Touareg :: Shifting Noise Between 2nd And 3rd Gear
Jan 12, 2004
I am hearing a noise first thing in the morning when I leave my house and the car is shifting from 2nd to 3rd. The sound, I think, is coming from the front center of car, say directly below the radio area. The noise lasts only 1 to 2 seconds and sounds like when some tries to put a transmission in reverse while still rolling forward. A metal against metal sound of two pieces trying to mate up. I'm thinking transmission...I'm hoping center diff. There was mention of a scraching sound coming from front passenger side on initial startup. Idea was this could be Immobilizer or ABS.
View 2 Replies
Advertisement
Today (not 2 days after taking delivery) I was travelling on the highway. stopped for fuel and as I am decelerating on the offramp when the truck shifted from 5th to 4th it went CLUNK, It did this twice, in the same circumstance. I can't make it replicate the noise every time. But 2 times in 24 hours is enough.
View 10 Replies
I am new to the all wheel drive breed. When I turn the all wheel drive knob one click over to the right (4x4 low I believe) how much rougher should the shifting be. I notice it starts in 2nd gear, but 2-3 shift jolts the car to the point it almost snaps your neck(not WOT just normal accelaration). Each subsequent shift is a little smoother, but still very noticably rough. Is this normal? Even in the regular high mode, sometimes my regular around town low throttle shifts are pretty jolting.
View 4 Replies
Seems like the problems just keep building up. Today leaving work T-reg shifts fine untill it got to 5th gear. It was around 35 mph. Went to give it more gas and it never shifted out of 5th to a lower gear. It did accelerate but even with pedal to the floor it never downshifted. Whats going on. It has done it twice in the past two days. After only having it on the road for less than 5 min each time.
View 6 Replies
Occasional clunk when truck is shifting gears. Not consistent. On highway at high acceleration clunk is more apparent. Any thoughts. 2004 v10 with new engine placed at 70,000km now at 85000km. Otherwise truck is running great.
View 8 Replies
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 Replies
I have two 2009 stick Focus SE 4drs (one for me and one for the Mrs.) Both are PZEV. Mine, with 66k runs great; hers, with 43k talks back when under initial load. When starting up from a stop or up shifting in any gear we get a snorting or knock in the 1000 -1500 rpm range. Once above 1500 rpm all is quiet. The funny thing is that if it is raining out, the noise does not occur. The car is also an absolute dog on any hill, putting the pedal to the floor does absolutely nothing (no knock, either) Having an identical car myself, and not experiencing these two things, I would guess that something is amiss. What might be the cause?
View 2 Replies
got a sweet deal on it but only 1 problem with the car. when i shift into 2nd gear there is a grinding noise, however it doesnt grind if i drive super slow... it doesnt really matter if i upshift or downshift into 2nd it will make the noise either way... also the grinding noise is only there WHILE shifting the lever into 2nd gear so its only there for a second, once the lever is shifted into 2nd gear there is no grinding noise at all...not sure if this is related but the clutch pedal also feels very lose just when its about to hits the floor...
View 4 Replies
I bought a new corolla 2009, automatic transmission (Not Robotic!) From the first day, when shifting from first to second gear the car makes an unnatural noise, like a whistle or a whine. (during shifting and sometimes a little bit before).
It only happens in the transition from first to second. It does not depend on the RPM at the moment. When the engine is cold, in the morning, the sound is still there, but weaker, when the engine warms up, the sound keeps appearing for the rest of the day. (I live in a country with a hot climate)
I have been told, 2009 model has the same transmission just as previous models, is it true? or there have been some changes in it?
View 10 Replies
Experienced a thumping noise when changing gear (automatic gearing). FOr eg. when i change from P to R or even D, there's a thumping noise which i think comes from either the gearbox or the diff. either way, sometimes the thumping noise is there and some other times, its gone.
I've only done around 1500 kms since new and if there's no solution, i'll just take it to the dealer and get it diagnosed.
View 1 Replies
New truck 11000kms ago thats done medium amount of work but nothing heavy or sustained for long periods of time. I get the feeling of clutches slipping especially when truck is cold but also when normal temps. Doesnt make any weird noises or anything. I can really notice the difference in torque if in manual mode being much better, but still not perfect if i stomp on the gas pedal and go through the gears in manual mode will still slip. Also is really harsh shift if i come to a halt in 3rd manual mode with the brake pedal depressed push minus button the truck makes very loud clunk noise into gear 2 then 1. Took it to ford they couldnt find anything ? Thinking of trying another dealer.
