working for a while but i want it to work now. The needle is frozen in the middle and wont move for shizz. Is it something electrical or should i buy a new gauge? I found some gauges for the 740 so I thought to ask first before buying it.
View 3 RepliesThe ambient temp gauge on my '07 Santa Fe stopped working, all I was getting was flashing bars across thee bottom. Someone in a thread said there was a TBS about that. I went to my Hyundai dlr and got a copy of the TSB. It was actually pretty easy to take everything apart. The problem was that there were no wires the color I was looking for, also, there were no wires connected to the terminal as shown in the TSB. I went back to my dealer, and after a little research, found that the TSB did not pertain to my car because it was a late model year production. I was told that to fix the problem on my car, all for the fuse blocks would have to be replaced. Shortly after that, I started getting erroneous readings, eg:126 degrees. Now it is reading correctly, but who knows for how long.
View 1 Replies I just Put an 98 1.8 T engine into a 2000 2.8 passat , Everything is working fine , But The Tachometer , The Rpm And The temperature Gauges in the cluster are not working ... The Fuel Gauge also Beep and indicate low fuel when i'm turning ... Actually , the car has the V6 Cluster , i switch those and it make no difference ....
All the wires are hooked up in the ecm compartement , each wire with good color ...
Is someone has both wiring diagram of ecm compartment plug ?? 2000 v6 and 98 1.8T
I have a 2000 monte carlo ss. A few months ago the check engine light came on, the temp gauge stopped working, and after shutting the car off you can hear the fan running for about 10-15mins after i shut it off. I assumed it was the thermostat, so that was the first thing i changed. For the first few weeks everything seemed fine. No check engine light, temp gauge worked...then today suddenly it all started happening again. What could be causing it if the thermostat has already been changed? what should i try next?
View 2 Replies