Toyota - Sienna :: 2007 - Code P2195 For O2 Sensor Signal Biased
Jul 19, 2016
I have a p2195 trouble code with my 2007 Toyota Sienna CE. This is O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1. I am assuming I'll need to replace this sensor. It's a little confusing but if I am reading my Haynes manual correctly, the repair goes as follows:
The sensor for 2007 and later models will be in the exhaust pipe after the catalytic converter. To remove it, it's necessary to remove the passenger seat, disconnect and snake the pigtail through the grommet in the car floor. Then, disconnect the O2 sensor from underneath the van and replace.
View 12 Replies
Advertisement
2007 camry xle 4 cylinder engine, 2.4 liter I'm getting a P2195 code, which is the A/F sensor B1 S1. I have a few questions:
1. Any diagram of the location?
2. I've been trying to figure out the correct part number, so I can search for a replacement. I've found 4 or 5 different numbers already. What is the correct part number?
3. Should I only by the OEM part? Or do the aftermarket brands like Denso work?
View 4 Replies
So I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 Replies
I have a 2006 Ranger 2.3l 4 cylinder that is have emissions problems the code the tech gave me was P2195 an I bought the o2 sensor just where it is, and the auto stores didn't have a manual for the year of my truck.
View 2 Replies
Any resource that I can use to find the part number of the O2 sensor on my wife's 03 v6 Camry.
I have a check engine light, scanned by code scanner to reveal P2195. This OBD code is supposedly sensor 1, bank 1 "stuck lean" which is the upper O2 sensor on the left side of the engine (closest to radiator with transverse mounting).
So it should be easy to change if this is the issue but I'm having a hell of a time finding the right part number. Too many choices.
View 12 Replies
I have a 2004 Sienna LE and it has left/right signal problem (not working) in the morning or when the weather is cold. The problem usually last for about 5 to 10 minutes until the inside car temperature becomes warm.
When this problem happens the emergency lights are working. Only the signal left and right do not work.
Is this a common Sienna problems? I brought the car to the dealer but they refused to fix it because they cannot duplicate the problem. I am guessing when the warranty has expired, they will make suggestion to replace the part but not until then.
View 30 Replies
I have a 2000 Toyota Sienna. At first I noticed that the dashboard light showing the left turn signal was on would light up when I put on the headlights. A few days later, I discovered that the left turn signal stops working when I apply the break. Also, when I'm using cruise control and use my left turn signal, the cruise control stops maintaining speed.
View 2 Replies
My 2009 Sienna has turned on the Malfunction Indicator Light but my OBD-II scanner shows "no codes". How can that be? How can I diagnose the problem?
View 4 Replies
The brakes on my 2007 Toyota Sienna suddenly went soft. The mechanic first replaced the rear pads, which needed to be done anyway, and when that didn't fix the problem he replaced the master cylinder. The brakes are still very soft. He has bled the system several times to get rid of possible air in the line, but that hasn't fixed the problem.
View 5 Replies
I have a 2004 Sienna LE with 169,500 miles. It started to shift hard between 2nd and 3rd gear in traffic (it had previously never had ANY hard shifting). A few minutes later the CEL came on along with the VSC and Traction Control lights. Both Advance Auto and a Toyota dealer confirmed that the codes showed the speed sensors on the rear wheels (both sides) were bad. The Toyota dealer also declared that the low gear solenoid in the transmission was bad and the transmission would need to be replaced soon. I found it strange that the transmission started shifting hard at the exact same time the speed sensors went bad. Is it possible that simply replacing the speed sensors would fix my hard shifting issue? I am a shade tree mechanic that does brake work and other intermediate tasks. Is speed sensor replacement an easy job on this Sienna?
View 6 Replies
I have a 2007 Toyota Sienna LE. Sometimes after starting the car the ABS and tire pressure lights come on and I am not able to shift the car out of park. The dealer ordered a brake switch and in the meantime I would just push the override button on the gear shift to move it out of park. BUT, when I do that I loose most of the power (radio, clock, blinkers, power locks/windows/doors, wipers...but not power steering). The brake switch came in. They replaced that, told me the battery (which was installed in July 2010) was very dead and replaced that too. I drove home happy. Next day, ABS and tire pressure lights are on, car won't shift out of park. I manually override it, loose power in said areas and go straight back to the dealer. They said the power was so silly (my word, not theirs) in the car they couldn't plug it into their computer to do the systems check, so they traced wires by hand, took all the wires out of the "block" and reconnected them. Once everything was back together, car works fine. They said no wires were loose and they don't know what was wrong or why it's suddenly fixed.
