Toyota - Camry :: 1995 - Making Clunking Noise
Feb 7, 2015
I have a 1995 Toyota Camry. I let my niece use it while on xmas break when I went to go pick it up it made a clunking screeching sound as i tried to back it out of the parking lot. I found it difficult to turn the wheel as well. I had to get it home so I drove from Orlando to St Augustine. Weird thing is that once on the highway going 70mph i didn't hear the sound anymore. I thought it was ok. I stopped in Daytona for gas and as i pulled away that sound began again. This lasted until i got to accelerated to about 50mph this time. I heard it again going through my neighborhood which is 25mph. It was very difficult to turn the wheel. My husband checked the power steering fluid which it was empty.
View 6 Replies
Advertisement
When I drive over bumps or dips my car makes this clunking noise in the front passenger side. I just had the front brake assembly replaced as well as the engine mounts but the noise is still occurring. what could this be and would it affect my new brakes in any way?
View 6 Replies
The '04 Camry with 72K miles is making a little of the clunking noise when the steering is hard-over to the right (have not tested left yet). My education on this site says it's the CV joint. So, how urgent is it to get this fixed? The car is getting used probably less than 8K miles/year.
View 4 Replies
Our 1995 Toyota Camry shakes and makes a loud rattling noise while driving, but not every time I drive the car. The rear seat of the vehicle, especially feels the shake. The rear tires have been replaced and aligned, but still the shake/noise persists. Our mechanic has not been able to recreate the noise. It has occurred in the winter and summer with or without the heater and/or air conditioning on or off. Sometimes the shaking is so severe, I am afraid of what will happen, but I will stop at the next light, sit for a minute or two, and when the light turns green, the car goes, no shaking involved - everything is fine. I typically drive in town so speed is only 45 mph or less. The car has only 137,000 miles, and is well-maintained.
View 2 Replies
05 Camry, 2.4L, 47K. Replaced the front brake pads two months ago. I put in Akebono pads and did nothing with the rotors as the original pads were not completely worn out and there is no vibration whatsoever in the pedal.
The pads have recently started making noise on brake application. I'm getting ready to take them back apart and re-lube everything. Should I take some sandpaper to the pads & rotors to knock off any glazing? Do I hit it with a course or fine grit? I have not had this problem happen in the past and was thinking that maybe it is the quality of the pads but I believe these are oem...
View 1 Replies
Our 2010 Toyota Camry makes a squealing noise as we back out of our garage.Does this mean we new rear brakes?
View 15 Replies
My car is making almost like a clunking sound when starting. It doesn't do it all the time, mostly it is when its a cold start but its happening more frequent. I have the push button start, would warranty cover this?
View 2 Replies
My wife's 2000 Passat 2.8 V6 has been making a clunking noise when you hit the gas for quite a while. I finally got the time to look under the hood and noticed that the engine (when the car is in drive) is rearing back and making a loud clunk noise. I thought at first it was a motor mount but this picture is what I found. It is a mount that comes off a spindle that is directly in the center of the engine and right under the radiator... I have been told it is a "snub mount", "front engine mount", "torque rod mount", etc.
The problem is, when I call around to the local parts places no one has a clue what I am asking for. So what I need is for someone to ID the mount and then point me in the right direction on were to purchase it. Also if there is a write up on how to change it, that would be very useful too. I noticed that it looks a lot like the APR "snub mount" I am looking at for my 1.8T A4 and they have very detailed directions on how to change it. Is this the same thing? Can I buy it at a VW dealership?
View 2 Replies
We have a 1995 Chrysler Concorde. It drives fine, but recently I have been hearing a clunking noise (two or three clunks) somewhere in the rear of the car AFTER I turn the car off. It does not clunk while driving or braking or slowing down: only right after the ignition is turned off.
