Touareg :: Shaking Back And Forth - While Backing Up Sound Like Bat Hitting Metal Pole?
May 15, 2004
I have been having two issues.
1.) Everytime I go to back up in my car the whole car starts shaking back in forth like someone is at the front and back rocking it.
2.) After my car has been driven around for a bit and I return to campus to look for parking spaces sometimes I have to back up because there aren't any. Whenever I go to back up, it makes this loud sound like a bat hitting a metal pole and it can be felt throughout the car. It does it all the time now.
I am beginnning to get scared to take this thing offroading. Also whenever I shift from P to R it makes this loud THUNK sound. I am going to let the dealer look at it when I take it in for the 10K service.
View 20 Replies
Advertisement
Sometimes when closing either the front driver or passenger door, it seems as though the door is not closing properly and it sounds like the latches are striking metal against metal. The doors always close and the noise does not occur all the time, in fact it occurs on a very seldom basis. The noise is very annoying and definitely does not sound right. I can not repeat the problem at will and I fear the dealer will not be able to locaate, unless it happens just as they close the door. The doors do close tight, but the sound is awful (sharp metal hitting metal sound).
View 2 Replies
I got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 Replies
Didn't have time to break out the digital camera, but what the two black painted bars set into the back of the rear seat are?? Doesn't appear to be part of the locking mechanism, but I'm uncertain.
View 2 Replies
Metal on metal rubbing sound when starting off from a stop at slow speeds? It seems like it is brake related because putting on the brakes stops the noise. The noise also seems to go away when you get a little more speed, and maybe when the it shifts from 1st to 2nd ? This also is intermittent.
View 2 Replies
When I was reversing back and turning the steering wheel. I heard a metal clunk sound and it had happened twice in the past two days. Today happened after I released the parking brake and set it to reverse. What is the problem? Miles on the car is ~30700 miles.
View 2 Replies
I described about 3 weeks ago this loud metal sound coming from the exhaust with any revs above 4k at stop or on the road. The car sounds like a Z06 Vette with out the cats on-it is really a loud disheartening sound. The VW stealership replaced the whole exhaust but the sound is still there. Where I should direct them to look??
View 6 Replies
I have a base v6. When I turn the steering wheel (for example, to make a left turn), it sounds like there is metal-on-metal rubbing. The wheel is not extended (turned all the way til it stops)...
View 2 Replies
I have a 2007 hyundai sonata, this car is my daily driver. I put 180 miles on it a day around trip. Currently has 180,200 miles on it. Last Friday on my trip home when i turned right I heard a metal on metal sound. I slowed down went straight and it went away. Talked to a few people and I think it may be the wheel bearing. Even if I hit a road reflector it starts up. It's the front left wheel. Get on the breaks it goes away.
So my question is... Wheel bearing??? And can I replace the whole hub and fix the problem or do I have to try and press the bearing out?
View 1 Replies
I have a 2003 Toyota Solara 4 cyl. auto. transmission. I recently had the head replaced. Now it is making a metal on metal sound near the drivers side of the engine. It makes the sound during idle, when I change gears, and the sound increases when I rev the engine. What could it be?
View 8 Replies
I thought i heard this yesterday when i left work but i was tired and said its in my head, THEN i go to leave right now and sure enough its a real sound, you can hear it very well through the front grill and then if you turn the volume up you can hear a ticking sound ever half a second or so, it also speeds up when i was pulling on the throttle cable. And after the truck fully warms up it goes away.......
View 14 Replies
My 2011 2.4l Sonata made a metal on metal sound suddenly the other day. About 4 days ago, I drove about 2 hours away from where I live, Mostly highway, about 80mph to a go kart race. Got out of the car for a while and came back in and was pulling away to run the store and as i started to approach the first stop sign maybe 500-600 ft from where i was parked, i heard a bad metal on metal sound, came to a complete stop at the sign and it stopped. Went back to the race after driving to the store about 5 miles away.
Got in the car to leave and same thing, just to the stop sign 500-600ft away. Drove home like i said mostly highway, and didn't hear a thing. Today, about 4 days later, I drove to Chicago O'hare airport, about 30min away, and it was fine the whole way there. However on the way back, after about 20-25min, I heard it again. So I came to complete stop as I was forced to by a traffic light as I was taking my exit off the highway, and It started making that sound again. So i came to a complete stop at the light and started moving again when it turned green and couldn't heard a thing.
