Touareg :: Instrument Cluster Setting Won't Working
Feb 18, 2004
The instrument cluster settings has not been working and they would not set when i would try to do this.It would go back to the same setting as before.They checked it on the computer and everything would register like it was ok but the computer could not detect the fault.Come to find out it needs a new instrument cluster and that was the fix for it after they took three more Tregs apart to make sure it would either work or not work at all.They all worked except for mine.It is being replaced and shipped overnight.
View 3 Replies
Advertisement
My dashboard has a rattle (surprise!) in the instrument cluster and today I have located the source of the noise. It comes from the right side of the hood piece over the dials. The right corner of the front edge of that hood rattles against the rest of the console. It can be fixed by applying a little piece of the electric tape or a piece of foam on the inside of that hood. I do want to go to the dealer and I'd prefer to fix such a minor problem by myself.
Looking for a schematic on how to take the dashboard apart? I wonder, why this dashboard hood consists of 2 pieces made of hard plastic attached without any padding? Of course, they will rattle!
View 15 Replies
I am on occasion getting a warning on my instrument cluster regarding my locking diff. System Fault!! Workshop!! is displayed. As well the adjustment knob on the center console flashes yellow.
View 11 Replies
The speedometer, tachometer, fuel gauge, battery meter, temp gauge and idiot lights went out. The car works fine. Dash is just dead. I did a quick look at the fuses in the glove box but it doesn't have the little card to tell fuse locations. So, I can't narrow it down but I don't see any blown fuses.
View 4 Replies
Noticed a clicking noise coming from the steering column or instrument cluster. This usually occurs when the car is warming up, but I have noticed it other times as well.
View 20 Replies
I did the rear fog light install yesterday and I am trying to activate the rear fog light icon in the instrument cluster. My lights have been vag'd (base now ...5692).
View 12 Replies
The brake pads worn symbol has lit up in the instrument cluster on my wife's 2008 Touareg V8. The car has 33K. Per Tom Bush VW in Jacksonville, both pads and rotors must be replaced. This is without even looking at it.
Per Osteen VW also in JAX, I might not have to replace the rotors. They stated that what they have seen is that usually the rotors don't get replaced until the second visit to replace pads.
View 5 Replies
I have an issue where the instrument cluster (tach, spedo, fuel, temp, door open indicator, etc) and AC stop working. It only happens under the following conditions and can be reproduced easily. All fuses have been check and are OK.
1.No Gauges
2.Remove and replace Multi-Fuse 20 (which is new and good)
3.Gauges and AC start working again
4.Drive car or start etc. and everything works fine
5.Power off car for exactly 1 min. or more with doors closed
6.Start car and no gauges or AC again
7.If wait less than 1 min. (tested 30 sec. to 59 sec. ) to restart the car and all gauges and AC continue to work fine
Where to start diagnosing.
View 1 Replies
Having issue with the 2006 Touareg instrument clusters. The upper left hand corner of the instrument cluster is getting dim. Also, my wife was driving to work the other day, and she stated that she heard what sounded like electrical arcing behind the console. Just curious. She has had the touareg in for service for the air bag error, which they had to order a part. Also, a mysterious headlight error keeps popping up, but then goes away. I don't want a fireball touareg.
View 5 Replies
Instrument cluster (speedometer, Tachometer, Break & ABS light) is not working while driving.
My video for my 2009 camry 2.4 LE is here: [URL] .....
Toyota service center asked $6000 to replace wire harness and PROBABLY electronic control unit.
I found some posts, but the answers are not that clear to fix it. [URL] ....
View 1 Replies
This is for my gf's 2010 sonata. The instrument cluster stopped working but then after a couple days it started again. Once again it stopped working. This time I checked the fuse and it was fine, there was power going to it. I was able to get it to start working again by disconnecting the battery. I hate electrical shorts. I have done some research but haven't come up with anything other than re-seat the cluster or replace it. I plan on doing that the next time it stops working. I'm thinking it might have something to do with the ignition, but i really don't know.
Engine codes are P0011/P0014/P0462
The P0011/P0014 are, i think, the oil control valve. I ordered that.
The P0462 code has to do with low voltage to the fuel level sensor, but the gas gauge has worked fine, well other than when none of the gauges work. Still I don't think it relates to cluster problem.
View 1 Replies
The instrument cluster in my 2000 Silverado 1500 recently stopped working. All the gauges are flush to the left, except for the oil and battery which stay about in the middle. I ordered a different cluster online and went to install it today, finding that it still doesnt work. Except in this one everything aside from battery and oil are flush to the right. What to try next or am I going to need to take it in?
View 1 Replies
2006 Sonata 3.3 (NF series). A few days ago the instrument cluster and LCD odometer stopped working.
The dash cluster lights up, warning lights flash on at start up just no indication of speed, fuel level, tach, or temp.
