Volkswagen - Routan :: 2010 - Knocking Metal Noise When Slowing Down
Oct 8, 2013
We recently purchased a (used) 2010 Volkswagen Routan with approximately 40k miles. Almost immediately we noticed a loud noise whenever we began to slow down in city traffic. The noise is loudest after the car has been driven for a while. It sounds like metal knocking around. The dealership claims the brake pads are causing this noise. They said the pads are perfectly good but are two different brands and this is what is causing the sound. I do not believe brake pads would continue to make this noise after 3 months if they were good. I am also not convinced it is the brake pads at all.
View 1 Replies
Advertisement
201w Routan SE 50000 miles. Past several months the gas pedal has gotten stuck to the floor four times. Always happens when going very slowly and romping on the pedal. Last time was today, 4/5/2016, when I was stopped at a round about and had to quickly accelerate as noone in our area knows how to navigate one. The pedal immediately stuck to the floor halfway around the round about and disengaged after I tapped on it. Hope this isn't a known issue cause I haven't gotten a recall notice for this piece of crap.
View 1 Replies
I have a 11' VW Routan and just started having the following issue:
Minimal amount of heat, even after the temp gauge indicates that the engine is up to operating temperature. On cold days the car warms up fine and sometimes I get very hot air heat (normal) coming from the vents then all of sudden the air goes cold or lukewarm. I need to stop the van, turn off the ignition and restart the van for the heat to come back. But every once in a while; while the cold air is coming out, it does hot again. What the problem(s?) might be?
View 5 Replies
I purchased a new 2009 VW Routan back in 2009. Things went well for roughly the first 3 years. About 7 months ago the car just shutdown while driving. I pulled over and it started up again. I mentioned it to the dealer when taking it in for maintenance and they couldn't find a problem. It again happened to my wife with our 2 little kids in the back. The car just shut off while driving and she couldnt start it again for a few minutes and the obviously concerned to drive it anywhere. We took it the the VW dealer service about 2 weeks ago right after the incident.
They had it for about a week and replaced the battery and some electrical systems. It worked for a week and the same thing happened again today! It's back at the VW dealer service department. Now I have zero confidence in this car and that the service department is capable of fixing the issue to begin with. I've read about a recall for the 2010 model for this issue and I'm gravely concerned I have a lemon on my hands and against a wall with no recourse. What are my options? I want to have VW replace it. It's only 3.5 years old and I'm not going to keep driving a car that can randomly shut down.
View 19 Replies
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 Replies
My Elantra's HVAC fan has always been a quiet thing, even on 3.....we won't mention level 4 and the fact it sounds like a 747 at takeoff.
I kid you not, the very evening I hit 60,000 miles and the general warranty expired, the blower motor started making noise like it was throwing a bearing and definitely sounded like some light metal-on-metal rubbing. After I became irritated at this, the noise went away and didn't come back until just a few weeks ago. I could make it stop by smacking on the bottom of the fan assembly a few times but I want a more permanent solution.
Tonight I dropped the blower out which was stupid easy except for the fact you're upside down in the dark with your head in a hole. But three screws and an electrical connector later, I dropped the assembly to find no serviceable components. I mentioned this to friend of mine who's into Volvos suggested spraying some lithium grease on the hub of the blower and letting it run long enough to quiet it down. I'll do this over the next few days and report back but part of me thinks a new blower may be in my future.
View 53 Replies
I have a 2011 Prius with about 32K miles on it. I've been hearing light metal on metal grinding noise for a few days now. So I decided to take it to a stealership and they told me my ceramic pads and brake rotors both need to be replaced for all 4 wheels. I thought Prius brakes don't need to be replaced for 100K miles.
View 7 Replies
I have a 2012 Elantra with 21000 miles on it. It runs well but in the last month or so it has started to make a strange noise when first accelerating. I would describe the noise as touching a fork to a metal fan...kind a "zzziiiinnnkkkk" sound, I guess. It only happens when the car has been sitting for a while and only on the first acceleration, usually in first, second, and third gear after which it immediately goes away and doesn't happen again until the next time we drive it. It seems like it would be related to the transmission except the sound is too tinny for it to be the gears. It sounds more like sheet metal making that sound. I took it to the dealer but they said they couldn't make it make the sound, which is crazy because it does it EVERY time we drive it.
