Touareg :: Rough Shifting Starts In 2nd Gear
Mar 10, 2005
I am new to the all wheel drive breed. When I turn the all wheel drive knob one click over to the right (4x4 low I believe) how much rougher should the shifting be. I notice it starts in 2nd gear, but 2-3 shift jolts the car to the point it almost snaps your neck(not WOT just normal accelaration). Each subsequent shift is a little smoother, but still very noticably rough. Is this normal? Even in the regular high mode, sometimes my regular around town low throttle shifts are pretty jolting.
View 4 Replies
Advertisement
I have a 03 ranger with a v6/auto trans. it drives fine around town. after i get on the freeway the overdrive light will start flashing. when i get off the freeway it will shift extremely rough. if i turn the truck off and right back on it will be fine again. What could be the problem?
View 5 Replies
I drive a 2002 Accent GL, automatic transmission with only 86,000 on it. For a while now I've been having transmission issues where the car will jerk violently when shifting or starts to rev in certain gear or in park. It also doesn't seem like it knows what gear it wants to be in half the time when I accelerate. Recently, while driving somewhere, it got real worse. It started revving and jumping and redlining and just going crazy while I was driving. I turned the car off and waited a while and turned it back down and it seemed to calm the issue a bit.
But I am afraid to drive right now. It's not the fluid. I've changed it twice in the past two years. Never works. I've seen issues like this on here before. If it IS the transmission needing to be replaced, why so soon with just 86,000 miles on it? And would having the transmission rebuilt be a better choice, cost-wise, but still just as effective?
View 7 Replies
There is never an issue when the weather is warm, but as soon as the first cold day in September in New York occurs, we usually have to wait 5 minutes or longer to shift the car into reverse or drive.We have taken the car to several repair shops to deal with this nuisance repair, and no one seems to want to investigate.
View 6 Replies
Today (not 2 days after taking delivery) I was travelling on the highway. stopped for fuel and as I am decelerating on the offramp when the truck shifted from 5th to 4th it went CLUNK, It did this twice, in the same circumstance. I can't make it replicate the noise every time. But 2 times in 24 hours is enough.
View 10 Replies
I am hearing a noise first thing in the morning when I leave my house and the car is shifting from 2nd to 3rd. The sound, I think, is coming from the front center of car, say directly below the radio area. The noise lasts only 1 to 2 seconds and sounds like when some tries to put a transmission in reverse while still rolling forward. A metal against metal sound of two pieces trying to mate up. I'm thinking transmission...I'm hoping center diff. There was mention of a scraching sound coming from front passenger side on initial startup. Idea was this could be Immobilizer or ABS.
View 2 Replies
Seems like the problems just keep building up. Today leaving work T-reg shifts fine untill it got to 5th gear. It was around 35 mph. Went to give it more gas and it never shifted out of 5th to a lower gear. It did accelerate but even with pedal to the floor it never downshifted. Whats going on. It has done it twice in the past two days. After only having it on the road for less than 5 min each time.
View 6 Replies
Occasional clunk when truck is shifting gears. Not consistent. On highway at high acceleration clunk is more apparent. Any thoughts. 2004 v10 with new engine placed at 70,000km now at 85000km. Otherwise truck is running great.
View 8 Replies
My 2009 Accent has some very rough shifts from 1st to 2nd when I'm in the low RPMs.
Hyundai performed a transmission fluid flush and the other gears shift completely effortlessly. Is my tranny dying or what?
View 15 Replies
I drive a '93 Toyota T100 with a manual transmission. Up until recently things were going great but I've noticed it is damn near impossible to shift from reverse back into first gear when I'm pulling out of my driveway. I've also found that shifting from first gear to second has become more difficult as well though not impossible. However if I'm shifting to third, fourth, or fifth gears I don't have any problem whatsoever. I had the transmission redone about a year ago after the clutch gave out so I'm hoping its not that.
