TrailBlazer :: Car Acts Like It Goes To Neutral In Third Gear
Nov 11, 2014
My daughter just gave me her 2003 TB, about 180,000 miles. She never serviced the tranny but changed the motor oil religiously. She went to take it out one day and it wouldn't shift out of 1st. There was no warning, such as, sluggish shifting, hard shifting, slipping.
I dropped the pan, (no metal shavings just some grey slimy gunk) changed the 2 shift solenoids, filter and fluid. Now the TB has first and second but acts like it goes to neutral in third (no third). Before I give up on this tranny I was wondering if there is anything else I should look at: vacuum leak, known electrical issues with the tranny, PCM. It does not set any codes.
View 3 Replies
Advertisement
I have a 2007 F150 FX4 with 105K on it. When it goes from 2nd into 3rd, it acts like it's in neutral. There's nothing there. This is in "D" with "OD" on. If i turn OD off, it will wind up and grab 2nd again and will coast if I let off the gas. Also, if I manually shift into 2nd, it will engage 2nd and I'll have engine braking if I let off the gas.
The trans fluid was full and bright red as is should be with no burnt smell to it.
I dropped the pan and the magnet was a little fuzzy with some metal filings but there was no metal laying in the pan. I also dropped the valve body and there were no broken snap rings and the e-clip on the OD servo was intact. The valve body was also clear of anything that shouldn't be there. I'm hoping that I can replace the shift solenoid and that will solve my issues.
View 4 Replies
My car stalled one day like I was in a high gear at too low of a speed when i was in neutral. It now acts as if it is in a high gear all the time when I am in neutral. When I press the clutch it will idle like it is supposed to but when i let off it pushes forward slightly then stalls exactly like it would if i was in 4th or 5th gear. When I shift into 1st 2nd 3rd or reverse it dies as if it is in gear but will not move even slightly, when I shift into 4th or 5th it again dies but it but is acting just as I would expect 4th or 5t to at a complete stop i feel slightly more power in 4th which is expected being a lower gear but I also feel 5th pull just like its supposed to. I cannot get it to come out of the high gear it is in even though i can move the stick into the neutral position. It is difficult to get the shifter into 4th or 5th but it will move into the other positions like it should with the same no power result. My clutch is fairly new and i have tried inspecting my sift linkage wit no obvious problems. (1991 honda accord lx 5 spd, 2.2 sohc)
View 2 Replies
My car was acting like it was in neutral. After cooling down for 20 minutes, it would drive about a block. Then it would not drive.
View 12 Replies
I bought this santa fe for parts for my other identical santa. When you take it out of park into r everse drive 1st 2nd gear it will idle down 200 rpm. It had no codes till I revved it up and moved gears. Codes trans module shift selonoid b and c. It makes no noise or vibration. The torque converter does not grab what so ever if it is even moving. I want to fix it now that I see its better condition.
View 1 Replies
So I put in new clutch yesterday. Reverse works, granny works, 3,4,5 work. ZF6 manual. But when I try to go 1st or 2nd. Its as if the truck is in neutral....what should I be looking for. I bought the truck having only knowing the clutch was completely shot, was not told about this 1&2 gear issue....
Do I need to pull the trans out again... or is there something I can see or adjust, because from what i can see where the shifter connects there is no adjustments. Is it probably a gear selector fork...or connection that took a crap. when moving in granny gear i did not hear any irregular noises....
View 2 Replies
I was driving 90 km an hr. and my trailblazer went into neutral and started making a ticking noise and it wont go forward or backward...
View 2 Replies
06 F550 w/5r110w. Truck and trans runs great then trans acts like it was shifted into neutral, rpm's flare up and if you don't get your foot out of it the trans will re engage aggressively. Changed the speed sensor on the rear axle, there are no codes, had a trans shop change the filters and fluids then change out all of the solenoids. They tell me its not a trans problem.
View 3 Replies
We own a 2005 Chevy Trailblazer, 8 cyl, 150K miles. Since July 11, the transmission has been slipping into neutral, usually when slowing down. This happens anywhere, and usually in slow (so far) traffic. My husband has been able to get the car to drive either in D3, or has been able to get it back into Drive, and the car just drives off like nothing happened. This usually takes a few minutes of turning it off and on, and shifting gears. Today he drove it in AWD, and it was fine (so far). He normally drives it in 4WD. They have been unable to duplicate this problem and, because there aren't any codes, cannot tell us what's going on. Needless to say, I've had it.
View 11 Replies
2012 Trailblazer 4x4. Got up this morning to go to work, no reverse gear. I pushed it out & drove to work (15 miles). Got to work & reverse works fine now. Drove home & parked. An hour later I go out & again, no reverse. What's going on?