View 32 Replies
At 75K my passenger side rear brakes were making metal on metal sound. I was really surprised as I have always learned that the front brakes take 80% of load and they always go out before the backs. So I took the wheel off and sure enough the pads were metal on metal. Changed everything out. (new rotors). I then went over to the driver side rear brake. Looks brand new. The pistons were barely out. I figured this caliper is bad. (I haven't change yet)
When I drive I can hear a very faint metal on metal sound when I brake. VERY FAINT. So with 75K miles on I figure the front brakes are due. Today I took the wheels off and inspected them. Tons of pad left on both of them. If I didn't know better I would say a brake job had been done very recently. (I've owned the car new so I know they have not had a brake job) However after reading many articles on this site I found a thread where one user said he was changing his front brakes for the first time with 110K on them and the pads still had 10K left in them. So the fact that my front pads are still pristine at 75K may not be a big deal (or not as big as I thought. Also I am not hard on brakes.)
However I'm not sure what is going on. Why would the passenger rear brake be metal on metal at 75K and the three other pads are like new. Is the passenger rear the only one working (or working much harder than the others) meaning the other three are bad? Or is the rear passenger bad and the other three are good? I have a working knowledge of cars but I am by no means a mechanic.
View 14 Replies
I picked my R up three weeks ago tomorrow. I took it in this morning because there has been brake noise from day one. The noise was a scraping, metal on metal sound that diminished a fair amount when the brakes were warm. I only got a very brief conversation with the service agent at the dealership this afternoon, and all he told me is that they had to order in new brakes. I don't know if it's just pads, or calipers or rotors or the whole deal! I'll get the whole scoop tomorrow.
View 5 Replies
I have got this noise which sounds like a light skimming of metal on metal. It sounds like a roller (airport baggage) spinning. It can be heard mostly when driving next to a wall or past parked cars. I suspect it being the bearing in either the water pump, idler pulley or even alternator. The car has 330000 kms but it is serviced regularly in which all fluids have been changed over time. I just want to drive through a tunnel and not hear any non harmonic sounds coming from the front.
View 10 Replies
I have a 2011 Santa Fe AWD Limited. 90,000 miles. I have a strange sound I need identifying. At first I thought the sound was my AC depressurizing, but it's not that. It sounds similar, but has a faint metal-on-metal jingle sound to it, like something is rubbing or something is rotating and intermittently hitting something just slightly. The mechanic went in to change the water pump because it was leaking, and he thought that the water pump when rotating was rubbing because the rubber ring/gasket was failing, therefore making that sound. Not it. Tired rotated and new brake pads put on. Still there. To be clear, the mechanic never said he heard the sound. I just told him about it.
I can hear the sound when I turn the car on and put it in reverse start backing up. I can hear it when I let off the brake (driving and in park), which lead me to believe that it could have been the pressure in the Master Cylinder or ABS. I don't know now because it does it intermittently when I am driving down the road with no brake applied. When I park, I put the car in Park, get off the brake and just listen. And I can hear it. When it is in park it is more rhythmic, with two or three second breaks in between. kshhh kshhh kshhh kshhh. (I hope you like my poor attempts at sound effects.)
Is it the ABS system? Don't tell me it's transmission related. I just bought this car (used at 87,000 miles) and already had the struts done, the water pump and drive belt done. For what it's worth, this car's passenger and back seats vibrate at 60+. Not sure if that has anything to do with this sound, but thought I would mention it. New struts and tire rotation did nothing.
View 1 Replies
I own a 2010 Toyota Prius that recently developed a metal-on-metal whining scraping sound when moving. It does not make sound when the vehicle is stationary, and it's intermittent - which makes me discount the rock-in-disc-rotor idea (not eliminate it, mind you). It's quite loud when it occurs, able to hear it over the stereo. Luckily I was near work at the time, so I went there - but the shop can't even look at it until Monday evening - so I am a bit panicked.
View 8 Replies
Some odd engine noise i noticed on my fiance's 2010 Ford Escape 6 cyl Limited.
I noticed it a week or so ago, the sound almost reminds me of marbles hitting metal. The sound is coming from a pulley on the driver side front of the engine bay (closest to bumper). Rather than trying to explain the sound more, listen to the two youtube clips i put up. Clip 2 from outside the grill you can hear it the most.
What this could be and what I can do to resolve? I prefer to try and fix car issues on my own rather than go to a mechanic, if possible.
Clip 1 : 2010 Ford Escape Limited Engine noise 1 - YouTube
Clip 2 : 2010 Ford Escape Limited Engine noise 2 - YouTube
View 4 Replies
I have a loose, binding, metal on metal sound on my steering wheel shaft. I have removed the steering wheel, replaced the clockspring, because when I removed wheel clockspring was in pieces and I thought that might be the issue. Guess not, because I'm still having problem. Other than having to remove or replace the whole steering column...
View 2 Replies
I notice that when I close my door, it actually sounds like metal on metal. Looking closely it doesn't appear to line up well with the latch on the door.
View 2 Replies
I've been hearing a metal on metal sound coming from the brakes. I checked the pads with the wheel on and they all looked good. The back were replaced before I bought the car back in October. Last night the brake warning light came on, so I brought to my local shop. Longer story short, the inner pad was completely worn out, but the outer's were good.
View 2 Replies
