Toyota - Corolla :: 2000 - While Slightly Press Gas Pedal Engine RPMs Jumps
Dec 7, 2013
Car is a 2000 Corolla CE.
When going at the desired speed (say 40mph) and there is lots of coasting room, I just let go off the accelerator and the car basically coasts. The engine RPM drops from 1600-1800 down to 900-1000 and it actually can coast a long way. Sometimes, I need to go faster (if I'm initially started at a slower speed) and when I press the gas pedal slightly, the tachometer shows the engine rpm jumps from the coasting 900-1000 to 1600-1800.
Is the tachometer (add on by ScanGuage) reporting it correctly? Is this a bad form of acceleration for the engine?
View 8 Replies
Advertisement
I have a Toyota Corolla 2010 LE. When I'm driving, no matter how fast I drive, I feel a vibration sound. When I press brake pedal, it's worse than driving. I recently replaced front rotors and brake pads. I also replaced whole tires a month ago.
View 9 Replies
I have a 2012 Toyota Corolla LE (automatic transmission) with 90000 miles on it.
For a long time now I have dealt with a whining sound in my 2012 Toyota corolla. The symptoms are that the sound only happens when the accelerator pedal is slightly engaged. This happens at any speed. At the slightest push of the pedal a whining/spinning sound happens and if you maintain pedal engagement the sound of whining/spinning continues. The sound goes away instantly when the pedal is depressed and will again come back when engaged subsequent times.
I have been researching on the internet and I seem to be pointed in the direction of the transmission fluid to change from the Toyota Genuine ATF WS currently being used in the 2012 Toyota Corolla as the stock transmission fluid to Redline D4 as others have experienced a similar noise problem in 2010 corolla models and have made the noise go away by using the Redline D4 because of viscosity differences. I am not sure however if the same transmission model (U341E) is being used in all Corolla models.
View 6 Replies
92 PA Base, 141,000 mls
Whenever I have to drive for more than 50 - 75 miles or for one hour at a constant speed, the engine causes the car to buck and loose acceleration. When I press the gas pedal down to the floor, the rpm's stay at zero or when I lightly press the gas pedal, it would accelerate but with noticeable hesitation and difficulty. I go from maintaining speeds of 70 miles down to 40 miles. It also feels like no fuel is getting to the engine. This causes me to pull over for a few minutes, shut the engine off, and then its okay to drive for a few more miles.
I replaced the fuel filter and the MAF sensor. When I changed the MAF, I noticed that the bottom portion of the old one where the little wires are, was broken. I really thought that was the issue but when I replaced it, it started doing the same thing. What should I check or replace next?
View 12 Replies
I have a 2000 Corolla CE with 48k miles that I bought 2 months ago. I took it in for an alignment and balance because it was pulling to one side and the steering shakes slightly at 70mph.
The before measurements was this:Left Front:Camber: 0.0Caster: 1.2Toe: 0.17
Right Front:Camber: -0.7Caster: 1.6Toe: 0.28
Front Total Toe: 0.45Steer Ahead: -0.06
Rear Left:Camber: -1.0Toe: 0.50
Rear Right:Camber -0.7Toe:-0.04
Rear Tota
View 13 Replies
I have a 1999 Grand Am 3.4L engine that has 227,000 miles on it. For quite a while now I've needed to press the gas pedal slightly in order for the car to start. Once it's started it idles fine. The car isn't throwing any codes and I've replaced quite a few things (not necessarily due to this...). Here's a list of what's new:
1) Camshaft Position Sensor
2) Plugs & Plug Wires
3) Mass Air Flow Sensor
4) PCV Hose
5) Fuel Filter
I've read about the Idle Air Control sensor, but I figured if there was something wrong with this it would throw a code and I'd have a dummy light on the dash (which there are none). What are some things I can look for to try to troubleshoot this issue?
View 6 Replies
I have a 2001 toyota corolla with a manual transmission that I just bought that has about 130,000 miles on it. It runs very well except for it runs out of oil about every 150 to 200 miles. The car does not seem to be leaking oil, however revving the engine in the slightest causes the car to smoke from the exhaust pipe. We tried changing the oil as well as putting in high mileage oil and sea foam motor treatment. This worked slightly but not much.
View 9 Replies
I have a 2005 Hyndai Accent GT automatic (83,000 km) and I am having a problem with the gear shifting. It's happening more and more.
As I am driving I am pretty sure that it's changing to a higher gear but when I slow down it seems like its not shifting down at all. Coming off the Highway I have to slow down and when I speed back up it seems like its still in the high gear. The RPM's instantly jumps up.
The only way it fixes it self is when I pull over and shut off the car and then start it up again and I am fine. A friend at work said that I may have to have my transmission fluid checked and filled up.
View 7 Replies
Toyota Corolla 93, manual transmission so there was a problem with idling, while it idles, the engine revs up but im not pressing the gas pedal at all. found out it the vacuum hose was broken. we fix it, buy a new one and now the engine dies out. change the air filter. The car still dies out. so the car either dies out or bad idling. what do i do?
View 5 Replies
I have a 2002 avalon XLS. In the morning the car cranks but wont start unless I press the gas pedal. After that everything was fine. But recently the problem is getting worse. The car became harder to start although it will start eventually. I have changed the Mass air flow sensor, but did not solve the problem.
