Toyota - Camry :: 2002 V6 - Stall / Check Engine Light Comes On Just Before Car Completely Stops
Aug 26, 2014
My 2002 Toyota Camry XLE V6 (115k miles) stalls once every 4 months (happened thrice in the last year) or so when I'm braking & bringing the care to a complete stop.
The check-engine light comes on just before the car completely stops. The steering wheel feels locked. Putting it back in parking, turning off & turning it back on doesn't work. The car doesn't start. After 10-15 minutes, If I put the key in, turn it on & try to turn the steering wheel while turning it on, it turns back up & runs without any issues for the next few months.
I've taken the car to 3 different mechanics (including a Toyota dealership mechanic) & they tell me that the car is in great condition (I've done a lot of preventive maintenance on the car). They can't find any error codes & they checked everything but can't find any issues
View 19 Replies
Advertisement
Car: Toyota Camry 2002 .. Mileage: 150K
Symptom:Check Engine light went on a few days ago.
Checked codes and got these (3):
1) P0420
2) P1310 and
3) P0420 P ("Pending" ?)
I also checked I/M Readiness and got these suspicious-looking values:CAT: NOT RDYEVAP: NOT RDYO2S: NOT RDYH02S: NOT RDY
NOTE all the other I/M values were N/A
Researching the Codes, it sounded like Ignition, and possibly the O2 sensor on the Catalytic Convertor. I had just had some engine work done by the dealer -- actually, replaced spark plugs -- so I figured to go back and bitch him out for screwing up my car.
A few days later, before I could engage my Rage, I went back and re-scanned. First I noticed the CEL was now OFF. Scanning, I now I get "NO CODES", and all the I/M values are now N/A; No more "NOT RDY".
What do you all make of this? Should I be concerned now that the CEL is Off, and I get No Codes with a scan?Or maybe I should take it to AutoZone for their free CEL diagnosis -- would their machine be more thorough than mine (Autel MaxioScan 300)??
View 4 Replies
I have 2002 camry 4 cylinders and has 175,000 miles. I was driving on the freeway and suddenly I felt a jerky motion and check engine light came on. When I stopped at light the car began to vibrate and when started driving at low speeds it got me home. Admittedly I had put lot of hard miles on the car in past 6 months and I was lazy in getting oil changed in time. It might have been 7000 miles since oil chg. I took the car to local oil change place they did not mention anything about engine but they said my transmission oil was dark and burnt. They said I should flush and replace. I agreed and tech said he had to do second flush as oil was still dark. After second flush, he said its little bit better.
I was hoping this would solve my problem but unfortunately no. Car was still vibrating and when i drove at slow speed it was driving but as soon as I tried to accelerate the car lost power. Check engine light has been on since the incident at freeway, but now check oil light and battery sign came on. The power steering lost power. I had to park the car and restarted, as long as I drove very slowly it would drive but if I tried to accelerate where the rpm went from 1 or to next level car would loose power with warning lights on. I had recently replaced fuel pump, filter and any repair which was suggested to me. Admittedly I have not done timing chain or belt.
View 9 Replies
I have a 2002 Toyota Corolla CE with about 115,000 miles.While I was traveling on the highway my car started shaking, losing power, and the check engine light started flashing. I drove a mile or two to a rest area because I didn't want to pull over on the highway. I had it towed home. It starts and idles, but I'm afraid to get it out on the road.
View 15 Replies
Had the oil changed today; before doing so, I saw that the check engine light had come on. Have been told by 3 professional car maintenance people that there is no connection between needing oil / oil change and check engine, that it would have been the check maintenance light.
Will take it in for diagnostic test by dealer. Also, was told by the oil change guy that he heard pinging which could mean that the car needs to have the valves adjusted, and that the check engine light is due to needing something or other with the gas tank filter which could have a leak/crack, etc.
