Trans Sport :: 1992 Pontiac - Cylinder 6 Not Firing When Engine Hot
Oct 29, 2012
We have a 1992 Pontiac Trans Sport with the Chevy 3.1 V6 TBI engine.
Engine was running poor because of a faulty Coolant Temperature sensor (rusted-out pins). Changed the sensor and cleaned-out rust from the socket and now it runs smooth when cold with decent acceleration.
Problem is that cylinder #6 is not firing when engine is hot at operating temperature. Engine shakes lightly but performance remains good.
Distributor, rotor, spark plugs, spark plug wires and Oxygen Sensor were all changed 1 week ago with new ACDelco parts. What to check next?
View 7 Replies
Advertisement
We have a '92 Pontiac Trans Sport with a 3.1L V6 TBI engine. Last Sunday evening it refused to start like someone left the transmission in Drive and the Park/Neutral switch was preventing it to start. There's the buzz sound from the fuel pump when you put the key on then nothing when you turn it to start the engine.
I checked the Park/Neutral swith by connecting an ALDL cable to the OBD port and it indicates correctly when I move the lever to Drive or Parking/Neutral. The only error code stored is "Fuel Pump Relay" but the Fuel Pump appear to be working?!
Battery is good, fuel pump fuse intact and the Park/Neutral switch appear to be working. How we can tackle this problem?
View 12 Replies
One of the '92 Pontiac Trans Sports (3.1L V6 engine) had developed a huge thirst - the fuel consumption had doubled along with a serious loss of power. All ignition components - distributor cap, rotor, spark plug wires and oxygen sensor are new ACDelco's.
ECM is not throwing-up any fault codes but we suspect a vacuum leak since this engine runs better with the air intake covered-up almost completely.
Is there any way to trace and fix this kind of issue? Any vacuum diagram for this car - I couldn't seem to find it in the GM Service Manual... How would you suggest we proceed?
View 12 Replies
2800rot./min when driving. engine showed signs that he drowns, I joined, he went shortly after that began to fall speed and the engine stopped. Then I could not start. Come to be fuel, received a little dirt somewhere and no longer feeds? What can I do?
View 3 Replies
When is cold, the engine starts but stops after 2-3 minutes. I can not start until after standing for 2-3 hours, and again stops.When I try to start, signs that would not fill with gasoline.What should I check first, what should be changed?
It was....now engine don't start!
Pontiac Trans Sport 1996,2.3l,16v,Quad4 DOHC
View 1 Replies
just bought a 2002 bonneville sle 2 weeks ago. First few dats it ran great, then it started missing. Dealer had his mechanic look at it. His diagnostics said #1 cylinder wasn't firing. I replaced plugs and wires. Then mechanic said injector wire to #1 cylinder was dead. He messed with wires and got the miss out of it. Today it's back.
View 3 Replies
My 92 transport 3.1L had started quitting on me while driving. After sitting for about 15mins I could get it started and then continue on driving. Now its doing it more and I can't take the chance of going anywhere in it.
Got a CEL so I flashed codes 34, and 45. Where to start troubleshooting with what these codes are saying that I should do?
View 14 Replies
Suddenly both electric windows started going up in hops on our '92 Pontiac Trans Sport SE.
If you leave it for 5-10 min. it would resume normal operation then it freezes again in a few seconds and so on.
- window buttons (left and right) checked-out ok
- driver window motor was changed an year ago - it doesn't have the same wear as the other motor
- both window lift mechanisms and guides are properly lubricated and work smoothly
View 4 Replies
I have a 97 Pontiac Transport and I was traveling down the road and suddenly i lost oil pressure the light came on and it started clattering so I checked the oil level and it was fine so i had it towed home. I changed the oil using a higher grade oil and lucas oil treatment and started it ...I still have the problem what do i do...
View 7 Replies
I started the car the other day and it was running really rough and engine light was on. I started pulling the spark plug wires and pulling #3 didn't make any difference in terms of decreasing performance where the others all did.
I've replaced the plug, and distributor cap. I've also confirmed with the plug out of the block that it is firing.