View 9 Replies
For the last few months my truck shifts rough between 2e and 3e gear. However it only does this first thing in the morning, when I leave the house I speed up until the end of the street, then when I let go of the gas it'll rev up a bit and shift from 2e to 3e while making a big clunking noise which I can definitely feel ...
It does it sometimes very rough and sometimes just a little bit. I used to not worry about it but i'm starting to wonder if something is wrong with my trans. Could it have something to do with the slip yoke?
Truck: f150 2009 xlt 4x4 supercab 6,5' box.....
View 14 Replies
I have a 2007 Passat wagon 4 motion V6 and what the problem is I am getting a rough shift between 3-4 gear sometimes, usually on a slow acceleration. I have had the valve body replaced which worked for a couple of months until the problem returned. I then had the transmission replaced which worked a little but the rough shifting is still present at times. The car still has warranty and not even the dealership knows what to do?
View 12 Replies
I around 1200 miles. The car would get going when i give it gas but it feels as if their was shifting lag or slipage. Only in first gear. Doesn't happen all the tho..usually happens on rolling stops... is this normal?
View 6 Replies
I Own A 92 Chevy Silverado, 154 K Miles. Runs Great! My Problem? I Experience Rough Shifting At First Take Off, After She Warms Up The Shifting Is Smooth. After Parking And Starting Again, Rough Shifting With A clunking Sound.
View 9 Replies
My 1992 F-250 7.3 4X4 has a very intermittent issue with the E40D. Rarely, usually after a lot of around town driving (I don't know if that has any direct correlation), I will get a rough shift from 1-2. It will kind of bang into gear and make the whole truck shudder.
On one of it's episodes, it also did it in 2-3, however that only happened once and I haven't been able to make it do that again. I'm worried that it's something that I should address, if I can do so without just rebuilding the whole transmission. It doesn't slip and shifts fine most of the time, other than the occasional 1-2 issue.
To cut this short, does this sound like a 1-2 accumulator issue? Maybe just old truck syndrome? I feel like this is a dumb as hell question, but isn't it a bad idea to install a shift kit in an E40D with 126K miles on it?
View 3 Replies
A few years ago my auto transmission in my 3.5 L engine hyundai santa fe started shifting rough from 2nd to 3rd gear, i did a trans flush and changed the input output sensors, anyway last week it started again, so i just changed the input output sensors again, it did not fix the prob this time, do you think a flush would work.
View 4 Replies
Starts fine. Runs fine till warmed up. Then dies at idle and runs rough on gear till 1000 rpm. Has only coded iac when unplugged. But would idle with it unplugged. I replaced it. Also got crank can code once while checking it ...
2001 dodge ram 1500 318 engine ....
View 2 Replies
Whilst driving unloaded, I mean the car is not under load, in say 5th gear , if I go to increase acceleration I often get a sudden unsmooth change to 4th. The change is not the normal smooth change down but a very abrupt clunk back to the lower gear. This is intermittent and hard to demonstrate to the dealer for repair.
View 4 Replies
My 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
View 1 Replies
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 Replies
I had recently purchased a 2003 golf gti AUTOMATIC (with optional shifter) with a 1.8 turbo 4 cylinder engine. The vehicle has 139,000 miles on it. Before purchasing, I had a mechanic come out and look at the vehicle for a pre-purchase inspection, and ran the code P0303 (cylinder 3 misfire) which without test driving, told me that is what caused the shift shudder I noticed when I had test driven it a previous day. He told me the coil packs were in good condition by looking at the top of them, and told me if I replace the spark plugs, the issue should go away.
I feel it is important to mention that he had also run codes on the transmission and nothing came up. Taking it home, this morning I had replaced the spark plugs and driven it for about an hour both regularly and aggressively to test it. The problem is still there, and I was really hoping that there is a solution to this problem, because everything else on the car is beautiful, while being my dream car, I just want it to work as well as I know it can. To be more descriptive, when shifting to 3rd the whole car feels basically like it is tripping over itself before successfully shifting.
View 10 Replies
