Toyota - Tacoma :: 1996 - Starter Doesn't Engage?
May 27, 2015
My 96 Tacoma has recently developed an issue where the starter doesn't engage when I turn the key. If I let out the clutch/break and start over, it typically works.
The weird part is that I never had this issue until I had the clutch replaced. The day after I got it back was the first time I had any issues. It is intermittent and doesn't happen anywhere close to all the time. I took it back to the shop that did my clutch and they told me I needed to replace my starter but I'm wondering if there is any other explanation for what's happening that would make sense given the timing of the whole thing. Could work they did replacing the clutch be causing this?
View 14 Replies
Advertisement
I have a 1996 Toyota Tacoma, 5 speed manual pickup.
Occasionally I use the air conditioner. I'll be driving along and it's working fine but then it stops putting out cold air. I pulled into the mechanic one day and confirmed that when it is not putting out cold air, the compressor still seems to be running.
If I go into a store for about 15 minutes and then come out again, it works again. What might be happening?
View 6 Replies
08 Lexus GS350. Drove car Christmas Eve everything was fine, Christmas morning I go to start the car and it attempts to start once and before it cuts on it stops. Then anytime afterwards when I push the start button the starter doesn't engage and the radiator cooling fan comes on. I let the car sit for half a day and try to start it again I get the same cycle (it engages the starter but quits before the car turns over)...
- Battery is new as of September 14 (also took the battery to get checked 100% charged).
- I replaced the alternator in November 14
- I currently have the car at my mechanics but they can't figure it out as of yet. So far they are saying that the can't the cars computer to respond to their machine.
View 14 Replies
I have a 96 Impala SS with over 100k. I have a problem with it not starting, it is random as far as time of the day or if its been doing it, I will crank the key and it does nothing, all lights are on but the starter does not engage. I tried moving the shift lever and no luck, until I put it in neutral rock it back and toward and then it will start, I've done this three times in a row and it has started each one.
View 2 Replies
My starter motor in my 2004 Golf 2.0 doesn't engage or spin when it is very cold. By very cold, I mean below 5F.
The battery has plenty of juice, and jumping the battery doesn't work. I turn the key to "start" and nothing happens. When key is in the on position, fans, wipers, etc all work fine. When the car warms up to 20F or so, everything is fine and the car starts.
Here's the funny thing. If I put a little space heater on the driver side floor to warm up the fuse and relay panel, it starts with no issue.
I don't know enough about the interlocks between load reduction, starter motor, ignition switch etc to make a good guess as to which relay (if any) may stick in extreme cold. It's a tough problem to diagnose, because I can only experiment when it gets REALLY cold, when it isn't very fun to experiment anyway. I don't think it's the piggy back harness, because the wipers, horn and fan all work.
View 4 Replies
The starter in my '93 Dakota was dying (usual signs of worn brushes) so I replaced it with a new one from AutoZone. The starters looked the same, and after calling back to double check the part #, the store swears it's the right part. However, when I engage the starter, it spins but the pinion gear doesn't engage the flywheel. I can't see how I could have installed it wrong - the two bolts seem to have only one place they can go.
View 19 Replies
My 1995 Toyota Tacoma won't start every time I turn the key. Sometimes it starts right up, but recently, more often than not it just gives a single click when the clutch pedal is pressed in just about all the way.
I replaced the neutral safety clutch switch and it started every time for about a week, then it went back to not starting reliably.
I'm growing tired of making sure I park on a hill each time I park.
View 4 Replies
This is a 1996 Toyota Tacoma, 2WD, 2.4L. When I apply the brakes I get a very heavy vibration in the front end, almost like a wobble. The vehicle otherwise stops fine. No noises. The vibration occurs at pretty much any speed over 20 mph. The frequency does not seem tied to the actual speed but it's hard to tell for sure. It does not do it when I apply the emergency brake only.