Fuse is good & has power to it. I re-seated all the connectors under the dash. No luck.
View 2 Replies
Ok .. Airbag warning light is on..... And won't go off i have taken battery off try reset that way nothing. Also steering wheel lights are off...
Only thing working on instruments on steering wheel is the left side is the radio and phone and volume and mode right side of steering wheel not working but nothing is illuminated!!!!???? On wheel
View 2 Replies
I have a 2013 F250 with 49.575 miles and Saturday the truck left me stranded. I was towing my small trailer and doing about 45 mph.....When just out of nowhere .....I got every possible warning come across my display and none of my instruments were working. That included speedo,tach,boost....even the radio and ac were effected in some way. So after a few miles I was able to pull over ....cut the truck off and it wouldn't start.... So I had Ford roadside service tow it to my home dealership.
View 13 Replies
I am really hoping that my instrument cluster in not working because my alternator went out at the same time. I really hope they are connected somehow. I really need a wiring diagram for this one. Just got the truck last week and have been taking care of the little things to get it fixed up and make it my own. my new rear step bumper came in today. I will be dropping off the the alternator for a rebuild tomorrow. So looking for a wiring diagram?
View 7 Replies
Have a '13 F150 Platinum. Recently three things "broke" at the same time and I suspect a fuse but cannot locate the right one. At first I thought it was just the GD Opener, but when trying to reprogram it, I realized the red lights were not lighting up and the Drivers side Vanity Mirror light was not working.
About the same time, I noticed that the Instrument Cluster Memory function quit working and weirdly, every time the truck is switched off and then back on, it always comes back to the trailer tow screen for my Snowmobile trailer.
I thought i had it solved when I found that the trailer back-up lamp relay power fuse ( #43 in fusebox under hood) was blown. I replaced with a good 15 amp fuse and the problems are still there. I have searched high and low and cannot find a fuse for the Car2u GD Opener or the Driver Vanity Mirror Light (neither Vanity light for that matter. I tested all under hood fuses, but the kick panel fuses are impossible to check one-by-one.
View 3 Replies
I'm having a little problem with my F350. I've had it for about a month now and the cluster had no problems or whatsoever. Then, I drove it today and I noticed that the instrument cluster is not working at all. The lights work, but the gauges wouldn't move. When I turn the key before starting it the chime is beeping faster than it usually did before and it wouldn't shut off unless I close the door. It also only indicates the airbag and battery light. I checked all the fuses and they were good especially #15 or #16 can't remember it right now.
I don't know if its related, but this past saturday I was messing with the overhead instrument cluster for the gas mileage and all that. I soldered some of the relays back on and that was it. I started the truck after I did all that, but everything was still working. It's been bugging me all day today.
View 3 Replies
So, went to drive the truck (2004 F250 6.0, 145000 mi) yesterday and the right half of my instrument cluster was not working (tach, trans temp and water temp), CEL and check gauges lights on. My scan gauges gives me readouts of all 3, so I know the computer knows the right values. Pulled all three fuses related to the cluster, all looked good. All gauges, including those not working, did full sweeps with key on after putting fuses back, so I know they function. Also, the glow plug light stays on way longer than normal.
View 2 Replies
My right side of my instrument cluster is not working. the Tachometer, Engine Temp and Trans Temp gauge are non responsive, and the CEL and Check gauge light is on. I have seen other posts with people that had the same problem but no solution to what fixed the problem. 2004 F250 Lariat.
View 4 Replies
I am currently converting a 1999 E350 7.3 diesel bus into a camper to live in. The bus has already had a lot of weird custom work. Done by someone else and a lot of the interior torn out and extra insulation put in. There is an exposed electrical panel behind the drivers seat. It was a cheap buy, previously fleet maintained with only 120k.
I was hooking up a battery for accessories to a terminal labeled "Battery" that does run indeed directly to the + terminal of the battery in the engine compartment.
Unfortunately I mistakenly connected the accessory battery to a terminal labeled "ignition" that runs to behind the dash. When I tried starting the vehicle off the auxiliary battery for a test everything went out for 2 seconds, I heard a click from the engine compartment, and everything than came back on. This is when I realized my mistake.
It used to be the speedo only didn't work (which I assumed was the step motor), now after this mistake all the gauges, the odometer and the buzzers don't work. Lights like the battery and airbag warning indicator still function.
Checked fuse 2 (15 amp) for the instrument cluster and it is intact. Actually checked every fuse in the vehicle in both fuse panels and all are intact. The radio works though and the vehicle is not equipped with power windows.
Going to go get a radio removal tool to take apart the dash and get back there. What this could be? Did I fry a relay? Did I fry the cluster circuit board.
View 6 Replies