View 9 Replies
I have a 2000 Toyota Camry that has a unique problem. The Check Engine light NEVER comes on even when first starting the car. I have access to a scanner and know that the car periodically throws a catalyst code but the light never comes on. I just assumed that the bulb was burned out.
Today while solving a non-working clock issue I had to take the instrument cluster to get to the clock. While I had it out I decided to check the Check Engine Light bulb. It looked fine so I took I replaced it with a bulb that I knew worked fine. Again, nothing. The bulb doesn't light at all. About 4 weeks ago my timing belt broke while driving (non-interference motor) and it threw a code for the camshaft position sensor but again the light never came on.
Why the light never comes on?
View 19 Replies
I had my 2000 Toyota Camry with 133,921 miles on it seen because of the check engine light.The codes obtained at the repair shop were:
P0136: Oxygen Sensor CKT Malfunction Bank 1 Sensor 2
P0446: Evap Control system Vent CKT Malfunction
They then ran a smoke test and found that the charcoal canister was leaking and needed replacement. The mechanic said that not doing the above would not affect the car's performance or its safety but it would not pass inspection with the check engine light on and with those codes.
View 5 Replies
2001 Camry 4 cylinder. Check engine light came on yesterday. Advance Auto pulled out the code P0446 for the evap. emissions system vent circuit.
The car has no symptoms other than this and is current on all maintenance, but obviously it is a 10-year old car and so it goes.
View 9 Replies
My check engine light kicked on about 6 months ago. The code was for the catalytic converter, which I did not replace because it is less than 2yrs old. It would go on and off intermittently, and for the last week it has remained off. All the other dash lights work fine, and I know it's not the fuse...
'97 Toyota Camry, 231,000 miles.
View 10 Replies
I have a 2002 4 cylinder Camry, and I've been having trouble with the EVAP test completing. I've been running the EVAP test to the letter, with no success, so I figure the problem might be dependent on something else not completing.
I used to get the occasional check engine light for loose gas cap. So a few days ago I intentionally left the gas cap VERY loose (it's essentially just sitting in the filler nozzle). But I'm not getting the check engine light. I think that the gas tank pressure test may not be running, and that may be why I can't get the EVAP test to complete successfully.
Conditions: The gas level is about 1/2 full, and the ambient temperature has been around 20-35 degrees F.
I'm having a hard time searching. Most search results deal with how to resolve the loose gas cap problem. The check engine light is not burned out... it comes on briefly when I start the car!
View 5 Replies
We have a 1992 Toyota Camry which runs great except that it stalls at every stop light. We have had the engine, distributor, coil, coolant temperature sensor; computer, and EGR valve checked. Yesterday the mechanic stated there was nothing wrong with the EGR Valve, what to check next?
View 2 Replies
So I have a 2012 Toyota Camry SE V6. Back in december I got into a front end accident, had the front repaired, (they did remove the coolant container and refilled it etch) Got my car back on December 22, coolant was full. A few days ago, checked again and i noticed the white coolant container was empty (there were some pink at a corner, i guess because the hose doesn't reach that low), i checked the metal cap, it was not "completely" empty just had a very very low layer of pink coolant. (i would say just some coolant at the surface)
I do recall a sweet burning smell maybe a month or 2 ago, but my engine light did not ever come on. When i refilled it, (my dad recommended to refill just half) I did that, a day later, i checked the levels again, it was empty again. so i refilled it to half again. i drove this morning for about 10 mins, its still at the same level (maybe i didn't drive it long enough?)
I'm freaking out whether i have been driving the car without coolant for that long, and whether there were any engine damage done (even though the engine light didn't come on) I have driven the car alittle over 5k since i got the car back.
View 8 Replies
My check engine light came on about 4 days ago on my 2014 toyota camry. Found the gas cap was loose that same day it came on and tightened but light is still on and Eco mode not coming on. Is it possible the problem is something else or does it take longer for the light to turn off.