View 4 Replies
Having been on a long road trip, I noticed that every time I switch off the engine, there is a grinding noise coming from the engine. Took the van in to Toyota for a regular service, they could not find anything wrong. I then took it to an alignment place having replaced all four tires. They heard the noise straight away and think it is a worn bearing in the cooling fan in the alternator. 2007 Toyota Sienna LE FWD... The car only has 22,956 miles on it.
View 4 Replies
The dash temp gauge reads in the middle between hot and cold within a few minutes of running. However, it takes about 20 minutes for hot air to come out the heater vents when the heater is set to maximum heat and the fan is on. What should I check and in what order?
View 19 Replies
I have a 2007 Toyota Sienna and the passenger sliding door will not slide on its own. You have to tug on the door to get it to engage. The repair shop said the door needs a new actuator. How hard is replacing the actuator on sliding passenger door?? My brother thinks he might be able to do it???
View 6 Replies
Its been cold here in CT for the past three days. It's been in the negatives... My engine light came on last night with a p2414 so I ran it, looks like front o2 sensor (could be a couple of things), so I cleared it and waited. Today it came back with p2195 and p2414. A different code for the same sensor. But my question is this. Before I replace the o2 sensor. Is there anything common for this car that would throw this code?
View 21 Replies
I got my car in November and I just did a scan and got this code. I don't have a CEL on. I do feel a slight vibration from time to time. It's very light.
Should I clear all DTCs and then run a scan a couple of days later to see what codes I truly have? Or should I address this code?
If yes, what should I do about this code? Do I need to buy a new knock sensor or should I check the wiring first with a voltmeter?
View 15 Replies
2005 Ford Taurus, 6cyl, 3.0L, OHV, 90K miles. CEL came on and code read was P2272 with info "O2 Bank2 sensor2 signal stuck lean". Should I assume that I need to replace one of the O2 sensors and if so, which one ?? Not sure, but I think this car has four O2 sensors ??
View 6 Replies
Both the P2195 (Oxygen sensor or A/F sensor stuck lean - bank 1 sensor 1) and P0031 (Oxygen sensor heater control circuit low - bank 1 sensor 1) were pulled on my 2009 LE (77K miles). Is it safe to assume that the upstream b1s1 sensor is the culprit?
I believe I've found the OE Denso part 234-9056 - is this the right one?
General question about O2 sensors - is it recommended to replace both the upstream and downstream at the same time, or is it not necessary to do that?
View 8 Replies
Last week I was on a dive trip and my RX remained parked outside for a week. As I was returning home and I was merging on the highway my CEL appeared; I used my scanner and the code was p2195, which I cleared. My RX was driven for about 5 minutes before merging onto the highway.
On my way home I needed to stop for gas, I filled up and them merged onto the highway and the CEL came on again. I used the scanner and the same code p2195- which I cleared.
I completed my drive home, and have only been doing short city driving since then an no CEL's.
View 2 Replies
Just the other day my A/C had started to blow hot air, so I looked online and was told to try and re-charge it by a few people so I went and bought a can of that r-134a recharge and as it was on the low port the gauge was not reading like any of the guides I saw, as it did not stay at just one # it would go from 25 then back up to 40+ then slowly back down and just kept going up and down, I am assuming as the compressor was kicking on.
So I did not charge it at all because the PSI said to be in my car at the temp was 45 and if it was doing this but going 25-40 and back I did not want to over fill it.
So then this morning after doing that last night my engine light comes on, but I was told that the a/c will not effect this but I had it checked and I got an error code (P2195) "lack of heated oxygen sensor bank 1 sensor 1 H02S11 switch sensor indicates lean" with a few causes that may be the reason.
Should I go ahead and charge the a/c? will this cel code have anything to do with the a/c? and also why was the gauge changing like that and not at one steady number? Could it be because the car is running hot and maybe I need to check the anti freeze/coolant?
View 1 Replies
I have a 2011 toyota camry. 3.5L v6. I have code p0157. I know my car has 4 o2 sensors, but I am not sure which one to buy. Where this o2 sensor is located, and which one to purchase. A part number would be very useful.
View 3 Replies
