Toyota - Corolla :: Noise In The Front Driver Side Wheel Well
Nov 30, 2014
I hit a curb in my 97 corolla now it's making a noise in the front driver side wheel well driving down the road, what it is?
View 6 RepliesI hit a curb in my 97 corolla now it's making a noise in the front driver side wheel well driving down the road, what it is?
View 6 RepliesMy car is a 2000 Corolla CE I bought 2 months ago with 45k miles. It does not have ABS system.
Before I took the mechanic:When I brake, there would be a "clamping" noise from the drivers front wheel sometimes. It sounds like the caliper "clamping" noise. The brake cylinder would also click the first time (and maybe second) the pedal is pressed.
The mechanic replaced the both front calipers, put new brake pads, installed rear drums and shoes, and changed brake fluid.
The brake pedal is now high and when I brake....it does brake but it's not like "instant stopping power" like new brake pads. Is this normal? (maybe I have to break them in). Also, the master cylinder is still clicking (I pump the brakes since my car has no ABS)....it clicks the first 2 times I pump. Is that normal?
Edit:Since the repair, I drove it for the second time. This time the brakes brake more "instantly". The clicking of the master cylinder is still there however, could this be due to air in the hoses?
I drive a 2006 Toyota Corolla, and I've noticed e a squeaky noise coming from my passenger side front wheel. The noise only occurs when I am accelerating the car and driving between 20-40 mph. As I accelerate, the squeaks increase in frequency. They disappear when I brake.
A mechanic replaced the front brake pads two years ago (15,000 miles ago) and also shaved the rotors. About a year later, the squeaks began. I brought the car into a different mechanic at that time (because I moved) and asked them to take a look. They checked the brakes and said they looked good. They attributed the noise to metallic brakes as opposed to ceramic and said the noise would go away in time. The noise has persisted, however, and is becoming more intense.
What is going wrong? Could this be a CV joint or wheel bearing issue? A rotor issue?
I have a 2006 Toyota Corolla. There are two plastic covers on the undercarriage of the vehicle in the front.. The front driver's side is loose; the oil change told me the little clips are broken and they used a "strap" to hook it back up. Well, on the Fla turnpike, the strap lasted about 30 minutes
View 2 RepliesI recently brought my 2005 toyota corolla to my mechanic to give my car a check up as i will be going on a three week road trip soon.Upon assessment, my mechanic told me that my front right wheel bearing was making a strange noise and that i should replace it. I went ahead and had it replaced. after i had it replaced the front right wheel area was still making a grinding noise (louder than before it was replaced). I brought it back and he replaced it again with a new wheel bearing.
Again after the 2nd replacement it continued to make a load crunching, grinding noise when ever i brake the car. So once again, i brought it back. I thought perhaps it was my brake rotor and had him check that. He did just that and said the break was fine. He said it may be because the axl was not sitting true. so i had the axl replaced. well today i picked up the car and drove it approx 5 miles and the same crunching/grinding noise persists!!! I brought it back and it is once again being worked on. I need it fixed and am worried that my car won't hold up for my upcoming 4000mile road trip. I have attached a video clip of the sound to this post.
I noticed while driving my car there was a unusual rumble or grinding sound coming from my drivers side front wheel well. I get out and look I see a bunch of Fluid all over my wheel well. I look around turn my wheel around and see this fluids all on my rotors and suspension. Ive noticed couple weeks back the boots on the struts were ripped in two pieces from deteriorating or dry rotting (this was on both sides) and ive also been hearing some odd squeaking sound for over 15k miles every once in a while going over big bumps or train tracks. Struts go out at only 80k miles on their corolla? Yeah struts do usually lose their life around 60-80k miles but I've never seen them leak around that many miles. Is this a common issue?
View 5 RepliesI have a 1991 Toyota Corolla Wagon (150,000 miles) with noise coming from right front wheel well. My car is making groaning and creaking noises like the hinges of an old wooden door. CV joints serviced <5000 miles and the boots are clean and intact. There is no clicking noises during a turn Left or Right. Bouncing the right front corner does not replicate the sounds, tho' there is some slight squeaking noise not heard from the shocks/struts in the other corners. The sound is NOT heard in the morning going to work, but is very noticeable driving home at 5pm. I notice the sound going downhill at 35 mph, but goes away with light braking, Going over railroad tracks does not affect the noises. I'm thinking this could be worn bushings, strut mounts or who knows what?
View 1 RepliesMy 2005 Prius has 95k miles on it. I've been hearing a cluck-cluck-cluck noise from near the front driver side wheel. I had an independent mechanic test drive it, who said the wheel bearing needs replacement. Should I have it checked out by a Toyota dealer? They're so much more expensive, but are is it worth taking it to them?
