Volvo :: 1988 240 Crank For 3 To 5 Seconds Before Starting When Turn Key Over
Jan 2, 2015
About 6 weeks ago I became the proud owner of an '88 240 wagon with ~ 235,000 miles.
When turning the key over to start Lucy (that's her name) most times she will crank for 3 to 5 seconds before indeed starting. I can avoid those 3 to 5 excruciatingly long seconds if I let her crank for a time or two then let her rest for a second - after that she will start up immediately when I turn the key again. This situation happens probably 14 times out of 15. The 15th she will start like a dream the first time. I have had the battery tested (although I could not find a date on the battery and the previous owner did not know when it was purchased), and I have completed a full tune up (plugs, wires, rotor and cap) among other maintenance issues as well.
Attached File(s)
Lucy.JPG ( 3.4MB )
Lucy_Under_the_Hood.JPG ( 3.87MB )
View 6 Replies
Advertisement
My 245 is running great. Love this car to death. I have been experiencing something weird. The car will start hard after sitting intermittently. It'll crank for 3 seconds and if I press the gas pedal it will fire right up. If I don't touch the pedal, itll will continue to crank...eventually sputtering and then firing. It will usually fore up right away if I don't let it sit for hours. I haven't exactly narrowed it down to a fuel prime issue, but that's kind of what it seems like to me. Are there any check valves or anything like that I could look into?
View 1 Replies
I was driving home just a few minutes ago when my headlights flickered and then cut out for a few seconds. They came back on, but I hadn't driven another 1/2 mile when they flickered again and went off for a further few seconds. This was repeated once more about a mile later, though when I pulled over (first time I was able to do so), they stayed off til after I restarted the car and banged on the dashboard.
Further symptoms: running lights, brake lights, and tail lights seem unaffected. Turning the switch for the headlights off and back on does not affect the issue.
View 6 Replies
I have just bought a 1988 740gl turbo and I was driving it the other day and when i came to a set of lights just as i stopped the car stalled on me then wouldn't start...
I left it for a hour or so came back and it started and i drove away and only went a few kms home.... what would this be I haven't driven it since!!
View 4 Replies
Pretty soon this thing's gonna have ALL new parts and STILL running rough! The Jeep has about 40K on a Jasper motor, 175K on everything else. I was experiencing starting issues (crank for 20-30 seconds), and noticed a P0171 code on my odometer (O2 sensor?) so off to my mechanic. He replaced two O2 sensors, no change. New code read MAP sensor, replaced, no change.
Finally, changed Fuel Pump in tank (Fuel filter was changed 2 months ago), still no change. I tried starting it tonight by turning the key 5-10 sec. to prime gas, started but still rough at idle. Runs strong above idle 1500-2000RPM. Mechanic can't check fuel pressure at rails? for some reason. My next thoughts were spark plugs and vacuum lines...
View 12 Replies
2007 350 the truck sat overnight (15 hrs) I went to start the truck and it had to crank for about 3 seconds which is abnormal for my truck?? It was about 80 degrees outside. Is there any reason for that?
View 7 Replies
About 95% of the time our 2012 Elantra runs great. But then 5% of the time, it hits us with this intermittent starting problem. It will crank but just won't turn over. It really feels like it's just not getting any fuel. This has happened intermittently for the past 2 years. Every time we take it in, the dealer can't replicate the problem. It starts right up for them. The car will behave well for a while but then inevitably, it acts up again - usually at 6:30am when we need to get to the hospital for work.
Here's a video of it in the act : [URL] .....
It's not the shift interlock - it wouldn't even crank if it were that.
View 26 Replies
So, before we diagnose further, i have my fuse #43 pulled because that has been the only thing that somehow magically makes my car run when its not plugged in. I believe I've been dealing with a bad distributor and haven't come up with the funds yet to mod it for a v6 mustang coilpack.
BUT as the title describes, this just started happening today. The cluster wont turn on, fuel pump is cranking over, and the starter will whine as it cranks but no spark. Is the distributor getting that bad or am i looking at something worse?
View 2 Replies
Yesterday the truck run Perfect. Got home and shut it off. This morning I get I. Turn key and the truck will crank but not start. After it tries to start the oil light comes on. I Che ked the oil and it was 2.5 its low. Added oil and it still isn't starting! 2010 f150 5.4l ....
View 3 Replies
Yesterday I was on a pretty long trip and stopped off the interstate to grab some food. My truck is really loud so I always shut my engine off at the drive-thru. When I went to crack it back up everything lit up but when I turned the key nothing happened. I had the truck towed home and I put a new starter on it. Still nothing.....
Well after further investigating where the positive wire that comes from the starter to the battery was broken at the battery post. Don't know how the heck that happened but I fixed it back to factory condition but still nothing. I'm at a complete loss. I checked all fuses and everything looks good.
When I turn the key everything lights up, then turn to crank it and nothing but a slight sound coming from those square silver things in the fuse panel under the steering wheel.
2007 f250 PSD with to many extras to list
View 6 Replies
What are the correct timing marks and positions for a Volvo 940 Turbo? I especially need the position of the crankshaft pulley. I have read the timing mark is on the cover, but unfortunately mine has dry rotted and crumbled away.
View 1 Replies
3 months ago I bought a beautiful dark-blue 1988 Volvo 240, manual transmission. This is my first Volvo and I'm already hooked! It's the car that's going to teach me to work on cars because for the most part it's beautifully simple. I bought a repair manual to be prepared, and have now encountered my first real issue.
