Yesterday I opened the lid of tank for windshield wiper liquid to add solution. But there is no filter ( fine plastic net). My old 2002 Avalon has it.
My new Avalon is 2014 Touring (V6).
I recently replaced the wipers on my 2007 Toyota Avalon Limited. The new wipers are a rather expensive one-piece design that tends to bounce along the windshield producing an irritating noise. Never had this problem with the original equipment wipers. I have cleaned the wipers with alcohol, which temporarily improves the situation but the problem quickly returns. Only relief comes during major downpours.
View 4 RepliesI have a 2013 Toyota Avalon Hybrid Touring Model.
The vehicle is great, however the clicking noise from the wiper relay is obnoxious. It is only when the intermittent wiper setting is applied that the noise is apparent. You can also duplicate it by manually moving the wiper knob up and down. I showed the dealer this twice, and both times they say it is normal. I will take a video later today and post it to show.
How do you replace a/c cabin filter on a 2009 Toyota Avalon Limited?
View 3 RepliesI currently have summer washer fluid in my 2003 Toyota Echo's windshield washer fluid tank. I need to replace this with winter washer fluid within the next few days before the temperature goes below freezing.
When I pop open the hood, I see that the bottle is located on the left hand side of the engine bay. The bottle has a black cap with a picture of a fountain (wiper spray).
I have no experience working on the mechanics of a car. However, I would like to know the easiest way of replacing my summer wiper fluid with winter wiper fluid. The tank is currently full with the summer washer fluid.
a) How do I go about emptying the bottle completely without removing it?
b) If I need to remove the bottle and then empty it completely, how do I do this and what tools do I need?
I finally had enough of the annoying squeak-squeak-squeak of my wiper blades every time I used them. Time for a fix!
First, I narrowed down the problem by making sure it was not the rubber wiper blade rubbing against the windshield. You can rule this out by simply lifting the wiper arms up to the locked position and turning them on. If they still squeak it’s not the rubber rubbing against the glass.
By carefully listening I narrowed down the squeak to be coming from under the large black plastic cover on the passenger side wiper. From what I have read other Gen II Prius owners have had this same problem. I discovered that you CANNOT remove that cover without removing the wiper arm assembly. But it’s not too hard.
So it rained today. I go to turn on my wipers, and they sound like this: [URL].......................
Clattering and skipping, only for the driver side. So I go to look at the wipers, and they look fine. Put it into service mode, and driver side is not flush to windshield. Took off the windshield blade and saw that the piece that attaches the blade to the arm is crooked. And then there's a slight bend in the arm itself. Pictures show it not very obvious, but is noticeable in person. And there is a bend on both, but the driver side is much more bent than the passenger, and its also at a different angle, hence the crooked attaching piece.
I took delivery of a new 2004 Touareg V8 with nav system radio, yesterday. On the way home, in the rain, the front windshield wipers stopped working as well as sound from the radio (controls, menus, etc... were still illuminated) This is not very comforting. Windshield wipers are quite necessary in the rain. The general technology behind windshield wipers and radios would seem to be mature to the point that reliability need not be questioned. As a new owner having just been through an hour of instruction on operating this piece of machinery, I felt somewhat inadequate that I could not operate the windshield wipers and radio. I said to myself, it can't be this hard! My wife and I became frustrated at each other to the point of my speculation on who would get the vehicle in the divorce.
When I finally made my way into my driveway, I decided to check the wiper fuse because it was most necessary, rain being forecast for the next several days.
I pulled the 30A fuse for the wipers and found it to be OK. I then replaced it. Behold, both the wipers and radio began to work. (The manual does not say anything about the radio being connected to the wiper fuse) Case closed, I thought. 5 minutes later they went out again. I pulled the fuse, replaced it and eureka, they began to work again. I drove the vehicle today for about 30 minutes at which time they ceased to function once more.
My latest issue is not having wiper fluid shoot out of the dispenser units to the wipers. I think it may be frozen, but the weather has only gotten warmer since it worked last.
What's odd is that, even if frozen, I would think one side might work and the other would not, but neither works. I can hear the pump trying to squirt it out, but nothing.
