The door in the dash wont go to defrost. It just quit today. I assume its vacuum controlled. What do i need to do to fix it? I thought about pulling the dash vent where i can reach in there n have a look but it doesnt want to come out. 1992 Toyota Camry....
View 7 Repliesmy heat has suddenly quit woking getting hot. It has plenty of water, my heater hoses are not gettting hot.
View 14 RepliesTroubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 RepliesI have a 1997 Mazda b4000 new plugs wires head gasket an I cleaned out the radiator. My question is the truck runs good but my heat quit workin what could it be all fuse look good. Also there is water coming out of my tailpipe with white smoke. Should I be concerned.
View 2 RepliesHave 2009 F350 SD Lariat SRW and looking for a way to troubleshoot the driver seat heater unit. The panel light comes ON when depressed but the heat quit working the other day. It was working fine and the passenger seat works great?
View 5 RepliesMy AC is not working on any setting but defrost. Warm air blows out on the reg AC settings, but if I turn it to defrost, chilly air comes out.
View 2 RepliesWe had a replacement rear windshield on 2009 camry , and now rear defrost does not work. Where would I look for a loose wire connection?
View 5 RepliesI have a 04 Silverado crew cab with automatic AC. After many dead battery problems, the AC blend doors quit working correctly. If I pull the fuse and then let them reprogram, it may take several tries but I can eventually get them to work correctly. The problem then is that it only lasts for a couple of days. How to program these correctly?
View 2 RepliesMy navigation door quit working, tilt function also, and it's stuck open. The Nav unit works fine. Dealer is telling me thousands to replace it - but I suspect it's like the Mercedes dealer where my SL was missing a $10 clip - and they wanted to replace the dashboard... I'm hoping it can be repaired. It makes a little "ping" sound then I turn the car off, but I don't hear the door motor.
View 14 RepliesI have a 2002 excursion xlt 4x4 v10
The door locks quit working. The previous owner did the tin foil repair... I replaced the four door actuators today. Now all of the doors lock and unlock on the manual buttons. The fob doesn't work on any door.. when i try and use the door code pad, the locks go into a cycle.. the keep trying to operate by themselves. I had to disconnect the battery to get it to stop. I can't find the door lock relays. I have most of the dash out. Where these are?
My drivers door lock quit working.all the others still respond to the drivers door switch.the motor works when on the bench.one of the wires has broken or lost connection. Where to check first?
View 4 RepliesMy Wife has a 1984 and I have a 1985 Toyota Pickup, 2wd, 22R engine, same dash and almost same everything. There are 4 settings on the selector switch (horizontal lever switch moving from left-to-right) for the blower fan: "Off", "Low", "Med" & "High". In both trucks, the "Low" setting for the BLOWER FANS quit working, but the other settings still work fine and amount heat-output is fine(so this is a FAN problem and not a "heating" problem).
Is the problem in the switch itself?, or in the blower fan resistor?, or in the blower fan motor? From what I've read elsewhere, it seems to be a blower fan Resister problem that is most likely. If that is the case, where exactly should I be looking for it and will I need to remove the dashboard? And what does it look like? I've seen a small black object about 1"x 1.75"x 1.75" and it has an Amperage listing on it and it's next to a Relay that seems to be related to the heater. I'm guessing that thing is not the resister if it's labeled "Amperage", I would think it should have an "Ohms" symbol or word or rating on it if it were the resistor, or is that really "it".
I went to go fuel up my '04 Toyota and when I turned the car back on, the radio and lighter (and the heat at first - it's working now...) were dead. What this could mean?
View 2 RepliesI've owned my 92 Camry since Septembe of last year. It is in wonderful condition (or, so I thought), but has been one headache after the next the last few weeks.
Most recently, the AC has apparently died. I went to turn it on as a test-run after the winter and discovered that the air was not cooling down. If my memory serves me correctly, I did not notice any lessening in the AC the last time I used it;it seems to have just quit.
I own a 2010 Camry LE 4 cyl.
The A/C quit working and I took it into the shop. They said the compressor was bad and wanted $1800 to replace it. At the time I didn't have the money and told them I would have to wait on it. Low and behold about two weeks later the A/C started working again and worked fine for the last two months. Now it's out again.
What you think might be the problem other than the compressor?
My passenger side power sliding door on my 2003 Olds Silhouette (147,000 miles) Occasionally will quit working. We can open it and close it manually and sometimes it will start working again, other times it won't work for several days and then all of a sudden it works again.
View 1 RepliesThe blue illuminated sills were already installed when I purchased the car...I just recently noticed that both sides don't light up anymore. I'm not sure when exactly they quit working, but i recently had my battery replaced. I checked every fuse in my car and can't find one that is blown. Is this a fuse problem? or did both sills just decide to crap out together? I checked both connections and they're solid.
View 14 Replies1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
My 2003 Ford Explorer Power Door Unlock on the drivers side quit working. I can unlock the doors using the fob, unlock them from the passenger side or unlock it manually. I have replaced the Power Door Lock switch but still have the same problem.
View 2 RepliesI just purchased a 2004 toyota camry limited edition about a month ago. During the last week off and on while the air conditioning is on it will quit cooling and the a/c light will flash on and off until I turn it off. Sometimes I can turn it back on and it will stay on, sometimes it will do it again. Sometimes I can get in the car, turn it on, and it just stays on and doesn't flash at all even on long trips. Anytime the a/c is on, the air is perfectly cold. It's only when the light is flashing that it quits cooling. Today is the first day that it did it multiple times on the way home from work.
By the time I got to my drive way though it wasn't going off and flashing but was once again staying on and cooling perfectly. Since I just purchased the car and have car payments on it, I am not rolling in dough. I have read a few posts that it's possibly the compressor but since mine blows so cold when it's on I do not think that is my problem...then again I could be wrong.
Last summer the CD drive quit: it's impossible to insert a disk in, although drive was empty. I took it to the dealership and they fixed it allegedly by doing some "reset". Now the issue comes back again. Should I demand replacement of the whole radio? I don't like them just keep resetting it.
View 5 Replies