View 12 Replies
I have a 2000 Toyota Camry with about 136,000 miles on it. Recently because it was making a loud noise and because the check engine light was on we got the exhaust system changed at Coles and this made the car silent as before.The mechanic there checked the check engine light code and reset it and he said it was an Evap code.He checked the fuel cap and found it to be OK. He said that if it comes back again I have to get it checked by some one who has a smoke machine to detect the leak and this could cost me about $100/- to set it right.The check engine light has come back again.
View 4 Replies
I had my local garage do their electronic check when my check engine light came on. They said the code they got indicated a failed catalytic converter and quoted me $720.00 for a California compliant replacement, including labor. I live in Connecticut. I'd like to take a few days to get a second opinion and second quote, but the garage manager said that driving it in this condition would risk fouling the oxygen sensor, which I recently replaced for a couple hundred bucks.
Should I be concerned about fouling the oxygen sensor by continuing to drive the car? 2000 Toyota Camry...
I looked under the car and the rear attachment bolts to the converter are rusted beyond recognition. I'm tempted to try replacing it myself but it may be a bit beyond my skills.
View 7 Replies
Check engine light was on for some time when I had filler neck and cap replaced. Computer sensors did not re-set until 501 mile mark, when light came on again. Checking the web, I find that some who appear to have knowledge of problem say it could be hoses, sensors, valves, or evap canister--the charcoal canister.
Mechanic who did original smoke test and recommended replacement of filler tube wants to replace evap canister without checking anything else. What should I do? At wits end, and car needed to pass inspection 2 days ago. Car has 157,000 miles or so...
View 9 Replies
Today my check engine light came on and the code is P0712. When I drove off from the parts store, the check engine light suddenly went off. What should I do at this point? What are the most likely problems/solutions.
View 1 Replies
I own a 2000 Toyota Camry that was given to me by my father. The check engine light illuminated last year so I brought the car in to my mechanic. He said it was the o2 sensor and changed it. That lasted about a month , and the light went on again. This time it had to do with some valves that get stuck open (or closed) but also had to do with the amount of oxygen that goes into the carburetor . I asked my Dad if he had this problem, and he told me that the engine light was illuminated often, that he had brought the car in about 6 times, but nothing was found. Previously I owned a 1998 Camry, and had the same problem; the check engine light illuminates, the diagnosis is the oxygen sensor, that gets changed, the light goes on again, this valve thing gets changed but the light goes on again in a month. I can't get the car inspected with the engine light illuminated. The light always goes back on but nothing else is found wrong with the vehicle. I really know nothing about cars.
View 4 Replies
It just so happens that I got my letter from the DMV telling me I needed to get my new tags, and this is an emissions test year for my car. I was buys the last few weeks so I figured this would be a good week to do it. Yesterday.......check engine light comes on. How does that happen???
So now I'm on a time crunch. I went to Advanced Auto this morning and they checked the code. It's P0440, an Evaporative Emissions code. Any thought on what that me be, or any checklist as to what to check first? I'm fairly handy, but know nothing about cars. I'm sure I can figure it out with some instructions.
Summary: Got a check engine code of P0440, Evaporative Emissions. On a time crunch because I need to get an emissions test done. I can probably fix it myself with some direction.
View 2 Replies
The check engine light on my 2006 Toyota Camry LE with 95,300 miles came up. The codes that came up on my diagnostic tool were p0011, p0101, and p0113. The code meanings are as follows:
p0011: refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car's power control module
p0101: problem with the Mass Air Flow (MAF) sensor or circuit
p0113: possibly issues with the Intake Air Temperature Sensor
How to solve the issue and get that annoying check engine light off?
View 2 Replies
I have a 2006 Toyota Solara V-6. I was driving down the street with no indication of what was about to happen. All of the sudden my check engine light came on and the car lost all power. I had the car towed home and had a mechanic look at it he put his scanner on it and I'm not sure what codes if any came up but he decided it was the ECM so he found a used one with a warranty and ordered it, he put it in and it did the same thing it turns over but wont start. What could it be ?
View 13 Replies
