I have a 98 trans sport and the temp gauge is reading low. Only on the first line when driving then when i pulled into the garage it went up one line and heat got warmer. Felt both upper and lower hoses and i can press them both in Fluids are full no leaks anywhere. oil is good tranny fluid is good. I just got it on a trade it runs and drives great no problems at all.
View 6 RepliesTranny fluid spews out pretty good underneath. Is it likely a broken hose? Where do I start?
View 3 RepliesHaving problems with the fuel indicator not reading full after a fill up. I have slowly filled my 2012 Passat TDI SEL till I can see diesel in the filler neck and the gauge still only shows 7/8 full?
View 9 Replies I installed a VF intake a few weeks back and noticed my car is peaking at around 14-15 PSI max according to my boost gauge, when it used to hit 17 peak. I'm not sure if I may have a leak nor have I checked it via vag-com.
It does feel a bit off, but for as far as I know the gauge could be messed up now.
Just wondering if there would be any immediate signs (sounds etc...) of whether there would be a leak, or what other problems may cause this.
As title really, it's a 1997 K2500 Suburban 4x4 auto 454. I haven't used the sub for a while but got in it the other day and it fired up all fine and I then looked to see what fuel I had left only to see the needle right over to full. Well I know it is nearly empty and I've never had the guts to fill the thing or should that be had the funds to fill it to the top, so know it is wrong. I got under the truck and unclipped the rear most wiring connector just infront of the fuel tank but the gauge still reads full. I suspect either the gauge is faulty (so is there anyway of checking) or the sender in the tank or wires in the tank have shorted (again anyway of testing without removing the tank).
View 3 RepliesThe gas gauge on my 2008 does not seem accurate. I had three bars left the other day and when I filled up it took 6.5 gallons. Normally with three bars it only takes 5.5 gallons. Also, it stays on "full" (all bars) a long time.
View 4 RepliesIt is a garage queen 1994 4.0 AWD with 42,000 miles in nearly perfect shape. Except for the dent in the rear on the passenger side.
I have posted a picture of the dash when going down the road. As you see the engine light is on. It comes on intermittently, pulled the codes, indicated MAF, 02 sensor, running lean/rich. Runs like a champ, no hesitation, still gets up and goes, gets the appropriate gas mileage. I replaced the 02 sensor with the original Ford Part. Didn't cause the engine light to stop going on after about 20 to 60 minutes driving, sometimes it doesn't come on at all.
Could this thermostat be running too cool and causing the engine to throw those codes? Would gladly take it to a mechanic, but seems like it might be a fishing trip with my dollars for them. Next I was going to replace the MAS myself, easily done with the original remanufactured part at a cost of 150.00, 70 for the core, but don't want to chase my tail with these engine lights on when it runs nearly perfect.
Have sprayed the MAF. Checked for air leaks anywhere. Done all the things I could do by just lifting the hood.
So the picture shows the Temp gauge barely touching the N flying down the road at 70 on a level surface, outside temp about 60. Reading the posts says they all run in the cool section of the temp gauge.
So the question is, do they run this cool? Heater works fine and the gauge goes up past the N resting before the O when going up hills on the way to Tahoe. Is this a thermostat problem on a 20 year vehicle with low mileage, or am I going to have to bite the bullet and let the mechanic go wandering through the vehicle?
I just noticed the oil pressure gauge on this Pontiac TS GT stays in the red zone at idle and climbs a little out of it at 2000 rpm and higher (never over the first unit). There's no other warning light or error in the dashboard - just the scary oil pressure gauge.
We brought this car home for repairs after a 600 km trip (370 miles) without any issues in mountain roads or hot weather. Engine temperature was well below the first quarter mark, acceleration was great and there was no strange sounds whatsoever...
When first started cold engine has no lifter or tapping noise. What would be the most obvious sign of oil starvation/low pressure on this engine?
Is there any way to confirm it beside the dash gauge? With this 3.8 engine what would be the most probable cause for this:
1. defective oil pressure sensor
2. failed oil pump
3. worn crankshaft bearings
4. worn camshaft bearings or other cause
I have a 2005 Toyota Matrix with 250k on it. It has run like a champ so far, with the only problem being an ECM recall last year. I have noticed a few problems recently; the heat blows cold air for quite awhile, and the temperature gauge, while not reading hot, sort of fluctuates between normal and a little warm. When the ECM was being replaced, the dealer said the serpentine belt was overdue for replacement, and I know he's probably right about that. He also said the water pump needed replacing, although I have never seen any signs of leaking. This car has been a champ, and I'd like to try and get another 100k out of it if possible. I'm pretty handy around a car, I've replaced an alternator and radiator before, and I'm working on a limited budget, so if any of this is doable by me, I'm up for it.
View 11 RepliesI have a 77 F100 2wd 302/c4. I recently replaced the rear plate to my gauge cluster after it crumbled to pieces. I swapped all the gauges to the new plate minus the fuel gauge since it decided it couldn't live if livin was without the old plate. I have a gauge cluster out of my 75 and decided to swap in my fuel gauge from that one. I put the cluster in the truck and fire it up for 10 mins or so and everything is working great except the temp gauge isn't moving. I figure it romeo and Juliet with the fuel gauge so I just swap all gauges from the 75 into the 77 cluster except the speedo. Same result.
