Toyota - Camry :: 2007 - Check Engine Light Is On Along With VSC And A Skid Control Lights
Sep 10, 2014
I recently bought a 2007 toyota Camry le v6 with less than 38,000 miles it currently has 39,300 miles and my check engine light is on along with the VSC and a skid control light (car with squiggle lines behind it) we have a had lots of rain here where I live and I had to drive through a couple deep water puddles. I looked up online and it said The engine light may turn on if the VSC and skid control lights are on. Could this be that the sensors maybe got wet? I don't think anything should be wrong with this car considering it's a toyota with less than 40k miles
View 14 Replies
Advertisement
Today my check engine light came on and the code is P0712. When I drove off from the parts store, the check engine light suddenly went off. What should I do at this point? What are the most likely problems/solutions.
View 1 Replies
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 Replies
The vehicle: 2007 Tundra, 5.7, 4WD, SR5, 71K miles
The issue: The Check Engine, VSC and 4LO indicators came on abruptly within 5 minutes of the first start-up of the day and after driving ~ 1/2 mile on paved road. Weather conditions: high humidity and unseasonable high ambient temperature.
What has been done: Immediately returned home. My local "guy" stopped by with his code checker. Codes that came up: C10201 and P2440 (Wheel sensor and secondary air pump, I am unsure which is which). Codes were cleared, indicators went off. Within 0.2 mile of driving "around the block" the same indicators and codes came on. My local guy recommended a trip to the dealer for repair as he would have to get sensors/parts from Toyota and be replacing sensors until the problem was repaired (I respect him for that).
The question: what is the guesstimated cost for dealer repair? The truck can be operated in a "failure" mode and can get to the local dealer under it's own (reduced) power.
View 6 Replies
Smokes comes out of hood, check engine light is on, ABS light is on, the rpm needle jumps When I stop it jumps to #2, when it does that also the car shakes like vibrating.....
View 7 Replies
I have a 2010 camry and I am coming up on 15000 miles so i know im going to be due for another maintenance. accordingly, the "maintenance required" flasher started going off, so i thought it was all good and i should just take it to the dealership soon. well this morning when i started it up, it started flashing the "maintenance req" but once i backed out and put it in drive, the check engine light popped up as well as the traction control light (car with squiggly tire marks behind it).
View 4 Replies
I have recently had a problem with my 2004 Prius - the brake lights came on while I was driving (both the red exclamation mark and the orange exclamation mark to the left of the speedometer) ...
The Toyota service center told me that I need to replace the skid Control ecu - the part number that they quoted is 89540 47050.
View 1 Replies
Engine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 Replies
2007 GS350... Yesterday i ended up changing my oil and did not noticed the oil seal for the oil filter shifted . So it dumped out about 3 qts of oil when I started the car. Oil everywhere. I ended up cleaning everything and did the oil change again. Now I am having an check vsc light, also the anti skid and abs light is on. No check engine light. What can it be??? Can i just run a generic scanner ?
View 1 Replies
I have an 07 Impala. Just recently, the engine light came on. I contacted OnStar who did a vehicle diagnostic and told me the problem was the emission control and further told me I should tighten my gas cap which might take care of the problem. It didn't. How important is it to take care of this?
View 3 Replies
I own a 2002 Solara V6 with over 300,000mi. The check engine light is on and affecting the tracking control. The dealer cannot find the cause without replacing many parts costing lots of money.
View 2 Replies
I have a 2000 Toyota Camry that has a unique problem. The Check Engine light NEVER comes on even when first starting the car. I have access to a scanner and know that the car periodically throws a catalyst code but the light never comes on. I just assumed that the bulb was burned out.
Today while solving a non-working clock issue I had to take the instrument cluster to get to the clock. While I had it out I decided to check the Check Engine Light bulb. It looked fine so I took I replaced it with a bulb that I knew worked fine. Again, nothing. The bulb doesn't light at all. About 4 weeks ago my timing belt broke while driving (non-interference motor) and it threw a code for the camshaft position sensor but again the light never came on.
Why the light never comes on?
View 19 Replies
So mad today. Check engine light came on, plugged in my scanner, got P0441 EVAP Emission Control system Purge Flow Fault and P0455 EVAP Emission Control System Leak (Large).
8-month old '13 TCH XLE is getting a check engine light already.
View 7 Replies
Car: Toyota Camry 2002 .. Mileage: 150K
Symptom:Check Engine light went on a few days ago.
