The 1999 Chevy Venture I have doesn't get enough power from the motor and lacks the force to accelerate, was told it could be with the sensors? Which sensors and where could they be located?
View 2 RepliesI have a 1999 ford f250 with a 6.8 liter v 10 engine. At about 40mph the truck will start missing and lacks power to accelerate further. This problem is intermittent. Some days it runs great and others the miss appears. Well I scanned and the code reader said that I had a misfire on cylinder 7. I took a chance and replaced the COP and the boot for that cylinder . Ran great for a day and then the miss came back. Same code again. What else might cause this? Are plugs difficult to change in these engines?
View 6 RepliesI have an 88 chevy K-1500 4x4 5.7L ... My truck lacks serious power, it idles rough, sometimes wont idle at all, sometimes Truck Idles fine. I have adjusted the timing to tdc, and 4 deg. both ways still runs like crap.. Sometimes I can keep it idleing, put it in rev. or drive, and it will die. I have no power and if I put my foot in it too much it will backfire. but will only backfires when in gear and press on the gas to put a load on the motor. I have replaced the: tps, map, egr, pcv, distributor, cap, ignition coil, rotor, plugs, wires, timing chain, both sprockets cam and crank, checked all hoses for leaks, replaced the injectors, the O2 sensor and have changed the intake gaskets. And am still having no luck...... I am bout to just drop an M80 in the gas tank and watch her burn..
View 14 RepliesI have checked the fuses and they are all good. I turn on the headlights and the dash lights do come on at that point but I have no power to the buttons on the panel or any of the climate settings.
View 3 RepliesI picked up this 2004 Chevy Venture for my daughter and it has a power steering fluid leak coming out of the power steering cooler line that runs along the frame in front. I know that the procedure to replace this line calls for disconnecting the intermediate shaft of the steering and lowering the subframe to gain access to the line connections on the rack. My question is, is it possible to replace that line without lowering the subframe? I ordered the new line and it's on its way. I wanna do the job right.
View 3 RepliesGot done with replacing head gaskets and intake gaskets, Van started fine and I backed it out of the garage. Left it running and put down ramps and drove up on them so I could get under and connect the exhaust. Got that done and then got back in it and all it will do is crank and it will not start now. It also has a new cam shaft sensor( wire broke on old one). I can hear the fuel pump when I turn the key. It is like now there is no fire to start it. What could be wrong? What do I check? What causes it to fire? If something was connected wrong, would it have still started and then wont do anything but crank? Got dark on me and started raining so I say tomorrow is another day. I feel it is something simple.
View 4 RepliesMy Chevy Venture 1998 power lock doors will unlock but won't lock. Checked fuse and is ok.
View 13 RepliesMy truck runs very rough and lacks power when cold, even during the Texas summer. Once it warms-up, everything is fine. It's almost like turning on a light switch. If it's plugged in for a couple/few hours, it's smooth as soon as it starts. I'm assuming it likes the oil once it reaches a specific temperature. What my problem is?
View 14 RepliesMy truck runs very rough and lacks power when cold, even during the Texas summer. Once it warms-up, everything is fine. It's almost like turning on a light switch. If it's plugged in for a couple/few hours, it's smooth as soon as it starts. I'm assuming it likes the oil once it reaches a specific temperature. What my problem is?
View 14 RepliesMy van ran fine, no problems until yesterday. I started it and it ran for a few minutes then I heard it bog down 2 times ran for a few more minutes fine then stalled. Now it turns over but will not start. I can hear fuel pump, I changed fuel filter.
View 14 RepliesMy Venture LS is stumbling upon acceleration. It starts to occur around 35 mph and then continues with occasional smooth sailing. No rough idle and no stumble when coasting. I had the spark plugs and wires replaced at the dealer today and it did nothing. Fuel trim is fine, LT runs from 0 to - 5 . I replaced the MAF sensor a few months ago and all other sensors test OK on the scanner.
Also, I took my car to the dealership to have the plugs and wires replaced and they used the after market wires named Xact. I have never been to a dealer where they used aftermarket parts. I thought that they were required by GM to use their parts?
A couple days ago my truck started stumbling and missing . And is lacking power . It starts fine and seems to run ok above 3000 rpm . But at idle and off it is stumbling pretty bad . And at highway speeds it stumbles once it goes into overdrive . I changed the plugs which where white ( I think lean ) then I bought a new coil pack and moved it through all ten positions ( I just replaced them all about a year ago .) then replaced the tps and the iac today also cleaned the maf and recharged my filter . Still no different . It hasn't been an on going thing . I was driving then stopped for a bit then about 1 hour later went to leave and this is where I'm at .
