Toyota - Corolla :: 2008 - Grinding Occurs Intermittently When Shifting Up Into 3rd Gear
Dec 7, 2014
I bought 2008 Corolla S 5 speed with 62K miles. Now have 135K miles. When shifting up into 3rd gear, a grinding occurs intermittently, more often as miles accumulate. I try to make sure clutch pedal is fully depressed. No problems occur with other forward gears, up or down. What the problem might be and/or what can be done to fix? This is the sixth car I have owned with manual transmission. Never a problem like this!
View 5 Replies
Advertisement
Our 05 Corolla, 160,000 miles, has started making a grinding sound when we upshift into 3rd, unless we let the rpms fall to below 1000. My husband said the clutch needed adjusting, but the dealer said this clutch is not adjustable. The dealer found nothing wrong and could not get the car to make the noise while in the shop. (It did actually get better for a while but got worse again almost immediately after the visit to the dealer.)
Our other car (a Saturn) has over 250K miles on the original clutch, so I don't think it's our driving. What could be wrong, and is this something that needs to be addressed soon lest we damage something irreparably? Also, this car has, since purchase, been nearly impossible to shift on the coldest mornings. Really, sometimes it is all I can do to get the lever in reverse to back out of the drive in winter (in Kansas). Warming up works, but it seems to take an inordinate amount of time before shifting is"normal."
View 3 Replies
got a sweet deal on it but only 1 problem with the car. when i shift into 2nd gear there is a grinding noise, however it doesnt grind if i drive super slow... it doesnt really matter if i upshift or downshift into 2nd it will make the noise either way... also the grinding noise is only there WHILE shifting the lever into 2nd gear so its only there for a second, once the lever is shifted into 2nd gear there is no grinding noise at all...not sure if this is related but the clutch pedal also feels very lose just when its about to hits the floor...
View 4 Replies
OK, my daughter bought a clunker. Engine compression tested good, and transmission shifted fine so I proceeded to fix the car. Everything went fine until I got to the passenger side axle. I've always reused the inboard "tulip", and have never pulled one. Until today. The boot on the remanufactured shaft would not fit over the old tulip. I rented a slide hammer with a cv remover attachment and removed the old tulip. I then installed the new shaft, using a hammer on the end of the shaft to reseat the new shaft in the transmission. I didn't hit it hard. Now the car makes a horrible groaning sound when I put it in reverse. When I shift back to park, it sounds like a gear grinding. Also, the car rolls when its in park as if it was in neutral. I'm totally stumped as to what I did wrong. Did I destroy the transmission???
View 19 Replies
I have an 05 corolla XRS. I just had a sport clutch put in about 1 year ago. Whenever I shift into 4th gear and accelerate, the RPMs drop about 500 and I lose power for about 3 seconds before it starts going back up. Other gears are acting normal. Best part is that I let my friend drive the car earlier and since he did it's been doing this.
View 7 Replies
I was driving my car today, and I stopped at a stop sign. When I went to go, I pushed the gas, and my car revved up, moved forward, then all of a sudden it made a loud grinding noise (Like I was dragging metal sheets), and the gas stopped responding (but the engine was still running). The car still turns on, but whenever the gas is pushed, it doesn't go and makes that awful noise. What could be wrong?
View 2 Replies
This is very weird. A strange noise occurs intermittently. It sort of sounds like a pulley slipping on a steel shaft briefly followed by a brief rattling noise and may or may not blow out fuse number 14 (A/C Pressure switch, backup lamp and daytime running lights, redundant speed control heated pcv, ABS, Reverse park aid, EC Mirror), then the brake light and the ABS light is displayed and the cruise control quits working. It does not ALWAYS blow out the fuse as I discovered yesterday.
The first time it happened (about three months ago) I was doing 75 when it happened and was unable to figure out what it was. Yesterday it happened and I new it was fuse number 14. I replaced the fuse and it happened again within 3 minutes. It may be when I turn the wheel to the left. The first time it happened I was changing lanes, yesterday when it happened I was on a ramp turning to the left. In the driveway it happened as a backed up and turned the wheel to the left. I cannot identify where the noise comes from. After the noise and the blown fuse the truck runs just fine and I can continue to drive.
View 5 Replies
My F-150 has developed a rattle and vibration at idle that only occurs with the truck in gear and stopped (with the brake depressed.) The noise appears to be coming from the front of the truck, perhaps from the driver's side (though it's difficult to tell while sitting in the cab).
Before I go crawling around underneath with my son holding the brake while the truck is in drive--I would sure like to know where it might be best to point the flashlight.
View 6 Replies
Just recently, my car 6 speed has started acting up and it's got me worried. First, and most notably, when I go to shift into 4th gear, there is a slight grinding noise and its a little tough to shift into 4th. Once it is in 4th gear, though, it shifts and drives fine with no other grinding noise. A buddy of mine says it might be the synchros, but what that means or how I can fix it.
Also, it has been having a rough idle on startup for a while now. It will idle at around 1,200 RPMs for a bit when I start it up, and it will kind of backfire out the exhaust a bit, kind of like it's a misfiring coilpack or something, but will usually go away after I drive for a bit.
Driving my car right now isn't very fun when I am only worrying about what's wrong with it, so I really want to get it fixed sooner rather than later, before these develop into larger problems.
View 7 Replies
A few weeks ago I bot this truck to have some fun with. 98 F150 4.2l with a lift and some beefy tires. Well something to get me into trouble. On the test drive i never herd anything, mostly because I wasn't ripping it around. I know very little about transmissions, mostly because I never had a problem before.
