The motor turns over but it just don't seem to have enough power to start. Have not tried to arc check from the plug wires. I believe the coil is internal on this model.
View 1 RepliesLast week the coil went out. The housing had several cracks, and the heavy oil had filled the distributor cap. So the coil, rotor, and distributor cap were replaced. About 4 days later, all my engine would do was make a grating sound when I turned the key. My boyfriend said that it sounded like my starter had gone. It wouldn't start with hitting it or anything. So, he and I, while trying to save some money because we're both on disability, replaced the starter. Now, when I turn the key, nothing happens! We're pretty sure the battery is dead. We have it on a trickle charge right now. But a funny thing happened, all of a sudden the open door alarm started going off! The door had been open for several minutes when it started. So we think that it may be a short. The starter relay, when you look at it, has a spot of corrosion on the indicator. Tomorrow we're going to try cleaning them.
1993 Toyota Camry DX with 170,000 miles ....
I have a 93 Camry that quit on the highway. No spark, crack in condensor replaced distributer. Still not run. Rotor not turning, replaced timing belt, main engine fuse heating up replaced that. Now it starts right up but only runs 10 minutes. Then won't restart until several hours go by then it will start again. Runs like a champ when it starts.
View 1 RepliesMy 2001 Toyota camry has twice just barely started. The car normally starts just fine but there are 2 times after I had been driving and making frequent stops and starts then the car barely turns over when I try to start it. Both times I did manage to get it started and then it ran fine and when I stopped it at home it restarted fine. Each time I also noticed that the clock had reset itself. There was a period of about 3 weeks between the two times it did this. Both days that this happened it was very hot outside. Why this is happening?
View 8 RepliesWhat this thing is on the top of my power steering pump? It has 2 vacuum hoses going to it, "is it some sort of booster"? Fluid is leaking from this thing and I don't know if it can be tightened or replaced.
View 9 RepliesMy 1995 Toyota Camry will not start, the engine turns but does not engage. I have had the fuel pump, fuel filter, and a relay switch replaced. After each repair the car runs for twp weeks and then will not start. I have had it towed and the mechanics start the car with no problem and they are unable to diagnose the problem. In a month and a half, I have had the car towed 3 times.
View 4 RepliesWhile raising both front doors windows, both windows stopped moving. Checked power locks and they didn't work either. Manual said to reset circuit breaker for this problem but where it's located and the manual doesn't specify either. Just need to know where the circuit breaker for the power windows and locks is located.
View 1 RepliesMy 2000 Mercury Villager won't start the motor turns over, it just won't start. I ran the battery dead trying to start it.
View 7 RepliesThe motor turns over, but it will not start.
View 3 RepliesEvery 2-3 days, intermittently-there is white smoke coming from the tailpipe of my car. The car seems to be sputtering, like it wants to cough, plus there is vibration in the steering wheel. All this happens while the car is idle like at a light. Then on other occassion, I am driving on the freeway and the car seems to sputter even at 45-65 mph, then it just smooths out. No problem.
Today, I was in the parking lot, there was no smoke but some sputtering when I shifted from park to drive. I drive 30-40 minutes to get to work and very afraid my car is going to breakdown. Also, I took my car to Toyota dealership and was told they could not tell me what was wrong with my car and to bring it back when to problem occurs again. I have pretty much "babied" my car, so I guess my car is beginning to reach middle age.
Add'l info: Camry XLE, 3.2L, automatic, 167,000 actual miles, warm climate, oil change every 14 weeks, tune-up about a month ago, coolant flush in June 2012, a/c is fine
A few months ago I had the passenger side Control Arm replaced. Over a year ago I had them both replaced with after market parts. I went into the dealer and was told the reason the parts failed so soon was because the parts were aftermarket parts and that I should have them replaced with original Toyota part. When the passenger side failed again, I had the dealer replace it with an original Toyota part.
Here's the problem: after they replaced the one side with an Toyota part I took my car and immediately when making a sharp turn to the right the vehicle making a jerking motion. It was unnerving the first time. It felt as if the vehicle might turn over. I noticed that this only happen or mostly happen when making a turn to the right.
Also, as I'm accelerating the vehicle will pull to the right the abruptly jerk to the left. What I was told by the dealer is that scene replaced the one side with a Original Part and the other side was an aftermarket part, the two not being of the same quality were what I felt he was saying that the parts were slightly different in size and would cause this problem.