I replaced the front disk brake pads, with new clips and shims. There were worn down pretty far and needed replacing. Unfortunately that did not make any difference in the vibration. Rotor runout and minumum thickness were checked while changing the disk brake pads and both were within specs. I did a quick inspection of the ball joints and tie rod ends by trying to move the tire and everything seems tight enough.
I'm not very proficient on suspension issues. What else can I look for.
View 19 Replies
I recently purchased 96 Toyota Tacoma 108 K miles. I discovered that it is totally missing all the front fender liners on both sides. Looking for info as to the number of parts needed for each side. No need to include the clips because they are bought by the 10 pack. Maybe how many 10 packs.
View 2 Replies
This is a great little truck we only use occasionally. It has 145,000 miles and runs great, but the a/c temperature is very sporadic, and this week it is 100 degrees! One day it will work fine, and the next day it will only blow hot air. Sometimes the air starts out cold, but after 5 min of driving, it turns hot. I have had the freon checked and my mechanic said part of the compressor (forget what he called it) was probably getting stuck at times, and he would have to pull it all out and possibly replace...
View 3 Replies
I have a 96 toyota camry that won't start. when i turn the key, the starter clicks but doesn't turn. I replaced the starter and it works fine (as does the one i took out). the battery was obviously checked and is charged. When I hook up the starter to the leads and its not in the engine it doesn't turn (in other words, its not a locked engine). I replaced one of the fuses in the starting relay and it didn't make a difference. So the problem is between the battery and the starter - the starter isn't getting enough power (if i take it to an autoparts store it works when hooked up to their system but doesn't work (but makes a click) when hooked up to the car.
View 3 Replies
I am the owner of a 1996 Toyota 4runner. Recently, when I bring the vehicle to a complete stop, the entire SUV shudders, almost lunges, forward. At times it feels like the brakes are trying to re-engage. Could really use some pointers on this issue.
View 6 Replies
I have a 1996 2.7L 4x4 Tacoma. About a month ago I had a problem pop up. I went to start my truck and nothing happened. All the dash lights came on(i.e. e-brake indicator, airbag light, check engine light) like they were suppose to when you turn on the key. I heard the fuel pump come on and the starter relay click, but the starter did not activate. My first thought was bad battery because it had the original from when I bought it used. So I replaced it. Thought problem was fixed, but it reappeared. Checked all the starter wires and alternator wiring and they all appear to be fine. Truck started fine for a week after I had inspected the wiring. Then the problem came back.Then I replaced the starter thinking maybe the solenoid was bad. Once again the truck started fine for a day or two then the problem resurfaced. I thought maybe the starter relay had a bad contact in it so I replaced that, with no luck. Then I replaced the ignition switch thinking maybe that had a bad contact in it. Once again no resolution to the problem. The final piece to the puzzle is that sometimes if you keep turning the key over and over the thing will start and other times it refuses.
View 11 Replies
I went to leave today and found the 2012 Accent (auto trans) won't start. The starter doesn't even try to engage.
Battery voltage was 11.5 both when turning the key to start, and when just in the accessory position.
I put jumper cables on it from my truck and left it for 5 minutes. Voltage was now 13.5 but it still wouldn't try to crank.
What to easily check? I plan to call the dealer in the morning and have them come get it since I only have 17,xxx miles on it.
View 21 Replies
So yesterday I drove to my friends house b4 work. My car started up just fine no problem. I was at his house for maybe an hour and as I was going to leave I tried to start my car and it was dead? All my lights work got a jump. Still nothing so today I took my starter off and had it tested( fail). Paid for a new one and put it back on. Hooked everything up. Went really smooth. But went to start it and it won't engage the flywheel? Am I missing something?
View 1 Replies
I have a 1998 Accord EX 4-cylinder that will not start. When I turn the key the starter does not engage. The green key indicator on the instrument panel looks like it recognizes the key security chip.