Checked codes and got these (3):
1) P0420
2) P1310 and
3) P0420 P ("Pending" ?)
I also checked I/M Readiness and got these suspicious-looking values:CAT: NOT RDYEVAP: NOT RDYO2S: NOT RDYH02S: NOT RDY
NOTE all the other I/M values were N/A
Researching the Codes, it sounded like Ignition, and possibly the O2 sensor on the Catalytic Convertor. I had just had some engine work done by the dealer -- actually, replaced spark plugs -- so I figured to go back and bitch him out for screwing up my car.
A few days later, before I could engage my Rage, I went back and re-scanned. First I noticed the CEL was now OFF. Scanning, I now I get "NO CODES", and all the I/M values are now N/A; No more "NOT RDY".
What do you all make of this? Should I be concerned now that the CEL is Off, and I get No Codes with a scan?Or maybe I should take it to AutoZone for their free CEL diagnosis -- would their machine be more thorough than mine (Autel MaxioScan 300)??
View 4 Replies
I had my 2000 Toyota Camry with 133,921 miles on it seen because of the check engine light.The codes obtained at the repair shop were:
P0136: Oxygen Sensor CKT Malfunction Bank 1 Sensor 2
P0446: Evap Control system Vent CKT Malfunction
They then ran a smoke test and found that the charcoal canister was leaking and needed replacement. The mechanic said that not doing the above would not affect the car's performance or its safety but it would not pass inspection with the check engine light on and with those codes.
View 5 Replies
2001 Camry 4 cylinder. Check engine light came on yesterday. Advance Auto pulled out the code P0446 for the evap. emissions system vent circuit.
The car has no symptoms other than this and is current on all maintenance, but obviously it is a 10-year old car and so it goes.
View 9 Replies
My check engine light kicked on about 6 months ago. The code was for the catalytic converter, which I did not replace because it is less than 2yrs old. It would go on and off intermittently, and for the last week it has remained off. All the other dash lights work fine, and I know it's not the fuse...
'97 Toyota Camry, 231,000 miles.
View 10 Replies
So I have a 2012 Toyota Camry SE V6. Back in december I got into a front end accident, had the front repaired, (they did remove the coolant container and refilled it etch) Got my car back on December 22, coolant was full. A few days ago, checked again and i noticed the white coolant container was empty (there were some pink at a corner, i guess because the hose doesn't reach that low), i checked the metal cap, it was not "completely" empty just had a very very low layer of pink coolant. (i would say just some coolant at the surface)
I do recall a sweet burning smell maybe a month or 2 ago, but my engine light did not ever come on. When i refilled it, (my dad recommended to refill just half) I did that, a day later, i checked the levels again, it was empty again. so i refilled it to half again. i drove this morning for about 10 mins, its still at the same level (maybe i didn't drive it long enough?)
I'm freaking out whether i have been driving the car without coolant for that long, and whether there were any engine damage done (even though the engine light didn't come on) I have driven the car alittle over 5k since i got the car back.
View 8 Replies
My check engine light came on about 4 days ago on my 2014 toyota camry. Found the gas cap was loose that same day it came on and tightened but light is still on and Eco mode not coming on. Is it possible the problem is something else or does it take longer for the light to turn off.
View 12 Replies
I have a 2000 Toyota Camry with about 136,000 miles on it. Recently because it was making a loud noise and because the check engine light was on we got the exhaust system changed at Coles and this made the car silent as before.The mechanic there checked the check engine light code and reset it and he said it was an Evap code.He checked the fuel cap and found it to be OK. He said that if it comes back again I have to get it checked by some one who has a smoke machine to detect the leak and this could cost me about $100/- to set it right.The check engine light has come back again.
View 4 Replies
I had my local garage do their electronic check when my check engine light came on. They said the code they got indicated a failed catalytic converter and quoted me $720.00 for a California compliant replacement, including labor. I live in Connecticut. I'd like to take a few days to get a second opinion and second quote, but the garage manager said that driving it in this condition would risk fouling the oxygen sensor, which I recently replaced for a couple hundred bucks.
Should I be concerned about fouling the oxygen sensor by continuing to drive the car? 2000 Toyota Camry...
I looked under the car and the rear attachment bolts to the converter are rusted beyond recognition. I'm tempted to try replacing it myself but it may be a bit beyond my skills.
View 7 Replies