So I figure its the sending unit now and maybe both gauges were fine to begin with. I put in a new sending unit and now the gauges works but the needle sits on the P in the word TEMP on the gauge which makes me uncomfortable. That's about 1/4 inch or so from being past the end of the gauge. I don't believe the truck is running that hot. The gauge was more or less straight vertical before the swap sitting right at the end of the E on TEMP. Did I get a bad sending unit? Is it a bad ground on the gauge? Was I supposed to take off the teflon tape that came on the threads of the sending unit? I'm gonna try removing that first and see if it lowers the needle.
I have a 2001 Excursion Limited V10. 146000 miles 2 wheel drive. I have had it about a year and this is my first winter to really have experience with her.
When the outside temperature is very cold and the engine is cold from sitting all night, at start up, the oil pressure gauge reads nothing and the oil pressure/temp idiot light is on. Only does this during the first very cold start up or after sitting and engine getting very cold again.
I can drive just a short distance (2 blocks) and both gauge and light go to normal and stay there for the rest of my drive. I am using a quality 5/20 oil and filter and the level is good. Warmer days it has never happened. Truck runs fine, smooth idle, no "limp mode". She has not had any recent work done. All the other dash gauges read fine.
There is something about really cold temperatures that have to be causing the issue , I think. ??
I got a 1998 Trans Sport Montana that has a dead speedometer. The computer knows how fast the car is going because I've seen the live data. I've also changed out the cluster and the problem is still there. I have a schematic of the wire that goes from the ecm to the instrument cluster, but it goes through an accessory connector block. Where this connector block is?
View 2 RepliesI was recently given my first Volvo. Its an 88 240dl. While driving my temp gauge climbs up to the red and sometimes hovers inside of it. It normally climbs up at stop signs and comes down on straight always then climbs right back up close to red. When the gauge was in the red i stopped the car and popped the hood open to see that the engine was not actually overly hot.
first i replaced coolant. nothing
then i replaced the thermostat. nothing
flushed radiator. nothing
Today i finally had enough and decided to switch out the water pump with a new one hoping that it would solve the problem seeing as it still had the factory one on. It did nothing. the gauge continues to climb up. I did replace one of the two senders in hope that it would fix the gauge reading but nothing.
Every now and then when I slow down the temp gauge drops about 1 notch below its normal 200 reading. It's nerver done this before. Car runs great and heat is strong. Is this a sign of a failing thermostat? If so, where is the thermostat located, is it hard to replace, and should I get OEM or is OTC ok? Car has 89K on it.
View 11 RepliesI have a 2006 Jeep Liberty 3.7L that has a temperature gauge on the dash that reads an overheat when driving. The oil looks normal, there is no white smoke, no bubbling from reservoir. I have replaced the following:
Radiator
Thermostat
Water Pump
Coolant Temperature Sensor
Coolant Reservoir Tank
I am not leaking any coolant and the reservoir level has been fine. I have let the vehicle idle for 20+minutes, with no overheat. When I drive it around, the temperature gauge will read an overheat. When I stop the car and pop the hood, the engine is not overheated and both rubber hoses to/from radiator are flowing the coolant. The only thing that will bring the gauge down is turning on the heater full blast. Could this be the gauge itself being bad? Could it be a short in a wire somewhere? I had thought maybe a head gasket, but have no symptoms of a head gasket.
I have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
I have a 2002 supercrew 5.4 triton. My coolant temp gauge is acting up. When it starts up its obviously in the cold range but when the truck begins to get up to temp, the gauge only goes up 1/4 full. What it can be?
View 4 RepliesMy '95 Grand Cherokee (104K miles) just started groaning when I make full turns. After first 1 or two turns, right or left, can hear the steering column groan and feel some resistance. Have I lost power steering fluid? or worse?
View 2 RepliesI have noticed when I turn the key on the needle moves down just a touch but goes back to full. I have disconnected the wiring harness for the fuel tank and reconnected it. I have tried tracing the harness back towards the front but no luck yet. I'm guessing it's a bad ground or something. And if so what was the solution.
View 5 RepliesDriving my 2003 today seen the "check gages" light on and the trans temp gage pegged on hot. CRAP, tranny time! look at the edge evo and it reads trans temp as -60F ???. Plugged in the torque pro and it reads 8,240F. At that point I figure its PROBABLY not that hot. Let it sit for a while and back to normal. Watch trans temp on torque pro as I drive it and everything is fine till it gets to about 150, then it jumps to 60F, then 30F, the 8240F. The cooler lines and trans pan are both feel normal. Picked up a new temp sender on my way home.
View 5 RepliesI replaced the sensor on top of the water pump and the gauge still doesn't work. I tested the gauge by unplugging and grounding out the wire and the gauge goes all the way up. What I can try next. I didn't get a Motorcraft sensor so I'm going to go get one of those tomorrow hoping the duralast wasn't correct even though it looked 98 percent identical to the original. 7.3 lite diesel.
View 1 Replies