View 5 Replies
'05 Gx470 w/ 93k mi. Time for new parts for all orig. frt. suspension? Started having "Clunking" up frt. Assume time for new shocks all around. Also, grease from upper ball joints half-way down steering knuckle arm, so probably dry? Thinking of replacing everything up frt. incl. hub bearings while have all apart and be done w/ it. Notice in FSM that this means replacing both upper and lower control arms that come w/ bushings and ball joints installed. Parts very pricey even w/ discounts ( 27% at myLparts), somewhere around $3,500 +/-, incl. rr. shocks. Rather cry once and hopefully get get another 90K +/- mi. w/o problems. I've always gone w/ OEM parts in past and probably paid the price, but since I'm doing all the work, hopefully evens out in long run.
View 1 Replies
For the last few weeks, when I make a turn (particularly a sharp turn in either direction) I get a "clunking" noise that sounds like it is coming from the front end somewhere. I can also feel it - almost like a gear slipping and engaging again. I am not in 4WD mode when this is happening. It NEVER happens unless I am turning a corner. If I drive straight, it's fine. 1999 Explorer XLT (4 door, 4wd model)....
View 2 Replies
I have a 1995 Ford Mustang GT. I've had it for 4 years now, and the engine rattles mostly when the RPMs are between 1500 and 2000, just after pressing the gas. Sometimes it does it when the RPMs are higher, around 2500, and sometimes it does it regardless of RPM after I've been driving it for a long duration. It's done this since I bought it, so it's not a pressing issue, but I'd still like to get it fixed.
View 10 Replies
We were flagged down on the highway by a very nice fellow motorist because we were gushing coolant. It was gushing. My passenger was a guy friend who used to work as an aircraft mechanic and works on his own vehicles, so I deferred to his supposedly greater automotive knowledge when he said I didn't need to call a tow truck. We got to within 100 feet of my mechanic (about 5 miles away) when my poor Jeep conked out after losing power and making an increasingly loud clunking noise for the last 500 or so feet. We pushed it in to the auto repair bay. The engine was smoking and would not start. The mechanic replaced a worn out radiator hose, which had become disconnected from the radiator (due to swelling, I think he said?), and the truck runs. There isn't a discernible difference in the engine performance after driving it around town for the day. My question is this: is the engine likely to be FUBAR and am I just playing a waiting game until it croaks?
View 8 Replies
While driving, the drive side door makes a creaking/clunking/rattle/popping noise. Its so damn annoying. It's all the time, if you roll the window down it doesn't do it as loud, but its cold out..
View 24 Replies
I have 2012 sentra with CVT transmission & 60,000 miles. I just got 60,000 miles service done. Service adviser called me to let me know that I need to have replaced upper strut bearing on the front (left & right) replaced because they are making clunking noise when turn wheels or parking. When I asked for the reason why they should go bed he told me that it's normal, some sand other debris could clog there or water could have damaged it.
View 4 Replies
I have a 1995 Mazda Truck, B2300 series that is a 4 wheel drive. Recently I had the front brakes replaced, new clay disc brakes. Not so long after that I started to hear a noise as I was braking as well as squeaking. I thought, of course it had something to do with the new brakes. The sound happened occasionally at first and now is every time I brake.
I can hear it as I'm coming to a stop, sounding like it's coming from the rear. It's a rubbing type noise, like a wa, wa, wa, wa that happens until I have stopped. After 2 mechanics I now have a $700 estimate to replace the u-joint, and they aren't even sure if that will fix it.
The front brakes are new. The rear drums have been replaced and machined to fit properly (they thought that was the issue). Is this common or something that I have to fix every such and such miles?
View 1 Replies
My 2002 Toyota Camry started making a clunking sound near the front left of the car (and I could barely feel it, too) at low speed over slight bumps. My mechanic, who I trust, said I had two broken engine mounts. He replaced them. Sound continued. He said I needed new struts. He replaced them. Sound continued. Decided to take it to a Toyota dealer. They said I needed new lower control arm bushings but couldn't guarantee that was the source of the sound and they would just have to see. I opted to ask yet another mechanic, who said the control arm bushings are NOT the problem, but he would have to spend some time (could be several hours) exploring to find out what the problem is...at $70+ per hour. The car only has 86,000 miles on it, but I'm getting concerned that I might end up paying for a new car without the new car smell if I keep spending money on "possible" causes.
