Touareg :: Rear Wiper ARM And 3rd Light LED String Replacement?
Aug 11, 2010
I have to replace my rear wiper arm and rear LED string on the hatch.
My rear wiper arm got damaged at a car wash, I took the cap off and removed the bolt however the arm will not come off.
The LED string, where to start and my dealer was unable to tell when I picked the part up.
View 6 Replies
Advertisement
How far does the rear wiper go? Full half circle; 180 degrees? Or is it less? It seems to me the couple times I used it, it made a full 180 degree sweep. After having the rear window replaced, it now only goes about 140-150 degrees. Stops at 10 o'clock position and returns.
View 3 Replies
I can activate the rear wiper spray, but cannot seem to activate the wiper itself. I am hoping that this is user error (misunderstanding owner's manual) rather than a broken rear wiper assembly.
View 2 Replies
The clips on the cover broke so I bought a new one. Since they redesigned the 04 base, I have to remove the base. I remove the nut on the outside and the 3 on the on the inside after removing the cover. However I can't figure out how to pull the wiper off and replace the base. There is something holding it together. There is a pin that is connected to the inside that has a round hole but it is not a torx, allen, or any type of other tool I tried.
View 5 Replies
How do I turn on the rear wiper without it spraying the window with washer fluid? I've followed the instructions in the manual for using the rear wiper, but very time I turn the wiper on it sprays the window with washing fluid. I don't need washer fluid sprayed on the window if the window is already wet from rain.
View 11 Replies
I bought replacement blades for Drivers side and rear window.
I'm half-way mechanical... OK , maybe 1/4. It appears that the blades themselves are not replaceable; only the refill (squeegee) portion is. is this correct?
Front-drivers-side actually looks like the complete blade may come off, but it's not obvious how it releases.
The rear appears to have no way to easily remove the complete blade.
View 7 Replies
[IMG] .....
I have the 2011 Touareg Hybrid and having a problem with the rear wiper. (Hybrid, TDI, or V6) I have 2 issues:
- Issue 1 : The rear wiper is leaking fluid and it drips down onto the tailgate and leaves a stain. (See photo) The first time i noticed this I have the wipers in the auto sensing mode. It has not rained any, but I thought it was possibly activating. After washing vehicle, I turned off the the auto sensing and it has not rained at all nor have I used the wiper for anything. It did it again. I have informed my service advisor at VW and they are going to look at it next time I take it in.
- Issue 2 : My dealer and I have narrowed this down to be only on the Hybrid. The rear wiper does not lift up. Meaning I cannot pull the wiper out at all for cleaning and washing vehicle. When I got my hybrid, I could do that. However, there is a cap at the end covering the spray holes. We had to push the cap down further to where the holes in the cap lined up with where the water shoots out. This appears to be the correct position for the cap, but it now prevents you from being able to raise the wiper. You can also see the cap in the photo.
View 24 Replies
I've got white string coming out from my rear seats between the seam of the back part of the seat and the part that you sit on. Not sure if this is a part of the seat or something that was left over that they didn't remove.
View 6 Replies
Last night while driving in the ice and snow storm we had in the north east my passenger side wiper started acting funny was hitting the driver side wiper and not going full cycle. I think there is something wrong with the linkage,the driver side works fine bringing it in for service Monday.
2006 V10
View 2 Replies
How to replace the FRONT RIGHT PARKING LIGHT. That is how it says in the instrument panel cluster...
View 1 Replies
Not real happy with stock blades. Leaves streaks. Bought right size Goodyear hybrid at Costco. But it seems the push button adapter will not work. Toyota has always used J hook before. So now they switch to push button but apparently some non standard version. Checked Rain-x, Bosch, Goodyear sites. Nobody lists 2016 Prius.
View 3 Replies
I have replaced the wiper motor and the wiper blades stop vertical on the wind shield. Readjusting the position of the wipers does not work. The wipers wipe the hood when that is done. I have done something wrong.