I would rather fix it myself if I could. I have already taken the car to the dealership four times in the last month (steering rack 2X, catalytic converter, lower vent not working)....
I did top it off with fluid last night, but there was/is already plenty in there.
[IMG] ....
I have an 05 Touareg and the passenger side windshield wiper is not wiping a small section of the screen, approximately behind the rear view mirror. It's not a problem with the blade (I replaced those) so I suspect the wiper arm needs adjustment. Raising the car's bonnet reveals the wiper arm attachment (see picture) but there's a plastic cover that it looks like I need to remove. Usually I use brute force and break things like this. How to
(1) remove the plastic cover and
(2) adjust the wiper arm
I have a 2007 Toyota Camry. The wiper arm on the driver side is not moving while the one on the passenger side is working fine. I thought the wipers went bad and changed to new ones but the problem is still there. Is there something wrong with a motor?
View 3 RepliesThe clips on the cover broke so I bought a new one. Since they redesigned the 04 base, I have to remove the base. I remove the nut on the outside and the 3 on the on the inside after removing the cover. However I can't figure out how to pull the wiper off and replace the base. There is something holding it together. There is a pin that is connected to the inside that has a round hole but it is not a torx, allen, or any type of other tool I tried.
View 5 RepliesThe windshield wipers aren't working properly. I can hear the motor trying to work, and either blade will try to work but get stuck against each other. I checked the fuses and nothing is burned out. I'm not sure if it is related to the problem but yesterday my husband was washing the car and I noticed that he had pulled the wiper blades away from the windshield so they were sticking up in the air. We filled the wiper fluid. I'm wondering if something got broken when he opened the hood without putting the blades down? They seem out of sync. He also did an oil change. Could he have done something to cause this problem while doing the oil change?
I want to open up and take a look at the motor functions, but I'm not sure where it's located and how to get to it.
I've been thinking about leaving the wipers in "service" position overnight when it's snowing or freezing rain. I'm wondering if I can go and start the engine and get the defroster going - or - will the wipers try to go back to their "parked" position as soon as I turn on the ignition? Not a fun thing if they are frozen to the glass...
View 15 RepliesThe Prius that I bought brand new last October has developed a crack just above the driver's side windshield wiper. I noticed it today while washing the car. At that time it was about eight or nine inches long, and relatively hard to see due to being so low on the windshield. I inspected the crack very carefully and could not see ANY type of impact damage. After driving it around for the day, the crack has now splintered off and is going in a few different directions now. In a couple of places along the crack a few small chips have also broken off.
View 10 RepliesI'm setting up a 9v 20mA 5mm LED array for some DRLs, but I'm worrying a little too much about my power supply. I remember reading about a year ago to tap into the windshield wiper motor for a 12V source. I know I'll need to get some resistors for that.
View 1 RepliesFound that OEM new wipers were not completely squeegee-ing the windshield. i.e. getting small patches of wet/unwiped areas. Seems like it's skimming some areas instead of actually wiping.
View 24 RepliesSo I have a 2001 Jetta Wolfsburg, the wipers work fine, but when I switch them off they stop in the middle of the windshield. Also when I use the spray, the fuse blows every time.
View 3 RepliesWhy only one windshield wiper would not work ?
View 3 RepliesI have a 2004 hyundai sante fe. None of my windshield washer fluid is spraying on my windows, front or back. I think the fuse to the windshield fluid might be broken so I opened up the fuse box but I can't find a fuse that says it's for the fluid.
There was one that said, I think, "Windshield" but it was a big gray little box it doesn't look like the rest of the fuses. I tried to pull on it but it wouldn't really budge and I didn't want to keep trying because I don't know what it is.
Just bought a used 2011 Elantra Limited and noticed a scratching sound when the wipers are activated. The result is a small scratch towards the bottom part of the windshield.
I can see exactly what is causing it - there is a spring that allows the wiper arm to pivot and the spring connects to a piece of metal that sticks out a bit when the arm is flat against the windshield. The piece of metal bows out a bit and only touches the windshield for a few inches when the wiper arm is at the bottom of the windshield.
I have tried to bend the wiper arm and also tried to bend the piece of metal to no avail to get the scratching to stop.