View 2 Replies
My wife's Treg is making a horrible deep rumbling noise right under the gear shifter. It sounds internal somewhere near the transfer case and I hear it about every 10 seconds or so...
View 6 Replies
I have a V6. Very happy with it...no real problems, but I do notice a fair amount of drive train gear lash noise when the vehicle is coasting and the windows are open. Is this normal? It not like it sounds really bad and hasn't gotten worse in the 2500 miles since I have my Treg...but I would like to know if it is normal.
View 10 Replies
My 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
View 1 Replies
I had recently purchased a 2003 golf gti AUTOMATIC (with optional shifter) with a 1.8 turbo 4 cylinder engine. The vehicle has 139,000 miles on it. Before purchasing, I had a mechanic come out and look at the vehicle for a pre-purchase inspection, and ran the code P0303 (cylinder 3 misfire) which without test driving, told me that is what caused the shift shudder I noticed when I had test driven it a previous day. He told me the coil packs were in good condition by looking at the top of them, and told me if I replace the spark plugs, the issue should go away.
I feel it is important to mention that he had also run codes on the transmission and nothing came up. Taking it home, this morning I had replaced the spark plugs and driven it for about an hour both regularly and aggressively to test it. The problem is still there, and I was really hoping that there is a solution to this problem, because everything else on the car is beautiful, while being my dream car, I just want it to work as well as I know it can. To be more descriptive, when shifting to 3rd the whole car feels basically like it is tripping over itself before successfully shifting.
View 10 Replies
Towing the 16 foot bambi airstream this weekend for Canada day long week-end. First 7 hour leg to destination great. On return trip gear selector on dash screen was flickering and would disappear completely. Engine seemed to be stuck in 1st gear but would run at about 80-100km/hour and 3000rpm. Also could not select anything except high gear(high gear/low gear selector just kept flashing)..... Trip computer/Gps also malfunctioning. The truck seemed to be trying to correct gear issues but eventually gear display totally disappeared and was left running at 80 km so as not to over rev the engine. Taking in tomorrow. Truck had new engine at 70000km, has 97000 on now. Throttle body replaced 2000km ago due to malfunction in shifting.
View 2 Replies
I don't have seamless shifting. I have a 2004 V8 and right now I'm driving a 2005 V6 loaner and it's soooo much smoother and is more of a joy to drive than my V8. It rides better and everything!
View 16 Replies
When shifting to LOW range is it ok to do this with the engine off. Like turn on the car but not with the engine on, as if to listen and make sure it sounds ok.
View 1 Replies
It wasn't until very recently that my 2005 Touareg (V8) just dumped a plethora of problems on me all at once. System Fault Workshop, Brake Assist Failure, etc... However, one of the more serious and annoying issues is the automatic transmission.
One day, the action of pushing the shifter over into the Tipronic slot was stiff and unyielding. A little pushing here and there and it popped in there. No big deal. A few days later, once in Tiptronic mode, it refused to downshift, it would only upshift. A few days later, it refused to shift at all once pushed over into Tiptronic mode. Upon removing it back into Drive mode, it also refused to shift there.
Now, to my surprise, my Touareg will not shift gears up or down unless it is in Sport mode, which is not too great for the long-distance commuting I have been doing lately, I would like my 5th gear back. I have been unsuccessful in searching any situations similar to this and I am worried about what kind of parts could have been damaged under the shifter... but I am skeptical about what electronics could be broken that tell not only Tiptronic but also Drive mode not to shift whatsoever, and that it may be more deep-seeded than some flimsy plastic under the console.
View 2 Replies
I have a 04 V8 with a hesitation in the shifting. The VIN is in the 44000's. The dealer says there is nothing they can do to flash the tranny, they've tried and it won't let them. I found the TSB referring to the engine code and they insist it doesn't apply to my vehicle. Is there anyway to find out for myself whether or not it is possible?
View 4 Replies
My 2004 V8 clunks when shifting gears, causing the engine to oscillate right through the seat. It also happens when driving a steady speed, e.g., 10MPH in traffic, and you goose the gas or release the gas altogether. So far:
1. Replaced transmission valve body
2. Replaced stepper motor
3. Replaced rear propellor shaft and bearing
I think this started with a reflash of the trans to cure the death lag.
View 2 Replies