View 14 Replies
Background: 2003 jetta; just changed rotors and pads on rear wheels a month ago, they are disc brakes
So the other day I was driving in a school zone at about 20 mph when I heard a VERY loud sound, like I'm dragging metal. i might also describe it as two rusty metal plates being rubbed against each other, but really really loud.
The noise is related to speed, it sounds cyclical and speeds up as the wheel turns faster. It occurs when I am NOT braking.
I parked the car and came back to it a few days later move it and the sound disappeared for the first 100 feet and then came back.
We did 2 things - we changed the caliper, and we also noticed that a caliper bolt was missing. I am pretty sure the noise was coming from that missing bolt - i think the caliper became dislodged and was making contact with the rotor. The caliper also seemed to be dragging a little bit so we went ahead and changed it too.
View 10 Replies
I have an 06 Beetle 5 cylinder, and just the other day, after getting a new battery and they installed it, when I'm driving and step on the gas into overdrive, it gets really loud, almost like a knocking or loud muffler that has a hole it it. However, it doesn't do this when I'm in park and step on the gas. Only in drive. It still has great power, but is loud now. I'm worried that the shop did something to mess it up, but they won't check it. There is enough oil in the engine.
View 1 Replies
At 75K my passenger side rear brakes were making metal on metal sound. I was really surprised as I have always learned that the front brakes take 80% of load and they always go out before the backs. So I took the wheel off and sure enough the pads were metal on metal. Changed everything out. (new rotors). I then went over to the driver side rear brake. Looks brand new. The pistons were barely out. I figured this caliper is bad. (I haven't change yet)
When I drive I can hear a very faint metal on metal sound when I brake. VERY FAINT. So with 75K miles on I figure the front brakes are due. Today I took the wheels off and inspected them. Tons of pad left on both of them. If I didn't know better I would say a brake job had been done very recently. (I've owned the car new so I know they have not had a brake job) However after reading many articles on this site I found a thread where one user said he was changing his front brakes for the first time with 110K on them and the pads still had 10K left in them. So the fact that my front pads are still pristine at 75K may not be a big deal (or not as big as I thought. Also I am not hard on brakes.)
However I'm not sure what is going on. Why would the passenger rear brake be metal on metal at 75K and the three other pads are like new. Is the passenger rear the only one working (or working much harder than the others) meaning the other three are bad? Or is the rear passenger bad and the other three are good? I have a working knowledge of cars but I am by no means a mechanic.
View 14 Replies
We purchased our 2011 Jetta SE Automatic brand new - first people to drive it - and have had virtually no problems up until this summer. The car has stalled on us dozens of times now and been to two different dealerships for service a handful of times and no one knows what the problem is. We found that the car typically stalls when we're slowing down; however, it recently stalled when we were in Park. When it stalls, the steering wheel locks up, the breaks are nearly impossible to push and everything seems to shut down except the radio. We're virtually a sitting duck for other cars.
When this happens, we're able to put the car back in park, turn it off and back on and drive fine for a while. It seems to be happening more frequently but the dealership hasn't been able to replicate the issue - there are no codes left on the computer and they've literally taken the car apart and can't find anything wrong. They've even 'driven' it for 200 miles and still, nothing. Initially we were told it was bad gas, then we were told it was an operating system update. Now they're trying to tell us that it's our driving style but multiple people in my family have driven the car with the same effect - stalling spontaneously while slowing down, stopping or trying to break.
We've also noticed skipping or slipping between gears when we're at higher speeds but I'm not sure if that's related. It almost feels like your foot falls off the accelerator or slips while you're driving but instead you're actually applying constant pressure.