View 12 Replies
1995 toyota camry 4 cylinder engine - My car was working fine yesterday, but today when I inserted my key; the key won't turn at all. I have try changing the shift control to neutral and jerk the steeling wheel. I have also went and copy my key. When I inserted the new key, it finally turn all the way, but then it got stuck in the ignition. After a few hour I got the new out of the ignition and try again. This time the new key can't turn all the way. My uncle believe that the key ignition sensory is the problem.
View 1 Replies
I changed the front brake rotors & pads on my wife's 2009 Toyota Camry & everything seems fine except when doing sudden or slightly hard stops it seems to do a clunk/knock type sound from the front brakes. It also only does it sometimes not every hard/sudden stop.
One thing that comes to mind is that when I went to tighten one of the guide pin bolts it was a real pain, the big bolt that the screw threads into kept spinning making it hard to tighten the bolt into & none of the others did this. I thought I tightened it down but possibly not?
View 5 Replies
I have a 1995 Camry with the 4cyl 5sfe engine and a manual transmission with about 120K miles. It's been very reliable overall, but lately it's been exhibiting some strange intermittent behavior. When driving at a steady speed between 2-3K rpms, it'll sometimes experience a momentary power loss. There's no stalling, but it's as if I've hit a stiff headwind or the brakes have been applied and then release. It doesn't seem to happen when accelerating, but as mentioned above, it's most noticeable when maintaining a steady speed. Sometimes it'll be very quick like it's bucking and other times it'll last a full second or two. It'll do it in all gears at both relatively low speeds and highway speeds, so there's no pattern there. There is no check engine light when this happens, but I have not yet attempted to check codes just in case it might be storing any. It'll happen when the engine is both cold and at normal operating temperature. I've also tried to observe whether or not the tachometer drops when it bumps, but haven't really been able to discern that due to the usual momentary nature of the power loss.
The coil on this car is integrated into the distributor and I read somewhere that it's common for these to start to go as these Camrys age and accumulate a lot of miles. I also read that it's common for these cars to hesitate due to internally leaking fuel pulsation dampeners. The AC compressor makes a little noise, and sometimes it almost feels like what you would expect it to feel when the compressor kicks on, although the jolt or 1-2 second sustained power loss, depending on what occurs, feels stronger than that. Plus it'll do it with the AC off, so that doesn't seem to be a possibility. Other than this problem, the car has no issues whatsoever. It's quiet, uses very little oil, idles perfectly and maintains optimal operating temperature. The miles are about 75% highway since I've been using it mostly as an airport commuter car. Most essential maintenance items, such as the clutch, timing belt, water pump, oil seals, PCV valve, thermostat, radiator, motor mounts, etc. have been replaced within the last 15K miles, and most are Toyota OEM parts. Plugs, wires, cap and rotor have all been replaced within the last 10K miles, again with Denso plugs and wires, but aftermarket cap and rotor. I did feel up under the distributor and got some fresh oil on my fingers, so the o-ring might be leaking a bit. However, I don't know yet if there is any internal leakage inside the distributor itself.
I'm going to tear into it a bit, but I wanted to see which direction to look first. Would you suspect a spark issue (again, no CEL illuminates), or something more like a fuel delivery issue? I also wondered if it might be something like the TPS or perhaps a cam or crank position sensor on the way out.
View 10 Replies
I just purchased a 1995 SL1. It has 95,000 on the car. It was a tow vehicle for an older man.It has an automatic transmission. It runs great but makes this funny noise. When you put the car in drive after having it completely shut off and after starting to accelerate to about 5 mph it makes a funny click clack noise followed by a beep. It does not sound mechanical but like a relay or something. It only does it once. As long as you don't turn the car off completely it does not do it again no matter if you put it back in park. If you turn the motor off and turn the key to ACC it does not do it. No other sounds at all. Transmission shifts fine. What it might be?
View 2 Replies