View 9 RepliesWhere the EGR Valve is located on a 2001 Chevy Venture? Pics of its location would be nice, if possible...
View 7 RepliesI have a 2005 f250 with a 5.4 3v. I bought the truck with a cracked passenger side exhaust manifold about a year ago. We'll here recently the crack got worse and was giving the code P0171, so I had a shop replace it. I picked the truck up and not even a mile down the road it started idling terrible at lights and had very poor acceleration. And it gave me P0174 this time. It's only gotten worse now it's reading P0172, P0174,P0161, and P1489. I've replaced the spark plugs, MAF sensor, both vct solenoid, an the upstream o2 sensor on the passenger side. I also know I don't have any intake or vacuum leaks, I've had a shop check and so have I. It's starting to get expensive just replacing stuff. So, maybe I have a clogged catalytic converter ?
View 8 RepliesYesterday our 2002 Chevy Venture minivan died in the store's parking lot. It would not stay running when we started it and let off the gas. As long as we were pushing the gas pedal down, the van would run. As soon as you let off the gas, it died.
So my husband walked to the auto store and bought a new fuel filter. He then tried to replace it in the store parking lot. As soon as he took off the 'male hose' from the fuel filter, a lot of gasoline sprayed him in his face and of course he came out from under the van screaming and in pain. (Don't worry with kids we had over 8 bottles of water in the van and I flushed his face and eyes for over 10 min and he is fine now).
Anyway, in the process of flailing under the van when the gas hit his face, he jumbled up these little black and rainbow colored rings and lost a long rusty screw/bolt that screws the main round body of the fuel filter to the underneath of the car and holds it in place.
We searched and could not find the bolt. My husband jumbled up the small rubber rings and did not know what was from the old or new filter. He tried placing them on the new fuel filter but as soon as he turned on the car, not even the engine just turned the key to where you can play the radio... all this gas sprayed out from the new fuel filter. After many tries of re-arranging the little o rings he gave up and called a tow truck.
Today he called auto zone and they looked at a new fuel filter in it's box (same one my husband bought) and told my husband that there was only one small black o ring on the fuel filter. So he put one ring on his new fuel filter (on the male hose I think) but still the filter sprays gas as soon as he turns the key. He then went and bought new 'hose clips' and tried those. The fuel filter still sprayed gas.
So, what I am now trying to find out is what could possibly be causing the fuel filter to spray the gas (leak). My husband (in his words) is a welder, not a modern car mechanic and is getting really stressed over this.
1. Does he need new or different sized little rubber rings?
2. Could the missing bolt that screws the large body of the filter to the car be causing this gas leak?
3. I read he should turn off the gas some where and then replace the filter, could this cause a gad leak issue because he did not do this before replacing the fuel filter?
i have a chevy venture and it was running just fine untill this morning it started to have a good amount of smoke coming from the exhaust and is running rough i took it to the autozone and had the codes checked since i let someone borrow my code reader but when i went there and had it done i got 5 codes out of it and they are....
p0300
p0301
p0463
p1106
p1189
What happened to it since it was running just fine all yesterday and before...
I have a 2004 Chevy Venture and the blower (Vent, AC, Heater, doesn't matter) is only blowing air out of the left or driver side of the van, nothing on the passenger side vents. There aren't 2 blower motors, are there? Is a door shut that shouldn't be? This van doesn't have dual climate control like my GM cars do. The rear controls work fine for the 2nd row passengers. Again, not tied to any blower speed or heat vs. AC. Same regardless. Nothing on the passenger side.
View 7 RepliesI have a 2003 Montana (same as Venture). The driver side window will get stuck half way down and the motor will grind. You can then run it back up, but when closed it will grind again.
View 4 RepliesI have a 1994 Ford F-150 pickup with a 4.9 litre fuel injected inline six. Truck ran fine and took me to my destination but after sitting for 4 hours the truck would not start. Engine would turn over normally and could hear fuel pump running (didn't seem to stop) but truck would not start.
I changed fuel filter but truck would still not start. I removed air filter assembly and poured starting fluid in the air intake and engine started but idled roughly. Engine will rev up but runs very rough and lacks power when driven. Also the check engine light stays on.
On my 1999 Chevy Silverado Z71, a gurgling water sound is present everytime I accelerate. Are there any other Chevy owners that have had this same problem? If so, how was it resolved?
View 14 RepliesI have a 95 Chevy S10 pickup with the TBI motor, Z engine code, that has begun to not start on occasion. The engine cranks but does not fire at all everything else seems normal. This only seems to happen in the morning so might be cold related. If the truck starts I can drive it all day without any starting issues.
View 9 Replies