I have a grinding noise when down shifting into 3rd for either 4 or 5th. It doesn't happen when I am going from 2-3. It also wont happen if i keep the clutch disengaged for a few seconds. It almost like the transmission need time to slow down for a second before shifting.
It also does this going into reverse.
View 1 Replies
Periodically my 1994 Toyota Corolla 5-speed manual will not start. Other times it seems to hesitate before starting. The rest of the time it starts fine.
When it does not start: I turn the key, and hear the fuel pump relay click, and hear the fuel pump on the gas tank energize, but the car does not try to crank. I do not know if the starter solenoid is engaging at this time, as I could not listen for it while in the car. When I did try to listen for it while under the hood with someone else starting the car, it actually started (did not exhibit the issue)
When it hesitates before starting: However, sometimes, when I turn the key I hear the fuel pump relay click and the fuel pump energize, after about 1-1/2 seconds of holding the key, it does start.
When it does start it sounds normal, not like a low battery. The battery is new. I had the charging system checked at Advance Auto and they said the battery was good as was the alternator and starter. Plenty of cranking amps.
I disconnected the main wire on the starter motor and cleaned it with a wire brush. I also cleaned up the battery terminals.
I did find that the switch on the clutch pedal that allows the car to start when pressed has some fluid leaking on it (clutch fluid I think). Could that be causing the intermittent starting issue? If so, can I just clean it with WD-40 or something like that?
View 1 Replies
My 2009 Toyota Corolla has started to make a grinding noise when starting. The sound is identical to when you try to start an idling car. What the problem is?
View 7 Replies
I inherited my Mother's 2000 Corolla CE with low mileage. I know that since the car was knew, she had the dealer check on why the horn did not blow every time she pressed it. I do not have those repair papers, so I do not know what they did to the car. Again, after each of 3 visits to the dealer, the horn would work for a few months. Finally, she gave up. Arizona does not test the horn, anyway. So, now, I am having the problem. (Also in my V90 Volvo post). Two cars with no horns.. Short of pulling out the air bag and the wires? Bad ground somewhere?
View 3 Replies
We have a 1998 Toyota Corolla with 170k miles. The brakes are squeaking and grinding often. In Feb. the front brake pads were replaced, but the noises continued. In May, they replaced the front pads again, within a week the grinding and squeaking continued. Finally, I took the car in late July and had the mechanic drive the car around. He said the back brakes were making the "grinding" noise and the front was squeaking. He said it was "cheap brake parts". When he looked at the brakes he said the back brakes needed adjusting and may not be working as well, therefore making the front brakes work hard. This caused the front brakes to get hot and develop a glaze. He adjusted the back brakes and scratched up the front brakes. The car was fine for about 2 weeks or so. The sounds have gotten progressively worse and I refuse to drive the car. The brakes seem to work, but the sound is so terrible like something is loose, or off and scraping metal. We have used this mechanic for years with a recommendation from our neighbors.
View 4 Replies
I have 2009 corolla with 70000 miles on it. I replaced new brake pads. I have some metal grinding noise when i turn right only. I tried looking online and got few similar problem faced by other people. I am not sure if its exactly same issue. No accident damage. Mostly driven on freeway.
1) noise looks similar
2) I do not get noise when i accelerate
3) for car this old is it expected ?
View 5 Replies
When I start my car (usually a cold start) I hear a TERRIBLE grinding-like noise. Other times it sounds like a shuffling noise. And then other times it's like its over-exerting itself trying to start up. I've taken it to the dealer many times as it's a 2014 Corolla. They have no answers. The claim it's just a characteristic of the car. I call bull. This isn't normal for any car. My car has a CVT transmission by the way. Could it be the starter? Spark plugs? Note: the noise is about 1000x worse in winter. Audio is attached in separate comment.
View 19 Replies
So the grind in 3rd gear is getting pretty bad. I have to put it into third slowly and 4th sometimes grinds a bit. Could it be the slave or master cylinder?
View 8 Replies
My 94 Toyota Corolla has about 190,000 miles on it and lately it has had a hard time shifting between 20-30mph. It finally does reach it and does not have trouble shifting at any other speeds. This only happens in the heat of the afternoon (Never have this problem in the morning). Also, my O/D light has been flashing when this happens, or at least around the time it happens. Could these two problems be linked? I took it to my mechanic in the morning and he checked the transmission fluid and it seemed fine, he also had no problems driving around when he tested the car. He said my transmission is going and that I should make "long term" plans. Is there any hope?
View 1 Replies
2011 Corolla S 1.8L 4 speed a/t
I have noticed that when my car shifts from second into third gear at around 50 km/hr that the rpm drops twice. It shifts (almost seemingly to a 2.5 gear) and the rpm drops and then a second later it's like it shifts again and the rpm drops again, is this torque converter lock up I am experiencing?
This also usually happens when I give it light throttle and not when I am heavily accelerating.
View 4 Replies
My 1995 corolla door would not close. I looked and discovered that the 3 screws holding the door lock mechanism in place were gone. I went to the hardware and bought 3 new screws and installed them. The door shut and now it will not open at all. It was opening intermittently, so I bought shorter screws and put them in and now it will not open at all. The screws are flush with the door. The door is not stuck, you can feel that it is locked, so forcing it will not work. Climbing in and out over the passenger seat is quickly losing it's appeal. Monday I am taking the door apart from the inside.
View 6 Replies
I have a '98 5-Speed Corolla. If I rev the engine when the car is in neutral and warming up I hear an odd grinding noise when I let off the gas and the engine goes down to idle. The noise does not occur if I put my clutch in. Is this something to worry about?
Also, I'm wondering what CV joints sound like when they're failing.
View 1 Replies