View 5 Replies
I own a 2010 Toyota Prius that recently developed a metal-on-metal whining scraping sound when moving. It does not make sound when the vehicle is stationary, and it's intermittent - which makes me discount the rock-in-disc-rotor idea (not eliminate it, mind you). It's quite loud when it occurs, able to hear it over the stereo. Luckily I was near work at the time, so I went there - but the shop can't even look at it until Monday evening - so I am a bit panicked.
View 8 Replies
Brand new 2012 jetta TDI (less than 1,000 miles). Standard, 6 speed. A few weeks ago, I went to brake, and my pedal went all the way to the floor (no resistance) w/o slowing me down. I let the pedal out (after freaking out a little), and when i went to try again, the brakes kicked in. I was a block from home, so I continued to drive, pulled in to park, and it happened again. Left foot on the clutch, right foot went to brake and went all the way to the floor. Took it straight to the dealer. They checked it, drove it, checked it again. Couldn't find anything.
I've driven about 500 miles since, with no incident. Then, it happened again. My brake pedal literally touched the floor, and didn't even slow me down. I tried pumping. Nothing. Took the pedal all the way out, and then recompressed- worked fine. Drove it to the dealer, happened one more time on the way (had to pull the ebrake to stop).
They have had it 2 days and still can't find anything wrong. I've been driving VWs since I got my license. I've never even owned an automatic, so the whole "maybe you were pressing the clutch instead of the brake" comment is out of the question. What is going on?!
View 12 Replies
My girlfriend has a 2007 Volkswagen Rabbit, and she said that occasionally when she slows down as she's getting off the freeway her car downshifts from third to first really quickly and she's concerned. She took it to the dealer but, of course, they couldn't tell what was wrong because it only happens on occasion. They said it might have something to do with the brakes pumping if she slows down too fast. The car has 60,000 miles on it.
View 3 Replies
When I am slowing down and lightly pressing on the brakes and around 18mph or lower i hear a tick-tick-tick-tick noise , sounds like a roulette wheel from a casino war game in vegas coming to a stop, from the left front side..what could this be? .
View 2 Replies
I got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 Replies
What we have is a 2011 F-350 with the ambulance package (obviously) and it has started making a very annoying sound from the front end. It has been into two different Ford Dealerships and they have not been able to remedy this issue. What happens is, when we are backing and turning, the front end makes a bad metal on metal grinding noise. When going straight down the road no issue just turning while backing. I know this is an ambulance and has the ambulance package but I think from the cab forward should just be all ford right?
View 2 Replies
I recently worked on a 2006 with 140K miles that presented with the following symptoms:
The hybrid battery was at 1 bar; the ICE would not start; the car was in Ready, but there were no codes. As I let it roll off the flatbed wrecker in Neutral, it felt lumpy. If you have ever pushed a car (or run out of gas in one) with a manual transmission that was in a high gear, engine off, it felt just like that.
I popped the hood and could see that the engine crank was turning while the car was being pushed in Neutral. What else turns with the wheels? MG2, or more specifically, the MG2 ring gear. What is the only way that the wheels could turn the ICE crank? The planetary carrier pinions were locked to the ring gear.
Surprisingly, while I was looking at things, it did manage to start the ICE pushing it around must have freed the carrier pinions, so I let it charge the hybrid battery. It was basically the worst metal-to-metal noise that I have ever heard! I pulled the drain plug and saw about a teaspoonful of large metal chips on the magnet. The fluid condition itself was very good, not the black factory fill that I am used to seeing come out.
View 19 Replies
I have a base v6. When I turn the steering wheel (for example, to make a left turn), it sounds like there is metal-on-metal rubbing. The wheel is not extended (turned all the way til it stops)...
View 2 Replies
I have an '02 Taurus. For the last year or so it has intermittently produced a metal on metal grinding noise while failing to start up. I'm told this is due to teeth being missing on the flywheel between the starter and the transmission. It's taken as many as six tries to get the car going. But the car has always started in the end.
My questions are: Is the problem flywheel worth replacing at this point at this price? Is it likely to fail totally any time soon?
Also, might the March '09 replacement starter be implicated?
View 5 Replies