My dad has a 04 f250 5.4 auto. The motor turns over but very slow and will not start. He's put two new starters on. I went and looked at it and figured it was loose cables or corrosion, but it was fairly clean, and tight. We decided to pull the battery out of his van that he drives everyday, and I cleaned everything very good. Same thing. Pulled the belt to make sure nothing was lockup, same thing. Truck was running and starting great, then just did this one morning on him.
View 9 RepliesMy 1998 Toyota Camry with about 157k creaks esp around turns and even more with adult rear seat passengers (not my in-laws my husband's). When my dealership did a really expensive routine service on my car said the front links and bushings needed to be replaced, but after the amount they charged me I had no money left. Would fixing these fix my creaking? If not should I do replace them anyways?
View 1 Replies2004 camry 4 cyl. turns over slow but starts. I checked battery voltage (car not running) it is 12.6 volts. when cranking in dropped to 6.??. The post terminals and cables looked ok but I did not disconnect or remove them to check. How can I verify if it is a bad battery or a bad starter.
View 3 RepliesI have a 96 f350 that I just replaced the batteries on and now when I go to start it does not hardly turn over. Starter just barely turns motor over and definitely not fast enough to start truck. Battery connections are tight and starter was replaced about 4 months ago.
View 4 RepliesWhen I turned the key to start my car, I got zero activity from it. No ticking, no lights, nothing. So I tried to do a push start, and the engine wouldn't engage. I took the key out, and suddenly my dome light popped on (though it was dim). I put my key back in and turned it, and dash lights looked normal and at full power, but as soon as I pressed the clutch down and tried to turn the key, everything went dead. I took the key out, put it back in, and turned it, but got nothing.
I pushed my truck up to the top of an incline, and turned the key. All the lights looked normal, so I thought I may be able to push start it. Key was in proper position, clutch was engaged, and gear shift was sitting in first. I got a decent speed, released the clutch... and everything went dead.
I can't decide if it's my starter or my ignition system, though I suppose it could be the wiring, or even something else.
Recently while driving my 93 Toyota Pickup 22RE, I experienced a loss of power. It is equipped with a 5 speed manual transmission and a 22RE engine. The engine has about 165K on it. I am aware that it could be a timing chain, or additionally, there is a sensor in the air intake that I have heard could be the problem. Also, if it is a timing chain, what are the chances of engine damage?
View 6 RepliesI have a 1997 Toyota Camry thats leaking oil profusely. Within a week of topping oil, the oil leak light turns on. The mechanic says that leak is somewhere near the engine and he needs to tear it apart to see whats up. Estimates run upto $ 800. I am trying to extract life from the car. Is Lucas stop leak advisable?
View 9 RepliesIt turns over but won't start. also makes a metallic sound it didn't do before while cranking.I changed battery a week ago and replaced air filter right before this started.Is it related or could it still be the starter even thou it's turning?
View 1 RepliesI have a '93 Toyota Celica Standard transmission. Recently it's been lagging in power. Only happens after it's warmed up. I'll be driving along and it just seems to lose power. Have to stomp on the gas to get it to kick in. Also, at the same time, when stopped it idles really low. Cold, no problem. Took it to Toyota dealer to have it diagnosed. I Stated that it might be the MAF sensor. They checked it out and said it needed a major tune up (to the tune of $700!) Now, I know it needs a tune up, but the symptoms don't seem to correlate to that being the problem. I asked about the MAF sensor and they said no diagnostic codes came up. Is it possible the air filter is clogged? Can the sensor malfunction intermittently?
View 14 RepliesI have a 2004 4-cylinder Camry. Saturday I changed the passenger side motor mount which was broken and the front motor mount, which did not appear to be broken, but there was more play in it than in the replacement. I had to take the battery out and the air intake in order to have enough room to remove the front mount. To remove the front mount, I jacked up the engine with a 2 X 4 underneath the oil pan so as not to damage it. The passenger side wheel rose several inches off the ground. After everything was back together, the car ran rough at first but eventually got better. The only symptom that remains is a noise and slight vibration when the car is in drive. In neutral and all other gears there’s no noise or vibration. They noise seems to be slightly less when the car starts to roll, and after a few seconds in motion, I can’t hear it. What’s causing the noise? If there a third motor mount that I may need to replace?
View 19 Replies