I'm not sure at this point what to look at next. This happened overnight, not gradually over time, and apart from running rough the engine isn't making any noises which based on sound, and how fast it happened doesn't make me think its a scoring/compression issue.
View 6 Replies
These super-hot days our TS had started to develop a very strange problem:
- when you first start the engine the A/C works normally and cold air blows from the front vents on A/C or MAX as usual
- if we shut-down the engine and try to engage A/C or MAX again the cold air would only come-out through the top (windshield) and low vents - no more front ventilation
- all solenoids appear to be working (moving)
View 4 Replies
Last week, the engine stopped twice in the 2 minutes after initial start....but then managed to take me back home. Was away for 1 week (not with TS) then when back , tried to start ...no joy.
This duplicates a similar event 8 years ago...solved with the ignition module being replaced.
[URL] .....
NO codes.
There are 2 options: crank sensor or ignition module. Will go for some tests and will report.
View 11 Replies
Looking for a wiring diagram for a 96 model with 3.4 engine? The horn fuse keeps blowing and I don't know what else is on that circuit to check. The horn works when the fuse is replaced but the fuse blows at some time afterwards.
View 5 Replies
If I press the gas a little hard in drive, my tires squeal but if I'm in reverse I can feel a slipping in the trans. If I try to back a trailer up an inclined driveway, it won't go, the trans slips. I have no crud in the pan. I've replaced the reverse boost valve. I installed a Trans-Go kit which is suppose to eliminate the reverse slip but it hasn't worked. Everything else works just fine and my fluid is red. I have engine braking in 2nd and 1st. The van backs up fine, it just does this in reverse under load.
View 2 Replies
Can i change from 3 cyl to 4 cyl 1992 metro....
View 1 Replies
Diagnostic says 1 and 6 are not firing. Car runs rough slightly. I think one of them is intermittently firing the other maybe not at all.
Possible causes according to diagnostic:
coil, plugs, injector, vacuum leak, wires (From memory)
Gas mileage is excellent. This makes me think its injectors. Failing plugs or wires would cause massive gas loss through misfiring cylinder.
Just bought this car. The seller said the wires and plugs are new. I will inspect tomorrow when I do the brakes.
Assuming they were replaced it leaves coil, vacuum or injectors.
View 17 Replies
I have a misfire on cyl 3, what is the firing sequence, changed plugs which didn't solve problem... so I'm going to try coil pack.
View 8 Replies
My Haynes manual indicates that the ELC exhausts air when the key is off. Is it intended to exhaust all air from the shocks every time I stop? It doesn't make sense to lower the vehicle every time I stop for fuel etc. With over 200k miles on this can it's amazing that the compressor still works.
View 9 Replies
I am working on my daughter's TS, it has been overheating. Water pump is fine and the thermostat is working fine also. I did notice that the temp gauge on the dash isn't. I have noticed that the fan isn't coming on either. I don't have a book on this car or a owners manual. So I am unsure of which fuses to check. I did try turning on the AC to MAX to see if that would start a fan, and that didn't work either.
View 13 Replies
About a week ago I was driving my Pontiac 2003 Grand Am V6 and it began to violently shake and the "check engine light" came on and started blinking. I then immediately took it to the mechanic It has been with the mechanic for 6 days and they were unable to locate the problem. They called me today and I was told that I have no compression in one of the cylinders (I have done business with them before and felt comfortable in that I wasn't being taken advantage of). Also, is there any problems in the future with getting a cylinder replaced i.e. other parts of the engine that might correlate?
View 17 Replies
My neighbor has a 2000 f150, 5.4 liter gasoline v8. The number 4 cylinder is not firing, additionally the injector is not putting any fuel in the cylinder either. We swapped coils, and plugs, problem stays in number 4 cylinder. He had a new computer installed but problem persists. I am trying to get a chiltons on order so I can see a wiring diagram, I'm wondering if the injector has any bearing on the coil, with respect to getting a fire/no fire order? What is upstream from these components?
View 6 Replies