For several months, even in the rain, it would start and run beautifully. Now when it sits in the rain overnight it will not start the following morning, or until the weather subsides. Once it has a few hours to "dry out" after the rain and humidity stops it starts beautifully. In the wet weather it wants to start, the starter goes and goes and at points it sounds like it almost catches, though ultimately won't. I imagine moisture is getting in somewhere and preventing spark at some point in the ignition system, but, like I mentioned, I'm new to this. Where to begin; what I should replace to begin troubleshooting this?
In a separate issue I can't get fuses for the rear tail/brake lights to keep from blowing when I replace them.
View 10 Replies
My 1988 240DL is miss firing #4 cylinder. I cannot get it to fire. this is what I have done:
Swapped plug wires with the #3 wire. Miss fire does not follow the wire
Swapped plugs with #1 plug. Miss fire does not follow the plug
Tested injector power with a tester and it lights up properly
Replaces #4 injector with a new one, still miss fires.
Replaced cap and rotor
Compression test shows 150 LB in #4
sworn and thrown a few tools, still miss fires.
Spark seems good with the plug out and grounded on the block. What else should I test and or try...
View 1 Replies
I have a 1988 Volvo 240 DL that I just replaced the battery. It started right up after it was installed. We drove it home and parked it for one week without trying to start it again because we still have parts to buy to pass safety. I live in UT. My son went out to start it today and it would not make any sound or turn over. What should I check next? Starter Solenoid? Alternator?
View 2 Replies
I have a 1988 Volvo 240 DL station wagon that has been in my family since just before I was born. It has somewhere around 300K miles on it (the odometer broke 7 years ago at 250K). It drives around town more or less fine, usually. But sometimes it loses power on me. Usually this happens when I take it on highways, up big hills, in situations where I need to accelerate quickly, etc. It just starts to slow down, and I have to downshift and ease slowly through whatever stretch of road I'm on until I can get back up to speed (usually on a downhill). It's not totally consistent--sometimes it has this problem, other times it doesn't.
The car will go through stretches where it runs fine, then I'll have this problem on a highway, and then it's a little more likely to happen for a period after that (even on surface streets). This has been happening in some form for a few years. When I first had the problem, it happened continually until I heard a terrible rattling in the engine. When I took it in, they found that a spring in the piston/cylinder had broken off and shot up, breaking the cap off one of the cylinders (sorry for the lack of a more technical explanation).
When they fixed that, the problem seemed to go away for a while, but eventually came back (though there has been no rattling since). The most recent time, it had been running around town just fine. Then I took it out on the highway and really lost power--had to slow it down to 35-40mph going up a hill on a 55mph highway. For the rest of the drive it struggled up hills, even as low as 2nd gear. But on my drive home (about 1.5 hours later), the car ran smoothly (though I continued to baby it, and there were fewer upward hills). Since then, even around town it sometimes feels like it might lose power again, but it never becomes a huge issue because I haven't demanded a whole lot of the car.
After that long-winded explanation, I'm wondering: could this be something as simple as spark plugs? Or is this definitely a bigger issue with the engine? If it's a cheap fix, I'm happy to go for it, but if it will require putting several hundred (or more) into the engine, I'm inclined just to let it limp along until it's finally time to take the car out back and shoot it. Figuratively, of course.
View 4 Replies
Recently my old workhorse started coughing and stalling. This isn't consistent at all. I'll be driving and the car will lose power and come back to life. It also stalls at stop signs. Brought to my mechanic and left it for a week with him and he can't figure it out. 1988 Volvo 240 over 200,000....
View 3 Replies
The car idles fine, but after a couple seconds in each gear (5spd. manual) it looses power and starts to stumble, but if i keep it at a low rpm, it will run. So, if it is the catalytic converter. how can i un-clog it? Dearborn protocol adapter.
View 1 Replies
I have an 88 244 dl. I recently changed the battery charge bulb in the instrument cluster and no I have a no start. The starter engages and the motor turns over but makes no attempt to start. I checked all the fuses including the 25 amp fuse under the hood.
View 2 Replies
I have an 88 volvo 244Dl with major hesitation while driving down the road. I recently had a no start issue and after a week at the shop it was fixed. During that repair it received: New Dist, cap, rotor, timing belt, coolant sensor, plugs, wires. With the hesitation I checked vacuum lines, cleaned T/B and MAA.
One thing I noticed, which seems weird... When the engine is hesitating, missing.. the radio becomes somewhat staticy. The reception of the radio mimics the hesitation of the engine.
View 2 Replies
I have tried about everything i know about cars on this truck!! It ran great when I got it until a head gasket got blown so I tore into it and replaced them both torqued heads to specs. Made sure valves wasn't to tight. Distributor is in correct spot timing is correct had ignition module tested good!!! Coil tested good replaced both fuel pumps and put new tank and sending unit in the truck b/c it needed it new fuel filter replaced return line firing order is correct 1 4 2 5 3 6 it is getting fire it will crank and crank sometimes act like it is going to start then not also I can get it to run for about 3 sec on 3 or 2 cylinders it seems to have plenty of compression as well!! only thing really I can think of that could be wrong is computer? Also one last detail tried pull starting it as well still wouldn't go.... V6 2.9L...
View 9 Replies
last night I was on my way to work and had the car in forth traveling about forty-five. A light ahead of me turned red and I held the clutch in until I had stopped. I shifted into what I thought was first. I discovered that regardless of the shifter position, the transmission left it in forth gear. Barely got it moving from a stop and brought it back home.
Looking under the car, I don't know exactly what the linkage mechanism looks like. I'm not sure how to tell if it has been disconnected or misaligned. I don't know if the problem is in the transmission itself either. The shifter moves to other positions freely, but in actuality it stays locked in forth gear.
View 3 Replies