View 10 Replies
When I press slightly on the accelerator just to get the truck moving and than let off the engine stays at the higher RPM typically just over a 1000. This only happens in drive not reverse and everytime I just slightly step on the accelerator. The truck only has 1K miles on it.
View 14 Replies
About two days ago we were driving home and our van started to make a noise when we press on the gas pedal. it sounds like a machine gun under the hood. what can it be?
View 14 Replies
I recently got the EGR system in my 1998 Rav4 working (replaced VSV) after driving with it non-functioning for several years. Without the system functioning, the engine ran great, but fuel efficiency suffered. Now, when the engine is warm only, the engine knocks and lugs between 1000 and 2000RPMs. This usually occurs right when I shift into 2nd gear. There are no engine trouble codes.
View 8 Replies
I'm having Hyundai Accent GLS Model 2005. Since yesterday, My tail lamp and Third Brake light is still switched on even I turn off the light & I notice that my Auto door lock is not functioning even I press the Brake Pedal. I tried to disconnect the battery & the Fuse and place it back but it doesn't works. Currently, I just pull out the fuse.
View 6 Replies
I have a 2000 Toyota Corolla LE that ran very well until about a month ago. It has about 146,000 miles on it. A month ago it started hesitating from a standstill and the engine ran extremely roughly when trying to move the car. But when I put it in low gear it did much better, although not great! When in Drive it barely moved the car at all and would frequently stop running completely.
When I took it to an auto parts store they hooked it up to their computer and it read out that I needed either spark pugs, spark plug wires, or a new coil. I have replaced the plugs, but that made little difference. I then took it to another auto repair place that told me that it was either a problems with valves, or a 'problems in the lower engine'. I don't know what that latter problems means but either way it sounds like it will be very expensive to fix.
View 1 Replies
When I took my new used car to the mechanic, complaining how there must be an oil leak cause well by now 9 bottles of oil in 7 weeks time have been put in, the mechanic told me the engine is burning the oil too fast. He said something about the piston, but I got all confused. He also said that the only way to fix this is to replace the engine, but he recommended not to cause it would cost more than the car is worth. This is a 2000 Toyota Corolla. Why this is happening and what i should do about it.
View 8 Replies
My 2001 Hyundai accent hatchback with around 135000 miles is having problems with the gas pedal. I start my car and can't really push down the gas pedal smoothly. It is initially hard where I have to slightly kick the pedal to move it. Otherwise if I rest my foot on the pedal and try to press it down I end up press it down too much where my car goes flying. Every time I come to a stop I have to do that to get the pedal to move. Its not stiff once I get the pedal to push down some but once I take my foot off the pedal I have to slightly kick it back down.
View 4 Replies
I had to really hard brake today over a very very short distance...the tires locked and the car slid for about 5 feet. Car is 2000 corolla, 4-spd auto.
As soon as I came to a full stop, I notice the engine was still "spinning" like it was in second gear...because the RPM was around 1000rpm (idle is 650). As soon as I started moving, there was a slight clunk noise (sounded like it came from CV half axle/transmission).
Although rare, This also happened a couple of times before when hard braking. It downshifts to 2.. idles around 1000rpm for a couple of seconds... and then there is a "slight" clunk noise.
Other than this, the transmission/engine has been very smooth and the car has no problems.
View 6 Replies
While driving, I noticed that when I floor the gas pedal to go faster, the engine revs up and takes about a second or 2 until the car accelerates. i also noticed that if i let go of the gas pedal while the engine revs then the car doesn't go any faster, it just revs then goes back to normal. Whats going on?
View 3 Replies
My Toyota Corolla 2000, 123,000 miles, Mass license plate, still getting 34 miles per gallon, has had check engine light on and off for a year.Failed inspection this June.
First garage in Somerville, without doing more than getting the three readings above, said catalytic converter was needed $350 plus labor.I was unable to do the work then and returned to NYC and job. Took to another mechanic recently to get fixed (as I wasn't returning to Mass for a while)and got only PO 171. I mentioned the other readings; they kind of scoffed it off.Trying to save me money (I guess), they cleaned the MAF filter and fuel ejectors for $200. Looked like it was fixed. A week later check engine light came on again and when I brought in found the PO 420 reading. They did not tell me if other computer read-outs were coming up as well.
Now they want to leave the oxygen sensor in front but change the one behind. Put in a newcatalytic converter $539 {they had quoted me $238 but it wasn't an OEM one I guess and they said they wouldn't warranty anything but this expensive one), charge me$137 for the oxygen sensor190 laborplus taxfor a total of a whooping $946!
I am afraid they will do this very expensive job and the check engine light will come on and htey will say o its something else.how can i be sure? also I was reading for a catalytic converter to go bad, something has caused it...what would that be? how to find out. Do they need to do the diagnosis with gas analyzer etc?
Why I spend a huge amount for an old car that is running well, not losing gas mileage, but perhaps is a bit slower on power.
View 9 Replies
My 2000 Toyota Corolla is making a knocking sound that gets worse when the car is in idle and in drive. I have a feeling that it is dying, but is it unsafe?
View 8 Replies
