Touareg :: V8 Timing Belt Literally Burnt Off
Feb 15, 2013
My timing belt literally burnt off today and jammed my engine up.
View 9 RepliesMy timing belt literally burnt off today and jammed my engine up.
View 9 RepliesI was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesSerpentine belt on a 2006 Honda Odyssey fraying and then ripping into the timing belt causing that belt to break? I recently had this scenario given to me as the cause of my recently replaced timing belt breaking.
View 11 RepliesI've got my sister's 1995 Dodge Neon with the 2.0L SOHC. While driving it recently I heard a horrible squeaking noise then a ZZZZZZzzzzzz sound. I immediately pulled over. The check engine light came on, and I shut the car off. Coolant was all over the place leading me to believe the water pump failed. I had it towed to my house, and now I will have it towed to the shop to get fixed. I would like to have them repair the timing belt and water pump. However, I am afraid that the valves were beaten to a pulp and now I will need a new engine. I was only going 35 mph when it happened. What are the odds that my valves were smashed up, and is there anything I can do to check them before I pay for a timing belt/water pump repair?
View 19 RepliesI brought my 2004 VW Touareg V6(83k miles) to the dealer for a recall on the ignition call and much to my surprise, was presented with a diagnosis of a $6,000 problem! The dealer told me that the computer read some codes which say that the timing chain is stretched and needs to be replaced. They said it will take 4-5 days and should be done asap so it doesn't "go out", because if it does, it's an even more expensive problem. I took the car to another VW repair shop and they asked me if I heard any noised when I start it cold (like pebbles in a bucket). I have not had any problems like that at all, so they said I shouldn't worry until I start getting symptoms. They also said there is no recommended point (like 90,000 miles) when VW recommends the change, so it really shouldn't be a common problem. I want to do the right thing, but I don't want to rush into an expensive repair if it isn't necessary.
View 1 RepliesI know that brake light usage varies by driver. However, this driver has never had to replace a brake light on any car I've owned within the first three years. I know this because several have been leased and I never had to replace any bulb.
My Treg brake light went out last week and I had to replace it. Is a shorter brake light life par for the course here? Any fancy reason? How many brake lights have you replaced?
Over the summer my car started having oil drips under it and it ended up being the valve cover gasket, so I replaced it. I noticed the half circle gasket next to the cam chain tensioner gasket was missing, so I just jammed it in there (didn't have tools/time to get cam chain gasket replaced). Before I changed these gaskets, oil would drip on the back side of the motor (farther from the front). Today I noticed drips of oil in front of the engine. Looking around there is oil in the timing belt area and is dripping down from there. It doesn't look like the VC gasket is leaking.
My question, what would cause oil to drip into/from the TB area?
engine = 1.8t ATW longitude
I am looking for a link or instructions on replacing the timing belt on a 2.8 30V. I attempted to search and mostly came up w/ the info relating to the turbo.
View 2 Replieshile since i've posted on the Tex. I've got a buddy who's looking at getting a 99 Passater, the car has 110k miles on it and it's the 1.8T. I've been reading a few posts out there about what to look for on these cars and of course maintenance records are at the top of that list. The other things I've been reading about is timing belt (I'm assuming this costs a few dollars to fix) probably should be done at 100k, and some front end suspension parts seem to go bad at an early interval. Anything else that we should look at on this car? It's an AutoTranny, I know the B4's had a horrible AT, I used to own one. Did they fix this pretty well in the B5's?
View 4 RepliesI recently changed the timing belt on my 2001 Avalon. I am now getting a P1351 code. I removed the timing belt covers and checked the marks, and everything lines up perfectly. I have checked this twice now. To give a little background, before I changed the timing belt, I was getting P0300, P0301, P0303 and P0305 codes along with a P1349. Upon looking up the codes, P0300 indicates a misfire on multiple cylinders, with P0301, P0303 and P0305 indicating misfires on cylinders 1, 3 and 5. The P1349 indicates a variable valve timing issue on bank 1 (cylinders 1, 3 and 5).