View 1 Replies
Is this easy to do? I can get the part fairly cheaply, but if I can save on the labor I would like to. I bought my prius new in 2005, and I still have it, even though I also have a tacoma. Because the Prius is my "second vehicle" now, I am trying to save on repairs.
View 2 Replies
Looking for a video or directions as to how I replace a windshield wiper motor on a 2006 SD?
View 2 Replies
I took delivery of a new 2004 Touareg V8 with nav system radio, yesterday. On the way home, in the rain, the front windshield wipers stopped working as well as sound from the radio (controls, menus, etc... were still illuminated) This is not very comforting. Windshield wipers are quite necessary in the rain. The general technology behind windshield wipers and radios would seem to be mature to the point that reliability need not be questioned. As a new owner having just been through an hour of instruction on operating this piece of machinery, I felt somewhat inadequate that I could not operate the windshield wipers and radio. I said to myself, it can't be this hard! My wife and I became frustrated at each other to the point of my speculation on who would get the vehicle in the divorce.
When I finally made my way into my driveway, I decided to check the wiper fuse because it was most necessary, rain being forecast for the next several days.
I pulled the 30A fuse for the wipers and found it to be OK. I then replaced it. Behold, both the wipers and radio began to work. (The manual does not say anything about the radio being connected to the wiper fuse) Case closed, I thought. 5 minutes later they went out again. I pulled the fuse, replaced it and eureka, they began to work again. I drove the vehicle today for about 30 minutes at which time they ceased to function once more.
View 6 Replies
Having issue with these wiper blades? My wife's touareg has less than 15k, but the wiper blades are streaking and otherwise less than useless. I have had the same wiper blades on my jetta for over 2 years with no issue. I have tried cleaning the wipers several times, but to no avail. Before I shell out $60+ on some wiper blades. I know I am gonna probably gonna have to get the new wipers.
View 1 Replies
[IMG] ....
I have an 05 Touareg and the passenger side windshield wiper is not wiping a small section of the screen, approximately behind the rear view mirror. It's not a problem with the blade (I replaced those) so I suspect the wiper arm needs adjustment. Raising the car's bonnet reveals the wiper arm attachment (see picture) but there's a plastic cover that it looks like I need to remove. Usually I use brute force and break things like this. How to
(1) remove the plastic cover and
(2) adjust the wiper arm
View 1 Replies
I was unable to find a related thread for this topic. I thought there was an old one.
Anyways, having issue of the drivers side wiper leaving an area unwiped at eye level?
New wipers fixes this problem, but for only two days
View 10 Replies
Looking for a tutorial on how to remove the multi-function switch? I have the, seemingly, common issue of wipers not turning off. I bought the new switch, but don't see how to get it out without taking the whole steering wheel off. I can't get to the screws on it at all. I got the plastic covers off, but can't see how to get the switch out.
View 3 Replies
I need detailed instructions for how to replace the right (passenger's side) rear turn signal bulb socket and the subassembly that holds the remaining bulbs and inserts into the tail light assembly. I've done this once before successfully but now can't seem to make it work now.
Without the subassembly inserted and locked into place with its locking tabs, the turn signal bulb locks into place in its socket, and that socket in turn easily inserts and locks into place in the hole in the outboard corner of the lens through the rear of the lens assembly. However, I can't seem to install both the turn signal bulb in its socket and the subassembly that holds the rest of the bulbs. The two contacts on the underside of the rim of the turn signal bulb socket would indicate that that the socket installs after the subassembly, but then it has nothing to plug into. When it's installed first, I don't see how the bulb would be energized.
The owner's manual of course says to have the dealer handle maintenance in this area.
View 1 Replies
2000 F350 CC DRW 4X4. There's a 3 light bar lamp mounted here that needs replacing. Plastic mounting -Grote 10-7016-01 PCC.- Can't find one. looking for replacement PN? like to have LED.
View 1 Replies