View 14 Replies
I have a 2004 Trailblazer LS with the 4.2L I6 and this problem just recently started and I found this video on youtube of someone having the exact same problem. [URL] ....
This noise is only there in reverse and drive. If you put it in park or neutral it goes away. Also goes away if you give it some throttle while in gear.
View 8 Replies
I was on my way to the store earlier today. Started the car, put in reverse, backed out, no problem---just like any other day. Put in first gear then started rolling. As I neared the RPM to shift to second, the gearbox was wobbly (which was strange), put it into second, then I had to downshift. It felt wierd. I pulled over. Car only goes into 1st and 2nd gear, I have no neutral and can't get into the other gears.
Some nice guy came up to me to see what the problem was. He told me it might be my clutch cable. He was nice enough to stop traffic for me so I could flip a u-turn in 1st gear to head back home.
So I'm home now, clutch can go into 1st or 2nd. Clutch feels normal, gearbox (where shifter is) is loose. I have a 2001 Saturn SL, I just hit 200,000 miles. I love this car. Runs great until today, just cant get into other gears or reverse.
View 30 Replies
I wonder what's the difference between Stealth (no arrow on display at all) and Neutral Gear? The reason I ask is, Neutral Gear is much easier to maintain than Stealth.
Also, when I break moderately hard, it seems like the CVT gear is put to low, so for every yard I travel, more rotation on charging motor. Since Toyota did a great job on transition between regeneration and brake pads, I can't tell when brake pads start to work. Any indications?
View 7 Replies
Emissions Workshop flashing in the info screen on the dash of my 2005 PASSAT TDI. The car went into neutral and refused to go into gear. Got it towed to the dealer and was informed that it required a software update. It was in the dealers 6 weeks earlier for its 75k. service. I feel ripped off....
View 2 Replies
1993 Geo Prizm with some odd 275,000 miles on it. Was at a stop sign, in first gear, and gave the car some gas. Very quickly it jumped out of first gear and stopped moving abruptly. Tried to get it back in first gear and it just stayed in neutral. Had to push it to the side of the road. Tried putting it in any gear and it wouldn't go. Then tried to have the car running in neutral and let up on the clutch and as soon as I started letting up on the clutch, something (like metal) started grinding. Pushing the clutch it (in neutral) stops the grinding. So, do I need a new clutch? New transmission?
View 11 Replies
Feel resistance going from neutral to 1st sometimes (and 4th to 5th or reverse)?
It doesn't happen all the time, but it doesn't feel very smooth. It feels like something is rubbing against the stick. When I reset to neutral and try it again, its smooth as butter.
View 11 Replies
The shift lever goes into the gates fine, if a bit easier. No weird noises. 1st and 2nd gear don't work - they act like neutral.
3rd-6th and reverse work fine. Clutch hadn't been slipping. It's the original clutch.
Local mechanic found no issues between the shift lever and the transmission itself. 3 weeks ago replaced timing belt and water pump and the car has been running well.
Yesterday I was driving home from work in light stop-and-go traffic. At one point I put the car in first and it acted like it was in neutral. Engine revved but there was no engagement of the drivetrain. 2nd gear was the same story. After experimenting, 3rd-6th and reverse worked and I was able to get the car limping off to a parking lot by starting in 3rd.
I got it towed to a local mechanic who services my car who said he doesn't crack open transmissions but would look to see if there was something obvious wrong between the transmission and the shift lever. He didn't find anything.
View 1 Replies
Today while driving, I was declining down a rather steep grade. I had my cruise control set at 65mph. As I was driving, I heard an odd noise, almost like my Prius was "revving" in a neutral gear. The battery was at a full or near full charge when this happened.
I found somewhere "What you're hearing is the engine braking - just what you'd expect when using B. The engine spins (pumps air) to slow down. At some point, if you have heavily charged your battery on the descent, the engine will be spun by the electric motor just to bleed off that excess electricity."
Only problem being, I was not in the "B" gear, I was in "D".
View 2 Replies
My 2005 Hyundai Elantra has 85,000 miles and we are having trouble with the gear shift. It will not shift into 1st from neutral but will shift into 1st from 2nd. We recently replaced the clutch (about 3 months ago). We are about to go on a road trip and are wondering whether we should get it checked out before hand.
View 9 Replies
2008 prius won't stay in gear, goes to neutral when hot...
View 12 Replies
A question during the show this week (1/22/2011) was whether it used more gasoline to idle in gear or in neutral with an automatic transmission. The answer was it makes little difference. I contend the engine uses more fuel idling in neutral. The reason is the increased level of partial vacuum within the intake manifold means more air and fuel will be drawn into the engine. When the vehicle is in gear, the engine idles slower, less vacuum, less fuel used.
View 8 Replies