When I checked for voltage at the starter solenoid coil wire I found about 9.0 volts without turning the key. When I turned the key I got a little over 11 volts. I disconnected the wire to the solenoid coil and measured 0 volts from the coil wire to the battery BUT 9.0 volts from the tab on the solenoid valve to the battery. It makes me think something is shorted to the frame of the starter.
View 2 Replies
Replaced starter after which when i turn key to on position starter will engage and actually start engine; turn to accessory and starter will engage but wont start engine. Checked double checked and so on installation. And then exchanged for another rebuilt starter with same results. the reason for replacing the starter in the first place was during the winter went out to start to let motor run fur a while which it did. Went to move before completely warmed up and killed engine starter never made another sound. 1978 gmc 6000....
View 9 Replies
Developed a problem that I'm trying to research a bit to see if there is a common problem. Haven't really seen too much info yet, other than a potential clutch switch that will continue to display "depress clutch!" That's not my problem.
I don't drive this thing more than once a month or so. But occasionally I'll drive it to work for week or less.
Basically, every once in a while I'll try to start the engine and the starter will engage and turn the engine for about 1/2 second and then stop. All lights on the dash stay on. I'll reset the key, and it will usually then start normally on the next try. Sometimes it does the same thing on the second attempt.
Battery is 100% topped up, as it stays on a battery tender. Battery load test shows great. Connections are tight and clean.
The other day I cleaned the main B+ terminal on the starter, made sure the terminal jamb nut was tight and cleaned; then assembled the terminal and torqued. Removed, cleaned and re-torqued the top bolt on the starter. Cleaned and re-tightened the main grounds. Also cleaned the solenoid connection and made sure it fit back on securely.
Was fine for about 6 starts then it did the same thing again.
The last work I did on the car was a clutch upgrade (myself)...literally almost a year ago. I've driven it about...500 or less miles since. So I'd have assumed bad starter connections, but I think I've ruled those out. I didn't drop the subframe, just the transmission. the problem did start pretty much immediately after that job and hadn't done it at all before that job.
So what other interconnects are in the system to control the starter? Relays, control modules, switches, sensors...I'm sure all of the above. Something is allowing the starter to turn for 1/2 second and then drops it.
Perhaps the battery is dropping below voltage while cranking and something is aborting the start?
I haven't really done much diagnosing other than a simple load test on the battery. I haven't taken voltage readings under cranking, voltage drops across wires or voltage readings at terminals yet. Ugh..I really just don't feel like it. Maybe I'll just dump the car into the Pasquotank River.
Not that it really matters, but I've also installed an APR K04, full exhaust, Carbino intake...I don't know what else. But it was all done quite a while ago, by me. This second clutch I've done seems to have been the thing that triggered this particular problem.
View 2 Replies
2003 Passat 1.8t FWD.
My buddy is having a wierd issue that just recently started after it's gotten cold out. The car would not start for him so he had me look at it. Attempting to start there's no sound from the starter at all. Battery is fine. When I shift in and out of a few gears, the starter engages and the car starts. Stop the car. Attempt to start it again and nothing. Shift through the gears some more and the car almost starts but quickly dies. Shift some more, start, running like a champ.
What is it about shifting through the gears that allows the starter to engage and the car to run again?
View 3 Replies
Came home from a trip and the Santa Fe had been parked for 3 days. No starting issues prior, but went to move it and no go. When I turn the keys something "spins" but the starter does not engage. 99% sure it needs replaced. 02 GLS V6 AWD
View 4 Replies
My mom's 2012 accent won't start. When turning the key the starter does not even attempt to engage. Battery voltage is fine, I also tried jumping it. I have already checked all the fuses and relays and they are good.
Whenever the car is attempted to be started, the Electronic Throttle Body/ MAF makes a high pitched sound but that is all we can get out of the car right now. I also checked the parking sensor by going from Park (P), through all the gears, and then back to Park. Still nada.
View 4 Replies