I had already changed all 6 coil packs and fuel injectors and spark plugs within the last year (iridium plugs), so I pretty much ruled out any of those. And since the valve timing code was on the same bank as the misfires, I figured that was the cause of the misfires. The oil level was fine, and it hadn't been all that long since I had changed oil. So the next possibility was the solenoid. I changed both of them. Since it was due for the timing belt, I decided to go ahead and change that too. Now, the P0300, P0301, P0303, 0305 and P1349 codes are gone. But after a day or two, the P1351 shows up. As I mentioned earlier, I took the timing belt covers off and checked the belt and alignment marks. All was perfect. I cleared the code. Within a few minutes of driving the code comes back. I checked the belt alignment again. Not loose, and marks line up perfectly. The car runs smooth as can be. I do notice that there is valve clatter on Bank 2. It sounds kind of like a diesel. But it is running smooth. It is also interesting that the original valve timing problem was on Bank 1, but the valve timing problem now is Bank 2. I have only driven it a few miles since the belt change. That's all it took for the code to come up.
OK, so yesterday I changed my timing belt and all new components. I started the car before completely reassembling everything (bumpers, etc.) and it ran a little rough at first, then smoothed out. But this only lasted a few seconds and then it died out. I thought not much about it and finished my reassembly. Afterwards, the car would crank and crank and finally start. However, it would never idle smooth and it stalled out only after 1-2 seconds.
I did some investigation, and found the plugs all had wet oil on them. Changed them out and tried to start car with same results. Looked again at the plugs and they weren't as oily, but on their way. I looked all over for a source of this problem and found a broken "pipe" on the passenger side of the engine. It is black and sits behind a heat shield, directly under a larger black pipe. They both run from front to back. I think the broken one might be a vacuum line of some type, although when I plug it, nothing happens.
My fear is that I botched the timing belt job and subsequently, bent a mess of valves. But, I'm holding out hope for another cause of this dilemma. What is the smaller black tube/pipe on the side of the intake? The broken piece comes off a 90 degree elbow pointing to the ground. I'm guessing it was broken before the timing belt job, but who knows? Perhaps I broke it when I moved the radiator into service mode. Could it be part of the turbo? I thought that might cause the rough idle and stalling.
Oh, one other thing. When I last tried to start the car, I got a flashing "STOP" on the instrument panel, followed by something about the oil. The oil words only appeared for a split second before going away. Not even long enough for me to read the whole sentence.
99 passat 1.8t with 5spd has 95k on it. 2 weeks ago my ex wifes car broke the timing belt and bent 12 valves so brought it to mechanics to get repaired and got it back seems to start up fine but when shes driving it stalls out on her. Mechanic says its something do with electronic throttle and nothing to do with his work. No check engine codes yet anyways .
View 1 RepliesI was just curious and bored this morning. So I wanted to ask you all what mileage did you replace your timing belt at?
View 24 RepliesMy 2004 Passat 1.8T GLS (station wagon) has 72,000 miles. I checked the manual which says that timing belt is to be replaced at 105,000 miles.
However, car is 8 years old - does the age matter or I should be fine until I get to 105,000 miles to replace the timing belt, tensioner, water pump etc.
I was told by VW service that my timing belt is loose and needs to be changed. Is it possible to know that without taking things apart? The belt was changed at 80k miles. The vehicle is at 132k miles now. Its a 2004 v8. the quote is $1400 which I suppose is in line with what these cost but I'm wondering if I can wait until 160K before changing it.
View 9 RepliesI got 123000 km on my car. Manual says 144000 km is the right mileage to replace the belt, but I have heard opinions that it should be done earlier.
View 7 RepliesI got 102k on my 2000 1.8T Passat, ATW engine code. I'm thinking about changing the timing belt. Is there any way to check if it was done before. How to recognize factory timing belt?
View 9 RepliesOf those out there whose Timing Belts HAVE failed , at what mileage have they gone bad and what damage was done?. This would be good to know to give an idea as to when to replace the Timing Belt.
View 12 RepliesFirst off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 RepliesLooks like my timing belt broke. I was taking my car out of the parking lot, and heard the warning chime. I tried to look at the warning light, I think it was the malfunction one. I heard a belt/ fan snap. The engine stalled and I dint try to resart the engine. I had it towed to the dealership and am waiting to hear from them. The engine dint make mucg of a noise but sorta just died. Does this sound like a timing belt? I am worried abt the damage. how much would it cost if it was a timing belt? my car only had 73k miles on it. It is a 2001.5 1.8t.
View 5 RepliesDoes VW have an official recommendation for replacing the timing belt?
None of the publications I've seen list the timing belt interval. My car is very close to 95k miles.