View 15 RepliesSo on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 RepliesGetting the car ready to drive 1500 miles cross country, I took the car to a mechanic for a check up. I asked him to pay particular attention to a thumping noise from the right front side below the floor every time the car goes over a small bump at low speeds. The car has 128 K miles. He tells me everything checked out fine except the attachment points of the sway bars are worn and that is the cause of the noise. He said that apart from the nuisance factor its not a safety issue and that I could leave it alone. Alternatively, replacing the bar/s would cost around $300. What is a sway bar and what does it do. I'm planning to trade this car in about a year from now. Till then it will be mostly used in city driving and commuting. It will be driven around 12K miles a year.
View 8 RepliesI've noticed a rattling noise coming from under the front of my 02 toyota corolla. I looked under the car and there seems to be a piece of metal under the front of the car thats vibrating and making the noise. The piece of metal is almost directly in the middle front of the car, in-between the front tires. The sound seems to be most prominent when I accelerating or backing up.
View 2 RepliesHad my wheel bearings replaced 3 weeks ago from a mechanic I never went to, as mine was on vacation. 3 days later tire fell off while driving. So we took it to my regular mechanic and had all safety issues fixed. New brakes, rotor, hub. But noticed that a grinding noise appeared. Took it back to mechanic, and he said that it was due to the spindle being slightly bent. Thst it wasnt a safety concerns, but will cause rotor/ brakes to wear out quicker.
I'd like to trust my mechanic, as he has always done good work for me in the past. But am a little shaky over every noise. I'd he correct?How soon should I get it repaired? I just dropped over $600 to get the can drivable again. So if I can push it off until I can afford it that would be great! Otherwise, I might need a small loan to repair.
2000 Corolla - "growling" noise on the passenger side of the engine / stops when I turn the steering wheel - no loss of PS fluid (I also flushed the system) - which bearing(s) might be bad...?
View 2 RepliesI have a 05 Prius. Developed a low hum noise some time ago. It now is so loud can't hear the radio. Sounds like a heavy agressive truck tire rolling down the road. When turning the steering wheel from right to left quickly, noise level changes. Does this sound like a bad wheel bearing and if so what am I looking at for repair costs?
View 5 RepliesTruck has 1800kms on her, pretty much brand new but there is an odd clicking noise on the front drivers side wheel when I adjust the steering from left to right and vice versa. Its quiet if I am going straight, but it sounds like there is a linkage loose. Its not too loud or noisy, but having problems with tierods/knuckle assy?
View 1 RepliesLowered my car yesterday. 23" FTG. I'm now hearing a clicking noise from my drivers side front wheel.. I mostly hear it when my foot is off the gas and I'm just coasting (usually at slower speed). Also, it gets louder (worse) and is accompanied by what sounds like a rubbing when I take turns.. Is it axle bind? Or should I be concerned?
View 1 RepliesI have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 RepliesAbout 6 weeks ago I noticed a noise coming from the front driver side wheel area. We had just gotten the tire rotated and once at freeway speed it was like a squealing noise, just like when you have worn brakes. Since then the squealing noise is gone and now it's a faint (hard to describe over text) "whomp whomp" noise as if I have off-road tires. I notice it more on freeways I supposed because it's a smoother straighter surface. On a particular right bending street by our house it's louder. What it might be? Car has 36k miles.
View 8 RepliesFirst issue started a few weeks ago. When turning left at a speed > 20mph or when turning wheel quickly I get a rattling noise, which is more prominent with the driver window down, so it sounds like it comes from the driver side front wheel, but not quite sure. It is fairly loud as I have had pedestrians look at my car when turning because they can hear the rattle.
Second issue started this morning but has persisted every time since. When the car is cooling down, we get that whirring noise, which I presume is thr coolant pump. That noise also happens now when I enter the car, and it is accompanied by a knocking noise as if somebody is hitting the outside of the car repeatedly. This is quite unnerving as it sounds like something is hitting the bodywork of the car. It stops immediately when the normal whirring stops.
I had the steering and water pump recall done in november last year, could this be related to that? Forgot ti add the car has done 49000miles....
It seems to be coming from the front passenger side wheel well area. It's only present during braking and coming to a stop. Seems to be also related to wheel speed. The brake performance doesn't seem to be impacted but it's very embarrassing creaking through a parking lot. The noise doesn't seem to be present on a cold start but once the brakes warm up it really comes to life.
I noticed with both wheels up off the ground that the front passenger side wheel (The side making noise) had more resistance than the drivers side when trying to spin. [URL]...............................
Noticed a clicking noise when only turning left out of a parking lot today? What this could be? Sounds like it was coming from the driver side front wheel?
View 2 Replies